MHMarkus Hoelzel

Markus Hoelzel

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Markus Hoelzel has a total of 76 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Mechanism for the Combined Li–Na Ionic Conductivity in Sugilite (Fe2Na2K[Li3Si12O30])-Type Compounds

    by So-Hyun Park, Carsten Paulmann, Markus Hoelzel, Rupert Hochleitner

    This study explains the ionic conductivity in the mineral sugilite (idealized formula: Fe2Na2K[Li3Si12O30]) by resolving the dynamic disorder of both Li and Na cations using synchrotron X-ray single-crystal diffraction from 298 K to 1023 K. Non-zero anharmonic atomic displacement parameters at Na and Li sites at 1023 K adumbrated long-range charge transport routes for Li and Na cations commonly parallel to the (a–b) plane. Temperature-enhanced diffuse residuals in Fourier maps could unambiguously localize two interstitial sites suitable for Li, as well as three for Na. Each two-dimensional (2D) network of Li and Na interstitials was formed parallel to each other, providing Li and Na hopping pathways. The higher concentration of Na cations hopping in short distances of 2.0962(4)–2.3015(5) Å could be the main reason for the higher bulk conductivity values evaluated by impedance spectra of sugilite in comparison to those of its structural relatives with low Na contents, e.g., the mineral sogdianite ((Zr,Al,Fe)2Na0.36K[Li3Si12O30]). Bond valence sum landscape maps supported the critical role of dynamic disorder of Na+ over densely packed 2D interstitial networks for combined ionic conductivity along with mobile Li+ in sugilite-type compounds.


  • Open Access

    Kinetics of Martensite Decomposition and Microstructure Stability of Ti-6246 during Rapid Heating to Service Temperatures

    by Anna-Lena Otte, Phuong Thao Mai, Andreas Stark, Markus Hoelzel, Michael Hofmann, Jens Gibmeier

    The aerospace alloy Ti-6246 was subjected to inductive heat treatments with high heating and quenching rates (up to 1500 K/s) while being applied to an in situ diffraction study at the HEMS beamline P07B at DESY. Thereby, the characterization of the emerging phases was possible at any point in the process. The heat treatment schedules include the preparation of Ti-6246 samples by means of a homogenization treatment and subsequent quenching to trigger α″-martensite formation. In order to simulate fast reheating within the scope of application, the samples were reheated to the upper range of possible service temperatures (550–650 °C) with a heating rate of 100 K/s. In a second heat treatment design, the homogenized and quenched sample state was exposed to high-temperature tempering at 840 °C, which aims for the elimination of α″. Again, fast reheating to the same service temperatures was executed. With the aim of this approach, the stability of the microstructure consisting of α-Ti, β-Ti and α″-martensite was characterized. Further, the martensite decomposition path was analyzed. It shows a two-tier nature, firstly approaching the bcc β-unit cell in the low-temperature range (<400 °C) but subsequently transforming into an hcp-like unit cell and later on into equilibrium α-Ti.


  • Open Access

    DISEMM: a tool for the investigation of elasto-plastic behaviour on polycrystalline samples using X-ray and neutron diffraction

    by Alexander Heldmann, Michael Hofmann, Markus Hoelzel

    The software DISEMM is designed to analyse diffraction data from in situ loading experiments on polycrystalline samples for the determination of single-crystal elastic constants (SECs) and elasto-plastic self-consistent (EPSC) modelling of lattice strains. The SECs can be obtained from powder-diffraction elastic constants using a variety of grain-to-grain interaction models, namely Voigt, Reuss, Hill, Kröner, de Wit and Matthies approaches. The texture of the polycrystalline sample can be taken into account using the orientation distribution function of the grains. For the analysis of two-phase materials, an approach was implemented to calculate the stress transfer between the phases and its impact on the apparent elastic properties. The calculated SECs can then be used as input into the EPSC model, which allows the user to predict the elasto-plastic behaviour for comparison with experimental lattice strain data and to investigate the activation of individual slip systems. For this purpose, critical resolved shear stresses and hardening parameters are adapted iteratively.


  • Open Access

    Structural Investigation into Magnetic Spin Orders of a Manganese Phosphatic Oxyhydroxide, Mn5[(PO4)2(PO3(OH))2](HOH)4

    by Sohyun Park, Anna Hartl, Denis Sheptyakov, Markus Hoelzel, Ana Arauzo

    The ferri- and antiferromagnetic structures of a hureaulite-type synthetic compound, Mn2+5(PO4)2(PO3(OH))2(HOH)4, were elucidated by high-resolution neutron powder diffraction in combination with magnetic susceptibility and heat capacity measurements. At 6.17 K, the paramagnetic phase (space group: C2/c) transforms to inherit a ferrimagnetic order (magnetic space group: C2′/c′), followed at 1.86 K by an incommensurately modulated antiferromagnetic order (magnetic superspace group: P21/c.1′(α0γ)00s with the propagation vector k(0.523(2), 0, 0.055(1)). In the ferrimagnetic state, antiferromagnetic interactions are dominant for both intra and inter pentamers of Mn2+(O, HOH)6 octahedra. Differently aligned spin-canting sublattices seen in the ferrimagnetic models at 3.4, 4.5, and 6.1 K explain a weak ferromagnetism in the title compound. The observation of magnetic moments vigorously changing in a small temperature range of 6.1–1.5 K adumbrates a high complexity of interplaying structural and magnetic orders in this manganese phosphatic oxyhydroxide.


