DCDouglas John Cleaver

Douglas John Cleaver

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Douglas John Cleaver has a total of 80 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Ultraconfined oblate hard particles between hybrid penetrable walls

    by C. Anquetil-Deck, D. J. Cleaver, P. I. C. Teixeira

    We have investigated, by Monte Carlo simulation, the orientational structure of very thin films of a discotic liquid crystal (DLC) confined between hybrid walls of controllable penetrability, as a function of wall separation Lz. Our purpose was to clarify whether, as predicted by continuum theory, the preferred orientation of the DLC is uniform, changes linearly, or changes discontinuously, when Lz and the anchoring strengths at either wall are changed. The model consists of oblate hard Gaussian overlap (HGO) particles: each wall sees a particle as a disk of zero thickness and diameter D less than or equal to that of the actual particle σ0, embedded inside the particle and located halfway along, and perpendicular to, its minor axis. This provides a particle-level mechanism to control the anchoring properties of the walls, from planar (edge-on) for D∼0 to homeotropic (face-on) for D∼σ0, which can be done independently at either wall. As in our earlier work [C. Anquetil-Deck et al., J. Phys. Chem. B 124, 7709 (2020)], which was restricted to Lz=6σ0, depending on the values of Ds≡D/σ0 at the top (Dst) and bottom (Dsb) walls, we find domains in (Dsb,Dst) space in which particle alignment is uniform planar (UP), uniform homeotropic (UH), or varies linearly from planar at one wall to homeotropic at the other (L), but no bistable or tristable regions are identified between these domains. Most importantly, there appears never to occur an abrupt change of the LC orientation when the walls strongly favor different anchorings, in general agreement with the scenario proposed by Velasco and co-workers [D. de las Heras et al., Phys. Rev. E 79, 011712 (2009)], but in contrast to the behavior of equivalent calamitic systems [F. Barmes et al., Phys. Rev. E 69, 061705 (2004); Phys. Rev. E, 71, 021705 (2005); C. Anquetil-Deck et al., Phys. Rev. E 86, 041707 (2012)]. However, for the thinnest films investigated (Lz=2σ0), the system is unable to accommodate a rotation of the preferred particle orientation from one wall to the other and adopts instead a tilted configuration, similar to that reported earlier for Gay-Berne films in symmetric confinement [T. Gruhn et al., Thin Solid Films 330, 46 (1998); Mol. Phys. 93, 681 (1998)] but which, as far as we know, has been missed in most earlier work.


  • Open Access

    Understanding and controlling the glass transition of HTPB oligomers

    by Eleftheria Dossi, Jacob Earnshaw, Laurence Ellison, Gabriella Rabello dos Santos, Hamish Cavaye, Douglas John Cleaver

    In this paper, we use a combination of experiment and simulation to achieve enhanced levels of synthetic control on the microstructure of the much-used binder material hydroxyl terminated polybutadiene (HTPB).


  • Ordering of oblate hard particles between symmetric penetrable walls

    by P. I. C. Teixeira, C. Anquetil-Deck, D. J. Cleaver

    We find the structure of a model discotic liquid crystal (DLC) confined between symmetric walls of controllable penetrability. The model consists of oblate hard Gaussian overlap (HGO) particles. Particle-substrate interactions are modelled as follows: each substrate sees a particle as a disc of zero thickness and diameter D less than or equal to that of the actual particle, σ0, embedded inside the particle and located halfway along, and perpendicular to, its minor axis. This allows us to control the anchoring properties of the substrates, from planar (edge-on) for D∼0 to homeotropic (face-on) for D∼σ0. This system is investigated using both Monte Carlo simulation and density-functional theory, the latter implemented at the level of Onsager’s second-virial approximation with Parsons-Lee rescaling. We find that the agreement between theory and simulation is substantially less good than for prolate HGOs; in particular, the crossover from edge-on to face-on alignment is predicted by theory to occur at D∼0.65σ0, but simulation finds it for D∼0.55σ0. These discrepancies are likely a consequence of the fact that Onsager’s theory is less accurate for discs than for rods. We quantify this by computing the bulk isotropic-nematic phase diagram of oblate HGOs. GRAPHICAL ABSTRACT


