Markku Hannula
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Markku Hannula has a total of 35 co-authors. Here are the top co-authors by number of shared publications:
- Mika Valden
Surface Science Laboratory, Faculty of Engineering and Natural Sciences, Tampere University, P.O. Box 692, FI-33014 Tampere, Finland
7 shared publications - Harri Ali-Löytty
Faculty of Engineering and Natural Sciences Tampere University P.O. Box 692 Tampere FI‐33014 Finland
6 shared publications - Jesse Saari
Surface Science Laboratory, Faculty of Engineering and Natural Sciences, Tampere University, P.O. Box 692, FI-33014 Tampere, Finland
5 shared publications - Kimmo Lahtonen
Tampere University
5 shared publications - Lauri Palmolahti
Surface Science Group, Faculty of Engineering and Natural Sciences, Tampere University, Tampere, Finland
4 shared publications Antti Tukiainen
Faculty of Engineering and Natural Sciences, Tampere University, P.O.B. 692, Tampere FI-33014, Finland
2 shared publications
Latest Publications
- Open Access
- 7 November 2024
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 16 (48) , 22383-22392
Production of mixed phase Ti3+-rich TiO2 thin films by oxide defect engineered crystallization
Oxygen vacancies and Ti3+ defects in the amorphous phase of TiO2 predetermine vacuum annealing induced crystallization. Anatase, nanocrystalline rutile or mixed phases can be created by defect engineering without affecting the O/Ti ratio.
- 7 November 2024
- Published by Royal Society of Chemistry (RSC) in Nanoscale
- Vol. 16 (48) , 22383-22392
Open AccessProduction of mixed phase Ti3+-rich TiO2 thin films by oxide defect engineered crystallization
Oxygen vacancies and Ti3+ defects in the amorphous phase of TiO2 predetermine vacuum annealing induced crystallization. Anatase, nanocrystalline rutile or mixed phases can be created by defect engineering without affecting the O/Ti ratio.
- Open Access
- 30 August 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (36) , 15357-15366
Low-Temperature Route to Direct Amorphous to Rutile Crystallization of TiO2 Thin Films Grown by Atomic Layer Deposition
- 30 August 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (36) , 15357-15366
Open AccessLow-Temperature Route to Direct Amorphous to Rutile Crystallization of TiO2 Thin Films Grown by Atomic Layer Deposition
- Open Access
- 25 February 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (9) , 4542-4554
Tunable Ti3+-Mediated Charge Carrier Dynamics of Atomic Layer Deposition-Grown Amorphous TiO2
- 25 February 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (9) , 4542-4554
Open AccessTunable Ti3+-Mediated Charge Carrier Dynamics of Atomic Layer Deposition-Grown Amorphous TiO2
- Open Access
- 25 September 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (41) , 25128-25134
Chemical Dissolution of Pt(111) during Potential Cycling under Negative pH Conditions Studied by Operando X-ray Photoelectron Spectroscopy
Dissolution of platinum catalyst is a major degradation mechanism of fuel cells but the exact reaction mechanism has remained unclear. Here, electrochemical ambient pressure X-ray photoelectron spectroscopy (EC-APXPS) was utilized to provide direct information on chemical species on a single crystal Pt(111) electrode under extremely low pH conditions. Measurements were conducted using a novel condensed electrolyte film electrochemical cell applying work function measurement as a loss-free probe for electrochemical potential. We show that platinum can dis-solve chemically as Pt2+ ion during potential cycling and redeposit as Pt2+ at the onset potential for cathodic reactions. The dissolution of Pt does not require electrochemical oxidation via oxide place-exchange. In contrast, the adsorption of oxygenated species (OH* or O*) at the onset potential for anodic reactions is a sufficient prerequisite to the dissolution. These results provide new insight to the degradation mechanism of Pt under extremely low pH conditions, predicted by the Pourbaix diagram, having practical applications to the durability of Pt-based catalysts in electrochemical energy conversion devices.
