Yoshihiro Oka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yoshihiro Oka has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
Tatsuya Nakamura
3 shared publicationsKeiichi Asami
2 shared publicationsKeiichiro Ohnishi
2 shared publicationsMitsuyasu Yatsuzuka
2 shared publicationsR. Hanafusa
Division of Electronic Materials and Devices, Department of Electrical Engineering and Computer Sciences, Graduate School of Engineering, University of Hyogo, 2167, Shosha, Himeji, Hyogo 671-2201, Japan
2 shared publications- Tatsuya Nakamura
University of Hyogo
2 shared publications
Latest Publications
- Open Access
Hydroxyl Radical Formation and Its Mechanism in Cavitation Bubble Plasma-Treated Water: A Chemical Probe Study
This study investigates the formation of hydroxyl radicals (OH radicals) in cavitation bubble plasma-treated water (CBPTW) using a chemical probe method. CBPTW samples were prepared with different electrode materials (W, Fe, Cu, and Ag), and the chemical scavenger was added two minutes after the completion of cavitation and plasma treatments. The concentrations of metal ions and hydrogen peroxide (H2O2) generated in the CBPTW were also measured over time. This study reveals a novel mechanism whereby metal nanoparticles and ions released from electrodes catalyze the continuous generation of hydroxyl radicals in CBPTW, which has not been fully addressed in previous studies. The results suggest a continuous generation of OH radicals in CBPTW prepared with W, Fe, and Cu electrodes, with the amount of OH radicals produced in the order Cu > Fe > W. The study reveals a correlation between OH radical production and electrode wear, suggesting that the continuous generation of OH radicals in CBPTW results from the catalytic decomposition of H2O2 by metal nanoparticles or ions released from the electrodes. It should be noted that cavitation bubble plasma (CBP) is fundamentally different from sonochemistry. While sonochemistry utilizes ultrasound-induced cavitation to generate radicals, CBP relies on plasma discharge generated inside cavitation bubbles. No ultrasound was applied in this study; therefore, all observed radical formation is attributable exclusively to plasma processes rather than sonochemical effects. However, the precise mechanism of continuous OH radical formation in CBPTW remains unclear and requires further investigation. These findings provide new insights into the role of electrode materials in continuous OH radical generation in cavitation bubble plasma treated water, offering potential applications in water purification and sterilization technologies.
Open AccessHydroxyl Radical Formation and Its Mechanism in Cavitation Bubble Plasma-Treated Water: A Chemical Probe Study
This study investigates the formation of hydroxyl radicals (OH radicals) in cavitation bubble plasma-treated water (CBPTW) using a chemical probe method. CBPTW samples were prepared with different electrode materials (W, Fe, Cu, and Ag), and the chemical scavenger was added two minutes after the completion of cavitation and plasma treatments. The concentrations of metal ions and hydrogen peroxide (H2O2) generated in the CBPTW were also measured over time. This study reveals a novel mechanism whereby metal nanoparticles and ions released from electrodes catalyze the continuous generation of hydroxyl radicals in CBPTW, which has not been fully addressed in previous studies. The results suggest a continuous generation of OH radicals in CBPTW prepared with W, Fe, and Cu electrodes, with the amount of OH radicals produced in the order Cu > Fe > W. The study reveals a correlation between OH radical production and electrode wear, suggesting that the continuous generation of OH radicals in CBPTW results from the catalytic decomposition of H2O2 by metal nanoparticles or ions released from the electrodes. It should be noted that cavitation bubble plasma (CBP) is fundamentally different from sonochemistry. While sonochemistry utilizes ultrasound-induced cavitation to generate radicals, CBP relies on plasma discharge generated inside cavitation bubbles. No ultrasound was applied in this study; therefore, all observed radical formation is attributable exclusively to plasma processes rather than sonochemical effects. However, the precise mechanism of continuous OH radical formation in CBPTW remains unclear and requires further investigation. These findings provide new insights into the role of electrode materials in continuous OH radical generation in cavitation bubble plasma treated water, offering potential applications in water purification and sterilization technologies.
