Naoko Yoshida
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Naoko Yoshida has a total of 82 co-authors. Here are the top co-authors by number of shared publications:
- Lingyu Meng
Nagoya Inst Technol Nitech, Dept Civil Engn, Nagoya 4668555, Japan
5 shared publications Fumichika Tanaka
Department of Civil and Environmental Engineering, Nagoya Institute of Technology (Nitech), Gokiso-Cho, Showa-Ku, Nagoya, Aichi, Japan
4 shared publicationsKazuki Iida
River & Water Resources Division, Nippon Koei Co. Ltd., 5-4 Kojimachi, Chiyoda-ku, Tokyo, Japan
4 shared publicationsMari Sugioka
Department of Civil and Environmental Engineering, Nagoya Institute of Technology (Nitech), Gokiso-Cho, Showa-Ku, Nagoya, Aichi, Japan
4 shared publications- Akira Hiraishi
Department of Environmental and Life Sciences, Toyohashi University of Technology, Toyohashi 441-8580, Japan
3 shared publications Arata Katayama
Department of Environmental Engineering and Architecture, Graduate School of Environmental Studies, Nagoya University, Nagoya, 464-8603, Japan
3 shared publications
Latest Publications
- 10 September 2025
- Published by Elsevier in Environmental Research
- Vol. 286 (Pt 1) , 122807
Carbon brush-activated electron shuttling accelerates acetoclastic methanogenesis in palm oil mill effluent
- 10 September 2025
- Published by Elsevier in Environmental Research
- Vol. 286 (Pt 1) , 122807
Carbon brush-activated electron shuttling accelerates acetoclastic methanogenesis in palm oil mill effluent
- Open Access
- 14 July 2025
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 27 (5) , 2931-2945
Enhancing sludge stabilization and methane production in the anaerobic digestion of palm oil mill effluent using carbon conductive materials
Palm oil mill effluent (POME) sludge is lipid rich and requires effective treatment. Anaerobic digestion is an economically viable solution for reducing environmental impacts while supporting energy recovery. However, its performance is often constrained by the accumulation of volatile fatty acids. This study evaluated the dosage effect of carbon and carbon–graphite felts (3, 6, 9, and 12 g L−1) on sludge stabilization and biogas production in lab-scale semi-continuous reactors under mesophilic conditions (37 ± 1 °C) at an organic loading rate of 1.5 g volatile solids (VS) L−1 day−1. The results showed that 3 g L−1 of carbon felt increased methane production rate by 20% compared to the blank (0.257 NL-CH4 gVSadded −1 day−1). The chemical oxygen demand and VS removal improved by 82% and 78%, respectively, compared to the blank, indicating significant organic matter degradation (p < 0.05). Total utilization of fatty acids reached 77%, demonstrating stable operational conditions and effective inhibition alleviation. Microbial community analysis revealed interactions involving Clostridium, Syntrophomonas, Methanosaeta, and Methanobacteria, suggesting improved direct interspecies electron transfer through conductive pathways. These findings demonstrate the effectiveness of conductive materials for stabilizing sludge and enhancing methane production, providing a practical solution for POME treatment.
- 14 July 2025
- Published by Springer Nature in Journal of Material Cycles and Waste Management
- Vol. 27 (5) , 2931-2945
Open AccessEnhancing sludge stabilization and methane production in the anaerobic digestion of palm oil mill effluent using carbon conductive materials
Palm oil mill effluent (POME) sludge is lipid rich and requires effective treatment. Anaerobic digestion is an economically viable solution for reducing environmental impacts while supporting energy recovery. However, its performance is often constrained by the accumulation of volatile fatty acids. This study evaluated the dosage effect of carbon and carbon–graphite felts (3, 6, 9, and 12 g L−1) on sludge stabilization and biogas production in lab-scale semi-continuous reactors under mesophilic conditions (37 ± 1 °C) at an organic loading rate of 1.5 g volatile solids (VS) L−1 day−1. The results showed that 3 g L−1 of carbon felt increased methane production rate by 20% compared to the blank (0.257 NL-CH4 gVSadded −1 day−1). The chemical oxygen demand and VS removal improved by 82% and 78%, respectively, compared to the blank, indicating significant organic matter degradation (p < 0.05). Total utilization of fatty acids reached 77%, demonstrating stable operational conditions and effective inhibition alleviation. Microbial community analysis revealed interactions involving Clostridium, Syntrophomonas, Methanosaeta, and Methanobacteria, suggesting improved direct interspecies electron transfer through conductive pathways. These findings demonstrate the effectiveness of conductive materials for stabilizing sludge and enhancing methane production, providing a practical solution for POME treatment.
