F. M. Tera
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
F. M. Tera has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Ali Hebeish
National Research Centre, Textile Research Division, Dokki, Cairo, Egypt
4 shared publications M.N. Michael
National Institute for Standards, Dokki, Cairo, Egypt
3 shared publicationsS. H. Samaha
Textile Department , National Institute for Standards , El-Haram , Giza , Egypt
3 shared publications- Dalia M. Essa
Textile Metrology Department, National Institute for Standards, Tersa Street, Giza, Egypt
2 shared publications - L. A. W. Abdou
Textile Research Division, National Research Centre, Dokki, Box 12622, Cairo, Egypt
2 shared publications M. N. Micheal
National Institute for Standards, El Harem, Egypt
2 shared publications
Latest Publications
- 1 January 2005
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 43 (5) , 1377-1386
Degradation Measurements of Linen Fabrics
- 1 January 2005
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 43 (5) , 1377-1386
Degradation Measurements of Linen Fabrics
- 10 January 2004
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 43 (4) , 1213-1227
Acrylonitrile Grafting onto Nylon-6 Fabric. II. Thermal, Mechanical, and Dyeing Characterization
Thermal analysis, mechanical behavior, and dyeing performance of nylon–graft-polyacrylonitrile (nylon–g-PAN) copolymers having different graft yields have been studied. The results of the thermogravimetric analysis (TGA) revealed that the weight loss decreased from 88.11% for ungrafted sample to 69.26 and 58.93% for nylon–g-PAN samples having 31.6 and 58.4% graft yields, respectively. Differential scanning calorimetry (DSC) of all grafted samples shows exothermic peak at 270°C. This peak is absolutely absent for the ungrafted sample. The air permeability values were decreased via grafting. The water permeability and bursting strength values decreased from 12.7 (mbar) and 1331 kiloPascal for ungrafted fabric to 9.75 (mbar) and 921 kiloPascal, respectively, for nylon having 8.4% graft yield. By increasing the graft yield, the water permeability and bursting strength values were gradually increased up to 11.3 (mBar) and 1168 kiloPascal for nylon having 20% graft yield. The dyeing performance of the disperse dye was evaluated.
- 10 January 2004
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 43 (4) , 1213-1227
Acrylonitrile Grafting onto Nylon-6 Fabric. II. Thermal, Mechanical, and Dyeing Characterization
Thermal analysis, mechanical behavior, and dyeing performance of nylon–graft-polyacrylonitrile (nylon–g-PAN) copolymers having different graft yields have been studied. The results of the thermogravimetric analysis (TGA) revealed that the weight loss decreased from 88.11% for ungrafted sample to 69.26 and 58.93% for nylon–g-PAN samples having 31.6 and 58.4% graft yields, respectively. Differential scanning calorimetry (DSC) of all grafted samples shows exothermic peak at 270°C. This peak is absolutely absent for the ungrafted sample. The air permeability values were decreased via grafting. The water permeability and bursting strength values decreased from 12.7 (mbar) and 1331 kiloPascal for ungrafted fabric to 9.75 (mbar) and 921 kiloPascal, respectively, for nylon having 8.4% graft yield. By increasing the graft yield, the water permeability and bursting strength values were gradually increased up to 11.3 (mBar) and 1168 kiloPascal for nylon having 20% graft yield. The dyeing performance of the disperse dye was evaluated.
- 4 January 2004
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 43 (2) , 503-517
Acrylonitrile Grafting onto Nylon-6 Fabric. I. Synthesis and Characterization
Graft copolymerization of acrylonitrile (AN) monomer into nylon fabrics without homopolymer formation in the raction medium was carried out to avoid the environmental problems and minimize the product cost. This was enabled by creation of free radicals built-in insitue on both surfaces and intermicelles of nylon fabric. The creation of these free radicals was generated by using potassium persulfate (KPS) as a main oxidizing agent in conjunction with sodium bisulfite (SBS) or benzaldehyde sodium bisulfite adduct (BSBS) as reducing agents. In addition to the redox initiation type and concentration, the graft yield (GY), homopolymer (HP), and total conversion percents were also studied in relation to the reaction time and temperature as well as liquor ratio and monomer concentration. At AN concentration of 0.754 mol/L, grafted nylon fabrics having GY of 12.5% and 14.9% were obtained without any HP formation using 1.0/2.0 × 10−2 mol/L for each of KPS/SBS and KPS/BSBS, respectively. Increasing the monomer concentration up to 1.886 mol/L outstandingly increases the GY to 31.7% and 35.6%, also without HP formation, using 0.3/0.6 × 10−2 mol/L for each KPS/SBS and KPS/BSBS, respectively. The grafted nylon fabrics were characterized by infrared (IR) spectra and thickness measurement.
