Jonathan Ehrler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Jonathan Ehrler has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
- Rantej Bali
Helmholtz-Zentrum Dresden-Rossendorf, Bautzner Landstraße 400, 01328 Dresden, Germany
5 shared publications - Juergen Fassbender
Helmholtz-Zentrum Dresden-Rossendorf
4 shared publications Jürgen Lindner
Ion Beam Physics and Materials Research, Helmholtz Zentrum Dresden Rossnedorf, Bautzner Landstr. 400, Dresden, Saxony, 01328, GERMANY
3 shared publicationsKay Potzger
Helmholtz-Zentrum Dresden-Rossendorf, Dresden, Sachsen, GERMANY
3 shared publications- Benedikt Eggert
Faculty of Physics and Center for Nanointegration Duisburg-Essen (CENIDE), University of Duisburg-Essen, 47057 Duisburg, Germany
2 shared publications - Florian Kronast
Helmholtz‐Zentrum Berlin für Materialien und Energie Berlin Germany
2 shared publications
Latest Publications
- Open Access
- 2 December 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (21) , 213906
Spin pumping at interfaces with ferro- and paramagnetic Fe60Al40 films acting as spin source and spin sink
We present a study of spin pumping efficiency and determine the spin mixing conductance and spin diffusion length in thin bilayer films based on 3d transition metal alloy Fe60Al40. Due to its magnetostructural phase transition, Fe60Al40 can be utilized as a ferromagnetic (FM) or paramagnetic (PM) material at the same temperature depending on its structural order; thus a thin Fe60Al40 film can act as a spin source or a spin sink when interfaced with a paramagnet or a ferromagnet, respectively. Ferromagnetic resonance measurements were performed in a frequency range of 5–35 GHz on bilayer films composed of FM–Fe60Al40/Pd and PM–Fe60Al40/Ni80Fe20 (permalloy). The increase in damping with the thickness of the paramagnetic layer was interpreted as a result of spin pumping into the paramagnet. We determine the spin mixing conductance at the FM–Fe60Al40/Pd interface and the spin diffusion length in Pd. For the PM–Fe60Al40/permalloy interface, we find a spin mixing conductance and a spin diffusion length for PM–Fe60Al40. The demonstrated bi-functionality of the Fe60Al40 alloy in spin pumping structures may be promising for spintronic applications.- 2 December 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (21) , 213906
Open AccessSpin pumping at interfaces with ferro- and paramagnetic Fe60Al40 films acting as spin source and spin sink
We present a study of spin pumping efficiency and determine the spin mixing conductance and spin diffusion length in thin bilayer films based on 3d transition metal alloy Fe60Al40. Due to its magnetostructural phase transition, Fe60Al40 can be utilized as a ferromagnetic (FM) or paramagnetic (PM) material at the same temperature depending on its structural order; thus a thin Fe60Al40 film can act as a spin source or a spin sink when interfaced with a paramagnet or a ferromagnet, respectively. Ferromagnetic resonance measurements were performed in a frequency range of 5–35 GHz on bilayer films composed of FM–Fe60Al40/Pd and PM–Fe60Al40/Ni80Fe20 (permalloy). The increase in damping with the thickness of the paramagnetic layer was interpreted as a result of spin pumping into the paramagnet. We determine the spin mixing conductance at the FM–Fe60Al40/Pd interface and the spin diffusion length in Pd. For the PM–Fe60Al40/permalloy interface, we find a spin mixing conductance and a spin diffusion length for PM–Fe60Al40. The demonstrated bi-functionality of the Fe60Al40 alloy in spin pumping structures may be promising for spintronic applications. - 19 October 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 104 (13) , 134417
Spin polarization and magnetotransport properties of systematically disordered thin filmsWe investigate the evolution of spin polarization, spontaneous Hall angle (SHA), saturation magnetization, and Curie temperature of -ordered thin films under varying antisite disorder, induced by -ion irradiation. The spin polarization increases monotonically as a function of ion fluence. A relatively high polarization of 46% and a SHA of 3.1% are achieved on 40 nm films irradiated with at 30 keV. An interesting divergence in the trends of the magnetization and SHA is observed for low disorder concentrations. The high spin polarization and its broad tunability range make ion-irradiated a promising material for application in spin electronic devices.- 19 October 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 104 (13) , 134417