  • Open Access

    Ordering of Oblate Hard Particles between Hybrid Penetrable Walls

    by Candy Anquetil-Deck, Douglas J. Cleaver, Paulo Ivo C. Teixeira

    We report a Monte Carlo (MC) simulation study of a model discotic liquid crystal (DLC) confined between hybrid walls of controllable penetrability. The model consists of oblate hard Gaussian overlap (HGO) particles. Particle-substrate interactions are modelled as follows: each substrate sees a particle as a disc of zero thickness and diameter D less than or equal to that of the actual particle, σ0, embedded inside the particle and located halfway along, and perpendicular to, its minor axis. This allows us to control the anchoring properties of the substrates, from planar (edge-on) for D∼ 0 to homeotropic (face-on) for D∼σ0 which can be done independently at either substrate. Depending on the values of Ds≡ D/σ0 at the top (Dst) and bottom (Dsb) substrates, we find domains in (Dsb,Dst) space in which particle alignment is uniform planar (UP), uniform homeotropic (UH), or varies linearly from planar at one substrate to homeotropic at the other (Lin). These domains are separated by regions of bistability (P-Lin and H-Lin) which appear to be wider than for prolate HGOs, and there may be also a small tristable (P-H-Lin) region. Results are compared with the predictions of density-functional theory, implemented at the level of Onsager’s second-virial approximation with Parsons-Lee rescaling. As in the case of symmetric confinement investigated previously, the agreement between theory and simulation is substantially less good than for prolate HGOs: in particular, for the investigated substrate separation L=6σ0, the Lin configuration is never predicted. These discrepancies are likely a consequence of the fact that Onsager's theory is less accurate for discs than for rods.


  • Self-assembly and entropic effects in pear-shaped colloid systems. I. Shape sensitivity of bilayer phases in colloidal pear-shaped particle systems

    by Philipp W. A. Schönhöfer, Matthieu Marechal, Douglas J. Cleaver, Gerd E. Schröder-Turk

    The role of particle shape in self-assembly processes is a double-edged sword. On the one hand, particle shape and particle elongation are often considered the most fundamental determinants of soft matter structure formation. On the other hand, structure formation is often highly sensitive to details of shape. Here, we address the question of particle shape sensitivity for the self-assembly of hard pear-shaped particles by studying two models for this system: (a) the pear hard Gaussian overlap (PHGO) and (b) the hard pears of revolution (HPR) model. Hard pear-shaped particles, given by the PHGO model, are known to form a bicontinuous gyroid phase spontaneously. However, this model does not replicate an additive object perfectly and, hence, varies slightly in shape from a “true” pear-shape. Therefore, we investigate in the first part of this series the stability of the gyroid phase in pear-shaped particle systems. We show, based on the HPR phase diagram, that the gyroid phase does not form in pears with such a “true” hard pear-shaped potential. Moreover, we acquire first indications from the HPR and PHGO pair-correlation functions that the formation of the gyroid is probably attributed to the small non-additive properties of the PHGO potential.


  • Self-assembly and entropic effects in pear-shaped colloid systems. II. Depletion attraction of pear-shaped particles in a hard-sphere solvent

    by Philipp W. A. Schönhöfer, Matthieu Marechal, Douglas J. Cleaver, Gerd E. Schröder-Turk

    We consider depletion effects of a pear-shaped colloidal particle in a hard-sphere solvent for two different model realizations of the pear-shaped colloidal particle. The two models are the pear hard Gaussian overlap (PHGO) particles and the hard pears of revolution (HPR). The motivation for this study is to provide a microscopic understanding for the substantially different mesoscopic self-assembly properties of these pear-shaped colloids, in dense suspensions, that have been reported in the previous studies. This is done by determining their differing depletion attractions via Monte Carlo simulations of PHGO and HPR particles in a pool of hard spheres and comparing them with excluded volume calculations of numerically obtained ideal configurations on the microscopic level. While the HPR model behaves as predicted by the analysis of excluded volumes, the PHGO model showcases a preference for splay between neighboring particles, which can be attributed to the special non-additive characteristics of the PHGO contact function. Lastly, we propose a potentially experimentally realizable pear-shaped particle model, the non-additive hard pear of revolution model, which is based on the HPR model but also features non-additive traits similar to those of PHGO particles to mimic their depletion behavior.


  • Open Access

    Programming emergent symmetries with saddle-splay elasticity

    by Yu Xia, Andrew A. DeBenedictis, Dae Seok Kim, Shenglan Chen, Se-Um Kim, Douglas J. Cleaver, Timothy J. Atherton, Shu Yang

    The director field adopted by a confined liquid crystal is controlled by a balance between the externally imposed interactions and the liquid’s internal orientational elasticity. While the latter is usually considered to resist all deformations, liquid crystals actually have an intrinsic propensity to adopt saddle-splay arrangements, characterised by the elastic constant $${K}_{24}$$ K 24 . In most realisations, dominant surface anchoring treatments suppress such deformations, rendering $${K}_{24}$$ K 24 immeasurable. Here we identify regimes where more subtle, patterned surfaces enable saddle-splay effects to be both observed and exploited. Utilising theory and continuum calculations, we determine experimental regimes where generic, achiral liquid crystals exhibit spontaneously broken surface symmetries. These provide a new route to measuring $${K}_{24}$$ K 24 . We further demonstrate a multistable device in which weak, but directional, fields switch between saddle-splay-motivated, spontaneously-polar surface states. Generalising beyond simple confinement, our highly scalable approach offers exciting opportunities for low-field, fast-switching optoelectronic devices which go beyond current technologies.


