Alexey A. Morozov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Alexey A. Morozov has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Vladimir A. Titarev
Federal Research Center “Computer Science and Control” of the Russian Academy of Sciences 2 , Vavilova str. 44/2, Moscow 119333
8 shared publications A. K. Rebrov
Kutateladze Institute of Thermophysics of Russian Academy of Sciences, 630090 Novosibirsk, Lavrentiev prosp. 1., Russia
5 shared publications- Mikhail Yu. Plotnikov
Kutateladze Institute of Thermophysics SB RAS, Novosibirsk, Russia
5 shared publications - Alexander V. Bulgakov
FZU—Institute of Physics of the Czech Academy of Sciences
3 shared publications - Elizaveta Ya. Gatapova
Kutateladze Institute of Thermophysics, Siberian Branch, Russian Academy of Sciences, Novosibirsk, Russia
3 shared publications A. V. Shishkin
Russian Academy of Sciences
2 shared publications
Latest Publications
- 19 September 2026
- Published by Elsevier in Journal of Computational Physics
- Vol. 568
Modeling of particle initiation at the boundary in the DSMC method: the Poisson distribution contribution
- 19 September 2026
- Published by Elsevier in Journal of Computational Physics
- Vol. 568
Modeling of particle initiation at the boundary in the DSMC method: the Poisson distribution contribution
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
Kinetic modeling of pulsed laser evaporation into vacuum: Calculation of the collisional region size for time-of-flight distribution analysis
Theoretical analysis of time-of-flight distributions during pulsed laser ablation in vacuum is based on the assumption of an almost spherical collisionless expansion, which is violated when measuring distributions near the evaporation surface. To determine when this condition is satisfied, it is important to know the size of the collisional expansion region. The solution to the problem of neutral gas expansion under pulsed evaporation into vacuum in the axisymmetric formulation with the determination of the transition to the collisionless expansion has been obtained by using two independent kinetic approaches: the direct simulation Monte Carlo (DSMC) method and the solution of the Bhatnagar–Gross–Krook model equation. A comparison of the results of these two kinetic approaches reveals a difference in the number of collisions per particle by 12%–25%. The size of the collisional region as a function of the number of evaporated monolayers was determined based on collision number analysis and the ballistic/collision flow decomposition approach in the DSMC method. The obtained data are used for the analysis of experimental time-of-flight distributions in pulsed laser ablation of copper in vacuum.
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
Kinetic modeling of pulsed laser evaporation into vacuum: Calculation of the collisional region size for time-of-flight distribution analysis
Theoretical analysis of time-of-flight distributions during pulsed laser ablation in vacuum is based on the assumption of an almost spherical collisionless expansion, which is violated when measuring distributions near the evaporation surface. To determine when this condition is satisfied, it is important to know the size of the collisional expansion region. The solution to the problem of neutral gas expansion under pulsed evaporation into vacuum in the axisymmetric formulation with the determination of the transition to the collisionless expansion has been obtained by using two independent kinetic approaches: the direct simulation Monte Carlo (DSMC) method and the solution of the Bhatnagar–Gross–Krook model equation. A comparison of the results of these two kinetic approaches reveals a difference in the number of collisions per particle by 12%–25%. The size of the collisional region as a function of the number of evaporated monolayers was determined based on collision number analysis and the ballistic/collision flow decomposition approach in the DSMC method. The obtained data are used for the analysis of experimental time-of-flight distributions in pulsed laser ablation of copper in vacuum.
- 28 March 2025
- Published by Elsevier in Applied Surface Science
- Vol. 698
Adhesion layer free room-temperature pulsed laser deposition of ultrathin Au films
- 28 March 2025
- Published by Elsevier in Applied Surface Science
- Vol. 698
Adhesion layer free room-temperature pulsed laser deposition of ultrathin Au films
- 1 November 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (11)
Kinetic study of time-of-flight distributions during pulsed laser evaporation into vacuum
A numerical study of the dynamics of gas expansion into vacuum during nanosecond laser evaporation out based on the analysis of time-of-flight distributions of neutral particles along the normal to the evaporation surface has been carried out. The solution to the problem in the axisymmetric formulation is obtained by using two independent kinetic approaches: the direct simulation Monte Carlo method and the solution of the Bhatnagar–Gross–Krook model equation. The particle velocity distribution on the time-of-flight detector was analyzed. For a correct description of the experimental data with good accuracy, the optimal value of the velocity cone angle, which determines the fraction of particles arriving at the detector, is determined. It is shown that at intensive evaporation, the number of low-velocity molecules arriving at the detector increases with increasing size of the evaporation spot, which leads to a decrease in the average particle energy. Reliable data on the dependence of the particle energy at the time-of-flight detector on the number of evaporated monolayers and the size of the evaporation spot have been obtained. Good agreement with calculations of other authors and known experimental data is shown.
