JWJames L. Weaver

James L. Weaver

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


James L. Weaver has a total of 122 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Rear surface isolated defect evolution in laser accelerated targets

    by C. Zulick, J. Fontana, D. Kehne, A. Porter, J. L. Weaver, A. L. Velikovich, Y. Aglitskiy, J. Bates, M. Karasik, A. J. Schmitt, et al.

    The hydrodynamic growth of pre-imposed isolated rear-surface defects, specifically 9–20 μm deep by 8–20 μm wide laser-machined grooves on planar polystyrene foils, was investigated using the NIKE krypton-fluoride laser facility at the U.S. Naval Research Laboratory. High-resolution monochromatic x-ray radiography was employed to capture streaked face-on and two-dimensional side-on images of the defect evolution. The observed interfacial dynamics are consistent with the key characteristics of isolated-defect-triggered hydrodynamic perturbation growth first observed with front-surface defects by Zulick et al. [Phys. Rev. Lett. 125, 055001 (2020)] and Zulick et al. [Phys. Plasmas 27, 072706 (2020)]. These characteristics include an inherently multi-mode, phase-locked perturbation development, a monotonic increase in the lateral dimension of the perturbed region, and the oblique ejection of spikes during the nonlinear growth phase. Initially, material accelerated into the rear-surface groove forms a jet, which is subsequently overtaken by multi-mode bubble and spike Rayleigh–Taylor growth at the front surface. Experimental results demonstrated good agreement with both high-resolution fastrad3d simulations and analytical theoretical predictions.


  • Open Access

    Absolute Hugoniot measurements in low-density plastic foams on the NIKE shock compression platform

    by Y. Aglitskiy, C. Zulick, M. Karasik, J. L. Weaver, A. L. Velikovich, A. J. Schmitt, J. W. Bates, P. M. Kozlowski

    The propagation of Mbar-range shock waves in low-density foam materials is of interest to target design in all approaches to inertial confinement fusion, high energy density physics, and laboratory astrophysics. We report absolute Hugoniot measurements for CH1.72N0.086O0.37 plastic foams with 73 and 94 mg/cm3 densities in the 32–107 km/s shock velocity range. The experiments were performed on the shock compression platform developed on the NIKE KrF laser facility at the U.S. Naval Research Laboratory. NIKE's 4 or 8-ns long flat-top laser pulses drive steady shock waves into foam targets at the ablative pressures of 1–7 Mbar. The propagation of the ablation and shock fronts is tracked continuously in time using streaked side-on monochromatic x-ray imaging radiography. The straight x−t trajectories of the shock and ablation fronts in the recorded streak images confirmed their steadiness. The SESAME tabulated equation of state predictions generally agrees with our Hugoniot data within a 95% confidence band. The experimental uncertainty of the evaluated shock density compression ratios remains large, indicating the need for more experiments and improved theoretical understanding of the strong shock propagation mechanisms in dry foams.


  • Open Access

    National Diagnostic Working Group (NDWG) for inertial confinement fusion (ICF)/high-energy density (HED) science: The whole exceeds the sum of its parts

    by J. D. Kilkenny, W. W. Hsing, S. H. Batha, G. A. Rochau, T. C. Sangster, P. M. Bell, D. K. Bradley, H. Chen, J. A. Frenje, M. Gatu-Johnson, et al.

    The National Diagnostic Working Group (NDWG) has led the effort to fully exploit the major inertial confinement fusion/high-energy density facilities in the US with the best available diagnostics. These diagnostics provide key data used to falsify early theories for ignition and suggest new theories, recently leading to an experiment that exceeds the Lawson condition required for ignition. The factors contributing to the success of the NDWG, collaboration and scope evolution, and the methods of accomplishment of the NDWG are discussed in this Review. Examples of collaborations in neutron and gamma spectroscopy, x-ray and neutron imaging, x-ray spectroscopy, and deep-ultraviolet Thomson scattering are given. An abbreviated history of the multi-decade collaborations and the present semiformal management framework is given together with the latest National Diagnostic Plan.