  • Double diamond phase in pear-shaped nanoparticle systems with hard sphere solvent

    by Philipp W A Schönhöfer, Douglas J Cleaver, Gerd E Schröder-Turk

    The mechanisms behind the formation of bicontinuous nanogeometries, in particular in vivo , remain intriguing. Of particular interest are the many systems where more than one type or symmetry occurs, such as the Schwarz’ diamond surface and Schoen’s gyroid surface; a current example are the butterfly nanostructures often based on the gyroid, and the beetle nanostructures often based on the diamond surface. Here, we present a computational study of self-assembly of the bicontinuous Pn m diamond phase in an equilibrium ensemble of pear-shaped particles when a small amount of a hard-sphere ‘solvent’ is added. Our results are based on previous work that showed the emergence of the gyroid Ia d phase in a pure system of pear-shaped particles (Schönhöfer et al 2017 Interface Focus 7 20160161), in which the pear-shaped particles form an interdigitating bilayer reminiscent of a warped smectic structure. We here show that the addition of a small amount of hard spherical particles tends to drive the system towards the bicontinuous Pn m double diamond phase, based on Schwarz diamond minimal surface. This result is consistent with the higher degree of spatial heterogeneity of the diamond minimal surface as compared to the gyroid minimal surface, with the hard-sphere ‘solvent’ acting as an agent to relieve packing frustration. However, the mechanism by which this relief is achieved is contrary to the corresponding mechanism in copolymeric systems; the spherical solvent tends to aggregate within the matrix phase, near the minimal surface, rather than within the labyrinthine channels. While it may relate to the specific form of the potential used to approximate the particle shape, this mechanism hints at an alternative way for particle systems to both release packing frustration and satisfy geometrical restrictions in double diamond configurations. Interestingly, the lattice parameters of the gyroid and the diamond phase appear to be commensurate with those of the isometric Bonnet transform.


  • Open Access

    Self-assembly of twisted, multi-sheet aggregates

    by Alireza Dastan, Elisabetta A. Matsumoto, William J. Frith, Douglas J. Cleaver

    Hierarchical self-assembly underpins much of the diversity of form and function seen in soft systems, yet the pathways by which they achieve their final form are not always straightforward – intermediate steps, kinetic effects and finite sizes of aggregates all influence the self-assembly pathways of these systems. In this paper, we use molecular dynamics simulations of binary mixtures of spheres and ellipsoidal discs to investigate the self-assembly of anisotropic aggregates with internal structures. Through this, the full aggregation pathways of spontaneously chiral, multi-bilayer and multi-layer assemblies have been tracked and characterised via a semi-qualitative analysis. This includes the unambiguous identification of first-, second- and third-generation hierarchical assemblies within a single simulation. Given the significant challenge of tracking full aggregation pathways in experimental systems, our findings strongly support the notion that molecular simulation has much to contribute to improving our understanding of hierarchical self-assembling systems. GRAPHICAL ABSTRACT


  • Thermal Hysteresis and Seeding of Twisted Fibers Formed by Achiral Discotic Particles

    by Alireza Dastan, William J. Frith, Douglas J. Cleaver

    In this paper, molecular dynamics simulations of simple disc-shaped particles are used to investigate the free self-assembly of defect-free fibers. Depending on the choice of particle shape and interaction strength, the formed fibers are reproducibly either straight or, for reasons of packing efficiency, spontaneously chiral. As they grow radially, increasing stresses cause chiral fibers to untwist either continuously or via morphological rearrangement. It is also found that, due to the kinetics of fiber initiation, the isotropic solution has to be significantly supercooled before aggregation takes place. As a result, the thermal hysteresis of one formed fiber extends to 13.9% of the formation temperature. In the presence of a three-thread seed cluster of 15 particles, however, monotonic fiber growth is observed 9.3% above the normal formation temperature. Thus, as in many experimental systems, it is the kinetic pathway, rather than the thermodynamic stability of the final assembly, that dominates the observed behavior.