SCStephen Michael Cox

Stephen Michael Cox

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Stephen Michael Cox has a total of 86 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Slugging in horizontal channel flow

    by Josef Adam Giddings, John Billingham, Stephen Michael Cox

    The stratified flow of gas–liquid mixtures is important in many industries, in particular oil and gas, where the formation of liquid slugs is usually undesirable. In this paper, we analyse the hydraulic model for turbulent, two-layer, gas–liquid flow in a horizontal channel developed by Needham et al. (2008, The development of slugging in two-layer hydraulic flows, IMA J. Appl. Math., 73, 274–322) who considered only the thin layer limit, for liquid layers of arbitrary thickness. This allows us to consider the effect of the prescribed inlet velocity ratio and the interaction of the gas layer with the upper wall of the channel on the formation of slug formation. We show that there is a critical Froude number above which small-amplitude disturbances to the uniform flow are unstable and grow to form non-linear roll waves. We investigate the existence of periodic travelling wave solutions and find that these are strongly influenced by the existence of two equilibrium solutions that are not present when the liquid layer is thin. The system of ordinary differential equations that describe travelling wave solutions has a complicated phase portrait which we study in some typical cases. We find that periodic solutions that have the channel close to filled with liquid can exist, and we identify them as slugs. We also study an initial value problem driven by noise at the inlet of the channel and find that structures locally similar to these periodic travelling waves are generated. We provide numerical evidence for the formation of slugs in cases where the initial liquid to homogeneous velocity ratio is greater than 0.5.

  • Experimental Validation of Harmonic Impedance Measurement and LTP Nyquist Criterion for Stability Analysis in Power Converter Networks

    by Valerio Salis, Alessandro Costabeber, Stephen M. Cox, Francesco Tardelli, Pericle Zanchetta

    This paper presents the first experimental validation of the stability analysis based on the online measurement of harmonic impedances exploiting the Linear Time Periodic (LTP) approach, applied to AC networks of power converters. Previous publications have provided the theoretical framework for the method, enabling the stability assessment of an unknown system adopting a black-box approach, relying only on injected perturbations and local measurements. The experimental case study considered in this paper comprises two single-phase converters, one acting as \textit{source subsystem} and the other as \textit{load subsystem}. A third converter, the \textit{Stability Measurement Unit} (SMU), is controlled to inject small current perturbations at the point of common coupling (PCC). From the measured small-signal perturbations of PCC voltage, source current and load current, the harmonic impedances of source and load subsystems are calculated. The LTP Nyquist Criterion is then applied to the ratio of the two harmonic impedances in order to assess the stability of the whole system. Theoretical and experimental results from a $5$ kW laboratory prototype are provided and confirm the effectiveness of the method. In addition, the measurements do not require sophisticated equipment or control boards and can be easily performed from data sampled by commercial micro-controllers.


  • Stability Assessment of High-Bandwidth DC Voltage Controllers in Single-Phase Active Front Ends: LTI Versus LTP Models

    by Valerio Salis, Alessandro Costabeber, Stephen M. Cox, Andrea Formentini, Pericle Zanchetta

    In recent years, a considerable effort has been made to minimize the size of dc-link capacitors in single-phase active front ends (SP-AFEs), to reduce cost, and to increase power density. As a result of the lower energy storage, a high-bandwidth outer dc voltage control loop is required to respond to fast load changes. Linearized modeling is usually performed according to the power-balance method and the control is designed using LTI techniques. This is done assuming negligible voltage ripple at twice the grid frequency, and the model is considered valid up to the grid frequency. However, its precise validity limits are usually unknown and the control design becomes empirical when approaching these boundaries. To overcome this drawback, linear time-periodic (LTP) theory can be exploited, defining the range of validity of the LTI model and providing precise stability boundaries for the dc-link voltage loop. The main result is that LTP models more accurately describe the system behavior and provide superior results compared to the LTI ones. Theoretical analysis, simulations, and extensive experimental tests on a 10-kW converter are presented to validate the claims.


  • Open Access

    A third-order class-D amplifier with and without ripple compensation

    by Stephen M. Cox, H. du Toit Mouton

    We analyse the nonlinear behaviour of a third-order class-D amplifier, and demonstrate the remarkable effectiveness of the recently introduced ripple compensation (RC) technique in reducing the audio distortion of the device. The amplifier converts an input audio signal to a high-frequency train of rectangular pulses, whose widths are modulated according to the input signal (pulse-width modulation) and employs negative feedback. After determining the steady-state operating point for constant input and calculating its stability, we derive a small-signal model (SSM), which yields in closed form the transfer function relating (infinitesimal) input and output disturbances. This SSM shows how the RC technique is able to linearise the small-signal response of the device. We extend this SSM through a fully nonlinear perturbation calculation of the dynamics of the amplifier, based on the disparity in time scales between the pulse train and the audio signal. We obtain the nonlinear response of the amplifier to a general audio signal, avoiding the linearisation inherent in the SSM; we thereby more precisely quantify the reduction in distortion achieved through RC. Finally, simulations corroborate our theoretical predictions and illustrate the dramatic deterioration in performance that occurs when the amplifier is operated in an unstable regime. The perturbation calculation is rather general, and may be adapted to quantify the way in which other nonlinear negative-feedback pulse-modulated devices track a time-varying input signal that slowly modulates the system parameters.

