Mei-Jiau Huang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mei-Jiau Huang has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Tai-Ming Chang
4 shared publicationsChao-Hua Wang
China Steel Corporation , Kaohsiung, Taiwan, Republic of China
3 shared publicationsChia-Tsung Hsieh
Department of Mechanical Engineering , National Taiwan University , Taipei, Taiwan, Republic of China
3 shared publicationsChien-Chou Weng
National Taiwan University Mechanical Engineering Department Taipei Taiwan
3 shared publicationsLiang-Chun Liu
3 shared publicationsShih-Tuen Lee
Department of Mechanical Engineering , National Taiwan University , Taipei, Taiwan, Republic of China
3 shared publications
Latest Publications
- 23 August 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 279
A hybrid simulation method integrating CFD and lumped-parameter thermal networks for tubular heat exchangers
- 23 August 2025
- Published by Elsevier in Applied Thermal Engineering
- Vol. 279
A hybrid simulation method integrating CFD and lumped-parameter thermal networks for tubular heat exchangers
- 28 July 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 255
A model for the lattice thermal conductivity of nanocrystalline materials with arbitrary grain size distribution
- 28 July 2024
- Published by Elsevier in Applied Thermal Engineering
- Vol. 255
A model for the lattice thermal conductivity of nanocrystalline materials with arbitrary grain size distribution
- 31 July 2023
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 27 (3-4) , 149-167
An Investigation into the Roughness and Film Thickness Effects on the Interfacial Thermal Resistance
- 31 July 2023
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 27 (3-4) , 149-167
An Investigation into the Roughness and Film Thickness Effects on the Interfacial Thermal Resistance
- 3 April 2023
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 27 (2) , 110-124
The Tortuosity Effect on the Thermal Conductivity of Si Nanowires
The thermal conductivity of tortuous silicon nanowires with constant cross section at room temperature was investigated in use of full-spectrum Monte-Carlo simulations. Various geometric features that can be possibly used to describe the tortuosity of the nanowires were studied and their relationships with the thermal conductivity were explored. Comparison of simulation results with experimental data shows similar magnitudes and variation trend of the thermal conductivity against the nanowire hydraulic diameter. The more tortuous, the smaller the thermal conductivity is. Among all, data collapse is best when shown against the surface-to-volume ratio and the correlation length of the surface roughness does not affect the thermal conductivity at all. By taking the surface-to-volume ratio into account for the boundary scattering rate, which also depends on the phonon frequency indirectly through the phonon group velocity, we are able to obtain satisfactory predictions based on a linear spectral model, not only about the thermal conductivity but also about the spectral heat flux density distribution. The model also shows that the relative reduction caused by tortuosity decreases with increasing frequency. For highly tortuous nanowires of diameter 22 nm, simply increasing the tortuosity is sufficient to obtain simulated thermal conductivities that are smaller than the experimentally measured value.
- 3 April 2023
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 27 (2) , 110-124
The Tortuosity Effect on the Thermal Conductivity of Si Nanowires
The thermal conductivity of tortuous silicon nanowires with constant cross section at room temperature was investigated in use of full-spectrum Monte-Carlo simulations. Various geometric features that can be possibly used to describe the tortuosity of the nanowires were studied and their relationships with the thermal conductivity were explored. Comparison of simulation results with experimental data shows similar magnitudes and variation trend of the thermal conductivity against the nanowire hydraulic diameter. The more tortuous, the smaller the thermal conductivity is. Among all, data collapse is best when shown against the surface-to-volume ratio and the correlation length of the surface roughness does not affect the thermal conductivity at all. By taking the surface-to-volume ratio into account for the boundary scattering rate, which also depends on the phonon frequency indirectly through the phonon group velocity, we are able to obtain satisfactory predictions based on a linear spectral model, not only about the thermal conductivity but also about the spectral heat flux density distribution. The model also shows that the relative reduction caused by tortuosity decreases with increasing frequency. For highly tortuous nanowires of diameter 22 nm, simply increasing the tortuosity is sufficient to obtain simulated thermal conductivities that are smaller than the experimentally measured value.
