Aliye Arabacı
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Aliye Arabacı has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Mehmet Ali Faruk Oksuzomer
Department of Chemical Engineering, Faculty of Engineering, İstanbul University - Cerrahpaşa, İstanbul, Turkiye
6 shared publications - Ibrahim Yusufoglu
Istanbul University
2 shared publications - Vedat Sarıboğa
Chemical Engineering Department, Istanbul University-Cerrahpaşa, Istanbul, Turkey
2 shared publications Ö. Serin
Istanbul University, Faculty of Engineering, Department of Metallurgical Engineering, Avcilar, 34320 Istanbul, Turkey
2 shared publications- Ahmet Orkun Kalpakli
İSTANBUL ÜNİVERSİTESİ - CERRAHPAŞA
1 shared publication C. Kahruman
1 shared publication
Latest Publications
- 10 September 2020
- Published by Taylor & Francis in Inorganic and Nano-Metal Chemistry
- Vol. 51 (9) , 1-10
Structural and electrical properties of Sm and Er co-doped ceria electrolytes
The aim of this study is to prepare Er and Sm co-doped CeO2 electrolytes via the Pechini method and investigate the effects of simultaneous addition of Sm and Er on the structural and electrical features of CeO2. The structural, functional group analysis, microstructures, and electrical properties of the electrolyte samples are conducted by X–ray diffraction, Fourier transform infrared spectroscopy, scanning electron microscopy, and impedance spectroscopy (IS). All the calcined and sintered electrolytes were obtained with cubic fluorite crystal structure without secondary oxide phases. After sintering at 1400 °C, highly dense electrolytes were achieved (> 90%). The IS measurements indicated that the highest ionic conductivity was observed for the singly doped Ce0.80Sm0.20O1.90 (σ750 °C = 3.86 x 10−2 S/cm) electrolyte. σ750°C was found to be 3.82 x 10−2, 1.73 x 10−2, 0.61 x 10−2 S/cm for Ce0.80Er0.05Sm0.15O1.90, Ce0.80Er0.10Sm0.10O1.90 and Ce0.90Er0.10O1.95, respectively.
- 10 September 2020
- Published by Taylor & Francis in Inorganic and Nano-Metal Chemistry
- Vol. 51 (9) , 1-10
Structural and electrical properties of Sm and Er co-doped ceria electrolytes
The aim of this study is to prepare Er and Sm co-doped CeO2 electrolytes via the Pechini method and investigate the effects of simultaneous addition of Sm and Er on the structural and electrical features of CeO2. The structural, functional group analysis, microstructures, and electrical properties of the electrolyte samples are conducted by X–ray diffraction, Fourier transform infrared spectroscopy, scanning electron microscopy, and impedance spectroscopy (IS). All the calcined and sintered electrolytes were obtained with cubic fluorite crystal structure without secondary oxide phases. After sintering at 1400 °C, highly dense electrolytes were achieved (> 90%). The IS measurements indicated that the highest ionic conductivity was observed for the singly doped Ce0.80Sm0.20O1.90 (σ750 °C = 3.86 x 10−2 S/cm) electrolyte. σ750°C was found to be 3.82 x 10−2, 1.73 x 10−2, 0.61 x 10−2 S/cm for Ce0.80Er0.05Sm0.15O1.90, Ce0.80Er0.10Sm0.10O1.90 and Ce0.90Er0.10O1.95, respectively.