- Open Access
- 14 September 2025
- Published by Springer Nature in Discover Plants
- Vol. 2 (1) , 1-19
Effect of discharge electrode material on germination of radish sprout using cavitation bubble plasma treated water
Low-temperature plasma has been attracting attention as a new method to promote seed germination. Cavitation bubble plasma, a type of low-temperature plasma, is a technology that generates electrode-derived metal nanoparticles/ions and abundant reactive oxygen species in water. In this study, it was investigated that the germination rate of radish (Raphanus sativus L.) sprouts seeds soaked in cavitation bubble plasma treated water produced using different electrode materials. It was revealed that the characteristics (metal concentration, hydrogen peroxide concentration, Oxidation–Reduction Potential, pH, conductivity) differed depending on the electrode material. Cavitation bubble plasma treated water produced using W, Fe, and Cu electrodes had high hydrogen peroxide concentrations and promoted seed germination. On the other hand, in the case of Ag electrodes, hydrogen peroxide rapidly decreased and did not promote germination. The germination rate of seeds soaked in hydrogen peroxide increased, but the germination-promoting effect was not as great as that of cavitation bubble plasma treated water, suggesting the involvement of other reactive oxygen species.
- 14 September 2025
- Published by Springer Nature in Discover Plants
- Vol. 2 (1) , 1-19
Open AccessEffect of discharge electrode material on germination of radish sprout using cavitation bubble plasma treated water
Low-temperature plasma has been attracting attention as a new method to promote seed germination. Cavitation bubble plasma, a type of low-temperature plasma, is a technology that generates electrode-derived metal nanoparticles/ions and abundant reactive oxygen species in water. In this study, it was investigated that the germination rate of radish (Raphanus sativus L.) sprouts seeds soaked in cavitation bubble plasma treated water produced using different electrode materials. It was revealed that the characteristics (metal concentration, hydrogen peroxide concentration, Oxidation–Reduction Potential, pH, conductivity) differed depending on the electrode material. Cavitation bubble plasma treated water produced using W, Fe, and Cu electrodes had high hydrogen peroxide concentrations and promoted seed germination. On the other hand, in the case of Ag electrodes, hydrogen peroxide rapidly decreased and did not promote germination. The germination rate of seeds soaked in hydrogen peroxide increased, but the germination-promoting effect was not as great as that of cavitation bubble plasma treated water, suggesting the involvement of other reactive oxygen species.
- Open Access
Dispersion of Long and Isolated Single-Wall Carbon Nanotubes by Using a Hydrodynamic Cavitation Method
Single-wall carbon nanotubes (SWCNTs) are promising materials for electronic applications, such as transparent electrodes and thin-film transistors. However, the dispersion of isolated SWCNTs into solvents remains an important issue for their practical applications. SWCNTs are commonly dispersed in solvents via ultrasonication. However, ultrasonication damages SWCNTs, forming defects and cutting them into short pieces, which significantly degrade their electrical and mechanical properties. Herein, we demonstrate a novel approach toward the large-scale dispersion of long and isolated SWCNTs by using hydrodynamic cavitation. Considering the results of atomic force microscopy and dynamic light-scattering measurements, the average length of the SWCNTs dispersed via the hydrodynamic cavitation method is larger than that of the SWCNTs dispersed by using an ultrasonic homogenizer.
Open AccessDispersion of Long and Isolated Single-Wall Carbon Nanotubes by Using a Hydrodynamic Cavitation Method
Single-wall carbon nanotubes (SWCNTs) are promising materials for electronic applications, such as transparent electrodes and thin-film transistors. However, the dispersion of isolated SWCNTs into solvents remains an important issue for their practical applications. SWCNTs are commonly dispersed in solvents via ultrasonication. However, ultrasonication damages SWCNTs, forming defects and cutting them into short pieces, which significantly degrade their electrical and mechanical properties. Herein, we demonstrate a novel approach toward the large-scale dispersion of long and isolated SWCNTs by using hydrodynamic cavitation. Considering the results of atomic force microscopy and dynamic light-scattering measurements, the average length of the SWCNTs dispersed via the hydrodynamic cavitation method is larger than that of the SWCNTs dispersed by using an ultrasonic homogenizer.
