S. H. Pawar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
S. H. Pawar has a total of 97 co-authors. Here are the top co-authors by number of shared publications:
- Nanasaheb Devappa Thorat
Department of Physics and Bernal Institute, University of Limerick, Castletroy, Limerick V94T9PX, Ireland
9 shared publications - Raghumani Singh Ningthoujam
Bhabha Atomic Research Centre
8 shared publications - Kiran Prakash Shinde
Department of Physics, Chungbuk National University 1 , Cheongju 28644, South Korea
7 shared publications P. M. Shirage
National Institute of Advanced Industrial Science and Technology (AIST)
6 shared publicationsR. M. Patil
Center for Interdisciplinary Research, D. Y. Patil University, Kolhapur-416006, India
6 shared publications- Sachin V. Otari
Department of Chemical Engineering, Konkuk University, Seoul 05029, Republic of Korea
6 shared publications
Latest Publications
- 1 March 2020
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 817
Effect of Nickel–Zinc Co-doped TiO2 blocking layer on performance of DSSCs
- 1 March 2020
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 817
Effect of Nickel–Zinc Co-doped TiO2 blocking layer on performance of DSSCs
- 8 April 2019
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (6) , 4117-4124
Synthesis and Performance Tuning of Sm0.2Ce0.8O2−δ Electrolyte for Low Temperature Solid Oxide Fuel Cell Application
- 8 April 2019
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 48 (6) , 4117-4124
Synthesis and Performance Tuning of Sm0.2Ce0.8O2−δ Electrolyte for Low Temperature Solid Oxide Fuel Cell Application
- 1 February 2016
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 59, 702-709
In vitro hyperthermia with improved colloidal stability and enhanced SAR of magnetic core/shell nanostructures
- 1 February 2016
- Published by Elsevier in Materials Science and Engineering: C
- Vol. 59, 702-709
In vitro hyperthermia with improved colloidal stability and enhanced SAR of magnetic core/shell nanostructures
- 9 November 2015
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 24 (12) , 4691-4695
A DNA-Assembled Fe3O4@Ag Nanorod in Silica Matrix for Cholesterol Biosensing
- 9 November 2015
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 24 (12) , 4691-4695
A DNA-Assembled Fe3O4@Ag Nanorod in Silica Matrix for Cholesterol Biosensing
- 12 October 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (107) , 88375-88381
Superparamagnetic core/shell nanostructures for magnetic isolation and enrichment of DNA
Fe3O4 magnetic nanoparticles (MNPs) are promising candidates for various biomedical applications due to their extraordinary properties.
- 12 October 2015
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (107) , 88375-88381
Superparamagnetic core/shell nanostructures for magnetic isolation and enrichment of DNA
Fe3O4 magnetic nanoparticles (MNPs) are promising candidates for various biomedical applications due to their extraordinary properties.
- 1 August 2015
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 163, 30-37
Studies on role of grain-size on transport properties of Sm0.5Sr0.5CoO3−δ cathodic films
- 1 August 2015
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 163, 30-37
Studies on role of grain-size on transport properties of Sm0.5Sr0.5CoO3−δ cathodic films
- 1 February 2015
- Published by Elsevier in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
- Vol. 136, 1175-1180
Intracellular synthesis of silver nanoparticle by actinobacteria and its antimicrobial activity
- 1 February 2015
- Published by Elsevier in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
- Vol. 136, 1175-1180
Intracellular synthesis of silver nanoparticle by actinobacteria and its antimicrobial activity
- 23 December 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (11) , 8463-8470
Magneto-separation of genomic deoxyribose nucleic acid using pH responsive Fe3O4@silica@chitosan nanoparticles in biological samples
Magneto-separation of genomic deoxyribose nucleic acid using pH responsive Fe3O4@silica@chitosan nanoparticles in biological samples.
- 23 December 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 5 (11) , 8463-8470
Magneto-separation of genomic deoxyribose nucleic acid using pH responsive Fe3O4@silica@chitosan nanoparticles in biological samples
Magneto-separation of genomic deoxyribose nucleic acid using pH responsive Fe3O4@silica@chitosan nanoparticles in biological samples.
- 4 March 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 4 (25) , 12662-12671
Colloidal stability of polyethylene glycol functionalized Co0.5Zn0.5Fe2O4 nanoparticles: effect of pH, sample and salt concentration for hyperthermia application
The long-term colloidal stability of magnetic nanoparticles (MNPs) is an important goal when such MNPs are used for biomedical applications. Co0.5Zn0.5Fe2O4 (CZF) MNPs were functionalized with polyethylene glycol (PEG) and the effect of surface functionalization on the colloidal stability was investigated by dispersing them in double distilled water , phosphate buffer saline (PBS) and Dulbecco's modified Eagle's medium with bovine serum albumin (DMEM-BSA) for possible application in magnetic hyperthermia. The colloidal stability was studied by measuring the particle charge and hydrodynamic diameter as a function of pH and ionic strength using the dynamic light scattering (DLS) method and zeta potential measurement. DLS and zeta potential results indicated that PEG-CZF MNPs dispersed in DDW exhibited poor stability, whereas those dispersed in PBS and DMEM-BSA exhibited excellent stability. An induction heating experiment revealed that the hyperthermia temperature (42–43 °C) could be achieved by the PEG-coated sample at a magnetic field of 168–335 Oe and a fixed frequency of 265 kHz. Interestingly, a high specific absorption rate (SAR) of 193 W g−1 was observed in the case of PEG coated MNPs in PBS medium, this is a very important parameter in hyperthermia applications and such a high SAR comes from the high contrition from the Brownian rotational relaxation because of the better dispersion of MNPs in PBS medium. PEG coated MNPs at concentrations below 1.8 mg mL−1 exhibited good viability above 86% in mice fibroblast L929 cells. The results suggest that co-precipitation synthesized CZF MNPs coated with PEG can be used as potential heating agents for magnetic particle hyperthermia.
