Goran Jelicic
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Goran Jelicic has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Yves Govers
German Aerospace Center (DLR), Institute of Aeroelasticity, Göttingen, Germany
3 shared publications Jan Schwochow
German Aerospace Center (DLR)
2 shared publicationsJulian Sinske
German Aerospace Center (DLR)
2 shared publicationsJulian Springer
German Aerospace Center (DLR)
2 shared publicationsRalf Buchbach
German Aerospace Center (DLR)
2 shared publications- Julian Sinske
Deutsches Zentrum für Luft-und Raumfahrt e.v., Institut für Aeroelastik, Göttingen, Germany
1 shared publication
Latest Publications
- Open Access
- 27 February 2018
- Published by Springer Nature in CEAS Aeronautical Journal
- Vol. 9 (1) , 207-218
HALO flight test with instrumented under-wing stores for aeroelastic and load measurements in the DLR project iLOADS
- 27 February 2018
- Published by Springer Nature in CEAS Aeronautical Journal
- Vol. 9 (1) , 207-218
Open AccessHALO flight test with instrumented under-wing stores for aeroelastic and load measurements in the DLR project iLOADS
- 5 January 2017
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Online Monitoring of Aircraft Modal Parameters during Flight Test based on permanent Output-Only Modal Analysis
The process adopted for continuous monitoring of eigenfrequencies and damping ratios during the test flight of a research aircraft is presented. This comprises measurement hardware, distributed data acquisition system and software architecture in order to stream, store, and simultaneously analyze data with the methods of Operational Modal Analysis. The algorithms utilize only measured output time histories to identify modal parameters at different flight conditions. The autonomous implementations of the Stochastic Subspace Identification (SSI) and the Least-Square Complex Frequency domain (LSCF) algorithms provide estimations of the aeroelastic damping within a few seconds
- 5 January 2017
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Online Monitoring of Aircraft Modal Parameters during Flight Test based on permanent Output-Only Modal Analysis
The process adopted for continuous monitoring of eigenfrequencies and damping ratios during the test flight of a research aircraft is presented. This comprises measurement hardware, distributed data acquisition system and software architecture in order to stream, store, and simultaneously analyze data with the methods of Operational Modal Analysis. The algorithms utilize only measured output time histories to identify modal parameters at different flight conditions. The autonomous implementations of the Stochastic Subspace Identification (SSI) and the Least-Square Complex Frequency domain (LSCF) algorithms provide estimations of the aeroelastic damping within a few seconds
- 5 January 2017
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Efficient ground vibration testing of aircraft based on output-only modal analysis during taxi
The work presented in this paper shows a simple way how to obtain eigenfrequencies,\ud damping ratios and mode shapes of an aircraft prototype. The only prerequisite is flight test\ud instrumentation (FTI) including a set of acceleration sensors with sufficient number and\ud distribution over the aircraft components and data acquisition hardware. For the excitation\ud of the structure the aircraft is towed by a tractor on the runway. The enforced motion at the\ud landing gears will induce distributed inertia excitation causing airframe vibrations that can\ud be measured with acceleration sensors. Time recordings of all acceleration channels are\ud converted to cross-power spectral densities and later on analyzed using the means of\ud operational modal analysis. The work presented here demonstrates how this method was\ud used to verify the proper operation of the FTI right before entering into the flight testing.\ud However, with more intensive installation, the method can also be used for a complete modal\ud identification of the aircraft on ground, equivalent to ground vibration testing (GVT)
- 5 January 2017
- Published by American Institute of Aeronautics and Astronautics (AIAA)
Efficient ground vibration testing of aircraft based on output-only modal analysis during taxi
The work presented in this paper shows a simple way how to obtain eigenfrequencies,\ud damping ratios and mode shapes of an aircraft prototype. The only prerequisite is flight test\ud instrumentation (FTI) including a set of acceleration sensors with sufficient number and\ud distribution over the aircraft components and data acquisition hardware. For the excitation\ud of the structure the aircraft is towed by a tractor on the runway. The enforced motion at the\ud landing gears will induce distributed inertia excitation causing airframe vibrations that can\ud be measured with acceleration sensors. Time recordings of all acceleration channels are\ud converted to cross-power spectral densities and later on analyzed using the means of\ud operational modal analysis. The work presented here demonstrates how this method was\ud used to verify the proper operation of the FTI right before entering into the flight testing.\ud However, with more intensive installation, the method can also be used for a complete modal\ud identification of the aircraft on ground, equivalent to ground vibration testing (GVT)