Sandro Santucci

A significant resonant tunneling effect has been observed under the 2.4 V junction threshold in a large area, carbon nanotube–silicon (CNT–Si) heterojunction obtained by growing a continuous layer of multiwall carbon nanotubes on an n-doped silicon substrate. The multiwall carbon nanostructures were grown by a chemical vapor deposition (CVD) technique on a 60 nm thick, silicon nitride layer, deposited on an n-type Si substrate. The heterojunction characteristics were intensively studied on different substrates, resulting in high photoresponsivity with a large reverse photocurrent plateau. In this paper, we report on the photoresponsivity characteristics of the device, the heterojunction threshold and the tunnel-like effect observed as a function of applied voltage and excitation wavelength. The experiments are performed in the near-ultraviolet to near-infrared wavelength range. The high conversion efficiency of light radiation into photoelectrons observed with the presented layout allows the device to be used as a large area photodetector with very low, intrinsic dark current and noise.

A significant resonant tunneling effect has been observed under the 2.4 V junction threshold in a large area, carbon nanotube–silicon (CNT–Si) heterojunction obtained by growing a continuous layer of multiwall carbon nanotubes on an n-doped silicon substrate. The multiwall carbon nanostructures were grown by a chemical vapor deposition (CVD) technique on a 60 nm thick, silicon nitride layer, deposited on an n-type Si substrate. The heterojunction characteristics were intensively studied on different substrates, resulting in high photoresponsivity with a large reverse photocurrent plateau. In this paper, we report on the photoresponsivity characteristics of the device, the heterojunction threshold and the tunnel-like effect observed as a function of applied voltage and excitation wavelength. The experiments are performed in the near-ultraviolet to near-infrared wavelength range. The high conversion efficiency of light radiation into photoelectrons observed with the presented layout allows the device to be used as a large area photodetector with very low, intrinsic dark current and noise.

Novel polystyrene‐based molecularly imprinted polymer nanofibers were synthesized through the electrospinning technique. The molecularly imprinted polymers were prepared using a non‐covalent approach and atrazine as template. For comparison, nonimprinted polymer nanofibers were also synthesized. The morphology of the synthesized nanofibers was characterized using scanning electron microscopy. The adsorption of pesticides, atrazine, atrazine desisopropyl, atraton, carboxin, linuron, and chlorpyrifos was studied under equilibrium (batch) conditions. To describe the adsorption capability of the synthesized polymers, Langmuir and Freundlich models were used. The Freundlich model provided a better mathematical approximation of the sorption characteristic for polymers nanofibers. To evaluate the adsorption capacity in the presence of interferents experiments on river water samples spiked with a mixture of six pesticides were also performed. The results obtained for the highest concentration levels investigated, show a greater amount of pesticide adsorbed on molecularly imprinted polymers and non‐imprinted polymers compared to those obtained using commercial stationary phases used as reference.

This study was carried out by varying both graphene oxide (GO) concentration (10 μg/mL, 50 μg/mL, 100 μg/mL) and flakes sizes of 1320 nm and 130 nm. Characterization by scanning electron microscopy and Raman spectroscopy demonstrate that the area of GO flakes varies of one order of magnitude but their chemical structure remains unmodified. A 24-h cytotoxicity test showed, for A549, a loss in the viability, while the test exhibits overall a positive increase in the viability for CaCo2 and Vero. A 24-h comet assay shows a marked GO genotoxicity: for micrometer-sized GO flakes the genotoxicity is in positive correlation with the concentration, while for nanometer-sized GO flakes there was a high degree of genotoxicity at the lowest concentration tested.

The attention on CeO₂-NPs environmental andin vivoeffects is due to their presence in diesel exhaust and in diesel filters that release a more water-soluble form of ceria NPs, as well as to their use for medical applications. In this work, acute and subacutein vivotoxicity assays demonstrate no lethal effect of these NPs. Anyhow, performingin vivoevaluations on CD-1 mouse systems, we demonstrate that it is even not correct to assert that ceria NPs are harmless for living systems as they can induce status of inflammation, revealed by hematological-chemical-clinical assays as well as histological and TEM microscope observations. TEM analysis showed the presence of NPs in alveolar macrophages. Histological evaluation demonstrated the NPs presence in lungs tissues and this can be explained by assuming their ability to go into the blood stream and lately into the organs (generating inflammation).

Nanomanipulation of matter to create responsive, ordered materials still remains extremely challenging. Supramolecular chemistry has inspired new strategies by which such nanomaterials can be synthesized step by step by exploiting the self-recognition properties of molecules. In this work, the ring-shaped architecture of the 2-Cys peroxiredoxin I protein from Schistosoma mansoni, engineered to have metal ion-binding sites, is used as a template to build up 1D nanoscopic structures through metal-induced self-assembly. Chromatographic and microscopic analyses demonstrate the ability of the protein rings to stack directionally upon interaction with divalent metal ions and form well-defined nanotubes by exploiting the intrinsic recognition properties of the ring surfaces. Taking advantage of such behavior, the rings are then used to capture colloidal Ni²⁺-functionalized ultrasmall gold nanoparticles and arrange them into 1D arrays through stacking into peapod-like complexes. Finally, as the formation of such nano-peapods strictly depends on nanoparticle dimensions, the peroxiredoxin template is used as a colloidal cut-off device to sort by size the encapsulated nanoparticles. These results open up possibilities in developing Prx-based methods to synthesize new advanced functional materials.

Cerium oxide nanoparticles, nanoceria, have been proposed as drug delivery devices and therapeutic tools also for neurological diseases due to their antioxidant properties and neuroprotective effects. However, very little evidence has been hitherto obtained on the passage of nanoceria across the blood-brain barrier in vivo. Distribution of in-house synthesized 10 nm nanoceria in spleen, liver, lung, kidney and brain was here examined at 24 h after a single iv injection of a nanoceria suspension at two concentrations (1 or 20 mg/kg). The use of fluorescein isothiocyanate-conjugated nanoceria allowed their visualization in confocal microscopy. The investigation was also pursued with inductively coupled plasma-mass spectrometry and with transmission and scanning electron microscopy. Consistently with previous investigations, these approaches pointed to accumulation of the largest amount of nanoceria in the liver and spleen, with deposition also in the kidney and lung, and no signs of overt pathology of these tissues. In the brain, confocal microscopy revealed penetration of fluorescent nanoceria into the parenchyma, albeit in limited amount, and astrocytic activation. Occurrence of electron-dense nanoceria-like particles in the cerebral cortex, sparse or in agglomerates, was confirmed by the ultrastructural study. The present findings contribute novel knowledge by showing nanoceria entry into the brain parenchyma.