Trilochan Mishra
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Trilochan Mishra has a total of 99 co-authors. Here are the top co-authors by number of shared publications:
- Kulamani Parida
Centre for Nano Science and Nano Technology, Institute of Technical Education and Research, Siksha ‘O’ Anusandhan University, Bhubaneswar-751030, India
16 shared publications - Noor Aman
Department of Chemistry, B.S. Abdur Rahman Crescent Institute of Science and Technology, Chennai, India
12 shared publications - Ranjan K. Sahu
Academic of Scientific and Innovative Research (AcSIR), New Delhi, India
5 shared publications J. Hait
ACC Division, National Metallurgical Laboratory, CSIR (Council of Scientific & Industrial Research), Jamshedpur-831007, India
4 shared publicationsR.K. Jana
ACC Division, National Metallurgical Laboratory, CSIR (Council of Scientific & Industrial Research), Jamshedpur-831007, India
4 shared publicationsArvind Sinha
3 shared publications
Latest Publications
- 3 January 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (2) , 2204-2215
Tailoring of Visible to Near-Infrared Active 2D MXene with Defect-Enriched Titania-Based Heterojunction Photocatalyst for Green H2 Generation
A wide solar light absorption window and its utilization, long-term stability, and improved interfacial charge transfer are the keys to scalable and superior solar photocatalytic performance. Based on this objective, a noble metal-free composite photocatalyst is developed with conducting MXene (Ti3C2) and semiconducting cauliflower-shaped CdS and porous Cu2O. XPS, HRTEM, and ESR analyses of TiOy@Ti3C2 confirm the formation of enough defect-enriched TiOy (where y is < 2) on the surface of Ti3C2 during hydrothermal treatment, thus creating a third semiconducting site with enough oxygen vacancy. The final material, TiOy@Ti3C2/CdS/Cu2O, shows a broad absorption window from 300 to 2000 nm, covering the visible to near-infrared (NIR) range of the solar spectrum. Photocatalytic H2 generation activity is found to be 12.23 and 16.26 mmol g-1 h-1 in the binary (TiOy@Ti3C2/CdS) and tertiary composite (TiOy@Ti3C2/CdS/Cu2O), respectively, with good repeatability under visible-NIR light using lactic acid as the hole scavenger. A clear increase of efficiency by 1.53 mmol g-1 h-1 in the tertiary composite due to NIR light absorption supports the intrinsic upconversion of electrons, which will open a new prospective of solar light utilization. Decreased charge-transfer resistance from the EIS plot and a decrease in PL intensity established the improved interfacial charge separation in the tertiary composite. Compared to pure CdS, H2 generation efficiency is 29.6 times higher on the noble metal-free tertiary composite with an apparent quantum efficiency of 12.34%. Synergistic effect of defect-enriched TiOy formation, creation of proper dual p-n junction on a Ti3C2 sheet as supported by the Mott-Schottky plot, significant NIR light absorption, increased electron mobility, and charge transfer on the conductive Ti3C2 layer facilitate the drastically increased hydrogen evolution rate even after several cycles of repetition. Expectantly, the 2D MXene-based heterostructure with defect-enriched dual p-n junctions of desired interface engineering will facilitate scalable photocatalytic water splitting over a broad range of the solar spectrum.
