Peter De Schryver
Peter De Schryver has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
- Nico Boon
Center for Microbial Ecology and Technology, Faculty of Bioscience Engineering, Ghent University
2 shared publications - Peter Bossier
Laboratory of Aquaculture & Artemia Reference Center (ARC), Ghent University, Rozier 44, B-9000 Gent, Belgium
2 shared publications W Verstraete
2 shared publicationsB De Gusseme
1 shared publication- Barbara Hostins
INVE Technologies, Dendermonde, Belgium
1 shared publication - Bart De Gusseme
Center for Microbial Ecology and Technology (CMET), Department of Biotechnology, Ghent University, Ghent, Belgium
1 shared publication
Latest Publications
- Open Access
Molybdate application in the early stages of shrimp growth suppresses sulphide formation in a shrimp pond bottom model
Oxygen depletion and sulphide formation, resulting from the accumulation of organic waste, are common challenges in shrimp ponds that could result in complete harvest failure. The stage at which these circumstances occur during the shrimp growth period remains elusive, yet, knowledge of the timing of oxygen depletion and sulphide formation is essential to enable remediating actions. Here, we used an experimental shrimp pond model at different stages in the shrimp growth period to determine when oxygen depletion and sulphide production occur. Microscale depth measurements of oxygen and H 2 S were determined using microelectrodes to visualize their profiles at different depths of the water-sediment interface and the sediment. We evaluated the potential of different molybdate concentrations at different stages to determine the optimal conditions to suppress H 2 S formation. Oxygen depletion and sulphide production took place in the middle of the shrimp growth cycle in the simulated model of waste accumulation. The addition of molybdate was only effective in the early stages of the onset of oxygen depletion and H 2 S formation, and residual molybdate was required to ensure a continuous suppression of sulphide production. However, oxygen depletion could not be prevented and reintroduction of oxygen did not occur when molybdate was added. In conclusion, molybdate appeared to be an effective strategy to suppress H 2 S formation at the onset of its production in a shrimp pond bottom model.
Open AccessMolybdate application in the early stages of shrimp growth suppresses sulphide formation in a shrimp pond bottom model
Oxygen depletion and sulphide formation, resulting from the accumulation of organic waste, are common challenges in shrimp ponds that could result in complete harvest failure. The stage at which these circumstances occur during the shrimp growth period remains elusive, yet, knowledge of the timing of oxygen depletion and sulphide formation is essential to enable remediating actions. Here, we used an experimental shrimp pond model at different stages in the shrimp growth period to determine when oxygen depletion and sulphide production occur. Microscale depth measurements of oxygen and H 2 S were determined using microelectrodes to visualize their profiles at different depths of the water-sediment interface and the sediment. We evaluated the potential of different molybdate concentrations at different stages to determine the optimal conditions to suppress H 2 S formation. Oxygen depletion and sulphide production took place in the middle of the shrimp growth cycle in the simulated model of waste accumulation. The addition of molybdate was only effective in the early stages of the onset of oxygen depletion and H 2 S formation, and residual molybdate was required to ensure a continuous suppression of sulphide production. However, oxygen depletion could not be prevented and reintroduction of oxygen did not occur when molybdate was added. In conclusion, molybdate appeared to be an effective strategy to suppress H 2 S formation at the onset of its production in a shrimp pond bottom model.
- 1 January 2016
- Published by Elsevier in Veterinary Microbiology
- Vol. 182, 44-49
Effect of poly-β-hydroxybutyrate on growth and disease resistance of Nile tilapia Oreochromis niloticus juveniles
- 1 January 2016
- Published by Elsevier in Veterinary Microbiology
- Vol. 182, 44-49
Effect of poly-β-hydroxybutyrate on growth and disease resistance of Nile tilapia Oreochromis niloticus juveniles
- 1 January 2013
- Vol. 78 (4) , 324-7
Use of poly-beta-hydroxybutyrate in bivalve larviculture.
