Seyed Mostafa Nowee
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Seyed Mostafa Nowee has a total of 43 co-authors. Here are the top co-authors by number of shared publications:
- Ali Abbas
School of Chemical and Biomolecular Engineering, University of Sydney, NSW 2006, Australia
4 shared publications - Navid Ramezanian
Department of Chemistry, Faculty of Science, Ferdowsi University of Mashhad, Mashhad, Iran
4 shared publications Jose A. Romagnoli
Department of Chemical Engineering, Louisiana State University, USA
3 shared publicationsDariush Jafari
Department of Chemical Engineering, Bushehr Branch, Islamic Azad University, Bushehr, Iran
2 shared publicationsIman Abrishamchi
Ferdowsi University of Mashhad
2 shared publicationsMeysam Moradgholi
2 shared publications
Latest Publications
- 26 August 2025
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 138 (6) , 3745-3763
Model identification of gas antisolvent crystallization of aspirin using nucleation, growth, and agglomeration kinetics
- 26 August 2025
- Published by Springer Nature in Reaction Kinetics, Mechanisms and Catalysis
- Vol. 138 (6) , 3745-3763
Model identification of gas antisolvent crystallization of aspirin using nucleation, growth, and agglomeration kinetics
- 1 April 2020
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 156, 402-413
Numerical simulation and theoretical investigation of a multi-cycle dual-evaporator adsorption desalination and cooling system
- 1 April 2020
- Published by Elsevier in Chemical Engineering Research and Design
- Vol. 156, 402-413
Numerical simulation and theoretical investigation of a multi-cycle dual-evaporator adsorption desalination and cooling system
- 1 November 2018
- Published by Elsevier in Renewable Energy
- Vol. 127, 433-443
Synergetic combination of 1D-2D g-C3N4 heterojunction nanophotocatalyst for hydrogen production via water splitting under visible light irradiation
- 1 November 2018
- Published by Elsevier in Renewable Energy
- Vol. 127, 433-443
Synergetic combination of 1D-2D g-C3N4 heterojunction nanophotocatalyst for hydrogen production via water splitting under visible light irradiation
- 1 April 2018
- Published by Elsevier in Solar Energy
- Vol. 164, 243-250
Experimental study of using Al2O3/methanol nanofluid in a two phase closed thermosyphon (TPCT) array as a novel photovoltaic/thermal system
- 1 April 2018
- Published by Elsevier in Solar Energy
- Vol. 164, 243-250
Experimental study of using Al2O3/methanol nanofluid in a two phase closed thermosyphon (TPCT) array as a novel photovoltaic/thermal system
- 2 August 2017
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 15 (7) , 1509-1520
Comparative study on adsorption of chromium(VI) from industrial wastewater onto nature-derived adsorbents (brown coal and zeolite)
- 2 August 2017
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 15 (7) , 1509-1520
Comparative study on adsorption of chromium(VI) from industrial wastewater onto nature-derived adsorbents (brown coal and zeolite)
- 1 February 2017
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 42, 300-314
Modeling and simulation of phenol removal from wastewater using a membrane contactor as a bioreactor
- 1 February 2017
- Published by Elsevier in Applied Mathematical Modelling
- Vol. 42, 300-314
Modeling and simulation of phenol removal from wastewater using a membrane contactor as a bioreactor
- 4 May 2016
- Published by Taylor & Francis in Journal of Dispersion Science and Technology
- Vol. 38 (5) , 677-685
A kinetic modeling of particle formation by gas antisolvent process: Precipitation of aspirin
Population balance equations (PBEs) are often integro-partial differential in nature due to complexities involved in nonconventional crystallization processes, especially gas antisolvent (GAS). The reason is that they include phenomena such as primary nucleation, secondary nucleation, crystal growth, agglomeration, and/or breakage of crystals. Therefore, the solution to such models has become rather difficult. Considering these difficulties, a powerful numerical algorithm was adopted in this paper to treat the population balance model for the precipitation of aspirin by the GAS process. This method was the combination of Lax–Wendroff and Crank–Nicholson numerical methods. It was used to investigate the effect of significant operating parameters, that is, antisolvent addition rate, process temperature, and solute concentration, on the final product properties for two solvents. The antisolvent addition rate was varied between 8 and 40 bar/min, the process temperature was kept constant at levels 37°C and 42°C, the solute concentration was manipulated at two levels, namely, 0.2 and 0.27 g solute/g solution, and methanol and acetone were used as the organic solvents. The results indicated the successful performance of the applied method in treating PBE, since smooth particle size distributions were produced, which were in an acceptable agreement with the experimental data of the investigated system.
- 4 May 2016
- Published by Taylor & Francis in Journal of Dispersion Science and Technology
- Vol. 38 (5) , 677-685
A kinetic modeling of particle formation by gas antisolvent process: Precipitation of aspirin
Population balance equations (PBEs) are often integro-partial differential in nature due to complexities involved in nonconventional crystallization processes, especially gas antisolvent (GAS). The reason is that they include phenomena such as primary nucleation, secondary nucleation, crystal growth, agglomeration, and/or breakage of crystals. Therefore, the solution to such models has become rather difficult. Considering these difficulties, a powerful numerical algorithm was adopted in this paper to treat the population balance model for the precipitation of aspirin by the GAS process. This method was the combination of Lax–Wendroff and Crank–Nicholson numerical methods. It was used to investigate the effect of significant operating parameters, that is, antisolvent addition rate, process temperature, and solute concentration, on the final product properties for two solvents. The antisolvent addition rate was varied between 8 and 40 bar/min, the process temperature was kept constant at levels 37°C and 42°C, the solute concentration was manipulated at two levels, namely, 0.2 and 0.27 g solute/g solution, and methanol and acetone were used as the organic solvents. The results indicated the successful performance of the applied method in treating PBE, since smooth particle size distributions were produced, which were in an acceptable agreement with the experimental data of the investigated system.