- 1 October 2021
- Published by Elsevier in Applied Thermal Engineering
- Vol. 197
A design and verification of a non-icing and non-condensing waste-cold-recovery system
- 1 October 2021
- Published by Elsevier in Applied Thermal Engineering
- Vol. 197
A design and verification of a non-icing and non-condensing waste-cold-recovery system
- 31 December 2018
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 23 (1) , 36-47
An Investigation into the Thermal Boundary Resistance Associated with the Twin Boundary in Bismuth Telluride
The thermal boundary resistances (TBRs) of twin boundaries occurring at three different atomic layers (Te1, Bi, and Te2) of bismuth telluride (Bi2Te3) are investigated in use of the non-equilibrium molecular dynamics (NEMD) simulation method. The simulation results show that among all, the Te1-twin boundaries bring about a lowest interfacial energy corresponding to a most stable system, which explains why this type of twin boundaries is mostly often observed in the laboratory; the Te2-twin boundaries on the other hand possess a largest interfacial energy, resulting in a least stable system. The order in magnitude of the TBRs associated with these three types of twin boundaries is Te2-twin > Bi-twin > Te1-twin. Moreover, the TBR associated with a pair of twin boundaries separated by a distance of 4 unit cell (UC) is found to be about twice as large as that of a single twin boundary of the same type. It implies that the mutual coupling, which causes an increase in TBRs, may be ignored and the effect of twin boundaries may be counted individually as long as the separation distance is larger than 4 UC.
- 31 December 2018
- Published by Taylor & Francis in Nanoscale and Microscale Thermophysical Engineering
- Vol. 23 (1) , 36-47
An Investigation into the Thermal Boundary Resistance Associated with the Twin Boundary in Bismuth Telluride
The thermal boundary resistances (TBRs) of twin boundaries occurring at three different atomic layers (Te1, Bi, and Te2) of bismuth telluride (Bi2Te3) are investigated in use of the non-equilibrium molecular dynamics (NEMD) simulation method. The simulation results show that among all, the Te1-twin boundaries bring about a lowest interfacial energy corresponding to a most stable system, which explains why this type of twin boundaries is mostly often observed in the laboratory; the Te2-twin boundaries on the other hand possess a largest interfacial energy, resulting in a least stable system. The order in magnitude of the TBRs associated with these three types of twin boundaries is Te2-twin > Bi-twin > Te1-twin. Moreover, the TBR associated with a pair of twin boundaries separated by a distance of 4 unit cell (UC) is found to be about twice as large as that of a single twin boundary of the same type. It implies that the mutual coupling, which causes an increase in TBRs, may be ignored and the effect of twin boundaries may be counted individually as long as the separation distance is larger than 4 UC.
- 20 August 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (11) , 6746-6750
Effect of the Temperature Dependence of Transmissivity on the Thermal Boundary Conductance Between Two Dissimilar Solids
- 20 August 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (11) , 6746-6750
Effect of the Temperature Dependence of Transmissivity on the Thermal Boundary Conductance Between Two Dissimilar Solids
- 1 November 2016
- Published by Elsevier in Advances in Engineering Software
- Vol. 101, 60-68
A sub-cell spectral-element simulator for 2D rigid-body-fluid interaction problems
- 1 November 2016
- Published by Elsevier in Advances in Engineering Software
- Vol. 101, 60-68
A sub-cell spectral-element simulator for 2D rigid-body-fluid interaction problems
- 2 January 2015
- Published by Wiley in Chemical Vapor Deposition
- Vol. 21 (4-5-6) , 111-121
An Investigation into, and Improvement of, the Non-uniformity of the Flow Field caused by the Pumping Effect in a Stagnation Flow CVD Reactor
- 2 January 2015
- Published by Wiley in Chemical Vapor Deposition
- Vol. 21 (4-5-6) , 111-121
An Investigation into, and Improvement of, the Non-uniformity of the Flow Field caused by the Pumping Effect in a Stagnation Flow CVD Reactor