Mrinmoy Garai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mrinmoy Garai has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Basudeb Karmakar
CSIR-Central Glass and Ceramic Research Institute
10 shared publications Basudeb Karmakar
6 shared publicationsNibedita Sasmal
Glass Science and Technology Section, Glass Division, CSIR-Central Glass and Ceramic Research Institute196 Raja S.C. Mullick RoadKolkata 700032India
6 shared publicationsAnal Tarafder
2 shared publications- Arianit A. Reka
Department of Chemistry, Faculty of Natural Sciences and Mathematics, University of Tetova, 1200 Tetovo, North Macedonia
2 shared publications Atiar R. Molla
Specialty Glass Division, CSIR-Central Glass & Ceramic Research Institute (CGCRI), Kolkata, India
2 shared publications
Latest Publications
- 29 March 2022
- Published by Elsevier in Solid State Communications
- Vol. 350
Crystallization and microstructure in K2O substituted SiO2–MgO–Al2O3–Li2O–AlPO4 glass-ceramics
- 29 March 2022
- Published by Elsevier in Solid State Communications
- Vol. 350
Crystallization and microstructure in K2O substituted SiO2–MgO–Al2O3–Li2O–AlPO4 glass-ceramics
- 15 January 2022
- Published by Elsevier
- p. 29-48
Adsorption of Cr(VI) ions from aqueous solutions by diatomite and clayey diatomite
- 15 January 2022
- Published by Elsevier
- p. 29-48
Adsorption of Cr(VI) ions from aqueous solutions by diatomite and clayey diatomite
- 6 December 2021
- Published by International Association of Advanced Materials in Advanced Materials Proceedings
- Vol. 3 (4) , 206-212
Zn2+ Substitution by Pb2+ in Alkaline-boro-aluminosilicate Glass-ceramics: Microstructural Aspects
- 6 December 2021
- Published by International Association of Advanced Materials in Advanced Materials Proceedings
- Vol. 3 (4) , 206-212
Zn2+ Substitution by Pb2+ in Alkaline-boro-aluminosilicate Glass-ceramics: Microstructural Aspects
- Open Access
- 18 March 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (19) , 11415-11424
Microstructure–mechanical properties of Ag0/Au0 doped K–Mg–Al–Si–O–F glass-ceramics
In understanding the catalytic efficacy of silver (Ag0) and gold (Au0) nanoparticles (NPs) on glass-ceramic (GC) crystallization, the microstructure–machinability correlation of a SiO2–MgO–Al2O3–B2O3–K2O–MgF2 system is studied.
- 18 March 2021
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 11 (19) , 11415-11424
Open AccessMicrostructure–mechanical properties of Ag0/Au0 doped K–Mg–Al–Si–O–F glass-ceramics
In understanding the catalytic efficacy of silver (Ag0) and gold (Au0) nanoparticles (NPs) on glass-ceramic (GC) crystallization, the microstructure–machinability correlation of a SiO2–MgO–Al2O3–B2O3–K2O–MgF2 system is studied.
- 1 December 2020
- Published by Elsevier in Materials Today Energy
- Vol. 18
Zr+4-controlled nucleation and microstructure in Si-Mg-Al-K-B-F glass-ceramic sealant (solid oxide fuel cell)
- 1 December 2020
- Published by Elsevier in Materials Today Energy
- Vol. 18
Zr+4-controlled nucleation and microstructure in Si-Mg-Al-K-B-F glass-ceramic sealant (solid oxide fuel cell)
- Open Access
- 11 May 2020
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 1 (3) , 463-468
Nanocrystalline microstructure in Sm3+ and Gd3+ doped K2O–MgO–Al2O3–SiO2–F glass-ceramic sealant (SOFC)
In order to demonstrate the effects of Sm3+ and Gd3+ ions on the crystalline microstructures of the magnesium-boro-alumino-silicate (MBAS) system, the K2O–MgO–B2O3–Al2O3–SiO2–F glass doped with 0–5 mol% Sm2O3 and Gd2O3 were synthesized by melt-quenching (1550 °C).
- 11 May 2020
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 1 (3) , 463-468
Open AccessNanocrystalline microstructure in Sm3+ and Gd3+ doped K2O–MgO–Al2O3–SiO2–F glass-ceramic sealant (SOFC)
In order to demonstrate the effects of Sm3+ and Gd3+ ions on the crystalline microstructures of the magnesium-boro-alumino-silicate (MBAS) system, the K2O–MgO–B2O3–Al2O3–SiO2–F glass doped with 0–5 mol% Sm2O3 and Gd2O3 were synthesized by melt-quenching (1550 °C).