  • Open Access

    Potassium Ion Conductivity in the Cubic Labyrinth of a Piezoelectric, Antiferromagnetic Oxoferrate(III) Tellurate(VI)

    by Ralf Albrecht, Markus Hoelzel, Henrik Beccard, Michael Rüsing, Lukas Eng, Thomas Doert, Michael Ruck

    Orange‐colored crystals of the oxoferrate tellurate K12+6xFe6Te4−xO27 [x=0.222(4)] were synthesized in a potassium hydroxide hydroflux with a molar water–base ratio n(H2O)/n(KOH) of 1.5 starting from Fe(NO3)3 ⋅ 9H2O, TeO2 and H2O2 at about 200 °C. By using (NH4)2TeO4 instead of TeO2, a fine powder consisting of microcrystalline spheres of K12+6xFe6Te4−xO27 was obtained. K12+6xFe6Te4−xO27 crystallizes in the acentric cubic space group I 3d. [FeIIIO5] pyramids share their apical atoms in [Fe2O9] groups and two of their edges with [TeVIO6] octahedra to form an open framework that consists of two loosely connected, but not interpenetrating, chiral networks. The flexibility of the hinged oxometalate network manifests in a piezoelectric response similar to that of LiNbO3.The potassium cations are mobile in channels that run along the directions and cross in cavities acting as nodes. The ion conductivity of cold‐pressed pellets of ball‐milled K12+6xFe6Te4−xO27 is 2.3×10−4 S ⋅ cm−1 at room temperature. Magnetization measurements and neutron diffraction indicate antiferromagnetic coupling in the [Fe2O9] groups.


  • Open Access

    Temperature dependent crystal structure re‐determination and electronic properties of UI3

    by Malte Sachs, Lars Deubner, Martin Möbs, Markus Hoelzel, Matthias Conrad, Florian Kraus

    In this work, we have re‐investigated the structural and physical properties of UI3 by means of temperature dependent powder neutron diffraction, heat capacity and magnetic measurements. We confirm that UI3 crystallizes in the PuBr3 structure type, space group Cmcm. We did not observe any temperature dependent structural phase transition in the temperature range from 10 to 300 K. We further report the first quantum chemical calculations of UI3 by density functional theory (DFT). The calculated structural and electronic properties demonstrate the pronounced two‐dimensional anisotropic effects present in UI3 due to its layered structure.


  • A Neutron Diffraction and Quantum-Chemical Study of [Mn(ND3)6](N3)2

    by Sergei I. Ivlev, Thomas G. Müller, Antti J. Karttunen, Markus Hoelzel, Florian Kraus

  • Open Access

    Additional Phases at High Boron Content in High-Temperature Co–Re–Cr Alloys

    by Přemysl Beran, Debashis Mukherji, Pavel Strunz, Ralph Gilles, Lukas Karge, Michael Hofmann, Markus Hoelzel, Joachim Rösler, Gergely Farkas

    Boron largely increases the ductility of polycrystalline high-temperature Co–Re–Cr alloys. Therefore, the effect of boron addition on the alloy structural characteristics is of large importance for the stability of the alloy at operational temperatures. Along with the Co-solid solution matrix phase transformation from hcp to fcc structure, additional structural effects were observed in situ at very high temperatures (up to 1500 °C) using neutron diffraction (ND) in boron-containing Co–17Re–23Cr alloys. Increasing boron content up to 1000 wt. ppm lowers the temperature at which sublimation of Co and Cr from the matrix occurs. As a result, the composition of the matrix in the surface region is changed leading to the formation of a second and a third matrix hcp phases at high temperatures. The consideration on the lattice parameter dependence on composition was used to identify the new phases appearing at high temperatures. Energy-dispersive spectroscopy and ND results were used to estimate the amount of Co and Cr which sublimated from the surface region of the high-boron sample. In the sense of alloy development, the sublimation of Co and Cr is not critical as the temperature range where it is observed (≥1430 °C) is significantly above the foreseen operation temperature of the alloys (1200 °C).


  • Open Access

    Influence of microstructure on symmetry determination of piezoceramics

    by M. Hinterstein, H. E. Mgbemere, M. Hoelzel, W. Rheinheimer, E. Adabifiroozjaei, P. Koshy, C. C. Sorrell, M. Hoffman

    The origin of the complex reflection splitting in potassium sodium niobate doped with lithium and manganese was investigated using temperature-dependent high-resolution X-ray and neutron diffraction as well as electron probe microanalysis and scanning electron microscopy. Two structural models were developed from the diffraction data. A single-phase monoclinicPmmodel is known from the literature and is able to reproduce the diffraction patterns perfectly. However, a model with phase coexistence of two classical orthorhombicAmm2 phases can also reproduce the diffraction data with equal accuracy. Scanning electron microscopy in combination with electron probe microanalysis revealed segregation of theA-site substituents potassium and sodium. This favours the model with phase coexistence and confirms the need for comprehensive analyses with complementary methods to cover a broad range of length scales as well as to assess both average and local structure.


  • [UCl4(HCN)4] – a hydrogen cyanide complex of uranium tetrachloride

    by S. S. Rudel, C. Pietzonka, M. Hoelzel, F. Kraus

    The reaction of uranium tetrachloride with anhydrous liquid hydrogen cyanide yields a turquoise microcrystalline powder of tetrachloridotetraformonitrileuranium(iv), [UCl4(HCN)4].