María Jesús Belzunce Segarra
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
María Jesús Belzunce Segarra has a total of 147 co-authors. Here are the top co-authors by number of shared publications:
- José Germán Rodríguez
AZTI, Marine Research, Basque Research and Technology Alliance (BRTA), Herrera Kaia, Portualdea z/g, Pasaia 20110, Spain
5 shared publications - Blánaid White
School of Chemical Sciences, Dublin City University, Dublin 9, Ireland
3 shared publications - Gary R. Fones
School of the Environment and Life Sciences (SELS) University of Portsmouth Portsmouth UK
3 shared publications Iratxe Menchaca
AZTI, Herrera Kaia Portualdea Z G, Pasaia 20110, Spain
3 shared publications- Joxe Mikel Garmendia
AZTI, Marine Research, Basque Research and Technology Alliance (BRTA), Herrera Kaia, Portualdea z/g, Pasaia 20110, Spain
3 shared publications - Miguel Caetano
CIIMAR—Interdisciplinary Centre of Marine and Environmental Research, University of Porto, Terminal de Cruzeiros do Porto de Leixões, Avenida General Norton de Matos, S/N, 4450-208 Matosinhos, Portugal
3 shared publications
Latest Publications
- Open Access
- 6 April 2025
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 215, 117915
Chemical emissions from offshore wind farms: From identification to challenges in impact assessment and regulation
- 6 April 2025
- Published by Elsevier in Marine Pollution Bulletin
- Vol. 215, 117915
Open AccessChemical emissions from offshore wind farms: From identification to challenges in impact assessment and regulation
- Open Access
- 2 February 2024
- Published by Elsevier in Data in Brief
- Vol. 53, 110145
Metal concentrations in transitional and coastal waters measured by passive (Diffusive Gradients in Thin-films) and spot sampling: MONITOOL Project Dataset
- 2 February 2024
- Published by Elsevier in Data in Brief
- Vol. 53, 110145
Open AccessMetal concentrations in transitional and coastal waters measured by passive (Diffusive Gradients in Thin-films) and spot sampling: MONITOOL Project Dataset
- Open Access
- 1 August 2021
- Published by Elsevier in Science of The Total Environment
- Vol. 783, 147001
Assessing variability in the ratio of metal concentrations measured by DGT-type passive samplers and spot sampling in European seawaters
- 1 August 2021
- Published by Elsevier in Science of The Total Environment
- Vol. 783, 147001
Open AccessAssessing variability in the ratio of metal concentrations measured by DGT-type passive samplers and spot sampling in European seawaters
- Open Access
- 14 July 2021
- Published by Pensoft Publishers in ARPHA Preprints
- Vol. 1, e70983
A Good Practice Guide for the Use of DGTs. Sampling of metals in transitional and coastal waters by Diffusive Gradient in Thin films (DGT) technique
This good practice guide is focused on the DGT devices, which are the most widely used passive sampler for metals, covering the following aspects: ■ Principle ■ Handling passive sampling devices for metals ■ Estimation of appropriate field deployment time ■ A Good Practice Guide for the Use of DGTs ■ Passive sampling device preparation and assembly ■ Selection of sampling site and safety precautions ■ Passive sampling device deployment and retrieval ■ Extraction of analytes from passive sampling devices ■ Analysis ■ Calculations
- 14 July 2021
- Published by Pensoft Publishers in ARPHA Preprints
- Vol. 1, e70983
Open AccessA Good Practice Guide for the Use of DGTs. Sampling of metals in transitional and coastal waters by Diffusive Gradient in Thin films (DGT) technique
This good practice guide is focused on the DGT devices, which are the most widely used passive sampler for metals, covering the following aspects: ■ Principle ■ Handling passive sampling devices for metals ■ Estimation of appropriate field deployment time ■ A Good Practice Guide for the Use of DGTs ■ Passive sampling device preparation and assembly ■ Selection of sampling site and safety precautions ■ Passive sampling device deployment and retrieval ■ Extraction of analytes from passive sampling devices ■ Analysis ■ Calculations
- 1 October 2016
- Published by Elsevier in Science of The Total Environment
- Vol. 566-567, 698-711
‘The past is the future of the present’: Learning from long-time series of marine monitoring
- 1 October 2016
- Published by Elsevier in Science of The Total Environment
