Mark Halpern

Observations with the Canadian Hydrogen Intensity Mapping Experiment (CHIME) have been used to measure the 21 cm intensity mapping autopower spectrum, at z ∼ 1, over a frequency range from 608.2 to 707.8 MHz at wavenumbers 0.4 h Mpc ⁻¹ ≲ k ≲ 1.5 h Mpc ⁻¹ . In this paper, we present the results of two different approaches to interpreting this measurement. In the first approach, we use a parametric power spectrum model to constrain an amplitude parameter, defined as A HI 2 ≡ 1 0 6 Ω HI 2 ( b HI 2 + 〈 f μ 2 〉 ) 2 , where Ω _HI is the cosmological density parameter for atomic hydrogen (H I ), b _HI is the linear bias for H I , and 〈 fμ ² 〉 incorporates the dominant large-scale impact of redshift-space distortions on the angle-averaged power spectrum. Imposing an additional prior on either Ω _HI or b _HI , based on values in the literature, allows us to break the pairwise degeneracy between those two parameters. In the second approach, we compare CHIME’s measurement with predictions for the power spectrum of H I from the IllustrisTNG simulations, finding that the measurement disagrees with the TNG100 run at 3.1 σ and the TNG300 run at 4.0 σ . The disagreement is likely attributable to the effects of nonlinear H I clustering and redshift-space distortions in the simulations, rather than the total abundance of H I , and invites further investigation of the physical processes in the simulations that determine the behavior of H I at nonlinear scales. These results exemplify the ability of 21 cm intensity mapping to provide astrophysical information using measurements at nonlinear scales.

We present the first detection of the cosmological 21 cm intensity mapping signal in autocorrelation at z ∼ 1 with the Canadian Hydrogen Intensity Mapping Experiment (CHIME). Using 94 nights of observation, we have measured the 21 cm auto power spectrum over a frequency range of 608.2–707.8 MHz ( z = 1.34–1.01) at 0.4 h Mpc ⁻¹ ≲ k ≲ 1.5 h Mpc ⁻¹ , with a detection significance of 12.4 σ . Our analysis employs significant improvements to the CHIME data processing pipeline compared to previous work, including novel radio frequency interference detection and masking algorithms, achromatic beamforming techniques, and foreground filtering before time averaging to minimize spectral leakage. We establish the robustness and reliability of our detection through a comprehensive suite of validation tests. We also measure the 21 cm signal in two independent sub-bands centered at z ∼ 1.08 and z ∼ 1.24 with detection significance of 8.6 σ and 9.1 σ , respectively. We briefly discuss the theoretical interpretation of these measurements in terms of a power spectrum model, deferring the details to a companion paper. This auto power spectrum detection demonstrates CHIME’s capability to probe large-scale structure through 21 cm intensity mapping without reliance on external galaxy surveys.

Line intensity mapping using atomic hydrogen (H I ) has the potential to efficiently map large volumes of the Universe if the signal can be successfully separated from overwhelmingly bright radio foreground emission. This motivates cross correlations, to ascertain the cosmological nature of measured H I fluctuations, and to study their connections with galaxies and the underlying matter density field. However, these same foregrounds render the cross correlation with projected fields such as the lensing of the cosmic microwave background (CMB) difficult. Indeed, the correlated Fourier modes vary slowly along the line of sight and are thus most contaminated by the smooth-spectrum radio continuum foregrounds. In this paper, we implement a method that avoids this issue by attempting to measure the nonlinear gravitational coupling of the small-scale 21 cm power from the Canadian Hydrogen Intensity Mapping Experiment (CHIME) with large-scale Planck CMB lensing. This measurement is a position-dependent power spectrum, i.e., a squeezed integrated bispectrum. Using 94 nights of CHIME data between 1.0 < z < 1.3 and aggressive foreground filtering, we find that the expected signal is 5 times smaller than the current noise. We forecast that incorporating the additional nights of CHIME data already collected would enable a signal-to-noise ratio of 3, without any further improvements in filtering for foreground cleaning.

The BICEP/Keck collaboration searches for B-mode polarization in the Cosmic Microwave Background (CMB) as evidence of inflationary gravitational waves, with current best constraints placing $r_{0.05} < 0.035$. Building even deeper and larger maps requires scaling detector count at 150 GHz, where B-mode power is expected to peak at $\ell \sim 80$. The BICEP Array 150 GHz receiver (BA150) fields 7776 superconducting transition edge sensor (TES) detectors, over 15× the 512 deployed in the previous BICEP/Keck 150 GHz receiver, making it the densest time-division multiplexed readout receiver in the collaboration's history. We present the complete detector characterization of all 12 detector modules as deployed in BA150. We report thermal properties ($T_{c}$, $G_{c}$, $P_\rm{sat}$), end-to-end optical efficiencies of 20–48%, and fractional bandwidths of $\sim$28% across all modules. We additionally report the identification and mitigation of an out-of-band high-frequency photon leak spanning 180–265 GHz, and present preliminary investigations of elevated on-sky noise attributed to aliased high-frequency detector noise.