- 3 January 2024
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 16 (2) , 2204-2215
Tailoring of Visible to Near-Infrared Active 2D MXene with Defect-Enriched Titania-Based Heterojunction Photocatalyst for Green H2 Generation
A wide solar light absorption window and its utilization, long-term stability, and improved interfacial charge transfer are the keys to scalable and superior solar photocatalytic performance. Based on this objective, a noble metal-free composite photocatalyst is developed with conducting MXene (Ti3C2) and semiconducting cauliflower-shaped CdS and porous Cu2O. XPS, HRTEM, and ESR analyses of TiOy@Ti3C2 confirm the formation of enough defect-enriched TiOy (where y is < 2) on the surface of Ti3C2 during hydrothermal treatment, thus creating a third semiconducting site with enough oxygen vacancy. The final material, TiOy@Ti3C2/CdS/Cu2O, shows a broad absorption window from 300 to 2000 nm, covering the visible to near-infrared (NIR) range of the solar spectrum. Photocatalytic H2 generation activity is found to be 12.23 and 16.26 mmol g-1 h-1 in the binary (TiOy@Ti3C2/CdS) and tertiary composite (TiOy@Ti3C2/CdS/Cu2O), respectively, with good repeatability under visible-NIR light using lactic acid as the hole scavenger. A clear increase of efficiency by 1.53 mmol g-1 h-1 in the tertiary composite due to NIR light absorption supports the intrinsic upconversion of electrons, which will open a new prospective of solar light utilization. Decreased charge-transfer resistance from the EIS plot and a decrease in PL intensity established the improved interfacial charge separation in the tertiary composite. Compared to pure CdS, H2 generation efficiency is 29.6 times higher on the noble metal-free tertiary composite with an apparent quantum efficiency of 12.34%. Synergistic effect of defect-enriched TiOy formation, creation of proper dual p-n junction on a Ti3C2 sheet as supported by the Mott-Schottky plot, significant NIR light absorption, increased electron mobility, and charge transfer on the conductive Ti3C2 layer facilitate the drastically increased hydrogen evolution rate even after several cycles of repetition. Expectantly, the 2D MXene-based heterostructure with defect-enriched dual p-n junctions of desired interface engineering will facilitate scalable photocatalytic water splitting over a broad range of the solar spectrum.
- 12 August 2023
- Published by Elsevier in Materials Today: Proceedings
- Vol. 112, 66-72
Synthesis and photocatalytic evaluation of 2D MoS2/TiO2 heterostructure photocatalyst for organic pollutants degradation
- 12 August 2023
- Published by Elsevier in Materials Today: Proceedings
- Vol. 112, 66-72
Synthesis and photocatalytic evaluation of 2D MoS2/TiO2 heterostructure photocatalyst for organic pollutants degradation
- 29 July 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 10 (33) , 12091-12105
Mechanical-load and temperature-engendered degradation of α-CsPbI 3 : reactive molecular dynamics simulation
The structural stability of CsPbI 3 has been studied using reactive molecular dynamics simulation under mechanical-load and temperature induced stress.
- 29 July 2022
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 10 (33) , 12091-12105
Mechanical-load and temperature-engendered degradation of α-CsPbI 3 : reactive molecular dynamics simulation
The structural stability of CsPbI 3 has been studied using reactive molecular dynamics simulation under mechanical-load and temperature induced stress.
- 2 December 2021
- Published by Wiley in Advanced Materials Interfaces
- Vol. 9 (2) , 2101680
Improved Interfacial Charge Transfer on Noble Metal‐Free Biomimetic CdS‐Based Tertiary Heterostructure @ 2D MoS2‐CdS‐Cu2O with Enhanced Photocatalytic Water Splitting
High charge separation efficiency with a wide optical absorption window is the prime requirement for the scale up of a stable solar photocatalytic hydrogen generation process. A new noble metal‐free heterostructure of 2D MoS2‐CdS‐Cu2O is designed by depositing cauliflower‐shaped CdS and nanosized Cu2O on exfoliated 2D MoS2. Characterization by XPS, high‐resolution transmission electron microscopy (HRTEM), and UV‐visible spectra confirms the formation of nanosized Cu2O with desired interface formation with MoS2 sheet and CdS thus extending the optical absorption range up to 900 nm. Water splitting activity in the presence of lactic acid is found to be 7.89 and 11.53 mmol g−1 h−1 on MoS2‐CdS and MoS2‐CdS‐Cu2O, respectively, with good repeatability under visible light. Efficient interfacial charge separation is manifested from demised photoluminescence (PL) intensity which supports the suppression of hole‐electron recombination in the tertiary heterostructure. In addition, the formation of dual p‐n junction as indicated from Mott–Schottky analysis further strengthen the faster electron and holes separation objective. Compared to the pure CdS, hydrogen efficiency is 20.96 times higher on a noble metal‐free tertiary catalyst with an apparent quantum efficiency of 8.75%. Hopefully, the 2D material‐based architecture of dual p‐n junction with desired interface engineering will facilitate the catalyst design with increased water splitting activity under solar/visible light.
