Balamurugan M. Sundaram
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Balamurugan M. Sundaram has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Hareesh V. Tippur
Auburn University
6 shared publications Hareesh V. Tippur
4 shared publications- Hareesh V. Tippur
Department of Mechanical Engineering, Auburn University, Auburn, USA
3 shared publications H. V. Tippur
Department of Mechanical Engineering, Auburn University, Auburn, USA
2 shared publicationsC Miao
Department of Mechanical Engineering, Auburn University, Auburn, AL 36849, USA
1 shared publicationCharlene M. Smith
Corning Research and Development Corporation
1 shared publication
Latest Publications
- 22 April 2024
- Published by Springer Nature in Journal of Dynamic Behavior of Materials
- Vol. 10 (2) , 181-199
Effect of Impact Velocity on Dynamic Crack Growth Across an Interface in Transparent Bilayers: An Experimental Study
- 22 April 2024
- Published by Springer Nature in Journal of Dynamic Behavior of Materials
- Vol. 10 (2) , 181-199
Effect of Impact Velocity on Dynamic Crack Growth Across an Interface in Transparent Bilayers: An Experimental Study
- 1 November 2018
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 120, 132-153
Dynamic fracture of soda-lime glass: A full-field optical investigation of crack initiation, propagation and branching
- 1 November 2018
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 120, 132-153
Dynamic fracture of soda-lime glass: A full-field optical investigation of crack initiation, propagation and branching
- 28 October 2018
- Published by Springer Nature
- p. 113-118
Mechanical Characterization of ZrO2 Rich Glass Ceramic
- 28 October 2018
- Published by Springer Nature
- p. 113-118
Mechanical Characterization of ZrO2 Rich Glass Ceramic
- 1 September 2018
- Published by Elsevier in Polymer Testing
- Vol. 70, 348-362
Quasi-static and dynamic mechanical behavior of transparent graft-interpenetrating polymer networks (graft-IPNs)
- 1 September 2018
- Published by Elsevier in Polymer Testing
- Vol. 70, 348-362
Quasi-static and dynamic mechanical behavior of transparent graft-interpenetrating polymer networks (graft-IPNs)
- 31 October 2017
- Published by Springer Nature
- p. 25-30
Dynamic Mixed-Mode Crack Initiation and Growth in PMMA and Polycarbonate
- 31 October 2017
- Published by Springer Nature
- p. 25-30
Dynamic Mixed-Mode Crack Initiation and Growth in PMMA and Polycarbonate
- 29 August 2017
- Published by Wiley in International Journal of Applied Glass Science
- Vol. 9 (1) , 123-136
Full‐field measurement of contact‐point and crack‐tip deformations in soda‐lime glass. Part‐ II : Stress wave loading
- 29 August 2017
- Published by Wiley in International Journal of Applied Glass Science
- Vol. 9 (1) , 123-136
Full‐field measurement of contact‐point and crack‐tip deformations in soda‐lime glass. Part‐ II : Stress wave loading
- 26 June 2017
- Published by Wiley in International Journal of Applied Glass Science
- Vol. 9 (1) , 114-122
Full‐field measurement of contact‐point and crack‐tip deformations in soda‐lime glass. Part‐I: Quasi‐static Loading
Transparent brittle ceramics such as soda‐lime glass pose unique challenges for performing full‐field optical measurement of deformations and stresses to characterize fracture and failure behaviors. Low fracture toughness coupled with high stiffness and elastic wave speeds are among the factors responsible for some of these challenges as deformations tend to be small and confined to an extremely small region near the stress concentrators. Need for strong birefringence, elaborate optics, or lack of sufficient measurement sensitivity are some of the factors against legacy techniques such as photoelasticity, optical interferometry, and speckle methods, respectively, to study soda‐lime glass. Motivated by these factors, the feasibility of Digital Gradient Sensing ( DGS ) method to measure crack‐tip and contact‐induced deformations in soda‐lime glass under quasi‐static loading is demonstrated. This first of a two parts paper demonstrates the applicability of DGS for the problem under quasi‐static loading condition. The optical measurements are used to evaluate the relevant parameters and compare with the analytical solutions. The second part of this study is focused on measuring contact‐point and crack‐tip deformations during impact‐induced stress wave loading.
- 26 June 2017
- Published by Wiley in International Journal of Applied Glass Science
- Vol. 9 (1) , 114-122
Full‐field measurement of contact‐point and crack‐tip deformations in soda‐lime glass. Part‐I: Quasi‐static Loading
Transparent brittle ceramics such as soda‐lime glass pose unique challenges for performing full‐field optical measurement of deformations and stresses to characterize fracture and failure behaviors. Low fracture toughness coupled with high stiffness and elastic wave speeds are among the factors responsible for some of these challenges as deformations tend to be small and confined to an extremely small region near the stress concentrators. Need for strong birefringence, elaborate optics, or lack of sufficient measurement sensitivity are some of the factors against legacy techniques such as photoelasticity, optical interferometry, and speckle methods, respectively, to study soda‐lime glass. Motivated by these factors, the feasibility of Digital Gradient Sensing ( DGS ) method to measure crack‐tip and contact‐induced deformations in soda‐lime glass under quasi‐static loading is demonstrated. This first of a two parts paper demonstrates the applicability of DGS for the problem under quasi‐static loading condition. The optical measurements are used to evaluate the relevant parameters and compare with the analytical solutions. The second part of this study is focused on measuring contact‐point and crack‐tip deformations during impact‐induced stress wave loading.
- 1 May 2017
- Published by Elsevier in Engineering Fracture Mechanics
- Vol. 176, 186-212
Dynamic mixed-mode fracture behaviors of PMMA and polycarbonate
- 1 May 2017
- Published by Elsevier in Engineering Fracture Mechanics
- Vol. 176, 186-212
Dynamic mixed-mode fracture behaviors of PMMA and polycarbonate
- 1 November 2016
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 96, 312-332
Dynamics of crack penetration vs. branching at a weak interface: An experimental study
- 1 November 2016
- Published by Elsevier in Journal of the Mechanics and Physics of Solids
- Vol. 96, 312-332
Dynamics of crack penetration vs. branching at a weak interface: An experimental study