Jinyoung Hwang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jinyoung Hwang has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
Jungmin Lee
School of Electronics and Information Engineering, Korea Aerospace University, Goyang-si, Gyeonggi-do 10540, Republic of Korea
4 shared publications- Sang Hyun Lee
School of Electrical Engineering, Korea University, Seoul, Republic of Korea
3 shared publications Seung Taek Jo
3 shared publicationsSunjae Kim
Department of Materials Science and Engineering Korea Aerospace University Goyang 10540 Republic of Korea
3 shared publications- Wan Sik Hwang
Department of Materials Science and Engineering, Korea Aerospace University, Goyang 10540, Republic of Korea
3 shared publications Jayoung Kim
School of Electronics and Information Engineering, Korea Aerospace University, Goyang-si, Gyeonggi-do 10540, Republic of Korea
2 shared publications
Latest Publications
- Open Access
- 8 September 2026
- Published by Elsevier in Materials Today Communications
- Vol. 56
Graph-based morphology–conductance scaling in crack-templated Ag conductive networks
- 8 September 2026
- Published by Elsevier in Materials Today Communications
- Vol. 56
Open AccessGraph-based morphology–conductance scaling in crack-templated Ag conductive networks
- 1 January 2026
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 41 (1) , 015011
Transverse U-shaped GaN light-triggered thyristor achieving enhanced optical absorption and high-speed switching
This work presents a U-shaped GaN light-triggered thyristor (LTT) with a transverse architecture designed to maximize optical absorption in the active base region for high-speed, high-voltage switching. Positioning the p-base at the illuminated bottom surface enables direct 350 nm excitation, minimizing optical losses and achieving over 97% photon absorption in the p-base, thereby enhancing photocarrier generation. Numerical simulations incorporating optical modeling confirm robust forward-blocking operation at 460 V and rapid optical switching; the anode-to-cathode voltage drops from 460 V to 5.2 V, and the anode current increases to 7.6 A cm −2 under 0.1 W cm −2 illumination. The intensity-dependent simulations show that the turn-on time is 311 ns at 0.1 W cm −2 and decreases to 99 ns at 1.0 W cm −2 , whereas d i /d t increases from 61.1 to 76.6 A cm −2 µ s with higher light intensity. Fast turn-off is also observed, consistent with GaN’s short minority-carrier lifetime. These results demonstrate that the proposed U-shaped GaN LTT enables efficient optical triggering and rapid switching with high-voltage capability, making it a promising solid-state switch for compact pulse-power applications.
- 1 January 2026
- Published by IOP Publishing in Semiconductor Science and Technology
- Vol. 41 (1) , 015011
Transverse U-shaped GaN light-triggered thyristor achieving enhanced optical absorption and high-speed switching
This work presents a U-shaped GaN light-triggered thyristor (LTT) with a transverse architecture designed to maximize optical absorption in the active base region for high-speed, high-voltage switching. Positioning the p-base at the illuminated bottom surface enables direct 350 nm excitation, minimizing optical losses and achieving over 97% photon absorption in the p-base, thereby enhancing photocarrier generation. Numerical simulations incorporating optical modeling confirm robust forward-blocking operation at 460 V and rapid optical switching; the anode-to-cathode voltage drops from 460 V to 5.2 V, and the anode current increases to 7.6 A cm −2 under 0.1 W cm −2 illumination. The intensity-dependent simulations show that the turn-on time is 311 ns at 0.1 W cm −2 and decreases to 99 ns at 1.0 W cm −2 , whereas d i /d t increases from 61.1 to 76.6 A cm −2 µ s with higher light intensity. Fast turn-off is also observed, consistent with GaN’s short minority-carrier lifetime. These results demonstrate that the proposed U-shaped GaN LTT enables efficient optical triggering and rapid switching with high-voltage capability, making it a promising solid-state switch for compact pulse-power applications.
- Open Access
- 14 December 2025
- Published by Wiley in Advanced Science
- Vol. 13 (13) , e18859
Direct Probing of Trap Dynamics in β ‐Ga 2 O 3 Schottky Barrier Diodes Using Single‐Voltage‐Pulse Characterization
Gallium oxide ( β ‐Ga 2 O 3 ) is a promising ultrawide‐bandgap semiconductor for next‐generation power electronics, but its performance is strongly limited by trap states that capture carriers. In this study, a single‐pulse characterization method is presented to directly probe trap dynamics in β ‐Ga 2 O 3 Schottky barrier diodes (SBDs). Transient current responses are systematically investigated under varying pulse widths, rise and fall times, amplitudes, and temperatures. The results reveal that traps in the neutral region progressively participate in electron capture, resulting in current decay during the constant‐voltage phase. Additionally, a delayed trap response produces asymmetry between the ramp‐up and ramp‐down transients. Analysis of the current decay yielded a trap density of ≈5×10 14 cm −2 , representing the total trap density near the Schottky junction. Exponential fitting provides a carrier capture time constant of ≈ 30 µs at a forward bias of 2 V, consistent with the onset of trap‐induced current degradation. Temperature‐dependent measurements indicate that carrier capture is suppressed at elevated temperatures, resulting in a trap activation energy of ≈0.16 eV. These findings demonstrate that the single‐pulse method offers a straightforward and effective approach for evaluating trap states under practical operating conditions in β ‐Ga 2 O 3 devices.
