Gwang-Nam Yun
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Gwang-Nam Yun has a total of 111 co-authors. Here are the top co-authors by number of shared publications:
Marcel Jonathan Hidajat
Green Carbon Research Center, Korea Research Institute of Chemical Technology (KRICT), 141 Gajeongro, Yuseong, Daejeon 34114, Republic of Korea
10 shared publicationsS. Ted Oyama
8 shared publicationsDong Won Hwang
6 shared publications- Dong Won Hwang
Green Carbon Research Center, Korea Research Institute of Chemical Technology (KRICT), 141 Gajeongro, Yuseong, Daejeon 34114, Republic of Korea
6 shared publications - Ryuji Kikuchi
Division of Applied Chemistry Hokkaido University Sapporo Japan
6 shared publications Atsushi Takagaki
5 shared publications
Latest Publications
- Open Access
- 21 October 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (43) , 51406-51418
Sustainable Chemical Recycling of Waste Polystyrene via Catalytic Pyrolysis over Waste Shell-Derived Calcium Oxide Catalysts
In this study, a series of seashell-based catalysts was synthesized via simple heat treatment and applied to the catalytic pyrolysis of buoy polystyrene (BPS) for the recovery of styrene monomer. This thermal process facilitates the phase transformation of CaCO3 into CaO, thereby enhancing its catalytic activity with a 56.5 wt % styrene monomer yield from BPS at 350 °C, highlighting its potential as an efficient and environmentally friendly solution for marine waste valorization. A comparative kinetic analysis of thermal and catalytic depolymerization revealed that below 350 °C, catalytic depolymerization exhibited a significantly higher reaction rate than thermal depolymerization, whereas at temperatures above 350 °C the reaction rates of both approaches were nearly the same. Additionally, energy assessment using weighted separation energy calculations based on target styrene purity and product distribution confirmed the economic advantage of catalytic depolymerization. This underscores its potential as a cost-effective and energy-efficient strategy for styrene monomer recovery.
- 21 October 2025
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (43) , 51406-51418
Open AccessSustainable Chemical Recycling of Waste Polystyrene via Catalytic Pyrolysis over Waste Shell-Derived Calcium Oxide Catalysts
In this study, a series of seashell-based catalysts was synthesized via simple heat treatment and applied to the catalytic pyrolysis of buoy polystyrene (BPS) for the recovery of styrene monomer. This thermal process facilitates the phase transformation of CaCO3 into CaO, thereby enhancing its catalytic activity with a 56.5 wt % styrene monomer yield from BPS at 350 °C, highlighting its potential as an efficient and environmentally friendly solution for marine waste valorization. A comparative kinetic analysis of thermal and catalytic depolymerization revealed that below 350 °C, catalytic depolymerization exhibited a significantly higher reaction rate than thermal depolymerization, whereas at temperatures above 350 °C the reaction rates of both approaches were nearly the same. Additionally, energy assessment using weighted separation energy calculations based on target styrene purity and product distribution confirmed the economic advantage of catalytic depolymerization. This underscores its potential as a cost-effective and energy-efficient strategy for styrene monomer recovery.