  • Open Access

    Suppressing parametric instabilities in direct-drive inertial-confinement-fusion plasmas using broadband laser light

    by J. W. Bates, R. K. Follett, J. G. Shaw, S. P. Obenschain, J. F. Myatt, J. L. Weaver, M. F. Wolford, D. M. Kehne, M. C. Myers, T. J. Kessler

    It has long been recognized that broadband laser light has the potential to control parametric instabilities in inertial-confinement-fusion (ICF) plasmas. Here, we use results from laser-plasma-interaction simulations to estimate the bandwidth requirements for mitigating the three predominant classes of instabilities in direct-drive ICF implosions: cross-beam energy transfer (CBET), two-plasmon decay (TPD), and stimulated Raman scattering (SRS). We find that for frequency-tripled, Nd:glass laser light, a bandwidth of 8.5 THz can significantly increase laser absorption by suppressing CBET, while ∼13 THz is needed to mitigate absolute TPD and SRS on an ignition-scale platform. None of the glass lasers used in contemporary ICF experiments, however, possess a bandwidth greater than 1 THz and reaching larger values requires the use of an auxiliary broadening technique such as optical parametric amplification or stimulated-rotational-Raman scattering. An arguably superior approach is the adoption of an argon-fluoride (ArF) laser as an ICF driver. Besides having a broad bandwidth of ∼10 THz, the ArF laser also possesses the shortest wavelength (193 nm) that can scale to the high energy/power required for ICF—a feature that helps to mitigate parametric instabilities even further. We show that these native properties of ArF laser light are sufficient to eliminate nearly all CBET scattering in a direct-drive target and also raise absolute TPD and SRS thresholds well above those for broadband glass lasers. The effective control of parametric instabilities with broad bandwidth is potentially a “game changer” in ICF because it would enable higher laser intensities and ablation pressures in future target designs.


  • Open Access

    Suppressing cross-beam energy transfer with broadband lasers

    by J.W. Bates, R.K. Follett, J.G. Shaw, S.P. Obenschain, R.H. Lehmberg, J.F. Myatt, J.L. Weaver, D.M. Kehne, M.F. Wolford, M.C. Myers, et al.


  • Scaled experiments on cavity confined explosions in limestone and poly(methyl methacrylate)

    by G. A. Cranch, J. Grun, C. Zulick, J. Weaver, K. B. Fournier, S. Compton, W. Dunlop, O. Walton, J. K. Gran, M. Groethe

    A scaled experiment comprising a laser-driven explosion in a cavity is used to characterize the coupling of mechanical energy into the surrounding solid material. Experiments are performed using poly(methyl methacrylate) and dry Salem limestone as the explosion containment blocks materials, in which are milled scaled spherical cavities of various dimensions. Measurements of the coupled shock, taken with fiber optic probes at the cavity wall, show the critical radius where wall deformation transitions from plastic to elastic deformation. These measurements also provide a diagnostic of the air blast, which is validated against GEODYN simulation code. The measurement of the coupled shock amplitude taken farther from the wall in the linear region indicates increased coupling efficiency in small cavities over the range of scaled cavity radii from 6 to 20 m / kt 1 / 3 , a phenomenon not previously observed in experiments. A comparison of results taken in this experiment with a parallel experiment using high explosive (HE) as the source shows that coupled shocks generated with HE are characteristically different with much larger amplitude than those produced by a high energy density laser-driven source with the same yield. This experimental technique potentially provides a rapid and cost-effective method to analyze the consequences of a full-scale, low yield, buried explosion.


  • Open Access

    Absolute Hugoniot measurements for CH foams in the 2–9 Mbar range

    by Y. Aglitskiy, A. L. Velikovich, M. Karasik, A. J. Schmitt, V. Serlin, J. L. Weaver, J. Oh, S. P. Obenschain, K. R. Cochrane