- 25 September 2019
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 123 (41) , 25128-25134
Open AccessChemical Dissolution of Pt(111) during Potential Cycling under Negative pH Conditions Studied by Operando X-ray Photoelectron Spectroscopy
Dissolution of platinum catalyst is a major degradation mechanism of fuel cells but the exact reaction mechanism has remained unclear. Here, electrochemical ambient pressure X-ray photoelectron spectroscopy (EC-APXPS) was utilized to provide direct information on chemical species on a single crystal Pt(111) electrode under extremely low pH conditions. Measurements were conducted using a novel condensed electrolyte film electrochemical cell applying work function measurement as a loss-free probe for electrochemical potential. We show that platinum can dis-solve chemically as Pt2+ ion during potential cycling and redeposit as Pt2+ at the onset potential for cathodic reactions. The dissolution of Pt does not require electrochemical oxidation via oxide place-exchange. In contrast, the adsorption of oxygenated species (OH* or O*) at the onset potential for anodic reactions is a sufficient prerequisite to the dissolution. These results provide new insight to the degradation mechanism of Pt under extremely low pH conditions, predicted by the Pourbaix diagram, having practical applications to the durability of Pt-based catalysts in electrochemical energy conversion devices.
- 1 August 2019
- Published by Elsevier in Acta Materialia
- Vol. 174, 237-245
Highly efficient charge separation in model Z-scheme TiO2/TiSi2/Si photoanode by micropatterned titanium silicide interlayer
- 1 August 2019
- Published by Elsevier in Acta Materialia
- Vol. 174, 237-245
Highly efficient charge separation in model Z-scheme TiO2/TiSi2/Si photoanode by micropatterned titanium silicide interlayer
- Open Access
- 4 January 2019
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (3) , 2758-2762
Diversity of TiO2: Controlling the Molecular and Electronic Structure of Atomic-Layer-Deposited Black TiO2
Visually black, electrically leaky, amorphous titania (am-TiO2) thin films were grown by atomic layer deposition (ALD) for photocatalytic applications. Broad spectral absorbance in the visible range and exceptional conductivity are attributed to trapped Ti3+ in the film. Oxidation of Ti3+ upon heat treatment leads to a drop in conductivity, a color change from black to white and crystallization of am-TiO2. ALD grown black TiO2, without any heat treatment, is subject to dissolution in alkaline photoelectrochemical conditions. The best photocatalytic activity for solar water splitting is obtained for completely crystalline white TiO2.
- 4 January 2019
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (3) , 2758-2762
Open AccessDiversity of TiO2: Controlling the Molecular and Electronic Structure of Atomic-Layer-Deposited Black TiO2
Visually black, electrically leaky, amorphous titania (am-TiO2) thin films were grown by atomic layer deposition (ALD) for photocatalytic applications. Broad spectral absorbance in the visible range and exceptional conductivity are attributed to trapped Ti3+ in the film. Oxidation of Ti3+ upon heat treatment leads to a drop in conductivity, a color change from black to white and crystallization of am-TiO2. ALD grown black TiO2, without any heat treatment, is subject to dissolution in alkaline photoelectrochemical conditions. The best photocatalytic activity for solar water splitting is obtained for completely crystalline white TiO2.
- Open Access
- 2 February 2018
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 30 (4) , 1199-1208
Improved Stability of Atomic Layer Deposited Amorphous TiO2 Photoelectrode Coatings by Thermally Induced Oxygen Defects
Amorphous titanium dioxide (a-TiO2) combined with an electrocatalyst has shown to be a promising coating for stabilizing traditional semiconductor materials used in artificial photosynthesis for efficient photoelectrochemical solar-to-fuel energy conversion. In this study we report a detailed analysis of two methods of modifying an undoped thin film of atomic layer deposited (ALD) a-TiO2 without an electrocatalyst to affect its performance in water splitting reaction as a protective photoelectrode coating. The methods are high-temperature annealing in ultra-high vacuum and atomic hydrogen exposure. A key feature in both methods is that they preserve the amorphous structure of the film. Special attention is paid to the changes in the molecular and electronic structure of a-TiO2 induced by these treatments. Based on the photoelectrochemical results the a-TiO2 is susceptible to photocorrosion but significant improvement in stability is achieved after heat treatment in vacuum at temperatures above 500 °C. On the other hand, the hydrogen treatment does not increase the stability despite the ostensibly similar reduction of a-TiO2.The surface analysis allows us to interpret the improved stability to the thermally induced formation of O− species within a-TiO2 that are essentially electronic defects in the anionic framework.
