Marta Mucientes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Marta Mucientes has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
- Oleg Victor Kolosov
Department of Physics, Lancaster University, Lancaster LA1 4YB, UK
5 shared publications - Charalambos Evangeli
Department of Materials, University of Oxford, Oxford OX1 3PH, United Kingdom
2 shared publications - Hatef Sadeghi
University of Warwick
2 shared publications - Jean Spièce
Institute of Condensed Matter and Nanosciences Université Catholique de Louvain (UCLouvain) 1348 Louvain‐la‐Neuve Belgium
2 shared publications Kunal Lulla
Physics Department, Lancaster University, Lancaster LA1 4YW, UK
2 shared publicationsA. Jennings
Department of Physics, Lancaster University 1 , Lancaster LA1 4YB, United Kingdom
1 shared publication
Latest Publications
- Open Access
- 1 March 2022
- Published by AIP Publishing in APL Materials
- Vol. 10 (3) , 031109
Solution-processed thin film transistors incorporating YSZ gate dielectrics processed at 400 °C
This work investigates a solution process for yttria-stabilized zirconia (YSZ) thin film deposition involving the addition of yttria nanoparticles, at 400 °C, in air. Different yttrium doping levels in the YSZ were studied and a wide range of optical, structural, surface, dielectric, and electronic transport properties were also investigated. An optimum yttrium doping level of 5% mol. resulted in the smoothest films (RRMS ∼ 0.5 nm), a wide bandgap (∼5.96 eV), a dielectric constant in excess of 26, and a leakage current of ∼0.3 nA cm−2 at 2 MV/cm. The solution-processed YSZ films were incorporated as gate dielectrics in thin films transistors with solution-processed In2O3 semiconducting channels. Excellent operational characteristics, such as negligible hysteresis, low operational voltages (5 V), electron mobility in excess of 36 cm2 V−1 s−1, high on/off current modulation ratio on the order of 107, and low interfacial trap density states (12 cm−2), were demonstrated. In addition, excellent film homogeneity was achieved over a large area (16 × 16 cm2), with both film thickness and capacitance deviation of <1.2%.
- 1 March 2022
- Published by AIP Publishing in APL Materials
- Vol. 10 (3) , 031109
Open AccessSolution-processed thin film transistors incorporating YSZ gate dielectrics processed at 400 °C
This work investigates a solution process for yttria-stabilized zirconia (YSZ) thin film deposition involving the addition of yttria nanoparticles, at 400 °C, in air. Different yttrium doping levels in the YSZ were studied and a wide range of optical, structural, surface, dielectric, and electronic transport properties were also investigated. An optimum yttrium doping level of 5% mol. resulted in the smoothest films (RRMS ∼ 0.5 nm), a wide bandgap (∼5.96 eV), a dielectric constant in excess of 26, and a leakage current of ∼0.3 nA cm−2 at 2 MV/cm. The solution-processed YSZ films were incorporated as gate dielectrics in thin films transistors with solution-processed In2O3 semiconducting channels. Excellent operational characteristics, such as negligible hysteresis, low operational voltages (5 V), electron mobility in excess of 36 cm2 V−1 s−1, high on/off current modulation ratio on the order of 107, and low interfacial trap density states (12 cm−2), were demonstrated. In addition, excellent film homogeneity was achieved over a large area (16 × 16 cm2), with both film thickness and capacitance deviation of <1.2%.
- Open Access
- 27 January 2022
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 14 (7) , 2593-2598
Low thermal conductivity in franckeite heterostructures
Franckeite, a natural 2D heterostructure, competes with high ZT values materials thanks to its measured low anisotropic thermal conductivity and high Seebeck coefficient.
- 27 January 2022
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 14 (7) , 2593-2598
Open AccessLow thermal conductivity in franckeite heterostructures
Franckeite, a natural 2D heterostructure, competes with high ZT values materials thanks to its measured low anisotropic thermal conductivity and high Seebeck coefficient.