- 1 July 2019
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 792, 1141-1149
Preparation and properties of ceramic electrolytes in the Nd and Gd Co-doped ceria systems prepared by polyol method
- 1 July 2019
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 792, 1141-1149
Preparation and properties of ceramic electrolytes in the Nd and Gd Co-doped ceria systems prepared by polyol method
- 18 May 2019
- Published by Springer Nature in Ionics
- Vol. 25 (10) , 4841-4850
Conductivity properties of lanthanide-co-doped ceria-based solid oxide electrolytes
- 18 May 2019
- Published by Springer Nature in Ionics
- Vol. 25 (10) , 4841-4850
Conductivity properties of lanthanide-co-doped ceria-based solid oxide electrolytes
- 1 April 2019
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 135 (4) , 571-574
Characterization of High Density CeO2-Based Electrolyte
- 1 April 2019
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 135 (4) , 571-574
Characterization of High Density CeO2-Based Electrolyte
- Open Access
- 1 January 2019
- Published by Walter de Gruyter GmbH
Oxide ionic conductivity and microstructures of Pr and Sm co-doped CeO2-based systems
- 1 January 2019
- Published by Walter de Gruyter GmbH
Open AccessOxide ionic conductivity and microstructures of Pr and Sm co-doped CeO2-based systems
- 23 November 2018
- Published by Taylor & Francis in International Journal of Polymeric Materials and Polymeric Biomaterials
- Vol. 68 (18) , 1167-1176
Production and sulfonation of bioactive polyetheretherketone foam for bone substitute applications
In this study, highly porous polyetheretherketone (PEEK) foams were produced by space holder-powder sintering method for bone substitute material and load-bearing orthopaedic hard tissue (knee, hip or spinal) implant applications. NaCl and carbamide powders were used as a space holder (pore former). PEEK has good chemical resistance, radiolucency, sterilization resistance, and mechanical properties close to bone. However, chemical and biological inertness and hydrophobic surface nature of the PEEK limits the bone attachment. Open pores can provide channels for the bone attachment and body fluid transmission, which is beneficial for implant fixation. In addition, sulfonation surface treatment was carried out in sulfuric acid to enhance the bioactivity. Wettability (contact angle) of the samples was investigated by using optical tensiometer. Wetting behaviour of the samples was increased with sulfonation. Apatite-forming ability (bioactivity) of the sulfonated samples was evaluated in simulated body fluid. Sulfonated foams were exhibited improved bioactivity due to the micro-porous surface structure and hydrophilic SO3H functional groups. Mechanical properties of the foams were also studied.
- 23 November 2018
- Published by Taylor & Francis in International Journal of Polymeric Materials and Polymeric Biomaterials
- Vol. 68 (18) , 1167-1176
Production and sulfonation of bioactive polyetheretherketone foam for bone substitute applications
In this study, highly porous polyetheretherketone (PEEK) foams were produced by space holder-powder sintering method for bone substitute material and load-bearing orthopaedic hard tissue (knee, hip or spinal) implant applications. NaCl and carbamide powders were used as a space holder (pore former). PEEK has good chemical resistance, radiolucency, sterilization resistance, and mechanical properties close to bone. However, chemical and biological inertness and hydrophobic surface nature of the PEEK limits the bone attachment. Open pores can provide channels for the bone attachment and body fluid transmission, which is beneficial for implant fixation. In addition, sulfonation surface treatment was carried out in sulfuric acid to enhance the bioactivity. Wettability (contact angle) of the samples was investigated by using optical tensiometer. Wetting behaviour of the samples was increased with sulfonation. Apatite-forming ability (bioactivity) of the sulfonated samples was evaluated in simulated body fluid. Sulfonated foams were exhibited improved bioactivity due to the micro-porous surface structure and hydrophilic SO3H functional groups. Mechanical properties of the foams were also studied.
- 1 November 2018
- Published by Elsevier in Solid State Ionics
- Vol. 326, 69-76
Synthesis and characterization of Pr/Gd co-doped ceria by using the citric acid–nitrate combustion method
- 1 November 2018
- Published by Elsevier in Solid State Ionics
- Vol. 326, 69-76
Synthesis and characterization of Pr/Gd co-doped ceria by using the citric acid–nitrate combustion method
- 1 July 2018
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 134 (1) , 122-124
Ionic Conductivity of Ce0.9-xGd0.1SmxO2-δ co-doped Ceria Electrolytes
- 1 July 2018
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 134 (1) , 122-124
Ionic Conductivity of Ce0.9-xGd0.1SmxO2-δ co-doped Ceria Electrolytes
- 1 September 2017
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 132 (3) , 458-460
Study on Sm3+ and Er3+ Co-Doped CeO2-Based Electrolytes
- 1 September 2017
- Published by Institute of Physics, Polish Academy of Sciences in Acta Physica Polonica A
- Vol. 132 (3) , 458-460
Study on Sm3+ and Er3+ Co-Doped CeO2-Based Electrolytes
- 10 February 2017
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 48 (5) , 2282-2288
Effect of Er, Gd, and Nd Co-Dopants on the Properties of Sm-Doped Ceria Electrolyte for IT-SOFC
- 10 February 2017
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 48 (5) , 2282-2288
Effect of Er, Gd, and Nd Co-Dopants on the Properties of Sm-Doped Ceria Electrolyte for IT-SOFC