Hidetoshi Kuramochi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hidetoshi Kuramochi has a total of 149 co-authors. Here are the top co-authors by number of shared publications:
Kouji Maeda
Department of Chemical Engineering & Materials Science, University of Hyogo, 2167 Shosha, Himeji, Hyogo 671-2201, Japan
25 shared publicationsKeisuke Fukui
Department of Chemical Engineering and Materials Science Graduate School of Engineering University of Hyogo Shosha 2167 Himeji 671−2280 Japan
18 shared publicationsMasahiro Osako
Material Cycles Division, National Institute for Environmental Studies, Onogawa 16-2, Tsukuba, Ibaraki 305-8506, Japan
15 shared publications- Kouji Maeda
Department of Chemical Engineering, University of Hyogo
12 shared publications - Kaiqin Xu
College of Civil Engineering, Fuzhou University, Fuzhou 350116, China
11 shared publications Katsuya Kawamoto
Center for Material Cycles and Waste Management Research, National Institute for Environmental Studies, Onogawa 16-2, Tsukuba, Ibaraki 305-8506, Japan
11 shared publications
Latest Publications
- Open Access
- 12 April 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (16) , 14470-14477
Size-Controlled Preparation of Polyethylene Nanoplastic Particles by Nanoprecipitation and Insights into the Underlying Mechanisms
- 12 April 2023
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 8 (16) , 14470-14477
Open AccessSize-Controlled Preparation of Polyethylene Nanoplastic Particles by Nanoprecipitation and Insights into the Underlying Mechanisms
Preparation of Nanoscale Particles of Five Major Polymers as Potential Standards for the Study of Nanoplastics
Nanoplastics are likely ubiquitous in the environment, and their potential toxic effects are a concern. However, quantitative information about the distribution of nanoplastics is still lacking, and toxicity tests are limited to a few select polymers because of the lack of appropriate standard materials, which should be nanoscale particles with standardizable morphologies, properties comparable to those of commercial polymers, and no impurities. Here, a precipitation‐based method for preparing spherical nanoscale particles without the introduction of impurities is developed. The similarity of the molecular weight distributions, crystallinities, and thermal properties of five major polymers prepared using this method—low‐density polyethylene, high‐density polyethylene, polypropylene, polyvinyl chloride, and polystyrene—to those of commercial polymers indicate their potential for use as standard nanoplastic particles. This study provides a fundamental approach for the synthesis of standard nanoplastic particles that will facilitate quantification of the concentrations of nanoplastics in the environment and tests of their toxicity, which are required to assess the risks associated with exposure to them.
Preparation of Nanoscale Particles of Five Major Polymers as Potential Standards for the Study of Nanoplastics
Nanoplastics are likely ubiquitous in the environment, and their potential toxic effects are a concern. However, quantitative information about the distribution of nanoplastics is still lacking, and toxicity tests are limited to a few select polymers because of the lack of appropriate standard materials, which should be nanoscale particles with standardizable morphologies, properties comparable to those of commercial polymers, and no impurities. Here, a precipitation‐based method for preparing spherical nanoscale particles without the introduction of impurities is developed. The similarity of the molecular weight distributions, crystallinities, and thermal properties of five major polymers prepared using this method—low‐density polyethylene, high‐density polyethylene, polypropylene, polyvinyl chloride, and polystyrene—to those of commercial polymers indicate their potential for use as standard nanoplastic particles. This study provides a fundamental approach for the synthesis of standard nanoplastic particles that will facilitate quantification of the concentrations of nanoplastics in the environment and tests of their toxicity, which are required to assess the risks associated with exposure to them.