- 17 July 2020
- Published by IOP Publishing in Nanotechnology
- Vol. 31 (41) , 415702
Mapping nanoscale dynamic properties of suspended and supported multi-layer graphene membranes via contact resonance and ultrasonic scanning probe microscopies
Graphene’s (GR) remarkable mechanical and electrical properties—such as its Young’s modulus, low mass per unit area, natural atomic flatness and electrical conductance—would make it an ideal material for micro and nanoelectromechanical systems (MEMS and NEMS). However, the difficulty of attaching GR to supports, coupled with naturally occurring internal defects in a few layer GR can significantly adversely affect the performance of such devices. Here, we have used a combined contact resonance atomic force microscopy (CR-AFM) and ultrasonic force microscopy (UFM) approach to characterise and map with nanoscale spatial resolution GR membrane properties inaccessible to most conventional scanning probe characterisation techniques. Using a multi-layer GR plate (membrane) suspended over a round hole, we show that this combined approach allows access to the mechanical properties, internal structure and attachment geometry of the membrane providing information about both the supported and suspended regions of the system. We show that UFM allows the precise geometrical position of the supported membrane-substrate contact to be located and provides an indication of the local variation of its quality in the contact areas. At the same time, we show that by mapping the position sensitive frequency and phase response of CR-AFM response, one can reliably quantify the membrane stiffness, and image the defects in the suspended area of the membrane. The phase and amplitude of experimental CR-AFM measurements show excellent agreement with an analytical model accounting for the resonance of the combined CR-AFM probe-membrane system. The combination of UFM and CR-AFM provide a beneficial combination for the investigation of few-layer NEMS systems based on two dimensional materials.
- 17 July 2020
- Published by IOP Publishing in Nanotechnology
- Vol. 31 (41) , 415702
Mapping nanoscale dynamic properties of suspended and supported multi-layer graphene membranes via contact resonance and ultrasonic scanning probe microscopies
Graphene’s (GR) remarkable mechanical and electrical properties—such as its Young’s modulus, low mass per unit area, natural atomic flatness and electrical conductance—would make it an ideal material for micro and nanoelectromechanical systems (MEMS and NEMS). However, the difficulty of attaching GR to supports, coupled with naturally occurring internal defects in a few layer GR can significantly adversely affect the performance of such devices. Here, we have used a combined contact resonance atomic force microscopy (CR-AFM) and ultrasonic force microscopy (UFM) approach to characterise and map with nanoscale spatial resolution GR membrane properties inaccessible to most conventional scanning probe characterisation techniques. Using a multi-layer GR plate (membrane) suspended over a round hole, we show that this combined approach allows access to the mechanical properties, internal structure and attachment geometry of the membrane providing information about both the supported and suspended regions of the system. We show that UFM allows the precise geometrical position of the supported membrane-substrate contact to be located and provides an indication of the local variation of its quality in the contact areas. At the same time, we show that by mapping the position sensitive frequency and phase response of CR-AFM response, one can reliably quantify the membrane stiffness, and image the defects in the suspended area of the membrane. The phase and amplitude of experimental CR-AFM measurements show excellent agreement with an analytical model accounting for the resonance of the combined CR-AFM probe-membrane system. The combination of UFM and CR-AFM provide a beneficial combination for the investigation of few-layer NEMS systems based on two dimensional materials.