- 1 November 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (11)
Kinetic study of time-of-flight distributions during pulsed laser evaporation into vacuum
A numerical study of the dynamics of gas expansion into vacuum during nanosecond laser evaporation out based on the analysis of time-of-flight distributions of neutral particles along the normal to the evaporation surface has been carried out. The solution to the problem in the axisymmetric formulation is obtained by using two independent kinetic approaches: the direct simulation Monte Carlo method and the solution of the Bhatnagar–Gross–Krook model equation. The particle velocity distribution on the time-of-flight detector was analyzed. For a correct description of the experimental data with good accuracy, the optimal value of the velocity cone angle, which determines the fraction of particles arriving at the detector, is determined. It is shown that at intensive evaporation, the number of low-velocity molecules arriving at the detector increases with increasing size of the evaporation spot, which leads to a decrease in the average particle energy. Reliable data on the dependence of the particle energy at the time-of-flight detector on the number of evaporated monolayers and the size of the evaporation spot have been obtained. Good agreement with calculations of other authors and known experimental data is shown.
- 1 June 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (6)
Evaporation into half-space: Kinetic simulation of Knudsen layer for monatomic gas
Tools for modeling phase change processes in confined spaces are necessary to estimate heat and mass fluxes impacted by micro-level effects. We develop and validate numerical models for the simulation of evaporation processes using the direct simulation Monte Carlo method and the S-model kinetic equation. The numerical results are compared with previous results obtained by Sone and Sugimoto using the Boltzmann–Krook–Welander kinetic equation. The method of moments for the solution of the Boltzmann equation is also applied. The profiles of macroscopic parameters in the Knudsen layer are analyzed in detail. A very good agreement among the results given by all the applied models is found for a Mach number up to 1. As the considered approaches differ only in the collision laws, the evaporation parameters (temperature, pressure ratios, and the evaporation rate) seem relatively insensitive to the collision law models. The analytical solutions for the marcoscopic profiles (temperature, velocity, density, and pressure) are in good agreement with the numerical results. Possible criteria for Knudsen layer thickness estimation are suggested and tested. The provided results could be used as reference data to test evaporation models.
- 1 June 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (6)
Evaporation into half-space: Kinetic simulation of Knudsen layer for monatomic gas
Tools for modeling phase change processes in confined spaces are necessary to estimate heat and mass fluxes impacted by micro-level effects. We develop and validate numerical models for the simulation of evaporation processes using the direct simulation Monte Carlo method and the S-model kinetic equation. The numerical results are compared with previous results obtained by Sone and Sugimoto using the Boltzmann–Krook–Welander kinetic equation. The method of moments for the solution of the Boltzmann equation is also applied. The profiles of macroscopic parameters in the Knudsen layer are analyzed in detail. A very good agreement among the results given by all the applied models is found for a Mach number up to 1. As the considered approaches differ only in the collision laws, the evaporation parameters (temperature, pressure ratios, and the evaporation rate) seem relatively insensitive to the collision law models. The analytical solutions for the marcoscopic profiles (temperature, velocity, density, and pressure) are in good agreement with the numerical results. Possible criteria for Knudsen layer thickness estimation are suggested and tested. The provided results could be used as reference data to test evaporation models.
- Open Access
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2996 (1)
Efficient numerical method for model kinetic equations as applied to pulsed laser ablation into vacuum
The paper is devoted to the construction of the efficient numerical methods to solve model kinetic equations as applied to the pulsed laser ablation (evaporatio
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2996 (1)
Open AccessEfficient numerical method for model kinetic equations as applied to pulsed laser ablation into vacuum
The paper is devoted to the construction of the efficient numerical methods to solve model kinetic equations as applied to the pulsed laser ablation (evaporatio
- Open Access
- 4 December 2023
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 459, 08006
Kinetic approach to the analysis of the flow around a levitating microdroplet
Two-dimensional direct Monte Carlo simulation of the flow around an evaporating water microdroplet in the air atmosphere above a dry or liquid surface has been carried out. We consider a cylindrical droplet 1 μm in diameter at a distance of 1 μm above the surface. The temperature of the droplet is taken equal to 65°C and 80°C. A significant decrease in the air concentration between the droplet and the liquid film surface is observed. The features of water vapor flow separately from the droplet surface and from the liquid film surface are considered. It is shown that, under certain conditions, condensation on the lower side and evaporation on the upper side on the droplet can occur simultaneously.