- 15 July 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 13 (29) , 11190-11201
Unraveling the Heterogeneous Oligomerization Mechanism of Linear α-Olefins Catalyzed by Silica-Supported 12-Tungstophosphoric Acid
- 15 July 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 13 (29) , 11190-11201
Unraveling the Heterogeneous Oligomerization Mechanism of Linear α-Olefins Catalyzed by Silica-Supported 12-Tungstophosphoric Acid
- 12 July 2025
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 58 (15) , 8165-8172
Unraveling the Unknown Effects of Impurities toward a Full Circular Economy of Polystyrene
- 12 July 2025
- Published by American Chemical Society (ACS) in Macromolecules
- Vol. 58 (15) , 8165-8172
Unraveling the Unknown Effects of Impurities toward a Full Circular Economy of Polystyrene
- 13 June 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (25) , 12139-12153
Composition-Dependent Copper-Based Binary Metal Alloys for Hydrogenation of Dimethyl Succinate to 1,4-Butanediol
- 13 June 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (25) , 12139-12153
Composition-Dependent Copper-Based Binary Metal Alloys for Hydrogenation of Dimethyl Succinate to 1,4-Butanediol
- 13 April 2025
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 19 (19) , 18095-18107
Carbide-Induced Thermal Shock Synthesis of High-Entropy Alloy Nanoparticles Anchored on WO3 Nanofibers for High-Performance Gas Sensors
The synthesis of high-entropy alloy nanoparticles (HEA NPs) on oxide supports with a uniform and homogeneous distribution has been a significant challenge in traditional carbothermal shock (CTS) methods. In this study, we introduce a carbide-induced thermal shock (CITS) process for synthesizing HEA NPs anchored on tungsten trioxide (WO3) nanofibers. Utilizing one-dimensional (1D) tungsten carbide (WC) nanofibers (NFs) as scaffolds, we facilitated their oxidation to WO3 while preserving structural integrity. This approach resulted in the formation of ultrasmall HEA NPs (1-3 nm) strongly anchored on the WO3 NFs, preventing grain growth and enabling a core-shell microstructure. The functionalized WO3 NFs with homogeneously distributed HEA NPs demonstrated significantly enhanced gas sensing performance, especially for hydrogen sulfide (H2S), with a response (Rair/Rgas) of 22.1 at 5 ppm. This improvement is attributed to the CITS process, which enhances the chemisorption of oxygen species and increases the density of Lewis acid sites, leading to superior catalytic performance and stability. The findings from this study demonstrate the effectiveness of the CITS method in synthesizing highly active oxide-based catalysts and its potential applications in advanced gas sensing technologies under extreme conditions.
- 13 April 2025
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 19 (19) , 18095-18107
Carbide-Induced Thermal Shock Synthesis of High-Entropy Alloy Nanoparticles Anchored on WO3 Nanofibers for High-Performance Gas Sensors
The synthesis of high-entropy alloy nanoparticles (HEA NPs) on oxide supports with a uniform and homogeneous distribution has been a significant challenge in traditional carbothermal shock (CTS) methods. In this study, we introduce a carbide-induced thermal shock (CITS) process for synthesizing HEA NPs anchored on tungsten trioxide (WO3) nanofibers. Utilizing one-dimensional (1D) tungsten carbide (WC) nanofibers (NFs) as scaffolds, we facilitated their oxidation to WO3 while preserving structural integrity. This approach resulted in the formation of ultrasmall HEA NPs (1-3 nm) strongly anchored on the WO3 NFs, preventing grain growth and enabling a core-shell microstructure. The functionalized WO3 NFs with homogeneously distributed HEA NPs demonstrated significantly enhanced gas sensing performance, especially for hydrogen sulfide (H2S), with a response (Rair/Rgas) of 22.1 at 5 ppm. This improvement is attributed to the CITS process, which enhances the chemisorption of oxygen species and increases the density of Lewis acid sites, leading to superior catalytic performance and stability. The findings from this study demonstrate the effectiveness of the CITS method in synthesizing highly active oxide-based catalysts and its potential applications in advanced gas sensing technologies under extreme conditions.
- Open Access
- 25 January 2025
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 92
Exploring the role of PdO and oxygen vacancies of Pd/CeO2 in bicarbonate hydrogenation
- 25 January 2025
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 92
Open AccessExploring the role of PdO and oxygen vacancies of Pd/CeO2 in bicarbonate hydrogenation
- Open Access
- 12 January 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 505
Process modeling and assessment of waste polystyrene pyrolysis: Comparing catalytic and thermal methods
- 12 January 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 505
Open AccessProcess modeling and assessment of waste polystyrene pyrolysis: Comparing catalytic and thermal methods
- 7 January 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 13 (2) , 1017-1030
A Mechanistic Study on the Selective Hydrogenation of γ-Butyrolactone over the Rationally Designed Bimetallic CuCo Catalysts
- 7 January 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 13 (2) , 1017-1030
A Mechanistic Study on the Selective Hydrogenation of γ-Butyrolactone over the Rationally Designed Bimetallic CuCo Catalysts
- Open Access
- 27 November 2024
- Published by Elsevier in Fuel Processing Technology
- Vol. 267
Data-driven analysis in the selective oligomerization of long-chain linear alpha olefin on zeolite catalysts: A machine learning-based parameter study
- 27 November 2024
- Published by Elsevier in Fuel Processing Technology
- Vol. 267
Open AccessData-driven analysis in the selective oligomerization of long-chain linear alpha olefin on zeolite catalysts: A machine learning-based parameter study