Andrea Spinelli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Andrea Spinelli has a total of 58 co-authors. Here are the top co-authors by number of shared publications:
- Alberto Guardone
Politecnico di Milano
10 shared publications - Marta Zocca
Department of Aerospace Science and Technology, Politecnico di Milano, Milan, Italy
9 shared publications Fabio Cozzi
Energy Department, Politecnico di Milano, Milano, Italy
7 shared publicationsAlberto Guardone
Department of Aerospace Science and Technology, Politecnico di Milano, Milano, Italy
6 shared publications- Giacomo Persico
Department of Energy, Politecnico di Milano, Via Lambruschini 4, Milano, 20156, Italy
6 shared publications - Vincenzo Dossena
Politecnico di Milano Department of Energy via Lambruschini, 4A 20156, Milano, Italy
6 shared publications
Latest Publications
- 15 October 2025
- Published by Springer Nature
- p. 215-226
Design of Experiments to Observe Liquid-to-Vapor Expansions Exploiting Molecularly Complex Organic Fluids
- 15 October 2025
- Published by Springer Nature
- p. 215-226
Design of Experiments to Observe Liquid-to-Vapor Expansions Exploiting Molecularly Complex Organic Fluids
- Open Access
- 22 May 2025
- Published by Global Power and Propulsion Society in Journal of the Global Power and Propulsion Society
- Vol. 9 (May) , 4-16
Experiments on supersonic ORC nozzles in linear cascade configuration
In organic Rankine cycle (ORC) power plants, the turbo-expander represents a critical component due to the major impact of its efficiency on system layout and overall plant performance and profitability. Also, its design is complicated by large expansion ratios, by the demand of operational flexibility and by the thermo-physical characteristics of the working fluid and non-ideal gas effects. This typically leads to turbines with low number of stages and transonic/supersonic flow regimes. The ORC turbine design relies on advanced aerodynamic models and high-fidelity tools based on computational fluid dynamics (CFD). The verification of high-fidelity tools is grounded in accurate fluid thermodynamic models and experimental data concerning canonical flows, since experiments on non-ideal flows within ORC turbine cascades are still missing in the literature. To fill this gap, a novel experiment has been designed at Politecnico di Milano involving an ORC supersonic linear cascade, aimed at characterizing the flow field within the bladed and semi-bladed portion of the channels, at the trailing edge where shock/fan systems arise, and downstream the cascade, by retrieving the pitch-wise total pressure loss distribution. This paper reports the outcomes of an experimental campaign focused on the expansion of hexamethyldisiloxane (MM) within the cascade. Initial commissioning tests were performed using nitrogen at different pressure levels. Finally, the experimental data gathered during a campaign carried out with MM in non-ideal conditions are presented and compared with CFD simulations results, allowing to assess non-ideal gas effects on the trailing edge shock pattern and pressure distribution through the cascade.
- 22 May 2025
- Published by Global Power and Propulsion Society in Journal of the Global Power and Propulsion Society
- Vol. 9 (May) , 4-16
Open AccessExperiments on supersonic ORC nozzles in linear cascade configuration
In organic Rankine cycle (ORC) power plants, the turbo-expander represents a critical component due to the major impact of its efficiency on system layout and overall plant performance and profitability. Also, its design is complicated by large expansion ratios, by the demand of operational flexibility and by the thermo-physical characteristics of the working fluid and non-ideal gas effects. This typically leads to turbines with low number of stages and transonic/supersonic flow regimes. The ORC turbine design relies on advanced aerodynamic models and high-fidelity tools based on computational fluid dynamics (CFD). The verification of high-fidelity tools is grounded in accurate fluid thermodynamic models and experimental data concerning canonical flows, since experiments on non-ideal flows within ORC turbine cascades are still missing in the literature. To fill this gap, a novel experiment has been designed at Politecnico di Milano involving an ORC supersonic linear cascade, aimed at characterizing the flow field within the bladed and semi-bladed portion of the channels, at the trailing edge where shock/fan systems arise, and downstream the cascade, by retrieving the pitch-wise total pressure loss distribution. This paper reports the outcomes of an experimental campaign focused on the expansion of hexamethyldisiloxane (MM) within the cascade. Initial commissioning tests were performed using nitrogen at different pressure levels. Finally, the experimental data gathered during a campaign carried out with MM in non-ideal conditions are presented and compared with CFD simulations results, allowing to assess non-ideal gas effects on the trailing edge shock pattern and pressure distribution through the cascade.
