Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Alberto Zanelli has a total of 251 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Coupling Photochromism and Charge Transport in π-Extended Arylazo Oligothiophenes and Oligothienoacenes

    by Chiara Taticchi, Federico Nicoli, Mattia Zangoli, Filippo Monti, Eugenio Lunedei, Alessandro Turci, Massimiliano Curcio, Pierluigi Mondelli, Mario Caironi, Magda Monari, et al.

    Developing photoresponsive molecular materials that couple efficient charge transport with robust photoswitching remains challenging because structural features enhancing one function often compromise the other. In this study, two homologous series of arylazo oligothiophenes and oligothienoacenes-in which an azo photoswitch is directly conjugated to a π-extended thiophenic scaffold-were systematically investigated. Ultraviolet-visible (UV-vis) spectroscopy combined with theoretical calculations shows that, in solution, π-extension enables E → Z photoisomerization using visible light but concurrently lowers the barrier for thermal Z → E back-conversion by activating rotational isomerization pathways. Aryl fluorination counteracts this effect by strengthening intramolecular S(n)···π interactions, extending the Z-isomer half-life from minutes to hours. In the solid state, π-extension promotes dense intermolecular packing that inhibits photoisomerization. Introduction of a bulky trityl group reduces packing density, as revealed by single-crystal analysis, restoring E ⇆ Z photochromism in crystalline thin films and inducing a crystalline-to-amorphous transformation, as evidenced by X-ray diffraction (XRD) and microscopic analysis. The resulting light-driven molecular and morphological reorganization enables reversible, light-induced modulation of electrical conductivity in two-contact planar devices. Space-charge-limited-current measurements show that conductivity changes correlate with isomer-dependent electron mobility properties. Overall, these findings establish π-extended azo-thiophene scaffolds as a versatile platform to couple photochromism and morphological reorganization with charge transport phenomena.

  • Open Access

    Engineering Biomass-Derived Activated Carbon for Caffeine Adsorption: Mass Transport and Interfacial Energetics

    by Rogerio dos Santos Maniezzo, Hugo Henrique Carline de Lima, Gredson Keiff Souza, Armando Mateus Pomini, Pedro Augusto Arroyo, Francielle Sato, Alberto Zanelli, Marcos Rogério Guilherme, Andrelson Wellington Rinaldi


  • Open Access

    Oligothiophene-based photosensitizers with tunable push–pull architectures: design, synthesis and characterization

    by Soraia Flammini, Manuele Di Sante, Paolo Emidio Costantini, Edoardo Jun Mattioli, Alessia Marconi, Eleonora Turrini, Silvia la Rosa, Maria Montrone, Tainah Dorina Marforio, Michela Nigro, et al.

    Rationally designed thiophene-based photosensitizers, characterized by push–pull architectures and conjugated to albumin, enable fluorescence imaging and efficient photodynamic cancer therapy.


  • Pseudomorphic Transformation in Nanostructured Thiophene-Based Materials

    by Mattia Zangoli, Raffaello Mazzaro, Eugenio Lunedei, Eduardo Fabiano, Ilse Manet, Andrea Candini, Alessandro Kovtun, Meriem Goudjil, Alberto Zanelli, Shlomo Rozen, et al.

    This study reveals the capability of nanostructured organic materials to undergo pseudomorphic transformations, a ubiquitous phenomenon occurring in the mineral kingdom that involves the replacement of a mineral phase with a new one while retaining the original shape and volume. Specifically, it is demonstrated that the postoxidation process induced by HOF·CH3CN on preformed thiophene-based 1D nanostructures preserves their macro/microscopic morphology while remarkably altering their electro-optical properties by forming a new oxygenated phase. Experimental evidence proves that this transformation proceeds via an interface-coupled dissolution-precipitation mechanism, leading to the growth of a porous oxidized shell that varies in thickness with exposure time, enveloping the pristine smooth core. The oxygenated species exhibits stronger electron-acceptor characteristics than the core material, promoting charge transfer state formation, as confirmed by microspectroscopy and DFT calculations. This enables (i) precise modulation of the nanostructure's surface potential, allowing for the formation of entirely organic heterojunctions with precise spatial resolution via wet chemical processing; (ii) effective doping of the nanostructure, resulting in a strong change of the conductivity temperature dependence and a switch between a low and high conduction state depending on the applied bias. Overall, this work showcases an approach to engineering "impossible" composite architectures with pre-established morphology and tailored chemical-physical properties.