- Open Access
- 16 August 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (36) , 26484-26493
Application of natural zeolite adsorption in cooperation with photosynthesis for the post-treatment of microbial fuel cells
Natural zeolites based on adsorption, combined with photosynthesis as secondary treatment for microbial fuel cells, achieved 84.5% removal of NH4+.
- 16 August 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (36) , 26484-26493
Open AccessApplication of natural zeolite adsorption in cooperation with photosynthesis for the post-treatment of microbial fuel cells
Natural zeolites based on adsorption, combined with photosynthesis as secondary treatment for microbial fuel cells, achieved 84.5% removal of NH4+.
- 5 July 2024
- Published by Elsevier in Environmental Research
- Vol. 259, 119503
Microbial fuel cell in long-term operation and providing electricity for intermittent aeration to remove contaminants from sewage
- 5 July 2024
- Published by Elsevier in Environmental Research
- Vol. 259, 119503
Microbial fuel cell in long-term operation and providing electricity for intermittent aeration to remove contaminants from sewage
- 27 June 2024
- Published by Elsevier in Bioelectrochemistry
- Vol. 160, 108770
Preliminary evaluation of electricity recovery from palm oil mill effluent by anion exchange microbial fuel cell
- 27 June 2024
- Published by Elsevier in Bioelectrochemistry
- Vol. 160, 108770
Preliminary evaluation of electricity recovery from palm oil mill effluent by anion exchange microbial fuel cell
- 1 January 2024
- Published by Elsevier in Journal of Cleaner Production
- Vol. 439, 140544
Anode biomass rather than soluble organic matter is fuel for electricity production in microbial fuel cell at longer hydraulic retention time
- 1 January 2024
- Published by Elsevier in Journal of Cleaner Production
- Vol. 439, 140544
Anode biomass rather than soluble organic matter is fuel for electricity production in microbial fuel cell at longer hydraulic retention time
- 12 December 2023
- Published by Elsevier in Environmental Research
- Vol. 243, 117744
Multi-anode enhanced the bioelectricity generation in air-cathode microbial fuel cells towards energy self-sustaining wastewater treatment
- 12 December 2023
- Published by Elsevier in Environmental Research
- Vol. 243, 117744
Multi-anode enhanced the bioelectricity generation in air-cathode microbial fuel cells towards energy self-sustaining wastewater treatment
- 27 November 2023
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 10 (1) , 296-303
Optimizing low-voltage boosting for an air-cathode microbial fuel cell with an anion exchange membrane in a 246 L wastewater treatment reactor
Microbial fuel cells (MFCs) have been applied in wastewater treatment; however, the secondary use of recovered electricity has been rarely investigated. Here, we aimed to optimize electricity recovery and the secondary use strategy using a 246 L reactor packed with 12 tubular air-cathode MFC units using an anion exchange membrane (AEM) as the separator. Parallelly connected eight MFC units exhibited a maximum electric power, 3.5-fold higher than a single MFC, from 16 to 58 mW; however, the power density was the highest for a single MFC or two MFCs considered together, at 0.10 and 0.11 W m−2, respectively, and decreased for more than three MFCs. Electricity recovery from the MFCs by changing the combination ratios of the MFCs and two DC/DC converters, LTC3105 and ADP5090, was the most efficient (60%) considering the connection of a single MFC and ADP5090, respectively. The 12 pairs of MFCs and ADP5090 in 245 L wastewater powered an aeration pump to achieve 0.39 L h−1 aeration flow in wastewater, an air fan to have 12.8 L h−1 air-flow, and lit two LEDs. Thus, the electricity generated by MFCs treating wastewater could be used to operate various devices, although improvements in individual MFCs are necessary for practical implementation.
