Jia Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jia Zhang has a total of 236 co-authors. Here are the top co-authors by number of shared publications:
Guangren Qian
45 shared publications- Guangren Qian
School of Environmental and Chemical Engineering, Shanghai University, Shanghai, China
35 shared publications Yang Yue
28 shared publicationsJianzhong Wu
15 shared publicationsQiang Liu
12 shared publicationsYunfeng Xu
SHU Center of Green Urban Mining & Industry Ecology, School of Environmental and Chemical Engineering, Shanghai University, No. 381 Nanchen Road, Shanghai, 200444, PR China
10 shared publications
Latest Publications
- 15 September 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (38) , 20731-20740
A Method for Recovery of High-Purity CaCO3 during Carbon Sequestration Using Municipal Solid Waste Incineration Fly Ash
The effective utilization of municipal-solid-waste-incineration fly ash (FA) is the bottleneck of incineration. Previous reports has carried out sufficient works on carbon sequestration using pure Ca source. Carbon sequestration of FA only generally results in pure CaCO3 by leaching Ca first. This work proposes a slow-crystallization-after-fast-carbonation method to separate CaCO3 from FA during carbon sequestration. In brief, CaCO3 is formed and separated after FA is removed from a monoethanolamine (MEA) carbonation solution. As a result, 290 kg of CaCO3 per ton of FA is separated, i.e., reaching a carbonation rate of 44 wt % Ca in FA. Impurity content (such as Cl and S) is less than 1 wt %, i.e., the purity of CaCO3 is bigger than 99 wt %. At the same time, leaching of the carbonation products meets the limits of GB 5085.3-2007. Furthermore, crystal phase of the CaCO3 is regulable. Bigger concentrations of MEA and Ca2+ are in favor of forming more vaterite, resulting in as high as 96% in this work. A crystal temperature of 60 °C helps to form 66% of aragonite in the separated CaCO3. The put-forward method is repeatable using the filtrate after carbon sequestration. Therefore, this work obtains relatively pure CaCO3 without acid leaching from FA, which is in favor of high-value-added utilization of FA.
- 15 September 2026
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 65 (38) , 20731-20740
A Method for Recovery of High-Purity CaCO3 during Carbon Sequestration Using Municipal Solid Waste Incineration Fly Ash
The effective utilization of municipal-solid-waste-incineration fly ash (FA) is the bottleneck of incineration. Previous reports has carried out sufficient works on carbon sequestration using pure Ca source. Carbon sequestration of FA only generally results in pure CaCO3 by leaching Ca first. This work proposes a slow-crystallization-after-fast-carbonation method to separate CaCO3 from FA during carbon sequestration. In brief, CaCO3 is formed and separated after FA is removed from a monoethanolamine (MEA) carbonation solution. As a result, 290 kg of CaCO3 per ton of FA is separated, i.e., reaching a carbonation rate of 44 wt % Ca in FA. Impurity content (such as Cl and S) is less than 1 wt %, i.e., the purity of CaCO3 is bigger than 99 wt %. At the same time, leaching of the carbonation products meets the limits of GB 5085.3-2007. Furthermore, crystal phase of the CaCO3 is regulable. Bigger concentrations of MEA and Ca2+ are in favor of forming more vaterite, resulting in as high as 96% in this work. A crystal temperature of 60 °C helps to form 66% of aragonite in the separated CaCO3. The put-forward method is repeatable using the filtrate after carbon sequestration. Therefore, this work obtains relatively pure CaCO3 without acid leaching from FA, which is in favor of high-value-added utilization of FA.