Spin polarization and magnetotransport properties of systematically disordered thin filmsWe investigate the evolution of spin polarization, spontaneous Hall angle (SHA), saturation magnetization, and Curie temperature of -ordered thin films under varying antisite disorder, induced by -ion irradiation. The spin polarization increases monotonically as a function of ion fluence. A relatively high polarization of 46% and a SHA of 3.1% are achieved on 40 nm films irradiated with at 30 keV. An interesting divergence in the trends of the magnetization and SHA is observed for low disorder concentrations. The high spin polarization and its broad tunability range make ion-irradiated a promising material for application in spin electronic devices.- Open Access
- 1 July 2020
- Published by IOP Publishing in New Journal of Physics
- Vol. 22 (7) , 073004
Magneto-structural correlations in a systematically disordered B2 lattice
Ferromagnetism in certain B2 ordered alloys such as Fe60Al40 can be switched on, and tuned, via antisite disordering of the atomic arrangement. The disordering is accompanied by a ∼1 % increase in the lattice parameter. Here we performed a systematic disordering of B2 Fe60Al40 thin films, and obtained correlations between the order parameter (S), lattice parameter (a 0), and the induced saturation magnetization (M s). As the lattice is gradually disordered, a critical point occurs at 1 − S = 0.6 and a 0 = 2.91 Å, where a sharp increase of the M s is observed. DFT calculations suggest that below the critical point the system magnetically behaves as it would still be fully ordered, whereas above, it is largely the increase of a 0 in the disordered state that determines the M s. The insights obtained here can be useful for achieving tailored magnetic properties in alloys through disordering.
- 1 July 2020
- Published by IOP Publishing in New Journal of Physics
- Vol. 22 (7) , 073004
Open AccessMagneto-structural correlations in a systematically disordered B2 lattice
Ferromagnetism in certain B2 ordered alloys such as Fe60Al40 can be switched on, and tuned, via antisite disordering of the atomic arrangement. The disordering is accompanied by a ∼1 % increase in the lattice parameter. Here we performed a systematic disordering of B2 Fe60Al40 thin films, and obtained correlations between the order parameter (S), lattice parameter (a 0), and the induced saturation magnetization (M s). As the lattice is gradually disordered, a critical point occurs at 1 − S = 0.6 and a 0 = 2.91 Å, where a sharp increase of the M s is observed. DFT calculations suggest that below the critical point the system magnetically behaves as it would still be fully ordered, whereas above, it is largely the increase of a 0 in the disordered state that determines the M s. The insights obtained here can be useful for achieving tailored magnetic properties in alloys through disordering.
- 1 September 2019
- Published by Elsevier in Acta Materialia
- Vol. 176, 167-176
The role of open-volume defects in the annihilation of antisites in a B2-ordered alloy
- 1 September 2019
- Published by Elsevier in Acta Materialia
- Vol. 176, 167-176
The role of open-volume defects in the annihilation of antisites in a B2-ordered alloy
- 5 December 2018
- Published by American Physical Society (APS) in Physical Review B
- Vol. 98 (21) , 214406
Direct observation of spin diffusion enhanced nonadiabatic spin torque effects in rare-earth-doped permalloy
The relation between the nonadiabaticity parameter and the damping parameter is investigated in permalloy-based microdisks. In order to determine , high-resolution imaging of the current-induced vortex-core displacement is performed using scanning electron microscopy with polarization analysis. The materials properties of the films are varied via rare-earth Dy doping, leading to a greatly enhanced damping, while retaining the same spin configuration for the confined vortex state. A clear trend to much higher nonadiabaticity values is seen for the higher doping levels and an averaged value of is determined for Dy doping, compared to which is extracted for pure permalloy. This is supportive of a similar scaling of and in this system, pointing to a common origin of the spin relaxation which is at the heart of nonadiabatic transport and the dissipation of angular momentum that provides damping, in line with theoretical calculations.- 5 December 2018
- Published by American Physical Society (APS) in Physical Review B
- Vol. 98 (21) , 214406
Direct observation of spin diffusion enhanced nonadiabatic spin torque effects in rare-earth-doped permalloy
