Bastien Oliver Burek
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Bastien Oliver Burek has a total of 52 co-authors. Here are the top co-authors by number of shared publications:
- Jonathan Zacharias Bloh
DECHEMA-Forschungsinstitut
16 shared publications - Frank Hollmann
Delft University of Technology
7 shared publications - Alexander Sutor
Institute of Measurement and Sensor Technology , UMIT TIROL – Private University for Health Sciences and Health Technology , Eduard-Wallnöfer-Zentrum 1, 6060 , Hall in Tirol , Austria
5 shared publications - Hong Thu Duong
DECHEMA-Forschungsinstitut
5 shared publications - Detlef Werner Bahnemann
Laboratory of Photoactive Nanocomposite Materials, Saint Petersburg State University, 199034 Saint-Petersburg, Russia
4 shared publications - Miguel Alcalde
Department of Biocatalysis Institute of Catalysis, CSIC Madrid Spain
4 shared publications
Latest Publications
- 27 May 2025
- Published by Royal Society of Chemistry (RSC) in Reaction Chemistry & Engineering
- Vol. 10 (9) , 2043-2052
Intensification of heterogeneous photocatalytic reactions using wireless light emitters: the case study of nitrobenzene reduction
Delocalized internal irradiation is a promising technique to intensify and scale up photochemical processes, as it prevents the otherwise unavoidable concentration of light energy. In particular, wireless light emitters (WLEs) powered by resonant inductive coupling showed promise in previous studies. However, the achieved photon flux was still relatively low. Herein, we show that through systematic optimization, the WLE technique can reach extremely high photon flux densities and energy efficiency, surpassing conventional photochemical reaction systems. Moreover, the intensification potential is demonstrated on the basis of a case study: the photocatalytic reduction of nitrobenzene in isopropanol using a TiO2 photocatalyst. The results also reveal a significant advantage of the WLE system. Due to the decentralized light emitters, the local accumulation of photon energy is minimized, preventing efficiency losses due to kinetic limitations at high light intensity.
- 27 May 2025
- Published by Royal Society of Chemistry (RSC) in Reaction Chemistry & Engineering
- Vol. 10 (9) , 2043-2052
Intensification of heterogeneous photocatalytic reactions using wireless light emitters: the case study of nitrobenzene reduction
Delocalized internal irradiation is a promising technique to intensify and scale up photochemical processes, as it prevents the otherwise unavoidable concentration of light energy. In particular, wireless light emitters (WLEs) powered by resonant inductive coupling showed promise in previous studies. However, the achieved photon flux was still relatively low. Herein, we show that through systematic optimization, the WLE technique can reach extremely high photon flux densities and energy efficiency, surpassing conventional photochemical reaction systems. Moreover, the intensification potential is demonstrated on the basis of a case study: the photocatalytic reduction of nitrobenzene in isopropanol using a TiO2 photocatalyst. The results also reveal a significant advantage of the WLE system. Due to the decentralized light emitters, the local accumulation of photon energy is minimized, preventing efficiency losses due to kinetic limitations at high light intensity.
- 31 March 2025
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 27 (16) , 8335-8346
Stabilization of TiO 2 -based photocatalytic coating on polymer substrates with complex geometry using laser annealing
Laser treatment was shown as appropriate method to anneal TiO 2 -based photoactive coatings on heat-sensitive polymer substrates, even in complex geometries.
- 31 March 2025
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 27 (16) , 8335-8346
Stabilization of TiO 2 -based photocatalytic coating on polymer substrates with complex geometry using laser annealing
Laser treatment was shown as appropriate method to anneal TiO 2 -based photoactive coatings on heat-sensitive polymer substrates, even in complex geometries.
- Open Access
- 18 October 2024
- Published by American Chemical Society (ACS) in ChemRxiv
Stabilization of TiO2-based Photocatalytic Coating on Polymer Substrates with Complex Geometry Using Laser Annealing
TiO2-based photocatalytic coatings on substrates often require thermal annealing to achieve sufficient long-term stability and resistance to abrasion. This is difficult to achieve when using polymer substrates and/or other components in the system which are not stable enough for high temperature annealing. Herein, we present a method for annealing in those cases which relies on localized heating using a laser. This allows the coating the thermally anneal while at the same time protecting the substrate from higher temperatures. This method was then successfully adopted for more complex geometries, namely (half-)spherical substrates used for the so-called wireless light emitter technology.
