JEJoan S. Esterle

Joan S. Esterle

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Joan S. Esterle has a total of 250 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Determining and Upscaling Optimal Bamboo Char parameters for Bio-Coke Production

    by Narelle Williams, Karen Michelle Steel, J. Esterle

    Utilising bio-char in coal blends to produce bio-coke has potential to achieve near-term decarbonisation of the blast furnace for steelmaking. Research at gram scale confirms char pyrolysis temperature and conditions significantly influence char yield, structure and key parameters. Using Bamboo (Bambusa tulda sp.) this study determined key char parameters, in particular BET pore surface area, ash and oxygen content need to be minimised to reduce the effect of char on coal fluidity during carbonisation. From this, a Bio-Char Optimal Zone was identified for chars most suitable in bio-coke production. The Bio-Char Optimal Zone targets a bio-char with a BET surface area <10m2/g and Oxygen Content <6% (ad), from a biomass with low inherent ash. Gram-scale pyrolysis enabled precise control over heating rate, target temperature, and gas flow conditions. This study has identified bio-char produced at the larger kilogram scale can result in minimal control of final pyrolysis temperature across the entire char sample, resulting in a temperature spread from 350°C to 950°C within the one char sample, determined by optical reflectance measurements. By integrating results from both gram and kilogram scale experiments, thermochemical control of large mass pyrolysis generated char within the Bio-Char Optimal Zone using a coke oven.

  • Open Access

    Coking behaviour of collotelinite and collodetrinite macerals

    by Karen Michelle Steel, Tara Congo, Zhentao Li, Uduak Eyibio, J. Esterle, Ashley Conroy, Oliver Scholes

    When predicting coke quality or coking behaviour, the more accurate models typically include vitrinite content and this work explores how the two most abundant vitrinite macerals behave during carbonisation. The insights gained highlight important differences in the behaviour of collotelinite and collodetrinite, paving the way for more sophisticated coke quality prediction models and enhanced blending and processing strategies. Australian bituminous coals with random vitrinite reflectance (Ro) ranging 0.81-1.18% were studied. Coal blocks were prepared with a 15 mm × 15 mm face running perpendicular to the bedding plane and polished to identify individual macerals using microscopy. These blocks were carbonised at 3°C/min to 525°C, set in resin, and repolished to examine the coking behaviour of the identified macerals “before and after.” Vitrinite concentrates (VCs) were prepared alongside “whole coal” samples to characterise viscosity using rheometry. Collotelinite underwent considerable expansion that was far greater than the expansion for collodetrinite. Extent of collotelinite expansion was greater for the lower ranked coals, characterised by large “balloons” and thin pore walls while higher ranked coals gave rise to smaller pores and thicker pore walls. Separated VCs were rich in collotelinite and generated significant fluidity, as indicated by their low minimum viscosity. For whole coals, minimum viscosities were higher due to the presence of inertinite, however, this work suggests higher viscosities are also due to an increased proportion of collodetrinite. The maceral picking process for one coal led to a situation where the VC and the whole coal had similar levels of vitrinite, however, the VC was richer in collotelinite and exhibited a significantly lower minimum viscosity. This result suggests the fluidity development and expansion behaviour for these two vitrinite macerals is different, and aligns with visual observations from the “before and after” tests. It is proposed that volatile release behaviour is different for collotelinite and collodetrinite due to differences in microstructure. More specifically, volatiles are better retained in collotelinite which contributes to its greater fluidity development and expansion behaviour. Collotelinite may be derived from single large pieces of wood that transform through a gel-like state during coalification which may enable it to have no, or very few, defects and therefore limited pathways for volatiles to leave. Instead, volatiles are trapped and contribute to both the liquid development and the expansion as bubbles nucleate in the liquid-like material and grow. There are no inclusions and defects to destabilise bubble interfaces, allowing significant expansion to occur, perhaps until the pore-wall material reaches neighbouring macerals or minerals. In the case of collodetrinite, we propose that it is comprised of individual components that are held together physically rather than chemically owing to its detrital origin. By definition, collodetrinite material is less than 10 µm in size and closely intermixed with other macerals and minerals. Accordingly, there are defects and grain boundaries between components through which volatiles may diffuse out. It is proposed that the relative ease of volatile release for different maceral types may play a crucial role in the coal’s fluidity development, and consequently its coking behaviour.