- Open Access
- 9 September 2019
- Published by AIP Publishing in Applied Physics Letters
- Vol. 115 (11) , 113103
Multimode probing of superfluid 4He by tuning forks
Flexural mode vibrations of miniature piezoelectric tuning forks (TFs) are known to be highly sensitive to superfluid excitations and quantum turbulence in 3He and 4He quantum fluids, as well as to the elastic properties of solid 4He, complementing studies by large scale torsional resonators. Here, we explore the sensitivity of a TF, capable of simultaneously operating in both the flexural and torsional modes, to excitations in the normal and superfluid 4He. The torsional mode is predominantly sensitive to shear forces at the sensor–fluid interface and much less sensitive to changes in the density of the surrounding fluid when compared to the flexural mode. Although we did not reach the critical velocity for the quantum turbulence onset in the torsional mode, due to its order of magnitude higher frequency and increased acoustic damping, the torsional mode was directly sensitive to fluid excitations, linked to quantum turbulence created by the flexural mode. The combination of two dissimilar modes in a single TF sensor can provide a means to study the details of elementary excitations in quantum liquids and at interfaces between solids and quantum fluid.
- 9 September 2019
- Published by AIP Publishing in Applied Physics Letters
- Vol. 115 (11) , 113103
Open AccessMultimode probing of superfluid 4He by tuning forks
Flexural mode vibrations of miniature piezoelectric tuning forks (TFs) are known to be highly sensitive to superfluid excitations and quantum turbulence in 3He and 4He quantum fluids, as well as to the elastic properties of solid 4He, complementing studies by large scale torsional resonators. Here, we explore the sensitivity of a TF, capable of simultaneously operating in both the flexural and torsional modes, to excitations in the normal and superfluid 4He. The torsional mode is predominantly sensitive to shear forces at the sensor–fluid interface and much less sensitive to changes in the density of the surrounding fluid when compared to the flexural mode. Although we did not reach the critical velocity for the quantum turbulence onset in the torsional mode, due to its order of magnitude higher frequency and increased acoustic damping, the torsional mode was directly sensitive to fluid excitations, linked to quantum turbulence created by the flexural mode. The combination of two dissimilar modes in a single TF sensor can provide a means to study the details of elementary excitations in quantum liquids and at interfaces between solids and quantum fluid.
- 7 August 2019
- Published by Wiley in Advanced Electronic Materials
- Vol. 5 (10) , 1900331
Nanoscale Thermal Transport in 2D Nanostructures from Cryogenic to Room Temperature
Nanoscale scanning thermal microscopy (SThM) transport measurements from cryogenic to room temperature on 2D structures with sub 30 nm resolution are reported. This novel cryogenic operation of SThM, extending the temperature range of the sample down to 150 K, yields a clear insight into the nanothermal properties of the 2D nanostructures and supports the model of ballistic transport contribution at the edge of the detached areas of exfoliated graphene which leads to a size‐dependent thermal resistance of the detached material. The thermal resistance of graphene on SiO2 is increased by one order of magnitude by the addition of a top layer of MoS2, over the temperature range of 150–300 K, providing pathways for increasing the efficiency of thermoelectric applications using van der Waals (vdW) materials. Density functional theory calculations demonstrate that this increase originates from the phonon transport filtering in the weak vdW coupling between the layers and the vibrational mismatch between MoS2 and graphene layers.
- 7 August 2019
- Published by Wiley in Advanced Electronic Materials
- Vol. 5 (10) , 1900331
Nanoscale Thermal Transport in 2D Nanostructures from Cryogenic to Room Temperature
Nanoscale scanning thermal microscopy (SThM) transport measurements from cryogenic to room temperature on 2D structures with sub 30 nm resolution are reported. This novel cryogenic operation of SThM, extending the temperature range of the sample down to 150 K, yields a clear insight into the nanothermal properties of the 2D nanostructures and supports the model of ballistic transport contribution at the edge of the detached areas of exfoliated graphene which leads to a size‐dependent thermal resistance of the detached material. The thermal resistance of graphene on SiO2 is increased by one order of magnitude by the addition of a top layer of MoS2, over the temperature range of 150–300 K, providing pathways for increasing the efficiency of thermoelectric applications using van der Waals (vdW) materials. Density functional theory calculations demonstrate that this increase originates from the phonon transport filtering in the weak vdW coupling between the layers and the vibrational mismatch between MoS2 and graphene layers.