- Vol. 566-567, 698-711
‘The past is the future of the present’: Learning from long-time series of marine monitoring
- 18 November 2015
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 49 (24) , 14204-14212
Metal Fluxes from Porewaters and Labile Sediment Phases for Predicting Metal Exposure and Bioaccumulation in Benthic Invertebrates
The use of diffusive gradients in thin films (DGT) for predicting metal bioavailability was investigated by exposing the bivalve Tellina deltoidalis to an identical series of metal-contaminated sediments deployed simultaneously in the field and laboratory. To understand the differences in metal exposure occurring between laboratory- and field-based bioassays, we investigated changes in metal fluxes to DGT probes in sediments and in metal concentrations and partitioning to porewaters and overlying waters. DGT-metal fluxes (Cu, Pb, and Zn) were lower in the overlying waters of most field bioassays compared to the laboratory, causing differences in Pb and Zn bioaccumulation between bivalves exposed to laboratory and field conditions. Overall, DGT-metal fluxes provided predictions of metal bioaccumulation similar to those obtained using dilute-acid extractable metal measurements. This study demonstrates that, irrespective of the physicochemical properties of the sediment and type of exposure (laboratory or fi...
- 18 November 2015
- Published by American Chemical Society (ACS) in Environmental Science & Technology
- Vol. 49 (24) , 14204-14212
Metal Fluxes from Porewaters and Labile Sediment Phases for Predicting Metal Exposure and Bioaccumulation in Benthic Invertebrates
The use of diffusive gradients in thin films (DGT) for predicting metal bioavailability was investigated by exposing the bivalve Tellina deltoidalis to an identical series of metal-contaminated sediments deployed simultaneously in the field and laboratory. To understand the differences in metal exposure occurring between laboratory- and field-based bioassays, we investigated changes in metal fluxes to DGT probes in sediments and in metal concentrations and partitioning to porewaters and overlying waters. DGT-metal fluxes (Cu, Pb, and Zn) were lower in the overlying waters of most field bioassays compared to the laboratory, causing differences in Pb and Zn bioaccumulation between bivalves exposed to laboratory and field conditions. Overall, DGT-metal fluxes provided predictions of metal bioaccumulation similar to those obtained using dilute-acid extractable metal measurements. This study demonstrates that, irrespective of the physicochemical properties of the sediment and type of exposure (laboratory or fi...
- 1 September 2015
- Published by Elsevier in Environmental Pollution
- Vol. 204, 48-57
The mismatch between bioaccumulation in field and laboratory environments: Interpreting the differences for metals in benthic bivalves
- 1 September 2015
- Published by Elsevier in Environmental Pollution
- Vol. 204, 48-57
The mismatch between bioaccumulation in field and laboratory environments: Interpreting the differences for metals in benthic bivalves
- 21 May 2014
- Published by Taylor & Francis in Chemistry and Ecology
- Vol. 30 (8) , 693-700
Determination of polychlorinated biphenyl and polycyclic aromatic hydrocarbon marine regional Sediment Quality Guidelines within the European Water Framework Directive
Marine regional Sediment Quality Guidelines (SQG) for polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH) from the Basque coast (SE Bay of Biscay) were determined, on the basis of sediment chemistry, toxicity and benthic community disturbance from analysis of 756 estuarine and coastal samples. The SQG were calculated using a percentile approach (based upon effect and non-effect data), using non-normalised and normalised concentration, by total organic carbon. However, normalisation by total organic carbon did not result in any improvement in accuracy compared with non-normalised values. Hence, this study proposes non-normalised SQG values for assessment of the chemical and physicochemical status in marine waters in the Basque Country, within the Water Framework Directive: 24.6–29 μg kg−1 for total PCBs; 164–285 μg kg−1 for low molecular weight PAH; 922–1537 μg kg−1 for high molecular weight PAH; and 1607–2617 μg kg−1 for total PAH.
