Carlos Ariño
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Carlos Ariño has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Antonio Sala
Instituto de Automática e Informática Industrial Universitat Politècnica de València Valencia Spain
31 shared publications - Emilio Pérez
Universitat Jaume I
10 shared publications - Jose Luis Pitarch
Universidad de Valladolid
7 shared publications - Andres Querol
Univ Jaume I Castellon, Syst Engn & Design Dept ESID, Castellon De La Plana, Spain
4 shared publications Antonio Sala
Dept. Ing. Sistemas y Automética. Universitat Politecnica de Valencia. Cno Vera s/n, E-46022 Valencia, Spain
3 shared publicationsF. Bedate
3 shared publications
Latest Publications
- Open Access
- 23 August 2023
- Published by Elsevier in Fuzzy Sets and Systems
- Vol. 472
Fuzzy discretization and control for non-linear, multiple binary input systems
- 23 August 2023
- Published by Elsevier in Fuzzy Sets and Systems
- Vol. 472
Open AccessFuzzy discretization and control for non-linear, multiple binary input systems
- 20 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control of Network Systems
- Vol. 8 (4) , 1592-1600
Optimal Sampling Pattern for the Free Final Time Linear Quadratic Regulator
The optimal sampling problem is the selection of the optimal sampling instants together with the optimal control actions such that a given cost function is minimized. In this article, we solve the optimal sampling problem for the free final time linear quadratic regulator. Each optimal sampling instant is computed as the minimization of a maximum eigenvalue problem that is formulated at each stage by previously applying dynamic programming. The solution provides the optimal sampling instants, control actions, and the optimal final time in a recursive and constructive way. Furthermore, the solution is optimal for any arbitrary number of control moves $N \geq 1$ , as it is not based on asymptotic arguments. Two application examples show the feasibility of the approach.- 20 April 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Control of Network Systems
- Vol. 8 (4) , 1592-1600
Optimal Sampling Pattern for the Free Final Time Linear Quadratic Regulator
The optimal sampling problem is the selection of the optimal sampling instants together with the optimal control actions such that a given cost function is minimized. In this article, we solve the optimal sampling problem for the free final time linear quadratic regulator. Each optimal sampling instant is computed as the minimization of a maximum eigenvalue problem that is formulated at each stage by previously applying dynamic programming. The solution provides the optimal sampling instants, control actions, and the optimal final time in a recursive and constructive way. Furthermore, the solution is optimal for any arbitrary number of control moves $N \geq 1$ , as it is not based on asymptotic arguments. Two application examples show the feasibility of the approach.- 28 September 2020
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 31 (17) , 8124-8146
Set‐based gain‐scheduled control via quasi‐convex difference inclusions
- 28 September 2020
- Published by Wiley in International Journal of Robust and Nonlinear Control
- Vol. 31 (17) , 8124-8146
Set‐based gain‐scheduled control via quasi‐convex difference inclusions
- 1 October 2017
- Published by Elsevier in Engineering Applications of Artificial Intelligence
- Vol. 65, 493-505
Shape-independent model predictive control for Takagi–Sugeno fuzzy systems
- 1 October 2017
- Published by Elsevier in Engineering Applications of Artificial Intelligence
- Vol. 65, 493-505
Shape-independent model predictive control for Takagi–Sugeno fuzzy systems
- Open Access
- 1 January 2015
- Published by Universitat Politecnica de Valencia in Revista Iberoamericana de Automática e Informática Industrial
- Vol. 12 (1) , 13-24
Control de un compensador activo selectivo mediante un algoritmo de optimización sujeto a restricciones cuadráticas
ResumenEl objetivo fundamental de este artículo es proponer un algoritmo de optimización basado en desigualdades matriciales lineales (LMIs) para la compensación selectiva del desequilibrio, el desfase y la distorsión armónica de las corrientes de carga de un sistema trifásico a cuatro hilos. Mediante el IEEE Std.1459 se determinan los términos de potencia que cuantifican cada uno de los fenómenos no eficientes a compensar (desequilibrio, desfase y distorsión) y, a continuación, se define la programación cuadrática sujeta a restricciones cuadráticas y la forma de resolver la optimización mediante LMIs. El algoritmo utiliza unos coeficientes de ponderación asociados a cada uno de los términos no eficientes para darles más o menos importancia relativa en función del criterio elegido en cada momento. Por otro lado, se realiza el diseño del condensador de corriente continua y los reguladores para el control de la tensión de dicho condensador. Así mismo, se diseñan tres tipos diferentes de reguladores para el control de corriente del SAPC y se analizan las prestaciones de cada uno de ellos. Finalmente se simulan diferentes casos de compensación selectiva, se analizan