- 4 January 2004
- Published by Taylor & Francis in Polymer-Plastics Technology and Engineering
- Vol. 43 (2) , 503-517
Acrylonitrile Grafting onto Nylon-6 Fabric. I. Synthesis and Characterization
Graft copolymerization of acrylonitrile (AN) monomer into nylon fabrics without homopolymer formation in the raction medium was carried out to avoid the environmental problems and minimize the product cost. This was enabled by creation of free radicals built-in insitue on both surfaces and intermicelles of nylon fabric. The creation of these free radicals was generated by using potassium persulfate (KPS) as a main oxidizing agent in conjunction with sodium bisulfite (SBS) or benzaldehyde sodium bisulfite adduct (BSBS) as reducing agents. In addition to the redox initiation type and concentration, the graft yield (GY), homopolymer (HP), and total conversion percents were also studied in relation to the reaction time and temperature as well as liquor ratio and monomer concentration. At AN concentration of 0.754 mol/L, grafted nylon fabrics having GY of 12.5% and 14.9% were obtained without any HP formation using 1.0/2.0 × 10−2 mol/L for each of KPS/SBS and KPS/BSBS, respectively. Increasing the monomer concentration up to 1.886 mol/L outstandingly increases the GY to 31.7% and 35.6%, also without HP formation, using 0.3/0.6 × 10−2 mol/L for each KPS/SBS and KPS/BSBS, respectively. The grafted nylon fabrics were characterized by infrared (IR) spectra and thickness measurement.
- 10 June 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 85 (9) , 1897-1903
Effect of chemical modification of cotton fabrics on dyeing properties
- 10 June 2002
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 85 (9) , 1897-1903
Effect of chemical modification of cotton fabrics on dyeing properties
- 3 May 1993
- Published by Elsevier in Thermochimica Acta
- Vol. 218, 229-245
Aesthetic parameters of highly feldspathic porcelain
- 3 May 1993
- Published by Elsevier in Thermochimica Acta
- Vol. 218, 229-245
Aesthetic parameters of highly feldspathic porcelain
- 1 January 1991
- Published by Wiley in Starch - Stärke
- Vol. 43 (6) , 235-238
Synthesis of Diethylaminoethyl-Starch (DEAE-Starch). Part I
- 1 January 1991
- Published by Wiley in Starch - Stärke
- Vol. 43 (6) , 235-238
Synthesis of Diethylaminoethyl-Starch (DEAE-Starch). Part I
- 31 December 1989
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 23 (3) , 209-216
Possible control of the mechanical properties of nylon-6, dralon and polyester polymers by neutron irradiation
- 31 December 1989
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 23 (3) , 209-216
Possible control of the mechanical properties of nylon-6, dralon and polyester polymers by neutron irradiation
- 31 December 1987
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 17 (1) , 13-19
Spectrophotometric study of the photo-degradation of disperse dyes on cellulose diacetate and polyamide films
- 31 December 1987
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 17 (1) , 13-19
Spectrophotometric study of the photo-degradation of disperse dyes on cellulose diacetate and polyamide films
- 31 December 1987
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 19 (4) , 343-351
Neutron irradiation effects on the structure of nylon 6, polyester and dralon fibers
- 31 December 1987
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 19 (4) , 343-351
Neutron irradiation effects on the structure of nylon 6, polyester and dralon fibers
- 31 December 1986
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 16 (2) , 163-167
Study of the spectrum fading curves of disperse dye on cellulose diacetate and polyamide films
- 31 December 1986
- Published by Elsevier in Polymer Degradation and Stability
- Vol. 16 (2) , 163-167
Study of the spectrum fading curves of disperse dye on cellulose diacetate and polyamide films