- 9 February 2011
- Published by Wiley in Water and Environment Journal
- Vol. 25 (1) , 106-115
Addition of an aerated iron‐rich waste‐activated sludge to control the soluble sulphide concentration in sewage
Hydrogen sulphide emission in sewers is associated with toxicity, corrosion and odour and also yields considerable costs. The purpose of this study was to evaluate whether the soluble sulphide concentration in raw sewage can be controlled by dosing an iron‐rich waste‐activated sludge (WAS) or an iron‐rich aerated waste‐activated sludge (AWAS). An average soluble sulphide elimination of 99% was achieved at an iron‐rich AWAS to sewage ratio (v/v) of 16%, whereas dosage of iron‐poor AWAS at the same ratio decreased the soluble sulphide in the raw sewage by only 53%. Our lab‐scale tests suggest that dosing iron‐rich AWAS to sewage did not affect the chemical oxygen demand (COD) and total ammonia nitrogen (TAN) removal as well as the nitrification efficiency in the receiving activated sludge system. The results indicate that iron‐rich AWAS dosage is a feasible technique to remediate the sulphide problem in sewers.
- 9 February 2011
- Published by Wiley in Water and Environment Journal
- Vol. 25 (1) , 106-115
Addition of an aerated iron‐rich waste‐activated sludge to control the soluble sulphide concentration in sewage
Hydrogen sulphide emission in sewers is associated with toxicity, corrosion and odour and also yields considerable costs. The purpose of this study was to evaluate whether the soluble sulphide concentration in raw sewage can be controlled by dosing an iron‐rich waste‐activated sludge (WAS) or an iron‐rich aerated waste‐activated sludge (AWAS). An average soluble sulphide elimination of 99% was achieved at an iron‐rich AWAS to sewage ratio (v/v) of 16%, whereas dosage of iron‐poor AWAS at the same ratio decreased the soluble sulphide in the raw sewage by only 53%. Our lab‐scale tests suggest that dosing iron‐rich AWAS to sewage did not affect the chemical oxygen demand (COD) and total ammonia nitrogen (TAN) removal as well as the nitrification efficiency in the receiving activated sludge system. The results indicate that iron‐rich AWAS dosage is a feasible technique to remediate the sulphide problem in sewers.
- 1 January 2009
- Vol. 59 (6) , 1248-54
Decreasing sulfide generation in sewage by dosing formaldehyde and its derivatives under anaerobic conditions.
Hydrogen sulfide emission in sewers is associated with toxicity, corrosion, odour nuisance and high costs. In this study, a new method to inhibit sulfide generation by means of formaldehyde and its derivatives has been evaluated under anaerobic conditions. The possible impact of formaldehyde on an activated sludge system and an appraisal of the economic aspects are presented as well. A dosage of 19 mg L(-1) formaldehyde resulted in a decrease of the sulfide production of 90%. Dosing of 32 mg L(-1) paraformaldehyde and addition of 111 mg L(-1) ureaformaldehyde were not sufficient to inhibit the sulfide generation in sewage to the same extent. The impacts of 19 mg L(-1) formaldehyde on activated sludge, in terms of COD removal, nitrification rate and oxygen uptake rates, were negligible. This suggests that formaldehyde dosage is a feasible technique to abate the sulfide problem in sewers.
- 1 January 2009
- Vol. 59 (6) , 1248-54
Decreasing sulfide generation in sewage by dosing formaldehyde and its derivatives under anaerobic conditions.
Hydrogen sulfide emission in sewers is associated with toxicity, corrosion, odour nuisance and high costs. In this study, a new method to inhibit sulfide generation by means of formaldehyde and its derivatives has been evaluated under anaerobic conditions. The possible impact of formaldehyde on an activated sludge system and an appraisal of the economic aspects are presented as well. A dosage of 19 mg L(-1) formaldehyde resulted in a decrease of the sulfide production of 90%. Dosing of 32 mg L(-1) paraformaldehyde and addition of 111 mg L(-1) ureaformaldehyde were not sufficient to inhibit the sulfide generation in sewage to the same extent. The impacts of 19 mg L(-1) formaldehyde on activated sludge, in terms of COD removal, nitrification rate and oxygen uptake rates, were negligible. This suggests that formaldehyde dosage is a feasible technique to abate the sulfide problem in sewers.
- 1 January 2008
- Vol. 73 (1) , 127-31
Sequential batch reactors as an alternative approach for bio-flocs technology in aquaculture: from waste to fish.
- 1 January 2008
- Vol. 73 (1) , 127-31
Sequential batch reactors as an alternative approach for bio-flocs technology in aquaculture: from waste to fish.