- 4 December 2023
- Published by EDP Sciences in E3S Web of Conferences
- Vol. 459, 08006
Open AccessKinetic approach to the analysis of the flow around a levitating microdroplet
Two-dimensional direct Monte Carlo simulation of the flow around an evaporating water microdroplet in the air atmosphere above a dry or liquid surface has been carried out. We consider a cylindrical droplet 1 μm in diameter at a distance of 1 μm above the surface. The temperature of the droplet is taken equal to 65°C and 80°C. A significant decrease in the air concentration between the droplet and the liquid film surface is observed. The features of water vapor flow separately from the droplet surface and from the liquid film surface are considered. It is shown that, under certain conditions, condensation on the lower side and evaporation on the upper side on the droplet can occur simultaneously.
- 1 December 2023
- Published by The Russian Academy of Sciences in Žurnal vyčislitelʹnoj matematiki i matematičeskoj fiziki
- Vol. 63 (12) , 1960-1972
Evolution of the Shape of a Gas Cloud during Pulsed Laser Evaporation into Vacuum: Direct Simulation Monte Carlo and the Solution of a Model Equation
The dynamics of gas expansion during nanosecond laser evaporation into vacuum is studied. The problem is considered in an axisymmetric formulation for a wide range of parameters: the number of evaporated monolayers and the size of the evaporation spot. To obtain a reliable numerical solution, two different kinetic approaches are used—the direct simulation Monte Carlo method and solution of the BGK model kinetic equation. The change in the shape of the cloud of evaporated substance during the expansion process is analyzed. The strong influence of the degree of rarefaction on the shape of the forming cloud is shown. When a large number of monolayers evaporate, good agreement with the continuum solution is observed.
- 1 December 2023
- Published by The Russian Academy of Sciences in Žurnal vyčislitelʹnoj matematiki i matematičeskoj fiziki
- Vol. 63 (12) , 1960-1972
Evolution of the Shape of a Gas Cloud during Pulsed Laser Evaporation into Vacuum: Direct Simulation Monte Carlo and the Solution of a Model Equation
The dynamics of gas expansion during nanosecond laser evaporation into vacuum is studied. The problem is considered in an axisymmetric formulation for a wide range of parameters: the number of evaporated monolayers and the size of the evaporation spot. To obtain a reliable numerical solution, two different kinetic approaches are used—the direct simulation Monte Carlo method and solution of the BGK model kinetic equation. The change in the shape of the cloud of evaporated substance during the expansion process is analyzed. The strong influence of the degree of rarefaction on the shape of the forming cloud is shown. When a large number of monolayers evaporate, good agreement with the continuum solution is observed.
- 1 December 2023
- Published by Pleiades Publishing Ltd in Computational Mathematics and Mathematical Physics
- Vol. 63 (12) , 2244-2256
Evolution of the Shape of a Gas Cloud during Pulsed Laser Evaporation into Vacuum: Direct Simulation Monte Carlo and the Solution of a Model Equation
The dynamics of gas expansion during nanosecond laser evaporation into vacuum is studied. The problem is considered in an axisymmetric formulation for a wide range of parameters: the number of evaporated monolayers and the size of the evaporation spot. To obtain a reliable numerical solution, two different kinetic approaches are used—the direct simulation Monte Carlo method and solution of the BGK model kinetic equation. The change in the shape of the cloud of evaporated substance during the expansion process is analyzed. The strong influence of the degree of rarefaction on the shape of the forming cloud is shown. When a large number of monolayers evaporate, good agreement with the continuum solution is observed.
- 1 December 2023
- Published by Pleiades Publishing Ltd in Computational Mathematics and Mathematical Physics
- Vol. 63 (12) , 2244-2256
Evolution of the Shape of a Gas Cloud during Pulsed Laser Evaporation into Vacuum: Direct Simulation Monte Carlo and the Solution of a Model Equation
The dynamics of gas expansion during nanosecond laser evaporation into vacuum is studied. The problem is considered in an axisymmetric formulation for a wide range of parameters: the number of evaporated monolayers and the size of the evaporation spot. To obtain a reliable numerical solution, two different kinetic approaches are used—the direct simulation Monte Carlo method and solution of the BGK model kinetic equation. The change in the shape of the cloud of evaporated substance during the expansion process is analyzed. The strong influence of the degree of rarefaction on the shape of the forming cloud is shown. When a large number of monolayers evaporate, good agreement with the continuum solution is observed.