Armando Fontalvo
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Armando Fontalvo has a total of 47 co-authors. Here are the top co-authors by number of shared publications:
- Ricardo Vasquez Padilla
School of Environment, Science and Engineering, Southern Cross University, Lismore, NSW, 2480, Australia
11 shared publications - Antonio Bula
Department of Mechanical Engineering, Universidad del Norte, Barranquilla 081007, Colombia
7 shared publications - Jorge Duarte Forero
Programa de Ingeniería Mecánica, Universidad del Atlántico, Carrera 30 Número 8-49, Puerto Colombia, Barranquilla 080007, Colombia
7 shared publications - John Pye
Australian National University
5 shared publications - Arturo Gonzalez-Quiroga
UREMA Research Unit, Mechanical Engineering Department, Universidad del Norte, Barranquilla 080001, Colombia
4 shared publications - German Amador
Universidad del Norte, Barranquilla, Colombia
3 shared publications
Latest Publications
- Open Access
- 28 August 2024
- Published by TIB Open Publishing in SolarPACES Conference Proceedings
- Vol. 2
Supercritical Water Gasification of Biomass on CSP Plants: Comparison of On-Sun and Off-Sun Designs
A comparative study of On-Sun and Off-Sun designs for supercritical water gasification (SCWG) of biomass on concentrated solar power (CSP) plants was here presented. In the On-Sun design, the tubular reactor was placed on a cavity receiver of a solar power tower (SPT) plant and the heat employed to produce the gasification came directly from the sun (viz. the solar radiation was concentrated, thanks to the heliostat field, onto the tube's surface). In the Off-Sun designs, the gasification of the biomass was carried out inside a heat exchanger and it was produced thanks to the heat absorbed from the hottest fluid, which can be obtained from CSP plants or electrical heating. This work numerically investigated the thermomechanical performance of both designs. The results stood out the relation between temperature-gas yield-thermal stress. In On-Sun configurations the gas yield was 5 times higher than those obtained in the Off-Sun configuration. However, the highest values of both temperature and stress may produce the failure of the reactor. This fact could be avoided in an Off-Sun reactor, since its uniform heating conditions mitigate the maximum temperature and stresses.
- 28 August 2024
- Published by TIB Open Publishing in SolarPACES Conference Proceedings
- Vol. 2
Open AccessSupercritical Water Gasification of Biomass on CSP Plants: Comparison of On-Sun and Off-Sun Designs
A comparative study of On-Sun and Off-Sun designs for supercritical water gasification (SCWG) of biomass on concentrated solar power (CSP) plants was here presented. In the On-Sun design, the tubular reactor was placed on a cavity receiver of a solar power tower (SPT) plant and the heat employed to produce the gasification came directly from the sun (viz. the solar radiation was concentrated, thanks to the heliostat field, onto the tube's surface). In the Off-Sun designs, the gasification of the biomass was carried out inside a heat exchanger and it was produced thanks to the heat absorbed from the hottest fluid, which can be obtained from CSP plants or electrical heating. This work numerically investigated the thermomechanical performance of both designs. The results stood out the relation between temperature-gas yield-thermal stress. In On-Sun configurations the gas yield was 5 times higher than those obtained in the Off-Sun configuration. However, the highest values of both temperature and stress may produce the failure of the reactor. This fact could be avoided in an Off-Sun reactor, since its uniform heating conditions mitigate the maximum temperature and stresses.
