Changshou Hong

The majority of uranium mill tailing impoundments in the southern part of China are located in humid subtropical regions where persistent rainfall and rapid evaporation of water after rain often occur. Under the prolonged influence of alternating wet and dry conditions, the covering soil layer of uranium mill tailing impoundments develops cracks, leading to the issue of degradation or even failure of the radon retardation effect. A beach surface of uranium mill tailing impoundments in the southern part of China is selected as the research object. Through use of a self-made simulation test device, a degradation experiment of uranium mill tailing covering soil models under wetting-drying cycles was conducted indoors. The experimental results indicate that with a constant amplitude of wetting-drying cycles, microcracks characterized by a narrow width and high abundance were mainly generated in the early-to-mid-stage of wetting-drying cycles. The main cracks, characterized by their wide width and less abundance, were mainly formed in the mid-to-late stage of wetting-drying cycles. After seven wetting-drying cycles, the total length of cracks showed a "stair-step" increase and the surface crack ratio exhibited a trend of moving from rapid growth to stable growth and then to a slight decline. The cumulative damage degree showed a rapid increase to stable growth with an increase in the number of wetting-drying cycles. Grey relational analysis revealed that, compared to other surface crack indicators, radon exhalation rate was the most closely correlated with the surface crack ratio. With a constant amplitude of wetting-drying cycles, the radon exhalation rate underwent four stages as the number of wetting-drying cycles increased: stage I witnessed a rapid increase, stage II witnessed a rapid decrease, stage III witnessed a gradual increase, and stage IV witnessed a stable or even slight decrease. With a constant number of wetting-drying cycles, the radon exhalation rate correspondingly increased with the amplitude of wetting-drying cycles, particularly noticeable when the alternation amplitude was 30 ± 20%. From the early mid-stage to the late stage of wetting-drying cycles, the curves of the radon exhalation rate, surface crack ratio, and cumulative damage degree tended to be consistent, showing a gradual increase. The research provided in this study offers valuable insights into radon control measures and environmental assessments on the beach surface of uranium mill tailing impoundments.

Natural uranium is a crucial resource for clean nuclear energy, which has brought significant economic and social benefits to humanity. However, the development and utilization of uranium resources have also resulted in the accumulation of vast amounts of uranium mill tailings (UMTs), which pose a potential threat to human health and the ecological environment. This paper reviews the research progress on UMTs treatment technologies, including cover disposal, solidification disposal, backfilling disposal, and bioremediation methods. It is found that cover disposal is a versatile method for the long-term management of UMTs, the engineering performance and durability of the cover system can be improved by choosing suitable stabilizers for the cover layer. Solidification disposal can convert UMTs into solid waste for permanent disposal, but it produces a large amount of waste and requires high operating costs; it is necessary to explore the effectiveness and efficiency of solidification disposal for UMTs, while minimizing the bad environmental impact. Backfilling disposal realizes the resource utilization of solid waste, but the high radon exhalation rate caused by the UMTs backfilling also needs to be considered. Bioremediation methods have low investment costs and are less likely to cause secondary pollution, but the remediation efficiency is low, it can be combined with other treatment technologies to remedy the defects of a single remediation method. The article concludes with key issues and corresponding suggestions for the current UMTs treatment methods, which can provide theoretical guidance and reference for further development and application of radioactive pollution treatment of UMTs. Graphical Abstract