  • Stability Boundary Analysis in Single-Phase Grid-Connected Inverters With PLL by LTP Theory

    by Valerio Salis, Alessandro Costabeber, Stephen M. Cox, Pericle Zanchetta, Andrea Formentini

    Stability analysis of power converters in ac networks is complex due to the nonlinear nature of the conversion systems. Whereas interactions of converters in dc networks can be studied by linearizing about the operating point, the extension of the same approach to ac systems poses serious challenges, especially for single-phase or unbalanced three-phase systems. A general method for stability analysis of power converters suitable for single-phase or unbalanced ac networks is presented in this paper, based on linear time periodic theory. A single-phase grid-connected inverter with phase-locked loop (PLL) is considered as case study. It is demonstrated that the stability boundaries can be precisely evaluated by the proposed method, despite the nonlinearity introduced by the PLL. Simulation and experimental results from a 10-kW laboratory prototype are provided to confirm the effectiveness of the proposed analysis.


  • Stability Assessment of Power-Converter-Based AC systems by LTP Theory: Eigenvalue Analysis and Harmonic Impedance Estimation

    by Valerio Salis, Alessandro Costabeber, Stephen M. Cox, Pericle Zanchetta

    Stability analysis of power-converter-based ac systems poses serious challenges not only because of the nonlinear nature of power converters, but also because linearization is not generally applied around a steady-state operating point, as in the dc case, but around a time-periodic operating trajectory. Typical examples are single-phase and unbalanced three-phase systems. In this paper, two general methods to assess stability of the aforementioned systems are presented. Both are based on the linear time periodic (LTP) systems theory. The first is model-based and relies on the evaluation of the eigenvalues of the linearized model, assuming a complete knowledge of the parameters. By contrast, the second proposes a set of small-signal current injections to measure the harmonic impedances and applies the LTP Nyquist criterion, so that the stability of the system can be assessed with a black-box approach, without relying on the knowledge of the system parameters. The basic LTP systems theory is reviewed in order to provide a mathematical justification for the second method. As case study, a simple network, consisting of a source full-bridge converter in ac voltage-control mode and a load full-bridge converter in ac current-control mode including phase locked loop, is considered. Analytical results based on average modeling and simulations based on both average and switching models are presented, showing good accuracy in the identification of the stability thresholds for both the proposed methods.


  • Small-Signal Analysis of Naturally-Sampled Single-Edge PWM Control Loops

    by Hendrik du Toit Mouton, Stephen Michael Cox, Brendan McGrath, Lars Risbo, Bruno Putzeys

    This paper presents a simple method to analyse the behaviour of feedback loops that contain a naturally-sampled single-edge pulse-width modulator. A small-signal model is derived by means of simple geometric arguments. It is shown how this small-signal model can be used to analyse the stability of the continuous-time pulse-width modulated feedback loop by using standard z-domain techniques. The strategy relies on familiar concepts like transfer functions and small-signal gains and does not require any in-depth knowledge of non-linear systems. A simple design process, where the continuous-time compensator is designed directly in the z-domain, is developed and detailed design equations are derived for a PI current regulator. It is shown how the proposed strategy can accurately predict instability that cannot be explained by means of the well-known average model of the pulse-width modulator. The theoretical analysis is confirmed by means of detailed timedomain simulations. The mechanisms that lead to instability are discussed and an equation for the critical loop gain is derived.


  • Analysis of a hysteresis-controlled self-oscillating class-D amplifier

    by Stephen M. Cox, Jun Yu, Wang Ling Goh, Meng Tong Tan

    This paper gives the first systematic perturbation analysis of the audio distortion and mean switching period for a self-oscillating class-D amplifier. Explicit expressions are given for all the principal components of audio distortion, for a general audio input signal; the specific example of a sinusoidal input is also discussed in some detail, yielding an explicit closed-form expression for the total harmonic distortion. A class-D amplifier works by converting a low-frequency audio input signal to a high-frequency train of rectangular pulses, whose widths are slowly modulated according to the audio signal. The audio-frequency components of the pulse-train are designed to agree with those of the audio signal. In many varieties of class-D amplifier, the pulse-train is generated using a carrier wave of fixed frequency, well above the audio range. In other varieties, as here, there is no such fixed-frequency clock, and the local frequency of the pulse-train varies in response to the audio input. Such self-oscillating designs pose a particular challenge for comprehensive mathematical modelling; we show that in order to properly account for the local frequency variations, a warped-time transformation is necessary. The systematic nature of our calculation means it can potentially be applied to a range of other self-oscillating topologies. Our results for a general input allow ready calculation of distortion diagnostics such as the intermodulation distortion, which prior analyses, based on sinusoidal input, cannot provide.

  • A generalised harmonic linearisation method for power converters input/output impedance calculation

    by Valerio Salis, Alessandro Costabeber, Pericle Zanchetta, Stephen Cox

    A general method for the evaluation of small-signal input impedances of power converters is presented in this paper. The method is based on harmonic linearisation and Fourier analysis techniques and a single-phase boost PFC is considered as case study. The analysis is based on the average model of the converter but no further approximations have been made and both voltage and current loops are included. A comparison between time domain and numerical simulation is presented to validate the proposed model.