- Open Access
- 17 August 2023
- Published by Elsevier in Solar Energy
- Vol. 263
Techno-economic assessment of a numbering-up approach for a 100 MWe third generation sodium-salt CSP system
- 17 August 2023
- Published by Elsevier in Solar Energy
- Vol. 263
Open AccessTechno-economic assessment of a numbering-up approach for a 100 MWe third generation sodium-salt CSP system
- Top Cited PapersOpen Access
- 3 July 2023
- Published by Elsevier in Applied Energy
- Vol. 348
Co-optimisation of the heliostat field and receiver for concentrated solar power plants
- 3 July 2023
- Published by Elsevier in Applied Energy
- Vol. 348
Top Cited PapersOpen AccessCo-optimisation of the heliostat field and receiver for concentrated solar power plants
- 10 December 2022
- Published by Elsevier in Applied Thermal Engineering
- Vol. 223
Solar-thermal beneficiation of iron ore: System-level dynamic simulation and techno-economic optimisation
- 10 December 2022
- Published by Elsevier in Applied Thermal Engineering
- Vol. 223
Solar-thermal beneficiation of iron ore: System-level dynamic simulation and techno-economic optimisation
- Open Access
- 17 May 2022
- Published by Elsevier in Solar Energy
- Vol. 239, 252-267
Techno-economic optimisation of a sodium–chloride salt heat exchanger for concentrating solar power applications
- 17 May 2022
- Published by Elsevier in Solar Energy
- Vol. 239, 252-267
Open AccessTechno-economic optimisation of a sodium–chloride salt heat exchanger for concentrating solar power applications
- 1 January 2022
- Published by AIP Publishing
- Vol. 2445, 050008
Exergy analysis of the impact of a heat exchanger on performance of an integrated sodium-salt CSP plant
- 1 January 2022
- Published by AIP Publishing
- Vol. 2445, 050008
Exergy analysis of the impact of a heat exchanger on performance of an integrated sodium-salt CSP plant
- Open Access
Thermal Optimization of a Dual Pressure Goswami Cycle for Low Grade Thermal Sources
This paper presents a theoretical investigation of a new configuration of the combined power and cooling cycle known as the Goswami cycle. The new configuration consists of two turbines operating at two different working pressures with a low-heat source temperature, below 150 °C. A comprehensive analysis was conducted to determine the effect of key operation parameters such as ammonia mass fraction at the absorber outlet and boiler-rectifier, on the power output, cooling capacity, effective first efficiency, and effective exergy efficiency, while the performance of the dual-pressure configuration was compared with the original single pressure cycle. In addition, a Pareto optimization with a genetic algorithm was conducted to obtain the best power and cooling output combinations to maximize effective first law efficiency. Results showed that the new dual-pressure configuration generated more power than the single pressure cycle, by producing up to 327.8 kW, while the single pressure cycle produced up to 110.8 kW at a 150 °C boiler temperature. However, the results also showed that it reduced the cooling output as there was less mass flow rate in the refrigeration unit. Optimization results showed that optimum effective first law efficiency ranged between 9.1% and 13.7%. The maximum effective first law efficiency at the lowest net power (32 kW) and cooling (0.38 kW) outputs was also shown. On the other hand, it presented 13.6% effective first law efficiency when the net power output was 100 kW and the cooling capacity was 0.38 kW.
Open AccessThermal Optimization of a Dual Pressure Goswami Cycle for Low Grade Thermal Sources
This paper presents a theoretical investigation of a new configuration of the combined power and cooling cycle known as the Goswami cycle. The new configuration consists of two turbines operating at two different working pressures with a low-heat source temperature, below 150 °C. A comprehensive analysis was conducted to determine the effect of key operation parameters such as ammonia mass fraction at the absorber outlet and boiler-rectifier, on the power output, cooling capacity, effective first efficiency, and effective exergy efficiency, while the performance of the dual-pressure configuration was compared with the original single pressure cycle. In addition, a Pareto optimization with a genetic algorithm was conducted to obtain the best power and cooling output combinations to maximize effective first law efficiency. Results showed that the new dual-pressure configuration generated more power than the single pressure cycle, by producing up to 327.8 kW, while the single pressure cycle produced up to 110.8 kW at a 150 °C boiler temperature. However, the results also showed that it reduced the cooling output as there was less mass flow rate in the refrigeration unit. Optimization results showed that optimum effective first law efficiency ranged between 9.1% and 13.7%. The maximum effective first law efficiency at the lowest net power (32 kW) and cooling (0.38 kW) outputs was also shown. On the other hand, it presented 13.6% effective first law efficiency when the net power output was 100 kW and the cooling capacity was 0.38 kW.
- Open Access
Energy and Exergy Analysis of Different Exhaust Waste Heat Recovery Systems for Natural Gas Engine Based on ORC
Waste heat recovery (WHR) from exhaust gases in natural gas engines improves the overall conversion efficiency. The organic Rankine cycle (ORC) has emerged as a promising technology to convert medium and low-grade waste heat into mechanical power and electricity. This paper presents the energy and exergy analyses of three ORC–WHR configurations that use a coupling thermal oil circuit. A simple ORC (SORC), an ORC with a recuperator (RORC), and an ORC with double-pressure (DORC) configuration are considered; cyclohexane, toluene, and acetone are simulated as ORC working fluids. Energy and exergy thermodynamic balances are employed to evaluate each configuration performance, while the available exhaust thermal energy variation under different engine loads is determined through an experimentally validated mathematical model. In addition, the effect of evaporating pressure on the net power output, thermal efficiency increase, specific fuel consumption, overall energy conversion efficiency, and exergy destruction is also investigated. The comparative analysis of natural gas engine performance indicators integrated with ORC configurations present evidence that RORC with toluene improves the operational performance by achieving a net power output of 146.25 kW, an overall conversion efficiency of 11.58%, an ORC thermal efficiency of 28.4%, and a specific fuel consumption reduction of 7.67% at a 1482 rpm engine speed, a 120.2 L/min natural gas flow, 1.784 lambda, and 1758.77 kW of mechanical engine power.
