Senthil Ramalingam
Research Subjects
Senthil Ramalingam has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
R. Silambarasan
Anna University
6 shared publications- Sudagar Subramanian
Department of Mechanical Engineering, Rajalakshmi Institute of Technology, Chennai, India
5 shared publications G. Pranesh
Anna University
4 shared publicationsPranesh Ganesan
4 shared publications- Rajkumar Thamizhvel
University College of Engineering
4 shared publications - Mohan Govindasamy
Department of Mechanical Engineering, University College of Engineering Villupuram, Villupuram 605103, Tamil Nadu, India
3 shared publications
Latest Publications
- 8 February 2026
- Published by Springer Nature
- p. 423-435
A Comparative Analysis of Bio-Oil Production from Plastic and Biomass with Aid of Nano Particles Through Pyrolysis Process
- 8 February 2026
- Published by Springer Nature
- p. 423-435
A Comparative Analysis of Bio-Oil Production from Plastic and Biomass with Aid of Nano Particles Through Pyrolysis Process
- 8 February 2026
- Published by Springer Nature
- p. 461-474
Experimental Investigation in C.I Engine Using Automobile Plastics Waste as Bio Oil (Pyrolytic Oil) by Thermal Cracking Process
- 8 February 2026
- Published by Springer Nature
- p. 461-474
Experimental Investigation in C.I Engine Using Automobile Plastics Waste as Bio Oil (Pyrolytic Oil) by Thermal Cracking Process
- 24 April 2025
- Published by Springer Nature in Polymer Bulletin
- Vol. 82 (11) , 6095-6114
Production of high-grade fuels from biomass and waste plastics and its influence in a CI engine
- 24 April 2025
- Published by Springer Nature in Polymer Bulletin
- Vol. 82 (11) , 6095-6114
Production of high-grade fuels from biomass and waste plastics and its influence in a CI engine
- 23 January 2024
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 46 (1) , 2040-2058
A comparative analysis of pyrolytic oil from medical waste and its suitability as fuel in a Compression Ignition engine
- 23 January 2024
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 46 (1) , 2040-2058
A comparative analysis of pyrolytic oil from medical waste and its suitability as fuel in a Compression Ignition engine
- 8 July 2022
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 20 (4) , 4017-4030
An alternative fuel to CI engine: delonix regia seed through biochemical and solar-assisted thermal cracking process
- 8 July 2022
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 20 (4) , 4017-4030
An alternative fuel to CI engine: delonix regia seed through biochemical and solar-assisted thermal cracking process
- 1 May 2020
- Published by Elsevier in Powder Technology
- Vol. 367, 213-224
Consequence of nanoparticles size on heat transfer characteristics of a radiator
- 1 May 2020
- Published by Elsevier in Powder Technology
- Vol. 367, 213-224
Consequence of nanoparticles size on heat transfer characteristics of a radiator
- 10 April 2020
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 46 (1) , 6385-6403
Influence of natural leaf additive in a biodiesel-operated LHR engine on performance and NOx emission
Biodiesel is an oxygenated, nontoxic, sulfur-free, biodegradable, and renewable fuel. It can be used in CI (Compression Ignition) engines in any proportion blended with diesel without any major modification. It is having the drawbacks of lower performance and higher NO emission. These problems can be prevented by means of providing low heat rejection (LHR) concept in CI engine and addition of natural leaf additive (NLA) with biodiesel. The LHR engine will improve the performance and the addition of NLA in biodiesel will improve the biodiesel properties and reduce NOx emission significantly. In this present work, the performance, combustion, and emission characteristics on lanthanum oxide coated in a CI engine fueled by jamun biodiesel with NLA of Albizia lebbeck (AL) at various concentrations like 500, 1,000, 1,500, and 2,000 ppm. The biodiesel is prepared from jamun oil using simple base catalyst transesterification process. The 20% proportions of jamun biodiesel showed lower brake thermal efficiency (BTE) are 2.54% and reduction in HC is 3.2%, CO is 3.7%, and smoke is 6.8% emissions except NOx emission is 13.7% than that of diesel at all loads. The 20% proportions of jamun showed higher efficiency ranging from 1 to 1.8% and reduction in HC by about 7%, CO by about 3%, and smoke by about 5% and NOx emission increased by 10% than that of diesel at all loads. The experiments are conducted in LHR engine and conventional engine with jamun along with NLA. The results showed a significant improvement in performance and a reduction in NOx emission by 27%.
- 10 April 2020
- Published by Taylor & Francis in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
- Vol. 46 (1) , 6385-6403
Influence of natural leaf additive in a biodiesel-operated LHR engine on performance and NOx emission
Biodiesel is an oxygenated, nontoxic, sulfur-free, biodegradable, and renewable fuel. It can be used in CI (Compression Ignition) engines in any proportion blended with diesel without any major modification. It is having the drawbacks of lower performance and higher NO emission. These problems can be prevented by means of providing low heat rejection (LHR) concept in CI engine and addition of natural leaf additive (NLA) with biodiesel. The LHR engine will improve the performance and the addition of NLA in biodiesel will improve the biodiesel properties and reduce NOx emission significantly. In this present work, the performance, combustion, and emission characteristics on lanthanum oxide coated in a CI engine fueled by jamun biodiesel with NLA of Albizia lebbeck (AL) at various concentrations like 500, 1,000, 1,500, and 2,000 ppm. The biodiesel is prepared from jamun oil using simple base catalyst transesterification process. The 20% proportions of jamun biodiesel showed lower brake thermal efficiency (BTE) are 2.54% and reduction in HC is 3.2%, CO is 3.7%, and smoke is 6.8% emissions except NOx emission is 13.7% than that of diesel at all loads. The 20% proportions of jamun showed higher efficiency ranging from 1 to 1.8% and reduction in HC by about 7%, CO by about 3%, and smoke by about 5% and NOx emission increased by 10% than that of diesel at all loads. The experiments are conducted in LHR engine and conventional engine with jamun along with NLA. The results showed a significant improvement in performance and a reduction in NOx emission by 27%.
- 1 January 2020
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 45 (1) , 230-262
Recent advances in the performance of Co-Current gasification technology: A review
- 1 January 2020
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 45 (1) , 230-262
Recent advances in the performance of Co-Current gasification technology: A review