João Francisco Silva Trentin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
João Francisco Silva Trentin has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Samuel da Silva
Department of Mechanical Engineering, Universidade Estadual Paulista (UNESP), Ilha Solteira, Brazil
6 shared publications - Davi Antonio Santos
Division of Mechanical Engineering, Department of Mechatronics, Aeronautics Institute of Technology (ITA), São José dos Campos, Brazil
4 shared publications - Hanspeter Schaub
University of Colorado
3 shared publications - Jean Marcos De Souza Ribeiro
Departamento de Engenharia Eltrica, Faculdade de Engenharia de Ilha Solteira, Universidade Estadual Paulista (UNESP), Ilha Solteira, Brazil
3 shared publications Gustavo Luis Chagas Manhães De Abreu
UNESP - Univ Estadual Paulista
1 shared publicationHanspeter Schaub
Department of Aerospace Engineering Sciences, Colorado Center for Astrodynamics Research, University of Colorado Boulder, Boulder, CO 80309-0431
1 shared publication
Latest Publications
- 23 March 2024
- Published by Springer Nature
- p. 119-132
Global Sliding Mode Control for a Fully Actuated Non-planar Hexarotor Aerial Vehicle
- 23 March 2024
- Published by Springer Nature
- p. 119-132
Global Sliding Mode Control for a Fully Actuated Non-planar Hexarotor Aerial Vehicle
- Open Access
- 25 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 9529-9546
Cooperative Threat Engagement Using Drone Swarms
The ability of multiple manned and unmanned aircraft systems to cooperatively engage and disable an aerial threat plays a decisive role in modern warfare scenarios. In this paper, we apply key methods to enable the so-called cooperative threat engagement capability among multiple networked agents, e.g ., a swarm of drones, with combat and communication capabilities. In particular, this research combines AI-based decision-making and control techniques for a swarm of loyal wingman drones to coordinate efficient defense actions in a cooperative and autonomous manner.We apply these concepts in a defense scenario that is modeled to analyze the loyal wingman concept, which we consider an interesting testbed for cooperative decision-making and low-level control techniques. The investigated methods were implemented in a realistic 3D UAV simulator for demonstration and evaluation.
- 25 January 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 11, 9529-9546
Open AccessCooperative Threat Engagement Using Drone Swarms
The ability of multiple manned and unmanned aircraft systems to cooperatively engage and disable an aerial threat plays a decisive role in modern warfare scenarios. In this paper, we apply key methods to enable the so-called cooperative threat engagement capability among multiple networked agents, e.g ., a swarm of drones, with combat and communication capabilities. In particular, this research combines AI-based decision-making and control techniques for a swarm of loyal wingman drones to coordinate efficient defense actions in a cooperative and autonomous manner.We apply these concepts in a defense scenario that is modeled to analyze the loyal wingman concept, which we consider an interesting testbed for cooperative decision-making and low-level control techniques. The investigated methods were implemented in a realistic 3D UAV simulator for demonstration and evaluation.
- 13 July 2022
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 44 (8) , 1-14
Dynamic modeling and control of a spherical pendulum with a VSCMG
- 13 July 2022
- Published by Springer Nature in Journal of the Brazilian Society of Mechanical Sciences and Engineering
- Vol. 44 (8) , 1-14
Dynamic modeling and control of a spherical pendulum with a VSCMG
- 24 May 2022
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 109 (3) , 1693-1704
Predefined-time global sliding mode control design for a 3D pendulum
- 24 May 2022
- Published by Springer Nature in Nonlinear Dynamics
- Vol. 109 (3) , 1693-1704
Predefined-time global sliding mode control design for a 3D pendulum
- 3 February 2021
- Published by Springer Nature in Meccanica
- Vol. 56 (4) , 981-990
An experimental study to swing up and control a pendulum with two reaction wheels
- 3 February 2021
- Published by Springer Nature in Meccanica
- Vol. 56 (4) , 981-990
An experimental study to swing up and control a pendulum with two reaction wheels
- Open Access
- 20 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 74922-74932
Inverted Pendulum Nonlinear Controllers Using Two Reaction Wheels: Design and Implementation
Reaction wheels have been extensively used to control and stabilize a wide range of applications due to the angular momentum exchange that they provide to mechanical systems. However, there exist several limitations associated with actuator saturation and the presence of singularities that lead towards the use of different controllers and devices. Recently, a new and unusual configuration using two reaction wheels was proposed and illustrated in an inverted pendulum to drive and control it using a simple and well-known PID controller. In this context, this paper improves the previous results on the same system by proposing two more sophisticated nonlinear controllers: a nonlinear proportional-derivative and a sliding mode controller. The proof of the stability of each controller is also provided, and the asymptotic stability is proven. A friction model is experimentally updated into the differential equations of the pendulum and also included for the controllers designing. A real-time application verifies the performance of the controllers using low-cost hardware. Results based on the analysis of different performance indices highlight the improvement of applying these two nonlinear control techniques comparing to the previous paper using this configuration of actuators.