- Open Access
- 1 December 2020
- Published by Elsevier in Biotechnology Reports
- Vol. 28, e00561
Bioleaching and removal of radiocesium in anaerobic digestion of biomass crops: Effect of crop type on partitioning of cesium
- 1 December 2020
- Published by Elsevier in Biotechnology Reports
- Vol. 28, e00561
Open AccessBioleaching and removal of radiocesium in anaerobic digestion of biomass crops: Effect of crop type on partitioning of cesium
- 1 April 2020
- Published by Elsevier in Chemosphere
- Vol. 244, 125531
Liquid chromatography–electrospray ionization-tandem mass spectrometry for the determination of short-chain chlorinated paraffins in mixed plastic wastes
- 1 April 2020
- Published by Elsevier in Chemosphere
- Vol. 244, 125531
Liquid chromatography–electrospray ionization-tandem mass spectrometry for the determination of short-chain chlorinated paraffins in mixed plastic wastes
- 1 December 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 696, 133957
Time series of hexabromocyclododecane transfers from flame-retarded curtains to attached dust
- 1 December 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 696, 133957
Time series of hexabromocyclododecane transfers from flame-retarded curtains to attached dust
- 20 November 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 27 (15) , 17596-17606
Simple solvatochromic spectroscopic quantification of long-chain fatty acids for biological toxicity assay in biogas plants
Oily organic waste is a promising feedstock for anaerobic co-digestion. Free long-chain fatty acids (LCFAs) produced from lipids can inhibit methanogenic consortia, so optimal control of LCFA concentration is the key to successful operation of co-digestion. Most LCFAs are present in the solid phase, making them difficult to be detected and monitored. This study proposes a simple and easy method for detecting LCFAs in both the liquid and solid phases of anaerobic digestate by combining liquid–liquid extraction followed by solid-phase extraction (SPE) and spectrophotometric analysis. The extraction procedure successfully removed impurities that interfere with the absorbance spectrum and ensured high recovery rates of LCFAs. The utility of the pretreatment used for the extraction was discussed using thermodynamic analysis and calculations of phase equilibrium for the solvent extraction system. The absorbance spectrum shift of pyridinium N-phenolate betaine (PNPB) dye-stained solution showed a good correlation with LCFA concentration and enabled highly sensitive measurements. Good quantification was demonstrated in experiments using various digestate samples obtained from the laboratory, pilot, and full-scale reactors.
- 20 November 2019
- Published by Springer Nature in Environmental Science and Pollution Research
- Vol. 27 (15) , 17596-17606
Simple solvatochromic spectroscopic quantification of long-chain fatty acids for biological toxicity assay in biogas plants
Oily organic waste is a promising feedstock for anaerobic co-digestion. Free long-chain fatty acids (LCFAs) produced from lipids can inhibit methanogenic consortia, so optimal control of LCFA concentration is the key to successful operation of co-digestion. Most LCFAs are present in the solid phase, making them difficult to be detected and monitored. This study proposes a simple and easy method for detecting LCFAs in both the liquid and solid phases of anaerobic digestate by combining liquid–liquid extraction followed by solid-phase extraction (SPE) and spectrophotometric analysis. The extraction procedure successfully removed impurities that interfere with the absorbance spectrum and ensured high recovery rates of LCFAs. The utility of the pretreatment used for the extraction was discussed using thermodynamic analysis and calculations of phase equilibrium for the solvent extraction system. The absorbance spectrum shift of pyridinium N-phenolate betaine (PNPB) dye-stained solution showed a good correlation with LCFA concentration and enabled highly sensitive measurements. Good quantification was demonstrated in experiments using various digestate samples obtained from the laboratory, pilot, and full-scale reactors.
- 1 July 2019
- Published by Elsevier in Bioresource Technology
- Vol. 283, 28-35
Anaerobic degradation of deca-brominated diphenyl ether contaminated in products: Effect of temperature on degradation characteristics
- 1 July 2019
- Published by Elsevier in Bioresource Technology
- Vol. 283, 28-35
Anaerobic degradation of deca-brominated diphenyl ether contaminated in products: Effect of temperature on degradation characteristics
- 3 June 2019
- Published by Wiley in Crystal Research and Technology
- Vol. 54 (7)
Effect of Taylor Vortex on Melt Crystallization of Fatty Acids
By employing an annular‐cylindrical‐type apparatus operated under a constant cooling rate, melt crystallization is studied to condense a saturated fatty acid (FA) from a binary mixture of the saturated FA with unsaturated FA. In the annular space between the stationary outer cylinder and the rotating inner cylinder, counter‐rotating toroidal vortices, that is, the Taylor vortices are observed. The vortices are found to play a unique role in the solidification of FAs to form a unique wavy layer on the inner cylinder. The mass and heat transfer analysis by numerical calculation reveals that both the velocity and temperature distributions change depending on the position in the annular space because of the centrifugal or centripetal radial flow caused by the Taylor vortices.
- 3 June 2019
- Published by Wiley in Crystal Research and Technology
- Vol. 54 (7)
Effect of Taylor Vortex on Melt Crystallization of Fatty Acids
By employing an annular‐cylindrical‐type apparatus operated under a constant cooling rate, melt crystallization is studied to condense a saturated fatty acid (FA) from a binary mixture of the saturated FA with unsaturated FA. In the annular space between the stationary outer cylinder and the rotating inner cylinder, counter‐rotating toroidal vortices, that is, the Taylor vortices are observed. The vortices are found to play a unique role in the solidification of FAs to form a unique wavy layer on the inner cylinder. The mass and heat transfer analysis by numerical calculation reveals that both the velocity and temperature distributions change depending on the position in the annular space because of the centrifugal or centripetal radial flow caused by the Taylor vortices.