- 18 October 2024
- Published by American Chemical Society (ACS) in ChemRxiv
Open AccessStabilization of TiO2-based Photocatalytic Coating on Polymer Substrates with Complex Geometry Using Laser Annealing
TiO2-based photocatalytic coatings on substrates often require thermal annealing to achieve sufficient long-term stability and resistance to abrasion. This is difficult to achieve when using polymer substrates and/or other components in the system which are not stable enough for high temperature annealing. Herein, we present a method for annealing in those cases which relies on localized heating using a laser. This allows the coating the thermally anneal while at the same time protecting the substrate from higher temperatures. This method was then successfully adopted for more complex geometries, namely (half-)spherical substrates used for the so-called wireless light emitter technology.
- 2 October 2023
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 44 (2) , 841-849
Effect of crystal orientation of AlN coatings on its high temperature oxidation in wet air
- 2 October 2023
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 44 (2) , 841-849
Effect of crystal orientation of AlN coatings on its high temperature oxidation in wet air
- Open Access
- 7 September 2023
- Published by Wiley in ChemPhotoChem
- Vol. 7 (11)
The Importance of Precise Reaction Condition Control for the Comparison of Photocatalyst Materials on the Example of Hydrogen Peroxide Formation over Polymeric Carbon Nitrides
In our study, we aimed to show how different reaction parameters can affect production rates using photocatalytic hydrogen peroxide formation by different polymeric carbon nitrides (PCN). For this purpose, selected materials were first compared under the same reaction conditions and compared with TiO2 (P25). We also show that different light intensities can have a different influence on seemingly similar materials. Since hydrogen peroxide production in the presence of an electron donor proceeds mainly by reduction of oxygen, we also show an influence of the oxygen flow on the formation rates. Thus, with high oxygen fluxes and high intensities of irradiated light, we were able to achieve an H2O2 concentration of 125 mM after about 25 h. Finally, the two best PCN materials were selected to measure light intensity dependence at different wavelengths up to visible light. It was found that they behaved differently at the different wavelengths and thus it could be shown that an exact specification of the reaction parameters is indispensable for comparisons in the literature.
- 7 September 2023
- Published by Wiley in ChemPhotoChem
- Vol. 7 (11)
Open AccessThe Importance of Precise Reaction Condition Control for the Comparison of Photocatalyst Materials on the Example of Hydrogen Peroxide Formation over Polymeric Carbon Nitrides
In our study, we aimed to show how different reaction parameters can affect production rates using photocatalytic hydrogen peroxide formation by different polymeric carbon nitrides (PCN). For this purpose, selected materials were first compared under the same reaction conditions and compared with TiO2 (P25). We also show that different light intensities can have a different influence on seemingly similar materials. Since hydrogen peroxide production in the presence of an electron donor proceeds mainly by reduction of oxygen, we also show an influence of the oxygen flow on the formation rates. Thus, with high oxygen fluxes and high intensities of irradiated light, we were able to achieve an H2O2 concentration of 125 mM after about 25 h. Finally, the two best PCN materials were selected to measure light intensity dependence at different wavelengths up to visible light. It was found that they behaved differently at the different wavelengths and thus it could be shown that an exact specification of the reaction parameters is indispensable for comparisons in the literature.
- Open Access
- 16 August 2023
- Published by Wiley in ChemSusChem
- Vol. 16 (23) , e202300613
Robust Light Driven Enzymatic Oxyfunctionalization via Immobilization of Unspecific Peroxygenase
Unspecific peroxygenases have attracted interest in synthetic chemistry, especially for the oxidative activation of C−H bonds, as they only require hydrogen peroxide (H2O2) instead of a cofactor. Due to their instability in even small amounts of H2O2, different strategies like enzyme immobilization or in situ H2O2 production have been developed to improve the stability of these enzymes. While most strategies have been studied separately, a combination of photocatalysis with immobilized enzymes was only recently reported. To show the advantages and limiting factors of immobilized enzyme in a photobiocatalytic reaction, a comparison is made between free and immobilized enzymes. Adjustment of critical parameters such as (i) enzyme and substrate concentration, (ii) illumination wavelength and (iii) light intensity results in significantly increased enzyme stabilities of the immobilized variant. Moreover, under optimized conditions a turnover number of 334,500 was reached.
- 16 August 2023
- Published by Wiley in ChemSusChem
- Vol. 16 (23) , e202300613
Open AccessRobust Light Driven Enzymatic Oxyfunctionalization via Immobilization of Unspecific Peroxygenase
Unspecific peroxygenases have attracted interest in synthetic chemistry, especially for the oxidative activation of C−H bonds, as they only require hydrogen peroxide (H2O2) instead of a cofactor. Due to their instability in even small amounts of H2O2, different strategies like enzyme immobilization or in situ H2O2 production have been developed to improve the stability of these enzymes. While most strategies have been studied separately, a combination of photocatalysis with immobilized enzymes was only recently reported. To show the advantages and limiting factors of immobilized enzyme in a photobiocatalytic reaction, a comparison is made between free and immobilized enzymes. Adjustment of critical parameters such as (i) enzyme and substrate concentration, (ii) illumination wavelength and (iii) light intensity results in significantly increased enzyme stabilities of the immobilized variant. Moreover, under optimized conditions a turnover number of 334,500 was reached.