los resultados obtenidos y se exponen las conclusiones.AbstractThe main goal of this work is the proposal of an optimization algorithm based on linear matrix inequalities (LMI) used to selectively compensate the unbalance, the harmonic distortion, and the phase shift introduced by the load currents in a three phase four-wire system. The use of the IEEE Std.1459 allows determining each of the power terms associated to these non-efficient phenomena. Once these power terms are defined, a quadratically constrained quadratic program is set and solved by LMIs. The algorithm uses three weighting coefficients associated to each non-efficient term in order to assign them a relative importance depending on a user determined criterion. Moreover, the paper presents the design of the DC bus capacitor as well as the regulators used to control its voltage. Furthermore, three different regulators are introduced and designed to control the SAPC currents. A comparison among them is also introduced. Finally, simulation results for different selective compensation cases are presented, analyzed and various conclusions are extracted
- 1 January 2015
- Published by Universitat Politecnica de Valencia in Revista Iberoamericana de Automática e Informática Industrial
- Vol. 12 (1) , 13-24
Open AccessControl de un compensador activo selectivo mediante un algoritmo de optimización sujeto a restricciones cuadráticas
ResumenEl objetivo fundamental de este artículo es proponer un algoritmo de optimización basado en desigualdades matriciales lineales (LMIs) para la compensación selectiva del desequilibrio, el desfase y la distorsión armónica de las corrientes de carga de un sistema trifásico a cuatro hilos. Mediante el IEEE Std.1459 se determinan los términos de potencia que cuantifican cada uno de los fenómenos no eficientes a compensar (desequilibrio, desfase y distorsión) y, a continuación, se define la programación cuadrática sujeta a restricciones cuadráticas y la forma de resolver la optimización mediante LMIs. El algoritmo utiliza unos coeficientes de ponderación asociados a cada uno de los términos no eficientes para darles más o menos importancia relativa en función del criterio elegido en cada momento. Por otro lado, se realiza el diseño del condensador de corriente continua y los reguladores para el control de la tensión de dicho condensador. Así mismo, se diseñan tres tipos diferentes de reguladores para el control de corriente del SAPC y se analizan las prestaciones de cada uno de ellos. Finalmente se simulan diferentes casos de compensación selectiva, se analizan los resultados obtenidos y se exponen las conclusiones.AbstractThe main goal of this work is the proposal of an optimization algorithm based on linear matrix inequalities (LMI) used to selectively compensate the unbalance, the harmonic distortion, and the phase shift introduced by the load currents in a three phase four-wire system. The use of the IEEE Std.1459 allows determining each of the power terms associated to these non-efficient phenomena. Once these power terms are defined, a quadratically constrained quadratic program is set and solved by LMIs. The algorithm uses three weighting coefficients associated to each non-efficient term in order to assign them a relative importance depending on a user determined criterion. Moreover, the paper presents the design of the DC bus capacitor as well as the regulators used to control its voltage. Furthermore, three different regulators are introduced and designed to control the SAPC currents. A comparison among them is also introduced. Finally, simulation results for different selective compensation cases are presented, analyzed and various conclusions are extracted
- 9 December 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 62 (02780046) , 1
Optimization Algorithm for Selective Compensation in a Shunt Active Power Filter
This paper proposes an optimization algorithm based on linear matrix inequalities (LMIs) to be implemented in a shunt active power filter (SAPF) enabling it to perform a selective compensation of nonefficient powers when the rated power of the SAPF is limited. The system uses the IEEE Standard 1459 to identify the different power terms (active, reactive, unbalance, and harmonics) demanded by local loads in a three-phase four-wire system. Then, the algorithm solves a quadratically constrained quadratic program by means of an LMI formulation and calculates the optimal reference currents that allow the SAPF to cancel a selection of the previously identified nonefficient power terms. For this selection, the algorithm presents different weighting coefficients in the cost index to be optimized. These coefficients assign a relative importance to each different nonefficient power term, giving priority to some over the others. Moreover, the optimization performed in this work to calculate the reference currents considers that the SAPF presents a power limitation. Finally, the reference currents' tracking has been implemented using a proportional feedforward controller which assures a constant commutation frequency of the SAPF. Experimental results demonstrate the validity of the proposal.