- 14 December 2025
- Published by Wiley in Advanced Science
- Vol. 13 (13) , e18859
Open AccessDirect Probing of Trap Dynamics in β ‐Ga 2 O 3 Schottky Barrier Diodes Using Single‐Voltage‐Pulse Characterization
Gallium oxide ( β ‐Ga 2 O 3 ) is a promising ultrawide‐bandgap semiconductor for next‐generation power electronics, but its performance is strongly limited by trap states that capture carriers. In this study, a single‐pulse characterization method is presented to directly probe trap dynamics in β ‐Ga 2 O 3 Schottky barrier diodes (SBDs). Transient current responses are systematically investigated under varying pulse widths, rise and fall times, amplitudes, and temperatures. The results reveal that traps in the neutral region progressively participate in electron capture, resulting in current decay during the constant‐voltage phase. Additionally, a delayed trap response produces asymmetry between the ramp‐up and ramp‐down transients. Analysis of the current decay yielded a trap density of ≈5×10 14 cm −2 , representing the total trap density near the Schottky junction. Exponential fitting provides a carrier capture time constant of ≈ 30 µs at a forward bias of 2 V, consistent with the onset of trap‐induced current degradation. Temperature‐dependent measurements indicate that carrier capture is suppressed at elevated temperatures, resulting in a trap activation energy of ≈0.16 eV. These findings demonstrate that the single‐pulse method offers a straightforward and effective approach for evaluating trap states under practical operating conditions in β ‐Ga 2 O 3 devices.
- Open Access
- 8 May 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (18) , 9309-9316
Optimized electrical and optical properties of Ag micro-meshes by self-generated cracks for transparent electrodes
Ag micro-mesh electrodes were fabricated using self-generated cracks. By varying the crack structure, we observed a strong correlation between crack width and FoM, which peaked when the widths were predominantly distributed in the 1–2 μm range.
- 8 May 2025
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 13 (18) , 9309-9316
Open AccessOptimized electrical and optical properties of Ag micro-meshes by self-generated cracks for transparent electrodes
Ag micro-mesh electrodes were fabricated using self-generated cracks. By varying the crack structure, we observed a strong correlation between crack width and FoM, which peaked when the widths were predominantly distributed in the 1–2 μm range.
- 17 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (9) , 3870-3876
Investigating Reverse Low-Bias Conduction Mechanisms in Ga2O3 Schottky Barrier Diodes Using Pulsed Current Methods
- 17 April 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (9) , 3870-3876
Investigating Reverse Low-Bias Conduction Mechanisms in Ga2O3 Schottky Barrier Diodes Using Pulsed Current Methods
- 31 January 2025
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 12 (2) , 809-818
Near-Infrared Phototransistor Using a SiGe-Based Light-Triggered Feedback Field-Effect Transistor with a Metasurface
- 31 January 2025
- Published by American Chemical Society (ACS) in ACS Photonics
- Vol. 12 (2) , 809-818
Near-Infrared Phototransistor Using a SiGe-Based Light-Triggered Feedback Field-Effect Transistor with a Metasurface
- 28 October 2024
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 16 (46) , 21523-21530
A computational framework for quantifying electrical conductance in metallic nanomesh using image processing and computer vision technologies
This study introduces a computational framework for precisely quantifying electrical conductance in metallic nanomesh structures, leveraging advanced image processing and computer vision algorithms. Nanomesh images obtained via scanning electron microscopy are subjected to preprocessing operations, including threshold-based binary conversion and convolution techniques, to mitigate defects and delineate conductive pathways. A rigorous equivalent electrical path model is subsequently established through keypoint identification via mean-shift segmentation. Kirchhoff's current law is applied to the model to deduce the conductance of the nanomesh. The computationally estimated conductance results are stringently validated against experimental measurements, confirming the model's accuracy. Further, the framework is applied to ascertain the resistivity of nanoscale Ag films deposited on glass substrates, revealing a resistivity higher than that of bulk materials—a finding corroborated by both computational predictions and experimental data. The methodology can be a robust, automated analytical tool for assessing conductance in comparable nanostructured materials.
- 28 October 2024
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 16 (46) , 21523-21530
A computational framework for quantifying electrical conductance in metallic nanomesh using image processing and computer vision technologies
This study introduces a computational framework for precisely quantifying electrical conductance in metallic nanomesh structures, leveraging advanced image processing and computer vision algorithms. Nanomesh images obtained via scanning electron microscopy are subjected to preprocessing operations, including threshold-based binary conversion and convolution techniques, to mitigate defects and delineate conductive pathways. A rigorous equivalent electrical path model is subsequently established through keypoint identification via mean-shift segmentation. Kirchhoff's current law is applied to the model to deduce the conductance of the nanomesh. The computationally estimated conductance results are stringently validated against experimental measurements, confirming the model's accuracy. Further, the framework is applied to ascertain the resistivity of nanoscale Ag films deposited on glass substrates, revealing a resistivity higher than that of bulk materials—a finding corroborated by both computational predictions and experimental data. The methodology can be a robust, automated analytical tool for assessing conductance in comparable nanostructured materials.
- Open Access
- 9 September 2024
- Published by Taylor & Francis in Nanocomposites
- Vol. 10 (1) , 363-372
A numerical study on electrical conductivity in hybrid composites—Quantitative analysis of morphology variations in percolating networks
- 9 September 2024
- Published by Taylor & Francis in Nanocomposites
- Vol. 10 (1) , 363-372
Open AccessA numerical study on electrical conductivity in hybrid composites—Quantitative analysis of morphology variations in percolating networks