- 2 December 2021
- Published by Wiley in Advanced Materials Interfaces
- Vol. 9 (2) , 2101680
Improved Interfacial Charge Transfer on Noble Metal‐Free Biomimetic CdS‐Based Tertiary Heterostructure @ 2D MoS2‐CdS‐Cu2O with Enhanced Photocatalytic Water Splitting
High charge separation efficiency with a wide optical absorption window is the prime requirement for the scale up of a stable solar photocatalytic hydrogen generation process. A new noble metal‐free heterostructure of 2D MoS2‐CdS‐Cu2O is designed by depositing cauliflower‐shaped CdS and nanosized Cu2O on exfoliated 2D MoS2. Characterization by XPS, high‐resolution transmission electron microscopy (HRTEM), and UV‐visible spectra confirms the formation of nanosized Cu2O with desired interface formation with MoS2 sheet and CdS thus extending the optical absorption range up to 900 nm. Water splitting activity in the presence of lactic acid is found to be 7.89 and 11.53 mmol g−1 h−1 on MoS2‐CdS and MoS2‐CdS‐Cu2O, respectively, with good repeatability under visible light. Efficient interfacial charge separation is manifested from demised photoluminescence (PL) intensity which supports the suppression of hole‐electron recombination in the tertiary heterostructure. In addition, the formation of dual p‐n junction as indicated from Mott–Schottky analysis further strengthen the faster electron and holes separation objective. Compared to the pure CdS, hydrogen efficiency is 20.96 times higher on a noble metal‐free tertiary catalyst with an apparent quantum efficiency of 8.75%. Hopefully, the 2D material‐based architecture of dual p‐n junction with desired interface engineering will facilitate the catalyst design with increased water splitting activity under solar/visible light.
- 1 September 2020
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 314
Shock wave induced exfoliation of molybdenum disulfide (MoS2) in various solvents: All-atom molecular dynamics simulation
- 1 September 2020
- Published by Elsevier in Journal of Molecular Liquids
- Vol. 314
Shock wave induced exfoliation of molybdenum disulfide (MoS2) in various solvents: All-atom molecular dynamics simulation
- 1 September 2020
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 252
Manipulation of mechanical properties of monolayer molybdenum disulfide: Kirigami and hetero-structure based approach
- 1 September 2020
- Published by Elsevier in Materials Chemistry and Physics
- Vol. 252
Manipulation of mechanical properties of monolayer molybdenum disulfide: Kirigami and hetero-structure based approach
- 20 September 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (10) , 105544
Development of magnetically separable mesoporous N doped TiO2-SiO2 coated Fe3O4 nanomaterial as solar photocatalyst for environmental application
- 20 September 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (10) , 105544
Development of magnetically separable mesoporous N doped TiO2-SiO2 coated Fe3O4 nanomaterial as solar photocatalyst for environmental application
- 1 August 2019
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 7 (4)
Synthesis of titanium based hetero MOF photocatalyst for reduction of Cr (VI) from wastewater
- 1 August 2019
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 7 (4)
Synthesis of titanium based hetero MOF photocatalyst for reduction of Cr (VI) from wastewater
- 1 April 2019
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 7 (2)
Development of novel TiO2-Cu2(OH)PO4 heterojunction as nanophotocatalyst for improved Cr (VI) reduction
- 1 April 2019
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 7 (2)
Development of novel TiO2-Cu2(OH)PO4 heterojunction as nanophotocatalyst for improved Cr (VI) reduction