ESErland M. Schulson

Erland M. Schulson

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Erland M. Schulson has a total of 27 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Angle of repose of granulated ice: effect of wood ash

    by William M. Harris, Andrii Murdza, Erland M. Schulson

    New experiments have revealed that the addition of a small amount of wood ash doubles the angle of repose of granulated ice at −10°C, but has little effect at −30°C. It is hypothesized that this behavior may be explained in terms of the freezing of water that is formed at the higher temperature through the reaction of salt within the ash.


  • Open Access

    Behavior Under Cyclic Loading of Freshwater Ice and Sea Ice With Thermal Microcracks

    by Andrii Murdza, Erland M. Schulson, Carl E. Renshaw

    The combination of thinning ice, larger waves, and damage due to diurnal thermal cycling motivate the need to better understand the impact of flexing under the action of oceanic waves on the strength of thermally cracked ice. To that end, new experiments were performed on freshwater, lab‐grown ice and first‐year natural sea ice. Both materials were cracked by thermal shocking and then subsequently cyclically flexed. Initially, the thermal cracks weakened both materials. When the cracked ice of either origin was cyclically flexed under fully reversed loading, its flexural strength, initially reduced by the stress‐concentrating action of the cracks, recovered to the strength of non‐cracked, non‐flexed ice. When the cracked ice was cyclically flexed non‐reversely, its strength recovered only partially. During reversed cyclic flexing, the cracked region experienced alternately compressive and tensile stresses. We suggest compression resulted in contact of opposing crack faces followed by sintering leading to strength recovery. During non‐reversed cyclic flexing, contact and sintering were reduced and ice strength did not fully recover. The tendency for cracks to heal during cyclic flexing may lessen their threat to the structural integrity of an ice cover.


  • Open Access

    Rapid Healing of Thermal Cracks in Ice

    by Andrii Murdza, Erland M. Schulson, Carl E. Renshaw, Arttu Polojärvi

    The structural integrity of the arctic sea ice cover is under threat owing largely to the combination of thinning and larger waves. Another contributor may be thermal cracking. In concentrating stress, thermal cracks may weaken the cover. Of interest, therefore, is the strength of thermally damaged ice. To that end, new experiments were performed on sea ice and on lab‐grown saline and salt‐free ice that had been cracked by thermal shocking. As expected, the cracks weakened the materials in accord with fracture mechanics. However, within tens to hundreds of seconds of shocking, the strength recovered completely, for the ice had healed. Healing is attributed to thermally activated sintering related to surface diffusion, assisted possibly by the formation of a quasi‐liquid layer on crack faces. Whether behavior on the small scale is indicative of behavior on the large scale remains to be determined.


  • Open Access

    Sampling Plume Deposits on Enceladus’ Surface to Explore Ocean Materials and Search for Traces of Life or Biosignatures

    by Mathieu Choukroun, Paul Backes, Morgan L. Cable, Edith C. Fayolle, Robert Hodyss, Andrii Murdza, Erland M. Schulson, Mircea Badescu, Michael J. Malaska, Eloïse Marteau, et al.

    Enceladus is unique as an astrobiology target in that it hosts an active plume sourced directly from its habitable subsurface ocean. Ice particles from the plume contain geochemical constituents that are diagnostic of the ocean conditions, and may hold traces of life and/or biosignatures, if they exist. Up to 93% of the plume particles fall back onto the surface of Enceladus. The low radiation environment and present-day activity are favorable to the preservation of any complex organics and putative biosignatures contained within these particles. Laboratory experiments and modeling suggest that plume deposits would likely be weakly consolidated and relatively easy to sample. Sampling systems like a dual rasp, under development to achieve technology readiness level (TRL) 5 in 2021, would enable a landed mission on Enceladus’ surface to acquire large amounts of surface materials, a requirement for analysis of trace constituents. A landed mission on Enceladus could greatly enhance our understanding of the chemical makeup of plume particles and the subsurface ocean, and seek traces of life and/or biosignatures.