- 28 August 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 257
Feasibility of solar-driven trilateral-like organic Rankine cycle with radial-inflow turboexpander
- 28 August 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 257
Feasibility of solar-driven trilateral-like organic Rankine cycle with radial-inflow turboexpander
- 2 May 2023
- Published by Springer Nature
- p. 217-228
Loss Measurement Strategy in ORC Supersonic Blade Cascades
- 2 May 2023
- Published by Springer Nature
- p. 217-228
Loss Measurement Strategy in ORC Supersonic Blade Cascades
- Open Access
- 13 January 2023
- Published by Elsevier in Applied Thermal Engineering
- Vol. 224
Design and commissioning of experiments for supersonic ORC nozzles in linear cascade configuration
- 13 January 2023
- Published by Elsevier in Applied Thermal Engineering
- Vol. 224
Open AccessDesign and commissioning of experiments for supersonic ORC nozzles in linear cascade configuration
- Open Access
- 11 July 2022
- Published by Springer Nature in Experiments in Fluids
- Vol. 63 (7) , 1-11
Shock loss measurements in non-ideal supersonic flows of organic vapors
This paper presents the first ever direct measurements of total pressure losses across shocks in supersonic flows of organic vapors in non-ideal conditions, so in the thermodynamic region close to the liquid–vapor saturation curve and the critical point where the ideal gas law is not applicable. Experiments were carried out with fluid siloxane MM (hexamethyldisiloxane, C $$_6$$ H $$_{18}$$ OSi $$_2$$ ), commonly employed in medium-/high-temperature organic Rankine cycles (ORCs), in the Test Rig for Organic VApors (TROVA), a blowdown wind tunnel at the Laboratory of Compressible fluid dynamics for Renewable Energy Applications (CREA lab) of Politecnico di Milano. A total pressure probe was inserted in superheated MM vapor flow at Mach number $$\sim 1.5$$ with total conditions in the range $$215-230~^\circ \hbox {C}$$ and $$2-12~\hbox {bar}$$ at varying levels of non-ideality, with a compressibility factor evaluated at total conditions between $$Z_\text {T}=0.68-0.98$$ . These operating conditions are representative of the first-stage stator of ORC turbines. Measured shock losses were compared with those calculated from pre-shock quantities by solving conservation equations across a normal shock, with differences always below $$2 \%$$ attesting a satisfactory reliability of the implemented experimental procedure. An in-depth analysis was then carried out, highlighting the direct effects of non-ideality on shock intensity. Even at the mildly non-ideal conditions with $$Z_\text {T}\gtrsim 0.70$$ considered here, non-ideality was responsible for a significantly stronger shock compared to the ideal gas limit at same pre-shock Mach number, with differences as large as $$6\%$$ . Graphical abstract- 11 July 2022
- Published by Springer Nature in Experiments in Fluids
- Vol. 63 (7) , 1-11
Open AccessShock loss measurements in non-ideal supersonic flows of organic vapors
This paper presents the first ever direct measurements of total pressure losses across shocks in supersonic flows of organic vapors in non-ideal conditions, so in the thermodynamic region close to the liquid–vapor saturation curve and the critical point where the ideal gas law is not applicable. Experiments were carried out with fluid siloxane MM (hexamethyldisiloxane, C $$_6$$ H $$_{18}$$ OSi $$_2$$ ), commonly employed in medium-/high-temperature organic Rankine cycles (ORCs), in the Test Rig for Organic VApors (TROVA), a blowdown wind tunnel at the Laboratory of Compressible fluid dynamics for Renewable Energy Applications (CREA lab) of Politecnico di Milano. A total pressure probe was inserted in superheated MM vapor flow at Mach number $$\sim 1.5$$ with total conditions in the range $$215-230~^\circ \hbox {C}$$ and $$2-12~\hbox {bar}$$ at varying levels of non-ideality, with a compressibility factor evaluated at total conditions between $$Z_\text {T}=0.68-0.98$$ . These operating conditions are representative of the first-stage stator of ORC turbines. Measured shock losses were compared with those calculated from pre-shock quantities by solving conservation equations across a normal shock, with differences always below $$2 \%$$ attesting a satisfactory reliability of the implemented experimental procedure. An in-depth analysis was then carried out, highlighting the direct effects of non-ideality on shock intensity. Even at the mildly non-ideal conditions with $$Z_\text {T}\gtrsim 0.70$$ considered here, non-ideality was responsible for a significantly stronger shock compared to the ideal gas limit at same pre-shock Mach number, with differences as large as $$6\%$$ . Graphical abstract - 8 February 2022