- 2 February 2018
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 30 (4) , 1199-1208
Open AccessImproved Stability of Atomic Layer Deposited Amorphous TiO2 Photoelectrode Coatings by Thermally Induced Oxygen Defects
Amorphous titanium dioxide (a-TiO2) combined with an electrocatalyst has shown to be a promising coating for stabilizing traditional semiconductor materials used in artificial photosynthesis for efficient photoelectrochemical solar-to-fuel energy conversion. In this study we report a detailed analysis of two methods of modifying an undoped thin film of atomic layer deposited (ALD) a-TiO2 without an electrocatalyst to affect its performance in water splitting reaction as a protective photoelectrode coating. The methods are high-temperature annealing in ultra-high vacuum and atomic hydrogen exposure. A key feature in both methods is that they preserve the amorphous structure of the film. Special attention is paid to the changes in the molecular and electronic structure of a-TiO2 induced by these treatments. Based on the photoelectrochemical results the a-TiO2 is susceptible to photocorrosion but significant improvement in stability is achieved after heat treatment in vacuum at temperatures above 500 °C. On the other hand, the hydrogen treatment does not increase the stability despite the ostensibly similar reduction of a-TiO2.The surface analysis allows us to interpret the improved stability to the thermally induced formation of O− species within a-TiO2 that are essentially electronic defects in the anionic framework.
- 9 October 2014
- Published by IOP Publishing in Nanotechnology
- Vol. 25 (43) , 435603
Biofunctional hybrid materials: bimolecular organosilane monolayers on FeCr alloys
Hybrid organic-inorganic interfaces are the key to functionalization of stainless steel (SS). We present a solution-based deposition method for fabricating uniform bimolecular organosilane monolayers on SS and show that their properties and functionalities can be further developed through site-specific biotinylation. We correlate molecular properties of the interface with its reactivity via surface sensitive synchrotron radiation mediated high-resolution photoelectron spectroscopy (HR-PES) and chemical derivatization (CD), and we demonstrate specific bonding of streptavidin proteins to the hybrid interface. The method facilitates efficient growth of uniform bimolecular organosilane monolayers on SS under ambient conditions without the need to prime the SS surface with vacuum-deposited inorganic buffer layers. The obtained insights into molecular bonding, orientation, and behaviour of surface-confined organofunctional silanes on SS enable a new generic approach to functionalization of SS surfaces with versatile nanomolecular organosilane layers.
- 9 October 2014
- Published by IOP Publishing in Nanotechnology
- Vol. 25 (43) , 435603
Biofunctional hybrid materials: bimolecular organosilane monolayers on FeCr alloys
Hybrid organic-inorganic interfaces are the key to functionalization of stainless steel (SS). We present a solution-based deposition method for fabricating uniform bimolecular organosilane monolayers on SS and show that their properties and functionalities can be further developed through site-specific biotinylation. We correlate molecular properties of the interface with its reactivity via surface sensitive synchrotron radiation mediated high-resolution photoelectron spectroscopy (HR-PES) and chemical derivatization (CD), and we demonstrate specific bonding of streptavidin proteins to the hybrid interface. The method facilitates efficient growth of uniform bimolecular organosilane monolayers on SS under ambient conditions without the need to prime the SS surface with vacuum-deposited inorganic buffer layers. The obtained insights into molecular bonding, orientation, and behaviour of surface-confined organofunctional silanes on SS enable a new generic approach to functionalization of SS surfaces with versatile nanomolecular organosilane layers.
- 1 October 2014
- Published by Elsevier in Applied Surface Science
- Vol. 317, 856-866
Controlling the synergetic effects in (3-aminopropyl) trimethoxysilane and (3-mercaptopropyl) trimethoxysilane coadsorption on stainless steel surfaces
- 1 October 2014
- Published by Elsevier in Applied Surface Science
- Vol. 317, 856-866
Controlling the synergetic effects in (3-aminopropyl) trimethoxysilane and (3-mercaptopropyl) trimethoxysilane coadsorption on stainless steel surfaces