Kathryn A. Whitaker
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Kathryn A. Whitaker has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
Adam K. Schmitt
The Dow Chemical Company , Midland , Michigan 48674 , United States
2 shared publicationsJunchi Ma
Department of Chemical Engineering, Carnegie Mellon University, Pittsburgh, Pennsylvania 15213, United States
2 shared publications- Lynn M. Walker
Department of Chemical Engineering and Materials Science
2 shared publications - Todd M. Squires
Department of Chemical Engineering, University of California, Santa Barbara, Santa Barbara, USA
2 shared publications - Tzu-Chi Kuo
The Dow Chemical Company, Midland, Michigan 48674, United States
2 shared publications Arash Nowbahar
Formulation Sciences, Core R&D, The Dow Chemical Company, Midland, Michigan 48674, United States
1 shared publication
Latest Publications
- Open Access
- 20 October 2023
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 39 (43) , 15238-15248
Solvent Quality and Aggregation State of Asphaltenes on Interfacial Mechanics and Jamming Behavior at the Oil/Water Interface
The formation of highly stable water-in-oil emulsions results in complications in both upstream and downstream processing. Emulsion stability in these systems has been connected to the adsorption of surface-active asphaltenes that are assumed to form a rigidified film at the oil/water (o/w) interface. Full characterization of this behavior is needed to allow for engineered solutions for enhanced oil recovery. Interfacial properties, such as surface pressure and interfacial elasticity, are implicated in the stabilizing mechanism for these observed films. Asphaltenes are known to be interfacially active in both good solvents (aromatics) and poor solvents (high ratio of aliphatic to aromatic). However, due to inherent complexities present in asphaltene studies, the details of the mechanical properties of the interface remain poorly understood. Despite the widely accepted perception that asphaltenes form persistent rigid films at fluid-fluid interfaces, the connection between bulk solution properties and interfacial mechanics has not been resolved. Here, the effects of solvent quality on the interfacial properties of asphaltene dispersions are determined by using a well-defined asphaltene/solvent system. Interfacial rigidity is observed only under poor solvent conditions, while the good solvent system remains fluid-like. The interfacial rheology under good and poor solvent conditions is measured simultaneously with surface pressure measurements to track interfacial development. It is shown that surface pressure and dilatational modulus measurements are not indicators of whether an interface demonstrates rigid behavior under large compressions. Finally, conditions required for asphaltene-coated interfaces to exhibit the mechanical behavior associated with a rigidified interface are defined. This work provides a framework for quantifying the impact of the aggregation state of asphaltenes on the stability and mechanics at the o/w interface.
- 20 October 2023
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 39 (43) , 15238-15248
Open AccessSolvent Quality and Aggregation State of Asphaltenes on Interfacial Mechanics and Jamming Behavior at the Oil/Water Interface
The formation of highly stable water-in-oil emulsions results in complications in both upstream and downstream processing. Emulsion stability in these systems has been connected to the adsorption of surface-active asphaltenes that are assumed to form a rigidified film at the oil/water (o/w) interface. Full characterization of this behavior is needed to allow for engineered solutions for enhanced oil recovery. Interfacial properties, such as surface pressure and interfacial elasticity, are implicated in the stabilizing mechanism for these observed films. Asphaltenes are known to be interfacially active in both good solvents (aromatics) and poor solvents (high ratio of aliphatic to aromatic). However, due to inherent complexities present in asphaltene studies, the details of the mechanical properties of the interface remain poorly understood. Despite the widely accepted perception that asphaltenes form persistent rigid films at fluid-fluid interfaces, the connection between bulk solution properties and interfacial mechanics has not been resolved. Here, the effects of solvent quality on the interfacial properties of asphaltene dispersions are determined by using a well-defined asphaltene/solvent system. Interfacial rigidity is observed only under poor solvent conditions, while the good solvent system remains fluid-like. The interfacial rheology under good and poor solvent conditions is measured simultaneously with surface pressure measurements to track interfacial development. It is shown that surface pressure and dilatational modulus measurements are not indicators of whether an interface demonstrates rigid behavior under large compressions. Finally, conditions required for asphaltene-coated interfaces to exhibit the mechanical behavior associated with a rigidified interface are defined. This work provides a framework for quantifying the impact of the aggregation state of asphaltenes on the stability and mechanics at the o/w interface.