- 9 December 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 62 (02780046) , 1
Optimization Algorithm for Selective Compensation in a Shunt Active Power Filter
This paper proposes an optimization algorithm based on linear matrix inequalities (LMIs) to be implemented in a shunt active power filter (SAPF) enabling it to perform a selective compensation of nonefficient powers when the rated power of the SAPF is limited. The system uses the IEEE Standard 1459 to identify the different power terms (active, reactive, unbalance, and harmonics) demanded by local loads in a three-phase four-wire system. Then, the algorithm solves a quadratically constrained quadratic program by means of an LMI formulation and calculates the optimal reference currents that allow the SAPF to cancel a selection of the previously identified nonefficient power terms. For this selection, the algorithm presents different weighting coefficients in the cost index to be optimized. These coefficients assign a relative importance to each different nonefficient power term, giving priority to some over the others. Moreover, the optimization performed in this work to calculate the reference currents considers that the SAPF presents a power limitation. Finally, the reference currents' tracking has been implemented using a proportional feedforward controller which assures a constant commutation frequency of the SAPF. Experimental results demonstrate the validity of the proposal.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1831-1836
Reliable fault-tolerant predictive control for Markov-jump Linear Systems
This work considers fault-tolerant model-predictive control for discrete-time Markov Jump Linear Systems subject to constraints on state and control variables. Hitting state constraints is a situation which should be avoided, but it is impossible to do that with total certainty when not all possible models are stable, except in trivial initial states (e.g., the origin). Hence, this work discusses how to ensure a certain degree of reliability (low likelihood of hitting constraints) in the above unstable-mode case if there exists a terminal controller which, on average, renders the system stochastically stable.
- 1 October 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1831-1836
Reliable fault-tolerant predictive control for Markov-jump Linear Systems
This work considers fault-tolerant model-predictive control for discrete-time Markov Jump Linear Systems subject to constraints on state and control variables. Hitting state constraints is a situation which should be avoided, but it is impossible to do that with total certainty when not all possible models are stable, except in trivial initial states (e.g., the origin). Hence, this work discusses how to ensure a certain degree of reliability (low likelihood of hitting constraints) in the above unstable-mode case if there exists a terminal controller which, on average, renders the system stochastically stable.
- 15 August 2014
- Published by Atlantis Press SARL
- p. 95-115
Polynomial Fuzzy Systems: Stability and Control
- 15 August 2014
- Published by Atlantis Press SARL
- p. 95-115
Polynomial Fuzzy Systems: Stability and Control
- 1 July 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10987584,p. 2288-2293
Model Predictive Control for discrete fuzzy systems via iterative quadratic programming
Takagi-Sugeno fuzzy models are exact representations of nonlinear systems in a compact region. Guaranteed-cost linear matrix inequalities produce controllers which minimize a shape-independent bound on a quadratic cost; however, the controller has a fixed structure (possibly suboptimal), say a Parallel Distributed Compensator (PDC), and does not allow input saturation. By posing the problem as a Model Predictive Control one, the ideas of terminal set, terminal controller and feasible set can be used in order to improve the performance of usual guaranteed-cost controllers for Takagi-Sugeno systems via Quadratic Programming. A Polya-based approach has been introduced in order to (conservatively) transform the invariant set problem into a polytopic one, as well as computing the controller feasibility region. The optimal controller is computed iteratively.
- 1 July 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 10987584,p. 2288-2293
Model Predictive Control for discrete fuzzy systems via iterative quadratic programming
Takagi-Sugeno fuzzy models are exact representations of nonlinear systems in a compact region. Guaranteed-cost linear matrix inequalities produce controllers which minimize a shape-independent bound on a quadratic cost; however, the controller has a fixed structure (possibly suboptimal), say a Parallel Distributed Compensator (PDC), and does not allow input saturation. By posing the problem as a Model Predictive Control one, the ideas of terminal set, terminal controller and feasible set can be used in order to improve the performance of usual guaranteed-cost controllers for Takagi-Sugeno systems via Quadratic Programming. A Polya-based approach has been introduced in order to (conservatively) transform the invariant set problem into a polytopic one, as well as computing the controller feasibility region. The optimal controller is computed iteratively.
- 1 July 2014
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 351 (7) , 3559-3576
Polytopic invariant and contractive sets for closed-loop discrete fuzzy systems
- 1 July 2014
- Published by Elsevier in Journal of the Franklin Institute
- Vol. 351 (7) , 3559-3576
Polytopic invariant and contractive sets for closed-loop discrete fuzzy systems