- Published by Elsevier in Measurement
- Vol. 192
Pneumatic system for pressure probe measurements in transient flows of non-ideal vapors subject to line condensation
- 8 February 2022
- Published by Elsevier in Measurement
- Vol. 192
Pneumatic system for pressure probe measurements in transient flows of non-ideal vapors subject to line condensation
- Open Access
- 10 September 2021
- Published by Springer Nature in Experiments in Fluids
- Vol. 62 (10) , 1-18
Direct velocity measurements in high-temperature non-ideal vapor flows
Direct velocity measurements in a non-ideal expanding flow of a high temperature organic vapor were performed for the first time using the laser Doppler velocimetry technique. To this purpose, a novel seeding system for insemination of high-temperature vapors was specifically conceived, designed, and implemented. Comparisons with indirectly measured velocity, namely inferred from pressure and temperature measurements, are also provided. Nozzle flows of hexamethyldisiloxane (MM, C $$_6$$ H $$_{18}$$ OSi $$_2$$ ) at temperature up to $$220\,^\circ \mathrm {C}$$ and pressure up to 10 bar were taken as representative of non-ideal compressible-fluid flows. The relative high temperature, high pressure and the need of avoiding contamination pose strong constraints on the choice of both seeding system design and tracer particle, which is solid. A liquid suspension of tracer particles in hexamethyldisiloxane is injected through an atomizing nozzle in a high-temperature settling chamber ahead of the test section. The spray droplets evaporate, while the particles are entrained in the flow to be traced. Three different test cases are presented: a subsonic compressible nozzle flow with a large uniform region at Mach number 0.7, a high velocity gradient supersonic flow at Mach number 1.4 and a near-zero velocity gradient flow at Mach number 1.7. Temperature, pressure and direct velocity measurements are performed to characterize the flow. Measured velocity is compared with both computational fluid dynamics (CFD) calculations and velocity computed from pressure and temperature measurements. In both cases, the thermodynamic model applied was a state-of-the-art Helmoltz energy equation of state. A maximum velocity deviation of 6.6% was found for both CFD simulations and computed velocity. Graphical abstract- 10 September 2021
- Published by Springer Nature in Experiments in Fluids
- Vol. 62 (10) , 1-18
Open AccessDirect velocity measurements in high-temperature non-ideal vapor flows
Direct velocity measurements in a non-ideal expanding flow of a high temperature organic vapor were performed for the first time using the laser Doppler velocimetry technique. To this purpose, a novel seeding system for insemination of high-temperature vapors was specifically conceived, designed, and implemented. Comparisons with indirectly measured velocity, namely inferred from pressure and temperature measurements, are also provided. Nozzle flows of hexamethyldisiloxane (MM, C $$_6$$ H $$_{18}$$ OSi $$_2$$ ) at temperature up to $$220\,^\circ \mathrm {C}$$ and pressure up to 10 bar were taken as representative of non-ideal compressible-fluid flows. The relative high temperature, high pressure and the need of avoiding contamination pose strong constraints on the choice of both seeding system design and tracer particle, which is solid. A liquid suspension of tracer particles in hexamethyldisiloxane is injected through an atomizing nozzle in a high-temperature settling chamber ahead of the test section. The spray droplets evaporate, while the particles are entrained in the flow to be traced. Three different test cases are presented: a subsonic compressible nozzle flow with a large uniform region at Mach number 0.7, a high velocity gradient supersonic flow at Mach number 1.4 and a near-zero velocity gradient flow at Mach number 1.7. Temperature, pressure and direct velocity measurements are performed to characterize the flow. Measured velocity is compared with both computational fluid dynamics (CFD) calculations and velocity computed from pressure and temperature measurements. In both cases, the thermodynamic model applied was a state-of-the-art Helmoltz energy equation of state. A maximum velocity deviation of 6.6% was found for both CFD simulations and computed velocity. Graphical abstract - 1 January 2020
- Published by Elsevier in European Journal of Mechanics - B/Fluids
- Vol. 79, 109-120
Accuracy assessment of the Non-Ideal Computational Fluid Dynamics model for siloxane MDM from the open-source SU2 suite
- 1 January 2020
- Published by Elsevier in European Journal of Mechanics - B/Fluids
- Vol. 79, 109-120
Accuracy assessment of the Non-Ideal Computational Fluid Dynamics model for siloxane MDM from the open-source SU2 suite