- 20 April 2022
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 12 (9) , 2755-2760
Sustainable nitrate production out of thin air: the photocatalytic oxidation of molecular nitrogen
Dinitrogen can be photocatalytically oxidized by TiO2 to nitrogen oxides and nitrates. This enables the sustainable production of fixed nitrogen essentially from thin air using sunlight.
- 20 April 2022
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 12 (9) , 2755-2760
Sustainable nitrate production out of thin air: the photocatalytic oxidation of molecular nitrogen
Dinitrogen can be photocatalytically oxidized by TiO2 to nitrogen oxides and nitrates. This enables the sustainable production of fixed nitrogen essentially from thin air using sunlight.
- Open Access
- 1 February 2022
- Published by Wiley in European Journal of Organic Chemistry
- Vol. 2022 (5) , e202200057
Front Cover: Photochemistry at Scale: Wireless Light Emitters Drive Sustainability in Process Research & Development (Eur. J. Org. Chem. 5/2022)
- 1 February 2022
- Published by Wiley in European Journal of Organic Chemistry
- Vol. 2022 (5) , e202200057
Open AccessFront Cover: Photochemistry at Scale: Wireless Light Emitters Drive Sustainability in Process Research & Development (Eur. J. Org. Chem. 5/2022)
- Open Access
- 18 November 2021
- Published by Wiley in European Journal of Organic Chemistry
- Vol. 2022 (5)
Photochemistry at Scale: Wireless Light Emitters Drive Sustainability in Process Research & Development
Carbon−carbon bond formation by dual Iridium‐Nickel photoredox catalysis has gained a lot of attention for late‐stage cross‐couplings of alkyls with aryls. However, the scalability of such reactions is greatly impeded by the poor light penetration depth into the strongly absorbing reaction media. Wireless internal illumination is a novel technique which circumvents the light penetration issue efficiently and therefore allows to scale photon‐driven reactions by conventional methods. Here we demonstrate that industrially relevant photoredox C−C couplings can be scaled seamlessly to different volumes, achieving qualitatively and quantitatively the same results at all scales. The use of conventional reactor types allows stirred, bubble column or fixed‐bed operation mode and is fully compatible with heterogeneous reaction mixtures. By minimizing reflection losses, we could also show a significant advantage in the reaction rate over an externally illuminated setup at the same light intensity.
- 18 November 2021
- Published by Wiley in European Journal of Organic Chemistry
- Vol. 2022 (5)
Open AccessPhotochemistry at Scale: Wireless Light Emitters Drive Sustainability in Process Research & Development
Carbon−carbon bond formation by dual Iridium‐Nickel photoredox catalysis has gained a lot of attention for late‐stage cross‐couplings of alkyls with aryls. However, the scalability of such reactions is greatly impeded by the poor light penetration depth into the strongly absorbing reaction media. Wireless internal illumination is a novel technique which circumvents the light penetration issue efficiently and therefore allows to scale photon‐driven reactions by conventional methods. Here we demonstrate that industrially relevant photoredox C−C couplings can be scaled seamlessly to different volumes, achieving qualitatively and quantitatively the same results at all scales. The use of conventional reactor types allows stirred, bubble column or fixed‐bed operation mode and is fully compatible with heterogeneous reaction mixtures. By minimizing reflection losses, we could also show a significant advantage in the reaction rate over an externally illuminated setup at the same light intensity.
- Open Access
- 2 February 2021
- Published by Wiley in ChemSusChem
- Vol. 14 (4) , 1053-1056
Intensification of Photobiocatalytic Decarboxylation of Fatty Acids for the Production of Biodiesel
Light‐driven biocatalytic processes are notoriously hampered by poor penetration of light into the turbid reaction media. In this study, wirelessly powered light‐emitting diodes are found to represent an efficient and scalable approach for process intensification of the photobiosynthetic production of diesel alkanes from renewable fatty acids.
- 2 February 2021
- Published by Wiley in ChemSusChem
- Vol. 14 (4) , 1053-1056
Open AccessIntensification of Photobiocatalytic Decarboxylation of Fatty Acids for the Production of Biodiesel
Light‐driven biocatalytic processes are notoriously hampered by poor penetration of light into the turbid reaction media. In this study, wirelessly powered light‐emitting diodes are found to represent an efficient and scalable approach for process intensification of the photobiosynthetic production of diesel alkanes from renewable fatty acids.