We present a catalog of 4539 fast radio bursts (FRBs) observed with the Canadian Hydrogen Intensity Mapping Experiment telescope between 2018 July 25 and 2023 September 15. These bursts originate from 3641 unique sources, including 981 bursts from 83 known repeating sources. For each FRB, the catalog provides an O ( 1 0 ′ ) estimate of sky location along with corresponding measurements of cumulative exposure time and survey sensitivity over the observing period. It includes a total-intensity dynamic spectrum between 400 and 800 MHz at 0.983 ms resolution. From this spectrum, we constrain a model of the burst morphology and measure key parameters such as arrival time, intrinsic temporal width, dispersion measure, scattering time, and flux density. This second catalog includes all FRBs from the first catalog, with every event reprocessed using a uniform and improved analysis framework. We show that previously published inferences remain valid under the updated measurements. We assess consistency of the detection rate across observational parameters, present initial distributions of burst properties, and outline ongoing and future studies that will use this catalog to investigate the nature of FRBs and their utility as astrophysical and cosmological probes.

We report the detection of a new 21 cm absorption system associated with the radio source NVSS J164725 + 375218 at a redshift of z = 2.327, identified through a pilot survey conducted by the Canadian Hydrogen Intensity Mapping Experiment (CHIME). This is the fifth detection of an associated system at z > 2. By analyzing a subset of available data, we conduct a spectrally blind survey for 21 cm absorption systems within the redshift range of 0.78–2.55 along 202 lines of sight toward known sources in the declination range of 35° to 60°. We detect three 21 cm absorbers: two previously known intervening systems and one newly discovered associated system. By fitting the absorption profiles with models containing one to three Gaussian components and selecting the best model using the Bayesian information criterion, we estimate the optical depth, velocity-integrated optical depth, and the ratio between the H i column density and the spin temperature of the absorption systems. These results demonstrate CHIME’s ability to discover new absorbers, even in a small subset of its full dataset.

We present power spectra of the cosmic microwave background (CMB) anisotropy in temperature and polarization, measured from the Data Release 6 maps made from Atacama Cosmology Telescope (ACT) data. These cover 19,000 deg ² of sky in bands centered at 98, 150 and 220 GHz, with white noise levels three times lower than Planck in polarization. We find that the ACT angular power spectra estimated over 10,000 deg ² , and measured to arcminute scales in TT, TE and EE, are well fit by the sum of CMB and foregrounds, where the CMB spectra are described by the ΛCDM model. Combining ACT with larger-scale Planck data, the joint P-ACT dataset provides tight limits on the ingredients, expansion rate, and initial conditions of the universe. We find similar constraining power, and consistent results, from either the Planck power spectra or from ACT combined with WMAP data, as well as from either temperature or polarization in the joint P-ACT dataset. When combined with CMB lensing from ACT and Planck , and baryon acoustic oscillation data from the Dark Energy Spectroscopic Instrument (DESI DR1), we measure a baryon density of Ω _b h ² = 0.0226 ± 0.0001, a cold dark matter density of Ω _c h ² = 0.118 ± 0.001, a Hubble constant of H ₀ = 68.22 ± 0.36 km/s/Mpc, a spectral index of n _s = 0.974 ± 0.003, and an amplitude of density fluctuations of σ ₈ = 0.813 ± 0.005. Including the DESI DR2 data tightens the Hubble constant to H ₀ = 68.43 ± 0.27 km/s/Mpc; ΛCDM parameters agree between the P-ACT and DESI DR2 data at the 1.6 σ level. We find no evidence for excess lensing in the power spectrum, and no departure from spatial flatness. The contribution from Sunyaev-Zel'dovich (SZ) anisotropy is detected at high significance; we find evidence for a tilt with suppressed small-scale power compared to our baseline SZ template spectrum, consistent with hydrodynamical simulations with feedback.

We present Atacama Cosmology Telescope (ACT) Data Release 6 (DR6) maps of the Cosmic Microwave Background temperature and polarization anisotropy at arcminute resolution over three frequency bands centered on 98, 150 and 220 GHz. The maps are based on data collected with the AdvancedACT camera over the period 2017–2022 and cover 19,000 square degrees with a median combined depth of 10 μK arcmin. We describe the instrument, mapmaking and map properties and illustrate them with a number of figures and tables. The ACT DR6 maps and derived products are available on LAMBDA at https://lambda.gsfc.nasa.gov/product/act/actadv_prod_table.html . We also provide an interactive web atlas at https://phy-act1.princeton.edu/public/snaess/actpol/dr6/atlas and HiPS data sets in Aladin (e.g. https://alasky.cds.unistra.fr/ACT/DR4DR6/color_CMB ).