  • Open Access

    Multifunctional Photoelectroactive Materials for Optoelectronic Applications Based on Thieno[3,4‐b]pyrazines and Thieno[1,2,5]thiadiazoles

    by Mattia Zangoli, Filippo Monti, Alberto Zanelli, Martina Marinelli, Soraia Flammini, Nicol Spallacci, Anna Zakrzewska, Massimiliano Lanzi, Elisabetta Salatelli, Filippo Pierini, et al.

    In this study, we introduce a novel family of symmetrical thiophene‐based small molecules with a Donor‐Acceptor‐Donor structure. These compounds feature three different acceptor units: benzo[c][1,2,5]thiadiazole (Bz), thieno[3,4‐b]pyrazine (Pz), and thieno[1,2,5]thiadiazole (Tz), coupled with electron donor units based on a carbazole‐thiophene derivative. Using Density Functional Theory (DFT), we investigate how the molecular geometry and strength of the central acceptor unit impact the redox and spectroscopic properties. Notably, the incorporation of Pz and Tz moieties induces a significant redshift in the absorption and emission spectra, which extend into the near‐infrared (NIR) region, simultaneously reducing their energy gaps (~1.4–1.6 eV). This shift is attributed to the increased coplanarity of the oligomeric inner core, both in the ground (S0) and excited (S1) states, due to the enhanced quinoidal character as supported by bond‐length alternation (BLA) analysis. These structural changes promote better π‐electron delocalization and facilitate photoinduced charge transfer processes in optoelectronic devices. Notably, we show that Pz‐ and Tz‐containing molecules exhibit NIR electrochromic behavior and present ambivalent character in bulk heterojunction (BHJ) solar cells. Finally, theoretical calculations suggest that these molecules could serve as effective two‐photon absorption (2PA) probes, further expanding their potential in optoelectronic applications.


  • Open Access

    Building towards Supercapacitors with Safer Electrolytes and Carbon Electrodes from Natural Resources

    by Mohammad Said El Halimi, Alberto Zanelli, Francesca Soavi, Tarik Chafik

    The growing interest in energy storage devices, both batteries and capacitors, could lead to the improvement of electrochemical properties such as extended charge/discharge cycles, high specific capacitance, and power density. Furthermore, the use of easily available raw materials for the production of carbon electrodes has attracted interest due to the criticality of the resources related to the current technologies of high-performance capacitors. The present article reviews carbon-based materials for supercapacitors derived from affordable coal deposits or crop waste with appropriate characteristics in terms of specific surface area, electrical conductivity, and charge/discharge stability. In addition, the substitution of organic liquids electrolytes with less dangerous solutions, such as aqueous electrolytes containing high concentrations of salt, is a valuable strategy for the design of green devices that is discussed in this review. Finally, the present article reviews the electrochemical performance of supercapacitors based on carbon electrodes obtained from various natural resources and their compatibility with safer and cheaper electrolytes.


  • Open Access

    Ionic Push–Pull Polythiophenes: A Further Step towards Eco-Friendly BHJ Organic Solar Cells

    by Martina Marinelli, Massimiliano Lanzi, Filippo Pierini, Yasamin Ziai, Alberto Zanelli, Debora Quadretti, Francesca Di Maria, Elisabetta Salatelli

    Four new conjugated polymers alternating benzothiadiazole units and thiophene moieties functionalized with ionic phosphonium or sulfonic acid salts in the side chains were synthesized by a postfunctionalization approach of polymeric precursors. The introduction of ionic groups makes the conjugated polymers soluble in water and/or polar solvents, allowing for the fabrication of bulk heterojunction (BHJ) solar cells using environmentally friendly conditions. All polymers were fully characterized by spectroscopic, thermal, electrochemical, X-ray diffraction, scanning electron, and atomic force techniques. BHJ solar cells were obtained from halogen-free solvents (i.e., ethanol and/or anisole) by blending the synthesized ionic push–pull polymers with a serinol-fullerene derivative or an ionic homopolymer acting as electron-acceptor (EA) or electron-donor (ED) counterparts, respectively. The device with the highest optical density and the smoothest surface of the active layer was the best-performing, showing a 4.76% photoconversion efficiency.


  • Open Access

    Push–pull thiophene-based small molecules with donor and acceptor units of varying strength for photovoltaic application: beyond P3HT and PCBM

    by Martina Marinelli, Andrea Candini, Filippo Monti, Alex Boschi, Mattia Zangoli, Elisabetta Salatelli, Filippo Pierini, Massimiliano Lanzi, Alberto Zanelli, Massimo Gazzano, et al.