    Absolute Hugoniot measurements for empty plastic foams at ∼10% of solid polystyrene density and supporting rad-hydro simulation results are reported. Planar foam slabs, ∼400 μm thick and ∼500 μm wide, some of which were covered with a 10 μm solid plastic ablator, were directly driven by 4 ns long Nike krypton-fluoride 248 nm wavelength laser pulses that produced strong shock waves in the foam. The shock and mass velocities in our experiments were up to 104 km/s and 84 km/s, respectively, and the shock pressures up to ∼9 Mbar. The motion of the shock and ablation fronts was recorded using side-on monochromatic x-ray imaging radiography. The steadiness of the observed shock and ablation fronts within ∼1% has been verified. The Hugoniot data inferred from our velocity measurements agree with the predictions of the SESAME and CALEOS equation-of-state models near the highest pressure ∼9 Mbar and density compression ratio ∼5. In the lower pressure range 2–5 Mbar, a lower shock density compression is observed than that predicted by the models. Possible causes for this discrepancy are discussed.


  • Capsule implosions for continuum x-ray backlighting of opacity samples at the National Ignition Facility

    by Y. P. Opachich, R. F. Heeter, M. A. Barrios, E. M. Garcia, R. S. Craxton, J. A. King, D. A. Liedahl, P. W. McKenty, M. B. Schneider, M. J. May, et al.

    Direct drive implosions of plastic capsules have been performed at the National Ignition Facility to provide a broad-spectrum (500–2000 eV) X-ray continuum source for X-ray transmission spectroscopy. The source was developed for the high-temperature plasma opacity experimental platform. Initial experiments using 2.0 mm diameter polyalpha-methyl styrene capsules with ∼20 μm thickness have been performed. X-ray yields of up to ∼1 kJ/sr have been measured using the Dante multichannel diode array. The backlighter source size was measured to be ∼100 μm FWHM, with ∼350 ps pulse duration during the peak emission stage. Results are used to simulate transmission spectra for a hypothetical iron opacity sample at 150 eV, enabling the derivation of photometrics requirements for future opacity experiments.


  • The design of the optical Thomson scattering diagnostic for the National Ignition Facility

    by P. S. Datte, J. S. Ross, D. H. Froula, K. D. Daub, J. Galbraith, S. Glenzer, B. Hatch, J. Katz, J. Kilkenny, O. Landen, et al.

    The National Ignition Facility (NIF) is a 192 laser beam facility designed to support the Stockpile Stewardship, High Energy Density and Inertial Confinement Fusion (ICF) programs. We report on the design of an Optical Thomson Scattering (OTS) diagnostic that has the potential to transform the community’s understanding of NIF hohlraum physics by providing first principle, local, time-resolved measurements of under-dense plasma conditions. The system design allows operation with different probe laser wavelengths by manual selection of the appropriate beam splitter and gratings before the shot. A deep-UV probe beam (λ0-210 nm) will be used to optimize the scattered signal for plasma densities of 5 × 1020 electrons/cm3 while a 3ω probe will be used for experiments investigating lower density plasmas of 1 × 1019 electrons/cm3. We report the phase I design of a two phase design strategy. Phase I includes the OTS telescope, spectrometer, and streak camera; these will be used to assess the background levels at NIF. Phase II will include the design and installation of a probe laser.


  • Understanding reconstructed Dante spectra using high resolution spectroscopy

    by M. J. May, J. Weaver, K. Widmann, G. E. Kemp, D. Thorn, J. D. Colvin, M. B. Schneider, A. Moore, B. E. Blue

    The Dante is an 18 channel filtered diode array used at the National Ignition Facility (NIF) to measure the spectrally and temporally resolved radiation flux between 50 eV and 20 keV from various targets. The absolute flux is determined from the radiometric calibration of the x-ray diodes, filters, and mirrors and a reconstruction algorithm applied to the recorded voltages from each channel. The reconstructed spectra are very low resolution with features consistent with the instrument response and are not necessarily consistent with the spectral emission features from the plasma. Errors may exist between the reconstructed spectra and the actual emission features due to assumptions in the algorithm. Recently, a high resolution convex crystal spectrometer, VIRGIL, has been installed at NIF with the same line of sight as the Dante. Spectra from L-shell Ag and Xe have been recorded by both VIRGIL and Dante. Comparisons of these two spectroscopic measurements yield insights into the accuracy of the Dante reconstructions.