- Open Access
- 15 December 2019
- Published by The Japanese Society for Multiphase Flow in JAPANESE JOURNAL OF MULTIPHASE FLOW
- Vol. 33 (4) , 374-381
Cavitation Bubble Plasma Technology and Its Applications
A cavitation bubble plasma, which is a kind of plasma in solution, is a low-temperature plasma generated in a large number of microbubbles of a solvent component generated by a cavitation phenomenon. In this paper, the cavitation bubble plasma technology is explained by introducing the originally developed apparatus, the discharge phenomenon, and the effect of cavitation bubbles. As application examples of cavitation bubble plasma, the results of water dispersion of carbon nanotubes, synthesis of silver nanoparticles, sterilization of Escherichia coli, and decomposition of methylene blue are introduced.
- 15 December 2019
- Published by The Japanese Society for Multiphase Flow in JAPANESE JOURNAL OF MULTIPHASE FLOW
- Vol. 33 (4) , 374-381
Open AccessCavitation Bubble Plasma Technology and Its Applications
A cavitation bubble plasma, which is a kind of plasma in solution, is a low-temperature plasma generated in a large number of microbubbles of a solvent component generated by a cavitation phenomenon. In this paper, the cavitation bubble plasma technology is explained by introducing the originally developed apparatus, the discharge phenomenon, and the effect of cavitation bubbles. As application examples of cavitation bubble plasma, the results of water dispersion of carbon nanotubes, synthesis of silver nanoparticles, sterilization of Escherichia coli, and decomposition of methylene blue are introduced.
- 1 May 2016
- Published by Elsevier in Solid State Ionics
- Vol. 288, 180-183
Electrochemical study of LiMn1.5Ni0.5O4 spinel oxides prepared by two-step process
- 1 May 2016
- Published by Elsevier in Solid State Ionics
- Vol. 288, 180-183
Electrochemical study of LiMn1.5Ni0.5O4 spinel oxides prepared by two-step process
- Open Access
- 16 December 2014
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (2) , A3045-A3051
Electrochemical and Magnetic Studies of Li-Deficient Li1-xCo1-xFexPO4Olivine Cathode Compounds
Li-deficient olivine compounds, Li1-xCo1-xFexPO4 (x < 0.15), were prepared by calcination of the sol-gel derived precursors in ambient atmosphere. They were almost single phase at x < 0.10 but some impurity phases were found at x > 0.10. The lattice parameters changed continuously with an increase in the Fe substitution. Their variation in the range of x < 0.10 roughly obeyed Vergard's law. From the 57Fe Mössbauer spectrum at room temperature, it was shown that the introduced Fe took a trivalent high-spin state in the olivine lattice. The temperature-dependent magnetic susceptibility exhibited that the Fe incorporation enhanced the antiferromagnetic ordering: the Neel temperature shifted higher. Furthermore, the electrochemical performances, such as cycling stability and rate capability, were improved significantly with an appropriate substitution (about 10%) with Fe3+. Consequently, the Fe3+ incorporated compounds with Li deficiency as the charge compensation are thought to be good candidates as high-voltage cathode material, which may enhance the energy density of Li ion battery.
- 16 December 2014
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 162 (2) , A3045-A3051
Open AccessElectrochemical and Magnetic Studies of Li-Deficient Li1-xCo1-xFexPO4Olivine Cathode Compounds
Li-deficient olivine compounds, Li1-xCo1-xFexPO4 (x < 0.15), were prepared by calcination of the sol-gel derived precursors in ambient atmosphere. They were almost single phase at x < 0.10 but some impurity phases were found at x > 0.10. The lattice parameters changed continuously with an increase in the Fe substitution. Their variation in the range of x < 0.10 roughly obeyed Vergard's law. From the 57Fe Mössbauer spectrum at room temperature, it was shown that the introduced Fe took a trivalent high-spin state in the olivine lattice. The temperature-dependent magnetic susceptibility exhibited that the Fe incorporation enhanced the antiferromagnetic ordering: the Neel temperature shifted higher. Furthermore, the electrochemical performances, such as cycling stability and rate capability, were improved significantly with an appropriate substitution (about 10%) with Fe3+. Consequently, the Fe3+ incorporated compounds with Li deficiency as the charge compensation are thought to be good candidates as high-voltage cathode material, which may enhance the energy density of Li ion battery.