  • Open Access

    High-frequency sequence cyclicity recorded in super-thick coal seam from the Middle Jurassic terrestrial basins of NW China

    by Yangyang Huang, Longyi Shao, J. Esterle, Xinning Li, Jiamin Zhou, Diefang Huang, Mengran Chen, Kai Zhou, Jing Lu

    Thick coal seams are important terrestrial carbon sinks that capture high-resolution records of environmental and climatic change. The Jurassic Period represents a key coal-forming interval, with extensive continental coal-bearing strata developed in northern China and Central Asia. This study focuses on the Santanghu Basin in northwestern China to investigate the relationship between astronomically forced climate cycles and peat accumulation in thick, low ash yield coal seams within mid- to high-latitude continental settings. Through petrological analysis, maceral data from thick coal seams were obtained, revealing cyclic vertical variations likely influenced by orbitally driven climate and by balance between accommodation rate and peat production rate. Additionally, spectral analysis of wireline logging data from Xishanyao Formation identifies sedimentary cycles orbitally driven by eccentricity, obliquity and precession cycles. These orbital cycles regulated basin hydrology and accommodation, thereby controlling both water table conditions and clastic input, which are respectively recorded by the vitrinite/inertinite ratio and gamma ray values. Coal intervals with relatively high vitrinite and low inertinite formed during high accommodation (wetting-up phase), characterised by increased and stable water tables that inhibited organic matter oxidation. These intervals correspond to low amplitude obliquity, which are interpreted to represent a relatively humid climate. In contrast, coal with low vitrinite and high inertinite reflects reduced accommodation and lowered water tables during drying-up phase, corresponding to relatively arid climate associated with high amplitude obliquity phases. These results indicate that super-thick coal seam development in the Santanghu Basin reflects combined effects of accommodation change and orbitally driven hydrological variability.

  • Open Access

    Shifting the Paradigm: Redefining the Chronostratigraphy of the Triassic Rewan Group, Bowen Basin, Australia

    by Matthew Scipione, Romain Vaucher, Eric Roberts, Alex J. McCoy‐West, Joan Esterle, Ashten Turner, Espen Knutsen

    The Triassic Rewan Group in the northern Bowen Basin, Queensland, Australia preserves a key record of terrestrial environments and faunas that have been assumed to document recovery following the end‐Permian mass extinction (EPME). The Rewan Group, consisting of the Sagittarius Sandstone and the Arcadia Formation, accumulated in a retroarc foreland basin during the Hunter–Bowen Orogeny, but its chronostratigraphy has remained poorly constrained because previous age models relied mainly on limited, geographically restricted biostratigraphy (esp. palynostratigraphy). Here, we couple detailed lithostratigraphic analysis with high‐density U–Pb detrital‐zircon (DZ) geochronology by LA‐ICP‐MS (ca. 300 analyses per sandstone), calibrated against latest Permian (ca. 252–251 Ma) tuff and tuffaceous reference horizons, and a detrital apatite U–Pb dataset, to establish a robust chronostratigraphic framework for the Sagittarius Sandstone and Arcadia Formation. We compare several maximum depositional age (MDA) metrics and show that maximum‐likelihood ages (MLA) at 10% discordance provide a stratigraphically coherent MDA estimate, with younger single‐grain and cluster‐based estimators used as internal checks and minimum bounds. Preferential zircon picking further shows that targeted grain selection enriches the youngest Triassic populations, strengthening the robustness of the resulting MDA constraints. The resulting MDAs demonstrate that the Rewan Group spans ca. 250–233 Ma (Olenekian to Carnian) and that the lower Rewan Group contact is strongly time‐transgressive. In the Taroom Trough (foredeep), fluvial successions show an overall up‐section younging from the latest Permian reference ages through Olenekian–Anisian Sagittarius Sandstone into the late Ladinian–earliest Carnian Arcadia Formation (based on sandstone MDAs). In contrast, in the Denison Trough (back‐bulge), the latest Permian coal measures are directly overlain by Middle–early Late Triassic Rewan Group deposits, implying a hiatus or condensed interval of at least ca. 12–15 Myr based on MDAs. We show that known Arcadia Formation vertebrate fossil‐bearing horizons are late Ladinian (239 Ma) to early Carnian (236 Ma) rather than earliest Triassic, with the younger date also corroborated by a detrital apatite lower‐intercept age of ca. 239 Ma. These revised ages show that the Arcadia Formation vertebrate assemblages do not come from the immediate post‐EPME interval but from the late Ladinian to early Carnian, across the onset of the Carnian Pluvial Episode.