  • Open Access

    Strength Evolution of Ice Plume Deposit Analogs of Enceladus and Europa

    by M. Choukroun, J. L. Molaro, R. Hodyss, E. Marteau, P. Backes, E. M. Carey, W. Dhaouadi, S. Moreland, E. M. Schulson

    Enceladus and possibly Europa spew materials from their internal ocean into their exosphere, some of which are deposited back onto the surface of those Ocean Worlds. This setting provides a unique opportunity to seek traces of past or extant life in ice plume deposits on their surfaces. However, the design of lander missions and surface sampling techniques and the choice of sampling locations rely heavily on strength expectations. Here we present an experimental investigation of the evolution in strength of ice plume deposit analogs at several temperatures, as well as a model that predicts first‐order estimates of the strength of evolved ice plume deposits under geologic timescales relevant to Enceladus and Europa. These results suggest that plume deposits remain weak and poorly consolidated on Enceladus, while they may develop substantial strength (comparable to solid ice) within <100 Myr on Europa.


  • Open Access

    Strengthening of columnar-grained freshwater ice through cyclic flexural loading

    by Andrii Murdza, Erland M. Schulson, Carl E. Renshaw

    Systematic experiments reveal that the flexural strength of freshwater S2 columnar-grained ice loaded normal to the columns increases upon cyclic loading. Specifically, over the range of stress amplitudes 0.1–2.6 MPa the flexural strength increases linearly with increasing stress amplitude. The experiments were conducted upon both reversed and non-reversed cyclic loading over ranges of frequencies from 0.03 to 2 Hz and temperatures from −25 to −3°C. Strengthening can also be imparted through bending-induced creep. The fundamental requirement for strengthening is that the surface that undergoes maximum tensile stress during failure must have been pre-stressed in tension. Flexural strength is governed by crack nucleation. We suggest that the process is resisted by an internal back-stress that opposes the applied stress and builds up through either crystal dislocations piling up or grain boundaries sliding.


  • Open Access

    Friction of sea ice

    by Erland M. Schulson

    Static and kinetic friction play a fundamental role in sea-ice mechanics. The coefficient of static friction increases with hold time under normal load and is modelled in terms of creep and fracture of asperities in contact. The coefficient of kinetic friction exhibits velocity strengthening at lower speeds and velocity weakening at intermediate speeds. Strengthening is modelled in terms of asperity creep and hardness; weakening is modelled in terms of a progressive increase in the true area of contact wetted by meltwater produced through frictional heating. The concept is introduced of contact size distribution in which the smallest contacts melt first, leading to the onset of weakening; the largest melt last, leading to a third regime of kinetic friction and again to strengthening where hydrodynamics governs. Neither the static nor the kinetic coefficient is significantly affected by the presence of sea water. The paper closes with a few implications for sea-ice mechanics. The paper is based largely upon a critical review of the literature, but includes a more quantitative, physics-based analysis of velocity strengthening and a new analysis of velocity weakening that incorporates parameters that describe the (proposed) fractal character of the sliding interface.This article is part of the theme issue ‘Modelling of sea-ice phenomena’.


  • Open Access

    Experimental studies on mechanical properties and ductile‐to‐brittle transition of ice‐silica mixtures: Young's modulus, compressive strength, and fracture toughness

    by Minami Yasui, Erland M. Schulson, Carl E. Renshaw

    We measured Young's modulus, fracture toughness, and compressive strength of ice and of ice‐0.25‐μm hard silica bead mixtures in controlled systematic experiments to determine the effect of silica on the ductile‐to‐brittle transition. Unconfined compressive strength was measured in a cold room at −10°C under a constant strain rate ranging from 10−5 to 6 × 10−1 s−1 of mixtures with silica volume fraction f of 0, 0.06, and 0.18. In the brittle regime, the compressive strength σpeak was a maximum at the transitional strain rate and then decreased with increasing strain rate. In the ductile regime, the σpeak increased exponentially with increasing strain rate as . The stress exponent n for f = 0.06 and 0.18 was ~6, twice as large as the value of pure ice, n ~ 3. The transitional strain rate increased with increasing silica volume fraction; 10−3–10−2 s−1 for pure ice, 10−2–10−1 s−1 for f = 0.06, and >6 × 10−1 s−1 for f = 0.18. Fracture toughness and Young's modulus were measured over the range 0 ≤ f ≤ 0.34. Fracture toughness scaled as f0.5, while Young's modulus increased linearly with f. Finally, a theoretical model of the transitional strain rate proposed by Schulson (1990) and Renshaw and Schulson (2001) was compared to the measured transitional strain rates. Model predictions were in accord with measured transitional strain rates for pure ice but somewhat higher than observed for ice‐silica mixtures. Large model uncertainty was due to high sensitivity of the transitional strain rate to the stress exponent n.