- 20 April 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 74922-74932
Open AccessInverted Pendulum Nonlinear Controllers Using Two Reaction Wheels: Design and Implementation
Reaction wheels have been extensively used to control and stabilize a wide range of applications due to the angular momentum exchange that they provide to mechanical systems. However, there exist several limitations associated with actuator saturation and the presence of singularities that lead towards the use of different controllers and devices. Recently, a new and unusual configuration using two reaction wheels was proposed and illustrated in an inverted pendulum to drive and control it using a simple and well-known PID controller. In this context, this paper improves the previous results on the same system by proposing two more sophisticated nonlinear controllers: a nonlinear proportional-derivative and a sliding mode controller. The proof of the stability of each controller is also provided, and the asymptotic stability is proven. A friction model is experimentally updated into the differential equations of the pendulum and also included for the controllers designing. A real-time application verifies the performance of the controllers using low-cost hardware. Results based on the analysis of different performance indices highlight the improvement of applying these two nonlinear control techniques comparing to the previous paper using this configuration of actuators.
- 18 September 2019
- Published by ASME International in Journal of Dynamic Systems, Measurement, and Control
- Vol. 141 (11)
Variable Speed Control Moment Gyroscope in an Inverted Pendulum
The use of variable speed control moment gyroscope (VSCMG) is an effective way for attitude stabilization of aerospace devices. It is possible to control the oscillation and direction rate of change in rigid bodies in space due to the controlled change of angular momentum rate. Thus, this paper proposes an atypical pendulum configuration controlled by a VSCMG actuator. The idea of the VSCMG pendulum (VSCMGP) is to use both the angular momentum variation in amplitude and direction to implement the control. The controller is designed using Lyapunov theory to stabilize the pendulum in the inverted position. The results illustrate the control using a VSCMG in an inverted pendulum showing how the stabilization of an inverted pendulum is performed using two control actions. Also, the comparison of the proposed pendulum with a classical configuration is presented.
- 18 September 2019
- Published by ASME International in Journal of Dynamic Systems, Measurement, and Control
- Vol. 141 (11)
Variable Speed Control Moment Gyroscope in an Inverted Pendulum
The use of variable speed control moment gyroscope (VSCMG) is an effective way for attitude stabilization of aerospace devices. It is possible to control the oscillation and direction rate of change in rigid bodies in space due to the controlled change of angular momentum rate. Thus, this paper proposes an atypical pendulum configuration controlled by a VSCMG actuator. The idea of the VSCMG pendulum (VSCMGP) is to use both the angular momentum variation in amplitude and direction to implement the control. The controller is designed using Lyapunov theory to stabilize the pendulum in the inverted position. The results illustrate the control using a VSCMG in an inverted pendulum showing how the stabilization of an inverted pendulum is performed using two control actions. Also, the comparison of the proposed pendulum with a classical configuration is presented.
- 29 June 2019
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering
- Vol. 234 (3) , 420-429
Attitude control of inverted pendulums using reaction wheels: Comparison between using one and two actuators
The attitude control using reaction wheels as actuators has been one of the most popular ways to stabilize and repel external disturbances in aerospace devices. From the controlled change of the angular momentum rate of change using reaction wheels, it is possible to control the oscillation and direction rates of change of rigid bodies in space. Thus, the main idea of this article is to present a case study with different configurations of the well-known reaction wheel pendulum. The first is based on the classical configuration, and the second, a new one, a pendulum with two reaction wheels. For both configurations, proportional–integral–derivative controllers were designed and experimental devices were built to perform real-time controllers using low-cost hardware. The simulated and experimental results have shown that the pendulums were controlled using a simple controller in the inverted position and the results were satisfactory. Four performance indices were calculated to evaluate the results for each configuration. They showed that the pendulum with two reaction wheels worked better than the pendulum with one reaction wheel. Two actuators made it easier to move and control the pendulum in the inverted position.
- 29 June 2019
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering
- Vol. 234 (3) , 420-429
Attitude control of inverted pendulums using reaction wheels: Comparison between using one and two actuators
The attitude control using reaction wheels as actuators has been one of the most popular ways to stabilize and repel external disturbances in aerospace devices. From the controlled change of the angular momentum rate of change using reaction wheels, it is possible to control the oscillation and direction rates of change of rigid bodies in space. Thus, the main idea of this article is to present a case study with different configurations of the well-known reaction wheel pendulum. The first is based on the classical configuration, and the second, a new one, a pendulum with two reaction wheels. For both configurations, proportional–integral–derivative controllers were designed and experimental devices were built to perform real-time controllers using low-cost hardware. The simulated and experimental results have shown that the pendulums were controlled using a simple controller in the inverted position and the results were satisfactory. Four performance indices were calculated to evaluate the results for each configuration. They showed that the pendulum with two reaction wheels worked better than the pendulum with one reaction wheel. Two actuators made it easier to move and control the pendulum in the inverted position.
- 1 January 2016
- Published by SWGE Sistemas Ltda
Controle Não-Linear de um Pêndulo com Roda de Reação