  • Open Access

    Palynostratigraphy and Bayesian age stratigraphic model of new CA-ID-TIMS zircon ages from the Walloon Coal Measures, Surat Basin, Australia

    by K. Sobczak, J. Cooling, T. Crossingham, H.G. Holl, M. Reilly, J. Esterle, J.L. Crowley, C. Hannaford, M.T. Mohr, Z. Hamerli, et al.


  • Origins of clay-rich strata in Cenozoic paleochannel deposits: an example from Suttor Formation, Queensland

    by T. Yu, J. Cooling, J. Esterle, T. Chadwick, A. Babaahmadi

    Cenozoic sediments cover much of Queensland’s landscape and record changes in climate and flora that evolved in tandem with the tectonic evolution in eastern Australia, associated with uplift and erosion events arising from Late Cretaceous sea-floor spreading in the Coral Sea, leading to the passive margin we see today. In eastern Australia, incised and potentially fault-bounded valleys developed on the pre-Cenozoic landscape and were variably infilled at different times by siliciclastic sediments, carbonaceous muds and peat, and basaltic lava flows. This study examines a 100 m-deep drill core through one such siliciclastic-dominated paleochannel incised into upper Permian coal measures on the western limb of the Bowen Basin. Palynological analysis, core logging, hyperspectral logging of the core, X-ray diffraction (XRD), SEM–EDS and U–Pb zircon geochronology were used to investigate the age and origins of these clay-rich deposits. Palynological analysis confirmed that the strata belong to the upper Paleogene and Neogene Suttor Formation, a time when Australia’s climate has been interpreted to shift from wet and warm to a more arid setting. Core logging revealed that the sequence in the studied channel began as a breccia/alluvial fan with chaotic angular clasts of Permian laminated siltstone, tuff and coal floating in disturbed poorly lithified sand with evidence of soft sediment deformation, possibly initiated by localised faulting. These clasts were continually reworked and broken down into a clast supported pebble conglomerate capped by a series of claystone with intermittent carbonaceous claystone and lignite, interpreted to have formed in a lacustrine environment that could be localised on the floodplain (oxbow) or more regional in extent. Above this, and interpreted from palynology as corresponding to a climatic shift to more arid conditions, are well sorted but subrounded sugar sands and intermittent clays with abundant iron staining (?paleosols) interpreted to represent sandy ephemeral channels. These are overlain by extremely weathered undated basalts. The hyperspectral logging of the core and XRD studies of the white claystone samples indicate that they are kaolinite-rich, but observations under SEM–EDS noted that their honeycomb structure mimicked that of smectite. The presence of abundant zircon suggested the possibility of syndepositional volcaniclastics, but U–Pb zircon geochronology recorded an age of 272–254 Ma (middle to late Permian). Hence local recycling of the tuffaceous smectite-rich coal measures within the incised alluvial system, assisted by intense weathering under a warm and wet climate, and potentially acid leaching from the organic-rich layers was the origin of the kaolinite-rich clay strata.

  • Open Access

    Characterising the contemporary stress orientations near an active continental rifting zone: A case study from the Moatize Basin, central Mozambique

    by Mojtaba Rajabi, Joan Esterle, Oliver Heidbach, Daniel Travassos, Silvestre Fumo