- 4 March 2014
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 4 (25) , 12662-12671
Colloidal stability of polyethylene glycol functionalized Co0.5Zn0.5Fe2O4 nanoparticles: effect of pH, sample and salt concentration for hyperthermia application
The long-term colloidal stability of magnetic nanoparticles (MNPs) is an important goal when such MNPs are used for biomedical applications. Co0.5Zn0.5Fe2O4 (CZF) MNPs were functionalized with polyethylene glycol (PEG) and the effect of surface functionalization on the colloidal stability was investigated by dispersing them in double distilled water , phosphate buffer saline (PBS) and Dulbecco's modified Eagle's medium with bovine serum albumin (DMEM-BSA) for possible application in magnetic hyperthermia. The colloidal stability was studied by measuring the particle charge and hydrodynamic diameter as a function of pH and ionic strength using the dynamic light scattering (DLS) method and zeta potential measurement. DLS and zeta potential results indicated that PEG-CZF MNPs dispersed in DDW exhibited poor stability, whereas those dispersed in PBS and DMEM-BSA exhibited excellent stability. An induction heating experiment revealed that the hyperthermia temperature (42–43 °C) could be achieved by the PEG-coated sample at a magnetic field of 168–335 Oe and a fixed frequency of 265 kHz. Interestingly, a high specific absorption rate (SAR) of 193 W g−1 was observed in the case of PEG coated MNPs in PBS medium, this is a very important parameter in hyperthermia applications and such a high SAR comes from the high contrition from the Brownian rotational relaxation because of the better dispersion of MNPs in PBS medium. PEG coated MNPs at concentrations below 1.8 mg mL−1 exhibited good viability above 86% in mice fibroblast L929 cells. The results suggest that co-precipitation synthesized CZF MNPs coated with PEG can be used as potential heating agents for magnetic particle hyperthermia.
- 5 November 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 4 (9) , 4515-4522
Non-aqueous to aqueous phase transfer of oleic acid coated iron oxide nanoparticles for hyperthermia application
Iron oxide magnetic nanoparticles (MNPs) alone are suitable for a broad spectrum of applications, but the low stability and heterogeneous size distribution in aqueous medium represent major setbacks. These setbacks can however be reduced or diminished through functionalization of MNPs with various biocompatible surfactants. In this study, magnetite (Fe3O4) nanoparticles were modified using oleic acid (OA) to reduce their agglomeration. To render hydrophilicity and to increase the colloidal stability of the MNPs, they were further functionalized with betaine-HCl (BTH). The physiochemical properties were well characterized using X-ray diffraction, Fourier transform infrared, thermogravimetric analysis, transmission electron microscopy and superconducting quantum interference device of the OA-BTH coated Fe3O4 MNPs in order to use them for hyperthermia application. Zeta potential study and size distribution of nanoparticles showed increased stability of the nanoparticles. The coated MNPs show increase in specific absorption rate value of 91.03 W g−1 at 335.2 Oe, making them more suitable for hyperthermia application. Cytotoxicity study was performed by MTT assay on L929 cell line for 24 h incubation period.
- 5 November 2013
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 4 (9) , 4515-4522
Non-aqueous to aqueous phase transfer of oleic acid coated iron oxide nanoparticles for hyperthermia application
Iron oxide magnetic nanoparticles (MNPs) alone are suitable for a broad spectrum of applications, but the low stability and heterogeneous size distribution in aqueous medium represent major setbacks. These setbacks can however be reduced or diminished through functionalization of MNPs with various biocompatible surfactants. In this study, magnetite (Fe3O4) nanoparticles were modified using oleic acid (OA) to reduce their agglomeration. To render hydrophilicity and to increase the colloidal stability of the MNPs, they were further functionalized with betaine-HCl (BTH). The physiochemical properties were well characterized using X-ray diffraction, Fourier transform infrared, thermogravimetric analysis, transmission electron microscopy and superconducting quantum interference device of the OA-BTH coated Fe3O4 MNPs in order to use them for hyperthermia application. Zeta potential study and size distribution of nanoparticles showed increased stability of the nanoparticles. The coated MNPs show increase in specific absorption rate value of 91.03 W g−1 at 335.2 Oe, making them more suitable for hyperthermia application. Cytotoxicity study was performed by MTT assay on L929 cell line for 24 h incubation period.