The relation between the nonadiabaticity parameter and the damping parameter is investigated in permalloy-based microdisks. In order to determine , high-resolution imaging of the current-induced vortex-core displacement is performed using scanning electron microscopy with polarization analysis. The materials properties of the films are varied via rare-earth Dy doping, leading to a greatly enhanced damping, while retaining the same spin configuration for the confined vortex state. A clear trend to much higher nonadiabaticity values is seen for the higher doping levels and an averaged value of is determined for Dy doping, compared to which is extracted for pure permalloy. This is supportive of a similar scaling of and in this system, pointing to a common origin of the spin relaxation which is at the heart of nonadiabatic transport and the dissipation of angular momentum that provides damping, in line with theoretical calculations.- 1 July 2018
- Published by Wiley in Physik in unserer Zeit
- Vol. 49 (4) , 163-164
Laser schaltet Magnet an und aus
- 1 July 2018
- Published by Wiley in Physik in unserer Zeit
- Vol. 49 (4) , 163-164
Laser schaltet Magnet an und aus
- 17 April 2018
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 10 (17) , 15232-15239
Laser-Rewriteable Ferromagnetism at Thin-Film Surfaces
Manipulation of magnetism using laser light is considered as a key to the advancement of data storage technologies. Until now, most approaches seek to optically switch the direction of magnetization rather than to reversibly manipulate the ferromagnetism itself. Here, we use ∼100 fs laser pulses to reversibly switch ferromagnetic ordering on and off by exploiting a chemical order–disorder phase transition in Fe60Al40, from the B2 to the A2 structure and vice versa. A single laser pulse above a threshold fluence causes nonferromagnetic B2 Fe60Al40 to disorder and form the ferromagnetic A2 structure. Subsequent laser pulsing below the threshold reverses the surface to B2 Fe60Al40, erasing the laser-induced ferromagnetism. Simulations reveal that the order–disorder transition is regulated by the extent of surface supercooling; above the threshold for complete melting throughout the film thickness, the liquid phase can be deeply undercooled before solidification. As a result, the vacancy diffusion in the resolidified region is limited and the region is trapped in the metastable chemically disordered state. Laser pulsing below the threshold forms a limited supercooled surface region that solidifies at sufficiently high temperatures, enabling diffusion-assisted reordering. This demonstrates that ultrafast lasers can achieve subtle atomic rearrangements in bimetallic alloys in a reversible and nonvolatile fashion.
- 17 April 2018
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 10 (17) , 15232-15239
Laser-Rewriteable Ferromagnetism at Thin-Film Surfaces
Manipulation of magnetism using laser light is considered as a key to the advancement of data storage technologies. Until now, most approaches seek to optically switch the direction of magnetization rather than to reversibly manipulate the ferromagnetism itself. Here, we use ∼100 fs laser pulses to reversibly switch ferromagnetic ordering on and off by exploiting a chemical order–disorder phase transition in Fe60Al40, from the B2 to the A2 structure and vice versa. A single laser pulse above a threshold fluence causes nonferromagnetic B2 Fe60Al40 to disorder and form the ferromagnetic A2 structure. Subsequent laser pulsing below the threshold reverses the surface to B2 Fe60Al40, erasing the laser-induced ferromagnetism. Simulations reveal that the order–disorder transition is regulated by the extent of surface supercooling; above the threshold for complete melting throughout the film thickness, the liquid phase can be deeply undercooled before solidification. As a result, the vacancy diffusion in the resolidified region is limited and the region is trapped in the metastable chemically disordered state. Laser pulsing below the threshold forms a limited supercooled surface region that solidifies at sufficiently high temperatures, enabling diffusion-assisted reordering. This demonstrates that ultrafast lasers can achieve subtle atomic rearrangements in bimetallic alloys in a reversible and nonvolatile fashion.
- 1 December 2017
- Published by Elsevier in Ultramicroscopy
- Vol. 183, 104-108
Laser-driven formation of transient local ferromagnetism in FeRh thin films
- 1 December 2017
- Published by Elsevier in Ultramicroscopy
- Vol. 183, 104-108
Laser-driven formation of transient local ferromagnetism in FeRh thin films