Joseph L. Loof
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Joseph L. Loof has a total of 1 co-authors. Here are the top co-authors by number of shared publications:
- Thomas G. Pratt
Department of Electrical Engineering, University of Notre Dame, Notre Dame, IN, USA
2 shared publications
Latest Publications
- 24 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 26 (7) , 1061-1064
Blind Separation of Frequency-Hopped Signals Using a Space-Polarization Receiver
An approach for associating signals from frequency hopped (FH) emitters has recently been proposed that leverages polarization-frequency characterizations obtained from dual-polarized antenna architectures. An effective extension of these methods is considered here that incorporates multiple spatially-separated dual-polarized antennas. Correlations in polarization-frequency responses, space-frequency responses, and hybrid combinations are leveraged to associate FH signals. The extended method is investigated using empirically-informed simulations and over-the-air experiments to illustrate the efficacy of the approach. The over-the-air experiments involved four frequency-hopped signals in a laboratory environment. A two-second interval was collected involving 2000 frequency hopping dwells. Results for a single manifold were found to experience misassociation errors, even at high SNR, due to similarities between polarization-frequency responses associated with the sources. When all manifolds are exploited, perfect association is achieved over the interval. Similar trends occur at low SNR, where increasing the number of available manifolds improves misassociation rates. It is concluded that additional diversities provided by a space-polarization architecture improve association performance.
- 24 May 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Signal Processing Letters
- Vol. 26 (7) , 1061-1064
Blind Separation of Frequency-Hopped Signals Using a Space-Polarization Receiver
An approach for associating signals from frequency hopped (FH) emitters has recently been proposed that leverages polarization-frequency characterizations obtained from dual-polarized antenna architectures. An effective extension of these methods is considered here that incorporates multiple spatially-separated dual-polarized antennas. Correlations in polarization-frequency responses, space-frequency responses, and hybrid combinations are leveraged to associate FH signals. The extended method is investigated using empirically-informed simulations and over-the-air experiments to illustrate the efficacy of the approach. The over-the-air experiments involved four frequency-hopped signals in a laboratory environment. A two-second interval was collected involving 2000 frequency hopping dwells. Results for a single manifold were found to experience misassociation errors, even at high SNR, due to similarities between polarization-frequency responses associated with the sources. When all manifolds are exploited, perfect association is achieved over the interval. Similar trends occur at low SNR, where increasing the number of available manifolds improves misassociation rates. It is concluded that additional diversities provided by a space-polarization architecture improve association performance.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 55 (6) , 3316-3329
Frequency-Hopped Signal Source Identification in Frequency-Selective Channels
Blind source separation of frequency-hopped signals is a challenging problem for cases involving multipath exhibiting temporal and angular spread. A novel solution is proposed that exploits polarization-frequency correlation to separate signals, enabling association of hopped signal in these adverse conditions. Performance depends upon signal-to-noise ratios and channelinduced signal feature differences. The method has the advantage of not requiring model order estimation of multipath. The efficacy of the approach is demonstrated in experiments and numerical analyses
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Aerospace and Electronic Systems
- Vol. 55 (6) , 3316-3329
Frequency-Hopped Signal Source Identification in Frequency-Selective Channels
Blind source separation of frequency-hopped signals is a challenging problem for cases involving multipath exhibiting temporal and angular spread. A novel solution is proposed that exploits polarization-frequency correlation to separate signals, enabling association of hopped signal in these adverse conditions. Performance depends upon signal-to-noise ratios and channelinduced signal feature differences. The method has the advantage of not requiring model order estimation of multipath. The efficacy of the approach is demonstrated in experiments and numerical analyses