- Open Access
- 31 March 2020
- Published by Frontiers Media SA in Frontiers in Materials
- Vol. 7
Cr+6 Controlled Nucleation in SiO2-MgO-Al2O3-K2O-B2O3-F Glass Sealant (SOFC)
This study highlights the strong effect of chromium (Cr6+) as a nucleating agent for SiO2-MgO-Al2O3-B2O3-K2O-F glass sealant. In the process, Al2O3 from the base glass was gradually substituted by K2Cr2O7, which considerably tuned the crystallization characteristics, microstructure, thermal, and mechanical properties. The distinctive feature of this study is the induction of nucleation and crystallization in glass matrix on addition of Cr6+ content performing only annealing heat-treatment (600°C). The melt-quenched SiO2-MgO-Al2O3-B2O3-K2O-F glass with zero Cr6+ content is found amorphous, which in presence of Cr6+ content became crystalline with MgCr2O4, K3CrF6, MgF2, and mullite (3Al2O3.2SiO2) phases. Glassy features in DSC and dilatometric thermal properties (Tg, Td, thermal expansion) were attained in glass without Cr- content, but glass-ceramic-like features obtained for Cr- containing glasses. Large thermal expansion (>11 × 10–6/K) was achieved for such glasses, and that is compatible with the CTE of solid oxide fuel cell (SOFC) components (electrode, interconnect, etc.) at the operating temperature (700–900°C). FESEM study revealed the development of 200–500 nm sized crystallites in 2 mol% K2Cr2O7-containing glass microstructure and that became more compact sorted with 10–50 μm sized crystals in higher Cr-doped glasses. Higher crystallinity was thus ascertained for higher Cr-containing glasses, which influenced the corresponding density and mechanical properties. From nano-indentation measurements, the hardness and Young’s modulus were estimated to be 0.6 (±0.5) and 25 (±10) GPa, respectively, for base glass and in the range of 3.3 to 8.4 and 58 to 94 GPa, respectively, for Cr-containing glass-ceramics. Hardness measured from micro-indentation tests for the base glass was 3.63 (± 0.18) GPa, which increased to 3.94–6.08 GPa for Cr-containing glass-ceramics. Due to the typical microstructure and compatible thermal and mechanical properties, 2 mol% K2Cr2O7-doped SiO2-MgO-Al2O3-B2O3-K2O-F glass can be useable as high temperature sealant (like SOFC).
- 31 March 2020
- Published by Frontiers Media SA in Frontiers in Materials
- Vol. 7
Open AccessCr+6 Controlled Nucleation in SiO2-MgO-Al2O3-K2O-B2O3-F Glass Sealant (SOFC)
This study highlights the strong effect of chromium (Cr6+) as a nucleating agent for SiO2-MgO-Al2O3-B2O3-K2O-F glass sealant. In the process, Al2O3 from the base glass was gradually substituted by K2Cr2O7, which considerably tuned the crystallization characteristics, microstructure, thermal, and mechanical properties. The distinctive feature of this study is the induction of nucleation and crystallization in glass matrix on addition of Cr6+ content performing only annealing heat-treatment (600°C). The melt-quenched SiO2-MgO-Al2O3-B2O3-K2O-F glass with zero Cr6+ content is found amorphous, which in presence of Cr6+ content became crystalline with MgCr2O4, K3CrF6, MgF2, and mullite (3Al2O3.2SiO2) phases. Glassy features in DSC and dilatometric thermal properties (Tg, Td, thermal expansion) were attained in glass without Cr- content, but glass-ceramic-like features obtained for Cr- containing glasses. Large thermal expansion (>11 × 10–6/K) was achieved for such glasses, and that is compatible with the CTE of solid oxide fuel cell (SOFC) components (electrode, interconnect, etc.) at the operating temperature (700–900°C). FESEM study revealed the development of 200–500 nm sized crystallites in 2 mol% K2Cr2O7-containing glass microstructure and that became more compact sorted with 10–50 μm sized crystals in higher Cr-doped glasses. Higher crystallinity was thus ascertained for higher Cr-containing glasses, which influenced the corresponding density and mechanical properties. From nano-indentation measurements, the hardness and Young’s modulus were estimated to be 0.6 (±0.5) and 25 (±10) GPa, respectively, for base glass and in the range of 3.3 to 8.4 and 58 to 94 GPa, respectively, for Cr-containing glass-ceramics. Hardness measured from micro-indentation tests for the base glass was 3.63 (± 0.18) GPa, which increased to 3.94–6.08 GPa for Cr-containing glass-ceramics. Due to the typical microstructure and compatible thermal and mechanical properties, 2 mol% K2Cr2O7-doped SiO2-MgO-Al2O3-B2O3-K2O-F glass can be useable as high temperature sealant (like SOFC).
- 1 December 2018
- Published by Elsevier in Ceramics International
- Vol. 44 (18) , 22308-22317
Microstructural characterization and wear properties of silver and gold nanoparticle doped K-Mg-Al-Si-O-F glass-ceramics
- 1 December 2018
- Published by Elsevier in Ceramics International
- Vol. 44 (18) , 22308-22317
Microstructural characterization and wear properties of silver and gold nanoparticle doped K-Mg-Al-Si-O-F glass-ceramics
- 10 July 2018
- Published by Springer Nature in MRS Advances
- Vol. 3 (60) , 3525-3533
Zn2+- Controlled Crystallization and Microstructure in K-Li-Mg-B-Si-Al-F Glass
- 10 July 2018
- Published by Springer Nature in MRS Advances
- Vol. 3 (60) , 3525-3533
Zn2+- Controlled Crystallization and Microstructure in K-Li-Mg-B-Si-Al-F Glass
- 1 September 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 678, 360-369
Rare earth ion controlled crystallization of mica glass-ceramics
- 1 September 2016
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 678, 360-369
Rare earth ion controlled crystallization of mica glass-ceramics