- 27 November 2023
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Water Research & Technology
- Vol. 10 (1) , 296-303
Optimizing low-voltage boosting for an air-cathode microbial fuel cell with an anion exchange membrane in a 246 L wastewater treatment reactor
Microbial fuel cells (MFCs) have been applied in wastewater treatment; however, the secondary use of recovered electricity has been rarely investigated. Here, we aimed to optimize electricity recovery and the secondary use strategy using a 246 L reactor packed with 12 tubular air-cathode MFC units using an anion exchange membrane (AEM) as the separator. Parallelly connected eight MFC units exhibited a maximum electric power, 3.5-fold higher than a single MFC, from 16 to 58 mW; however, the power density was the highest for a single MFC or two MFCs considered together, at 0.10 and 0.11 W m−2, respectively, and decreased for more than three MFCs. Electricity recovery from the MFCs by changing the combination ratios of the MFCs and two DC/DC converters, LTC3105 and ADP5090, was the most efficient (60%) considering the connection of a single MFC and ADP5090, respectively. The 12 pairs of MFCs and ADP5090 in 245 L wastewater powered an aeration pump to achieve 0.39 L h−1 aeration flow in wastewater, an air fan to have 12.8 L h−1 air-flow, and lit two LEDs. Thus, the electricity generated by MFCs treating wastewater could be used to operate various devices, although improvements in individual MFCs are necessary for practical implementation.
- Open Access
- 18 August 2023
- Published by Wiley in Environmental Microbiology Reports
- Vol. 15 (6) , 557-567
Dehalococcoides mccartyi strain NIT01 grows more stably in vessels made of pure titanium rather than the stainless alloy SUS304
Advances in many isolation studies have revealed that pure Dehalococcoides grow stably, although the large‐scale pure cultivation of Dehalococcoides has yet to be established. In this study, 7 L‐culturing of Dehalococcoides mccartyi strain NIT01 was first performed using vessels made of glass and stainless alloy SUS304. All batches cultured in the glass vessel successfully dechlorinated >95% of 1 mM trichloroethene (TCE) to ethene (ETH), whereas only 5 out of 13 batches cultured in the SUS304 vessel did the same. The difference in dechlorination efficiency suggested the possible inhibition of dechlorination by SUS304. Also, the strain NIT01 showed long delays in dechlorination with pieces of SUS316, steel, and a repeatedly used SUS304, but not with titanium. The repeatedly used SUS304 cracked and increased the Fe 2+ concentration to ≥76 μM. Dechlorination by this strain was also inhibited with ≥1000 μM Fe 2+ and ≥23 μM Cr 3+ but not with ≤100 μM Ni 2+ , suggesting that Cr 3+ eluted from solid stainless alloys inhibited the dechlorination. Culturing in a titanium vessel instead of a stainless alloy showed the complete dechlorination of 1 mM TCE within 12–28 days with a growth yield of 2.7 × 10 7 cells/μmol‐released Cl − , even after repeating use of the vessels six times.
- 18 August 2023
- Published by Wiley in Environmental Microbiology Reports
- Vol. 15 (6) , 557-567
Open AccessDehalococcoides mccartyi strain NIT01 grows more stably in vessels made of pure titanium rather than the stainless alloy SUS304
Advances in many isolation studies have revealed that pure Dehalococcoides grow stably, although the large‐scale pure cultivation of Dehalococcoides has yet to be established. In this study, 7 L‐culturing of Dehalococcoides mccartyi strain NIT01 was first performed using vessels made of glass and stainless alloy SUS304. All batches cultured in the glass vessel successfully dechlorinated >95% of 1 mM trichloroethene (TCE) to ethene (ETH), whereas only 5 out of 13 batches cultured in the SUS304 vessel did the same. The difference in dechlorination efficiency suggested the possible inhibition of dechlorination by SUS304. Also, the strain NIT01 showed long delays in dechlorination with pieces of SUS316, steel, and a repeatedly used SUS304, but not with titanium. The repeatedly used SUS304 cracked and increased the Fe 2+ concentration to ≥76 μM. Dechlorination by this strain was also inhibited with ≥1000 μM Fe 2+ and ≥23 μM Cr 3+ but not with ≤100 μM Ni 2+ , suggesting that Cr 3+ eluted from solid stainless alloys inhibited the dechlorination. Culturing in a titanium vessel instead of a stainless alloy showed the complete dechlorination of 1 mM TCE within 12–28 days with a growth yield of 2.7 × 10 7 cells/μmol‐released Cl − , even after repeating use of the vessels six times.
- 14 August 2023
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 459, 132251
Soil organic matter and nutrient availability affect the applicability of low-carbon energy source in Dehalococcoides-augmented soil
- 14 August 2023
- Published by Elsevier in Journal of Hazardous Materials
- Vol. 459, 132251
Soil organic matter and nutrient availability affect the applicability of low-carbon energy source in Dehalococcoides-augmented soil