- Open Access
- 26 January 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 37 (4) , 2791-2798
Advantages of a Millifluidic Approach to the Characterization of Long-Time Solvency Effects on Bulk Asphaltene Precipitation
- 26 January 2023
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 37 (4) , 2791-2798
Open AccessAdvantages of a Millifluidic Approach to the Characterization of Long-Time Solvency Effects on Bulk Asphaltene Precipitation
- 30 June 2019
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 35 (29) , 9374-9381
Effect of Ethylcellulose on the Rheology and Mechanical Heterogeneity of Asphaltene Films at the Oil–Water Interface
Asphaltenes are surface-active molecules that exist naturally in crude oil. They adsorb at the water-oil interface and form viscoelastic interfacial films that stabilize emulsion droplets, making water-oil separation extremely challenging. There is thus a need for chemical demulsifiers to disrupt the interfacial asphaltene films, and thereby facilitate water-oil separation. Here, we examine ethycellulose (EC) as a model demulsifier and measure its impact on the interfacial properties of asphaltene films using interfacial shear microrheology. When EC is mixed with an oil and asphaltene solution, it retards the interfacial stiffening that occurs between the oil phase in contact with a water phase. Moreover, EC introduces relatively weak regions within the film. When EC is introduced to a pre-existing asphaltene film, the stiffness of the films decreases abruptly and significantly. Direct visualization of interfacial dynamics further reveals that EC acts inhomogeneously, and the relatively soft regions in the initial film are seen to expand. This mechanism likely impacts emulsion destabilization, and provides a new insight to the process of demulsification.
- 30 June 2019
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 35 (29) , 9374-9381
Effect of Ethylcellulose on the Rheology and Mechanical Heterogeneity of Asphaltene Films at the Oil–Water Interface
Asphaltenes are surface-active molecules that exist naturally in crude oil. They adsorb at the water-oil interface and form viscoelastic interfacial films that stabilize emulsion droplets, making water-oil separation extremely challenging. There is thus a need for chemical demulsifiers to disrupt the interfacial asphaltene films, and thereby facilitate water-oil separation. Here, we examine ethycellulose (EC) as a model demulsifier and measure its impact on the interfacial properties of asphaltene films using interfacial shear microrheology. When EC is mixed with an oil and asphaltene solution, it retards the interfacial stiffening that occurs between the oil phase in contact with a water phase. Moreover, EC introduces relatively weak regions within the film. When EC is introduced to a pre-existing asphaltene film, the stiffness of the films decreases abruptly and significantly. Direct visualization of interfacial dynamics further reveals that EC acts inhomogeneously, and the relatively soft regions in the initial film are seen to expand. This mechanism likely impacts emulsion destabilization, and provides a new insight to the process of demulsification.
- Open Access
- 20 May 2019
- Published by Springer Nature in Nature Communications
- Vol. 10 (1) , 1-8
Colloidal gel elasticity arises from the packing of locally glassy clusters
Colloidal gels formed by arrested phase separation are found widely in agriculture, biotechnology, and advanced manufacturing; yet, the emergence of elasticity and the nature of the arrested state in these abundant materials remains unresolved. Here, the quantitative agreement between integrated experimental, computational, and graph theoretic approaches are used to understand the arrested state and the origins of the gel elastic response. The micro-structural source of elasticity is identified by the l-balanced graph partition of the gels into minimally interconnected clusters that act as rigid, load bearing units. The number density of cluster-cluster connections grows with increasing attraction, and explains the emergence of elasticity in the network through the classic Cauchy-Born theory. Clusters are amorphous and iso-static. The internal cluster concentration maps onto the known attractive glass line of sticky colloids at low attraction strengths and extends it to higher strengths and lower particle volume fractions.
- 20 May 2019
- Published by Springer Nature in Nature Communications
- Vol. 10 (1) , 1-8
Open AccessColloidal gel elasticity arises from the packing of locally glassy clusters
Colloidal gels formed by arrested phase separation are found widely in agriculture, biotechnology, and advanced manufacturing; yet, the emergence of elasticity and the nature of the arrested state in these abundant materials remains unresolved. Here, the quantitative agreement between integrated experimental, computational, and graph theoretic approaches are used to understand the arrested state and the origins of the gel elastic response. The micro-structural source of elasticity is identified by the l-balanced graph partition of the gels into minimally interconnected clusters that act as rigid, load bearing units. The number density of cluster-cluster connections grows with increasing attraction, and explains the emergence of elasticity in the network through the classic Cauchy-Born theory. Clusters are amorphous and iso-static. The internal cluster concentration maps onto the known attractive glass line of sticky colloids at low attraction strengths and extends it to higher strengths and lower particle volume fractions.
- 22 September 2017
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 31 (10) , 10555-10565
Mechanistic Study of Water Droplet Coalescence and Flocculation in Diluted Bitumen Emulsions with Additives Using Microfluidics
- 22 September 2017
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 31 (10) , 10555-10565
Mechanistic Study of Water Droplet Coalescence and Flocculation in Diluted Bitumen Emulsions with Additives Using Microfluidics