    Here is reported an expedient synthesis implementing enabling technologies of a family of thiophene-based heptamers alternating electron donor (D) and acceptor (A) units in a D–A′–D–A–D–A′–D sequence. The nature of the peripheral A groups (benzothiadiazole vs. thienopyrrole-dione vs. thiophene-S,S-dioxide) and the strength of the donor units (alkyl vs. thioalkyl substituted thiophene ring) have been varied to finely tune the chemical-physical properties of the D–A oligomers, to affect the packing arrangement in the solid-state as well as to enhance the photovoltaic performances. The optoelectronic properties of all compounds have been studied by means of optical spectroscopy, electrochemistry, and density functional theory calculations. Electrochemical measurements and Kelvin probe force microscopy (KPFM) predicted a bifunctional behaviour for these oligomers, suggesting the possibility of using them as donor materials when blended with PCBM, and as acceptor materials when coupled with P3HT. Investigation of their photovoltaic properties confirmed this unusual characteristic, and it is shown that the performance can be tuned by the different substitution pattern. Furthermore, thanks to their ambivalent character, binary non-fullerene small-molecule organic solar cells with negligible values of HOMO and LUMO offsets were also fabricated, resulting in PCEs ranging between 2.54–3.96%.


  • Single-material organic solar cells with fully conjugated electron-donor alkoxy-substituted bithiophene units and electron-acceptor benzothiadiazole moieties alternating in the main chain

    by Martina Marinelli, Massimiliano Lanzi, Andrea Liscio, Alberto Zanelli, Mattia Zangoli, Francesca Di Maria, Elisabetta Salatelli

    Main chain conjugated linear polymers, constituted by alternating electron-donor (D) and -acceptor (A) moieties, have been prepared with the aim of testing their performances as photoactive components in single material organic solar cells (SMOSCs). The D moiety is constituted by bithiophene co-units bearing in position 3 of the thiophene ring a hexyloxy, a hexyloxymethyl or a hexyl group, while the A moiety is represented by the benzothiadiazole group. The D–A polymers were obtained in high yield through the poorly demanding oxidative FeCl3 polymerization process – starting, respectively, from the related precursors 4,7-bis(3-hexyloxythiophen-2-yl)benzo[c][2,1,3]thiadiazole, 4,7-bis[3-(6-methoxyhexyl)thiophen-2-yl]benzo[c][2,1,3]thiadiazole and 4,7-bis(3-hexylthiophen-2-yl)benzo[c][2,1,3]thiadiazole – with low dispersity indexes, close to the monodisperse state, after fractionation with methanol. The materials have been thoroughly characterized for their physical and structural properties and then tested for photoconversion efficiency in SMOSCs by using different deposition procedures of the photoactive component. In agreement with Kelvin probe force microscopy (KPFM) measurements, the best photovoltaic performance was observed for the polymer based on conjugated 3-alkoxythiophene and benzothiadiazole moieties, achieving significant photocurrents for this type of fully conjugated alternating D–A structure (Jsc = 2.63–3.72 mA cm−2).


  • Open Access

    Titania nano-coated quartz wool for the photocatalytic mineralisation of emerging organic contaminants

    by M. Saracino, L. Pretali, M. L. Capobianco, S. S. Emmi, M. L. Navacchia, F. Bezzi, C. Mingazzini, E. Burresi, A. Zanelli

    Many emerging contaminants pass through conventional wastewater treatment plants, contaminating surface and drinking water. The implementation of advanced oxidation processes in existing plants for emerging contaminant remediation is one of the challenges for the enhancement of water quality in the industrialized countries. This paper reports on the production of a TiO2 nano-layer on quartz wool in a relevant amount, its characterization by X-ray diffraction and scanning electron microscopy, and its use as a photocatalyst under ultraviolet radiation for the simultaneous mineralisation of five emerging organic contaminants (benzophenone-3, benzophenone-4, carbamazepine, diclofenac, and triton X-100) dissolved in deionized water and tap water. This treatment was compared with direct ultraviolet photolysis and with photocatalytic degradation on commercial TiO2 micropearls. The disappearance of every pollutant was measured by high performance liquid chromatography and mineralisation was assessed by the determination of total organic carbon. After 4 hours of treatment with the TiO2 nano-coated quartz wool, the mineralisation exceeds 90% in deionized water and is about 70% in tap water. This catalyst was reused for seven cycles without significant efficiency loss.