Open AccessEnergy and Exergy Analysis of Different Exhaust Waste Heat Recovery Systems for Natural Gas Engine Based on ORC
Waste heat recovery (WHR) from exhaust gases in natural gas engines improves the overall conversion efficiency. The organic Rankine cycle (ORC) has emerged as a promising technology to convert medium and low-grade waste heat into mechanical power and electricity. This paper presents the energy and exergy analyses of three ORC–WHR configurations that use a coupling thermal oil circuit. A simple ORC (SORC), an ORC with a recuperator (RORC), and an ORC with double-pressure (DORC) configuration are considered; cyclohexane, toluene, and acetone are simulated as ORC working fluids. Energy and exergy thermodynamic balances are employed to evaluate each configuration performance, while the available exhaust thermal energy variation under different engine loads is determined through an experimentally validated mathematical model. In addition, the effect of evaporating pressure on the net power output, thermal efficiency increase, specific fuel consumption, overall energy conversion efficiency, and exergy destruction is also investigated. The comparative analysis of natural gas engine performance indicators integrated with ORC configurations present evidence that RORC with toluene improves the operational performance by achieving a net power output of 146.25 kW, an overall conversion efficiency of 11.58%, an ORC thermal efficiency of 28.4%, and a specific fuel consumption reduction of 7.67% at a 1482 rpm engine speed, a 120.2 L/min natural gas flow, 1.784 lambda, and 1758.77 kW of mechanical engine power.
- Open Access
- 20 May 2019
- Published by MDPI AG in Preprints.org
Energy and Exergy Analysis of Different Exhaust Waste Heat Recovery Systems for Natural Gas Engine Based on ORC
One way to increase overall natural gas engine efficiency is to transform exhaust waste heat into useful energy by means of a bottoming cycle. Organic Rankine cycle (ORC) is a promising technology to convert medium and low grade waste heat into mechanical power and electricity. This paper presents an energy and exergy analysis of three ORC-Waste heat recovery configurations by using an intermediate thermal oil circuit: Simple ORC (SORC), ORC with Recuperator (RORC) and ORC with Double Pressure (DORC), and Cyclohexane, Toluene and Acetone have been proposed as working fluids. An energy and exergy thermodynamic model is proposed to evaluate each configuration performance, while available exhaust thermal energy variation under different engine loads was determined through an experimentally validated mathematical model. Additionally, the effect of evaportating pressure on net power output , absolute thermal efficiency increase, absolute specific fuel consumption decrease, overall energy conversion efficiency, and component exergy destruction is also investigated. Results evidence an improvement in operational performance for heat recovery through RORC with Toluene at an evaporation pressure of 3.4 MPa, achieving 146.25 kW of net power output, 11.58% of overall conversion efficiency, 28.4% of ORC thermal efficiency, and an specific fuel consumption reduction of 7.67% at a 1482 rpm engine speed, a 120.2 L/min natural gas Flow, 1.784 lambda, and 1758.77 kW mechanical engine power.
- 20 May 2019
- Published by MDPI AG in Preprints.org
Open AccessEnergy and Exergy Analysis of Different Exhaust Waste Heat Recovery Systems for Natural Gas Engine Based on ORC
One way to increase overall natural gas engine efficiency is to transform exhaust waste heat into useful energy by means of a bottoming cycle. Organic Rankine cycle (ORC) is a promising technology to convert medium and low grade waste heat into mechanical power and electricity. This paper presents an energy and exergy analysis of three ORC-Waste heat recovery configurations by using an intermediate thermal oil circuit: Simple ORC (SORC), ORC with Recuperator (RORC) and ORC with Double Pressure (DORC), and Cyclohexane, Toluene and Acetone have been proposed as working fluids. An energy and exergy thermodynamic model is proposed to evaluate each configuration performance, while available exhaust thermal energy variation under different engine loads was determined through an experimentally validated mathematical model. Additionally, the effect of evaportating pressure on net power output , absolute thermal efficiency increase, absolute specific fuel consumption decrease, overall energy conversion efficiency, and component exergy destruction is also investigated. Results evidence an improvement in operational performance for heat recovery through RORC with Toluene at an evaporation pressure of 3.4 MPa, achieving 146.25 kW of net power output, 11.58% of overall conversion efficiency, 28.4% of ORC thermal efficiency, and an specific fuel consumption reduction of 7.67% at a 1482 rpm engine speed, a 120.2 L/min natural gas Flow, 1.784 lambda, and 1758.77 kW mechanical engine power.