- 21 May 2014
- Published by Taylor & Francis in Chemistry and Ecology
- Vol. 30 (8) , 693-700
Determination of polychlorinated biphenyl and polycyclic aromatic hydrocarbon marine regional Sediment Quality Guidelines within the European Water Framework Directive
Marine regional Sediment Quality Guidelines (SQG) for polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH) from the Basque coast (SE Bay of Biscay) were determined, on the basis of sediment chemistry, toxicity and benthic community disturbance from analysis of 756 estuarine and coastal samples. The SQG were calculated using a percentile approach (based upon effect and non-effect data), using non-normalised and normalised concentration, by total organic carbon. However, normalisation by total organic carbon did not result in any improvement in accuracy compared with non-normalised values. Hence, this study proposes non-normalised SQG values for assessment of the chemical and physicochemical status in marine waters in the Basque Country, within the Water Framework Directive: 24.6–29 μg kg−1 for total PCBs; 164–285 μg kg−1 for low molecular weight PAH; 922–1537 μg kg−1 for high molecular weight PAH; and 1607–2617 μg kg−1 for total PAH.
- 1 May 2012
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 185 (2) , 1305-1318
Integrative sediment assessment at Atlantic Spanish harbours by means of chemical and ecotoxicological tools
This study refers to the integrative assessment of sediment quality in three harbour areas at the Spanish Atlantic Coast: Vigo (Northwestern Spain), Bilbao and Pasajes (Northern Spain). At each site, two lines of evidence have been considered: chemical analyses (metal, PAH and PCB concentrations in sediments and ammonia concentration in bioassays) and toxicity tests (Microtox®, Corophium sp. marine amphipod and Paracentrotus lividus sea urchin larvae). Chemical and ecotoxicological results have been integrated by means of a tabular matrix and a multivariate factorial analysis (FA). Highly toxic samples have been characterised in Vigo and Pasajes harbours while Bilbao samples present toxicity levels ranging from non-toxic to moderately toxic. High toxicity is associated with high levels of contaminants whereas confounding factors (ammonia, organic matter and mud) have been identified to be the main cause of low to moderate toxicity. Based on the obtained results, it can be concluded that deriving potential toxicity of sediments based on comparison with Sediment Quality Guidelines (SQGs) is in agreement to toxicity results in areas presenting high levels of contaminants. However, at lower levels of toxicity (low to moderate), the mismatch between the potential toxicity (SQG approach) and the toxicity measured by bioassays is greater, as the former only accounts for chemical concentrations, without considering the interaction between contaminants and the effect of confounding factors. Contrarily, the multivariate analysis seems to be a robust tool for the integration and interpretation of different lines of evidence in areas affected by different sources of contamination.
- 1 May 2012
- Published by Springer Nature in Environmental Monitoring and Assessment
- Vol. 185 (2) , 1305-1318
Integrative sediment assessment at Atlantic Spanish harbours by means of chemical and ecotoxicological tools
This study refers to the integrative assessment of sediment quality in three harbour areas at the Spanish Atlantic Coast: Vigo (Northwestern Spain), Bilbao and Pasajes (Northern Spain). At each site, two lines of evidence have been considered: chemical analyses (metal, PAH and PCB concentrations in sediments and ammonia concentration in bioassays) and toxicity tests (Microtox®, Corophium sp. marine amphipod and Paracentrotus lividus sea urchin larvae). Chemical and ecotoxicological results have been integrated by means of a tabular matrix and a multivariate factorial analysis (FA). Highly toxic samples have been characterised in Vigo and Pasajes harbours while Bilbao samples present toxicity levels ranging from non-toxic to moderately toxic. High toxicity is associated with high levels of contaminants whereas confounding factors (ammonia, organic matter and mud) have been identified to be the main cause of low to moderate toxicity. Based on the obtained results, it can be concluded that deriving potential toxicity of sediments based on comparison with Sediment Quality Guidelines (SQGs) is in agreement to toxicity results in areas presenting high levels of contaminants. However, at lower levels of toxicity (low to moderate), the mismatch between the potential toxicity (SQG approach) and the toxicity measured by bioassays is greater, as the former only accounts for chemical concentrations, without considering the interaction between contaminants and the effect of confounding factors. Contrarily, the multivariate analysis seems to be a robust tool for the integration and interpretation of different lines of evidence in areas affected by different sources of contamination.