NNNenad Novkovski

Nenad Novkovski

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Nenad Novkovski has a total of 23 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Range of applications and modifications of the Terman method for the determination of the density of interface states

    by N Novkovski

    The presence of localised energy states at the semiconductor-dielectric interface (interface states, interface traps) presents a critical issue for nanoelectronics devices. Such states exert a significant influence on device performance by creating charge-trapping centres, elevating leakage currents, and decreasing carrier mobility within the channel near the interfaces. The main physical quantity characterising its amount is the interface state density, D it . Numerous experimental techniques for the characterisation of interface states have been developed, including capacitance–voltage ( C–V ) measurements (at high and low frequencies as well as quasi-static), conductance methods, deep-level transient spectroscopy, and charge pumping techniques. Each method offers distinct advantages in probing different energy regions within the bandgap and varying time scales of trap dynamics. Among the capacitance–voltage techniques, the Terman method is selected for this review. The method relies on a single measured high-frequency (typically 1 MHz) C–V curve, along with a theoretical curve derived from known analytical expressions. The expression for determining the interface state density from these two functions is also analytical, but the computation requires numerical differentiation because the experimental curve is only available in numerical form. The emphasis of the review is on the applications and adaptations of the Terman method, mainly during the past decade. One of the adaptations directions relies on numerical simulations instead of analytical expressions. Numerical simulation approaches are intended to replace standard methods, as shown with examples in this work. The benefits of numerical simulations lie in their ability to introduce complex device structures and new material systems. Although the foundational principles of the Terman method have long been set up, it continues to serve as a valuable and actively investigated approach for characterising interface properties across a broad range of contemporary semiconductor materials and devices, while considering the expected limitations of the method.

  • Open Access

    Tauc plot refined

    by Nenad Novkovski

    The Tauc plot is a well-known method for determining the bandgap of amorphous and crystalline semiconductors, using the measured absorption coefficient. The common Tauc plot method remains a widely used and effective approach for estimating the bandgap of diverse materials, thus exhibiting that it is a versatile tool in studying material properties. When experimental misapplications, such as inappropriate spectral range selection, are properly addressed, an accuracy on the order of ±50 meV can be achieved. Furthermore, the refined Tauc plot methods, incorporating improved data preprocessing and fitting strategies, enable even greater precision in bandgap determination, alongside a larger set of extracted parameters.


  • Solar Radiation: Driving Atmospheric Change

    by Vlado Spiridonov, Mladjen Ćurić, Nenad Novkovski


  • Open Access

    Review of: "Negative Capacitance Effect at the Interface Between Si Wafers with Undulating Surfaces"

    by Nenad Novkovski

    An attractive title is not justified by the content of the paper. Neither experiment is done correctly, nor does the analysis provide a sound physical explanation of the indicated effect (negative capacitance). First, a capacitor structure with a hi...

  • Open Access

    Electrospun PEO/rGO Scaffolds: The Influence of the Concentration of rGO on Overall Properties and Cytotoxicity

    by Aleksandra Ivanoska-Dacikj, Petre Makreski, Nikola Geskovski, Joanna Karbowniczek, Urszula Stachewicz, Nenad Novkovski, Jelena Tanasić, Ivan Ristić, Gordana Bogoeva-Gaceva

    Reduced graphene oxide (rGO) is one of the graphene derivatives that can be employed to engineer bioactive and/or electroactive scaffolds. However, the influence of its low and especially high concentrations on scaffolds’ overall properties and cytotoxicity has yet to be explored. In this study, polyethylene oxide (PEO)-based scaffolds containing from 0.1 to 20 wt% rGO were obtained by electrospinning. Morphological, thermal and electrical properties of the scaffolds were characterized by SEM, Raman spectroscopy, XRD, DSC and electrical measurements. The diameter of the fibers decreased from 0.52 to 0.19 µm as the concentration of rGO increased from 0.1 wt% to 20 wt%. The presence of rGO above the percolation threshold (5.7 wt%) resulted in a significantly reduced electrical resistivity of the scaffolds. XRD and Raman analysis revealed delamination of the graphene layers (interlayer spacing increased from 0.36 nm to 0.40–0.41 nm), and exfoliation of rGO was detected for the samples with an rGO concentration lower than 1 wt%. In addition, an evident trend of increasing cell viability as a function of the rGO concentration was evidenced. The obtained results can serve as further guidance for the judicious selection of the rGO content incorporated into the PEO matrix for constructing electroactive scaffolds.


  • Refined analysis of C–V and I–V characteristics of Al/dielectric/Si structures containing nanosized Ta 2 O 5 /SiO x N y dielectric stack

    by Nenad Novkovski

    In this work we carry out a refined analysis of the C–V and I–V characteristics of Al/Ta 2 O 5 /SiO x N y /Si structures at limited voltages (from −3.0 V to +1.0 V). The modified Terman method was used to determine the interface state densities over the silicon bandgap, and an extended comprehensive model was utilised to determine the I–V characteristics of metal/high-κ/SiO 2 /Si structures. A sharp peak in interface states distribution is observed at around 0.1 eV above the valence band top; its presence is identified as the origin of the double-knee shaped C–V characteristics. The substantial contribution of the Schottky effect was observed in the leakage currents at low voltages.


  • Open Access

    Analysis of Conduction and Charging Mechanisms in Atomic Layer Deposited Multilayered HfO2/Al2O3 Stacks for Use in Charge Trapping Flash Memories

    by Nenad Novkovski, Albena Paskaleva, Aleksandar Skeparovski, Dencho Spassov

    Method for characterization of electrical and trapping properties of multilayered high permittivity stacks for use in charge trapping flash memories is proposed. Application of the method to the case of multilayered HfO2/Al2O3 stacks is presented. By applying our previously developed comprehensive model for MOS structures containing high-κ dielectrics on the J-V characteristics measured in the voltage range without marked degradation and charge trapping (from −3 V to +3 V), several parameters of the structure connected to the interfacial layer and the conduction mechanisms have been extracted. We found that the above analysis gives precise information on the main characteristics and the quality of the injection layer. C-V characteristics of stressed (with write and erase pulses) structures recorded in a limited range of voltages between −1 V and +1 V (where neither significant charge trapping nor visible degradation of the structures is expected to occur) were used in order to provide measures of the effect of stresses with no influence of the measurement process. Both trapped charge and the distribution of interface states have been determined using modified Terman method for fresh structures and for structures stressed with write and erase cycles. The proposed method allows determination of charge trapping and interface state with high resolution, promising a precise characterization of multilayered high permittivity stacks for use in charge trapping flash memories.


  • Open Access

    Modification of the Terman method for determination of interface states in metal–insulator–semiconductor structures

    by Nenad Novkovski

    In this work a modification of Terman method for determination of interfacial energy states located in the forbidden energy gap of the semiconductor (interface states) convenient for application in metal-high-κ-Si structures is proposed and explained in details. It has been found that usually observed presence of tails in the distribution of interface states towards the band edges is an artifact due to the method of determination of interface state densities. While excluding the contribution of quantum charge in semiconductor close to the interface with dielectric, these tails in the distribution disappear. Simple efficient method for determination of total density of interface states over the silicon bandgap is proposed.