- 14 May 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (21) , 14897-14906
Redispersion Technologies of V on TiO 2 for an Enhanced Catalytic Activity
Sintering and agglomeration of active species in the catalyst is a determining factor adversely affecting the catalytic activity. However, redispersion investigation is typically reported for noble-metal catalysts. In this work, we have put forward two simple technologies for the redispersion of V active species on the TiO2 support. One is a redox treatment under NH3 followed by O2 at 300 °C, and the other is a steam treatment at 180 °C. As a result, the V particle size is reduced from the obvious 1-2 nm to an unrecognizable size on TiO2, together with forming isolated and polymerized V-O-Ti. At the same time, although the crystal and textural properties are hardly affected, the surface redox ability and acidic-site amount are both increased. The mechanism investigation reveals that both thermal-derived migration and surface hydroxyl of TiO2 are responsible for the redispersion. In the application of selective catalytic reduction of nitrogen oxide, the conversion of the redispersed catalyst is increased from 46.2% (the fresh catalyst) to as high as 98.0% under the same conditions. Furthermore, the redispersion methods are repeatable for catalysts synthesized by different methods in this work. The above result not only increases the catalytic performance of the as-prepared catalyst but is also in favor of waste-catalyst regeneration.
- 14 May 2026
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 42 (21) , 14897-14906
Redispersion Technologies of V on TiO 2 for an Enhanced Catalytic Activity
Sintering and agglomeration of active species in the catalyst is a determining factor adversely affecting the catalytic activity. However, redispersion investigation is typically reported for noble-metal catalysts. In this work, we have put forward two simple technologies for the redispersion of V active species on the TiO2 support. One is a redox treatment under NH3 followed by O2 at 300 °C, and the other is a steam treatment at 180 °C. As a result, the V particle size is reduced from the obvious 1-2 nm to an unrecognizable size on TiO2, together with forming isolated and polymerized V-O-Ti. At the same time, although the crystal and textural properties are hardly affected, the surface redox ability and acidic-site amount are both increased. The mechanism investigation reveals that both thermal-derived migration and surface hydroxyl of TiO2 are responsible for the redispersion. In the application of selective catalytic reduction of nitrogen oxide, the conversion of the redispersed catalyst is increased from 46.2% (the fresh catalyst) to as high as 98.0% under the same conditions. Furthermore, the redispersion methods are repeatable for catalysts synthesized by different methods in this work. The above result not only increases the catalytic performance of the as-prepared catalyst but is also in favor of waste-catalyst regeneration.
- 11 September 2025
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 399
Synchronous zeolite shaping and pore-size regulation for effective selective adsorption of thiophene from crude benzene
- 11 September 2025
- Published by Elsevier in Microporous and Mesoporous Materials
- Vol. 399
Synchronous zeolite shaping and pore-size regulation for effective selective adsorption of thiophene from crude benzene
- 31 July 2025
- Published by Springer Nature in Tungsten
- Vol. 7 (4) , 887-897
Re-recognizing W/Mo promoter as a transformer changing inactive V into highly active catalytic species distribution
- 31 July 2025
- Published by Springer Nature in Tungsten
- Vol. 7 (4) , 887-897
Re-recognizing W/Mo promoter as a transformer changing inactive V into highly active catalytic species distribution
- 6 May 2025
- Published by American Chemical Society (ACS) in ACS Applied Engineering Materials
- Vol. 3 (5) , 1380-1388
Zeolite Framework Has a Bigger Controlling Effect than Transition-Metal Valence on Oxygen Replenishing Speed and Catalytic Activity
- 6 May 2025
- Published by American Chemical Society (ACS) in ACS Applied Engineering Materials
- Vol. 3 (5) , 1380-1388
Zeolite Framework Has a Bigger Controlling Effect than Transition-Metal Valence on Oxygen Replenishing Speed and Catalytic Activity
- 18 March 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (12) , 5886-5896
Enhanced SO2-Resistance Ability of Ce-Modified TiO2-Wrapped V2O5 Catalyst
- 18 March 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (12) , 5886-5896
Enhanced SO2-Resistance Ability of Ce-Modified TiO2-Wrapped V2O5 Catalyst
- 20 February 2025
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 51 (4) , 2007-2025
Influence of the catalyst dynamic reconstruction on the catalytic performance
- 20 February 2025
- Published by Springer Nature in Research on Chemical Intermediates
- Vol. 51 (4) , 2007-2025
Influence of the catalyst dynamic reconstruction on the catalytic performance