TTTrevor J. Thornton

Trevor J. Thornton

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Trevor J. Thornton has a total of 112 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • β –Ga₂O₃ Sub-Micron FinFETs With Si Delta-Doped Channel Modulating >3 × 10 13 cm –2 Charge Density

    by Nabasindhu Das, Cameron Gorsak, Ankita Kashyap, Advait Gilankar, Pushpanshu Tripathi, Salil A. Paranjape, Trevor Thornton, Hari Nair, Nidhin Kurian Kalarickal

    This letter reports on the design and demonstration of high-performance β-Ga₂O₃ FinFETs utilizing MOCVD grown Si delta-doped channel to achieve enhanced carrier transport and electrostatic control. A high sheet charge density of 3.3×10¹³ cm⁻² was modulated using 100 nm fin channels, delivering a peak drain current of 137 mA/mm and a peak transconductance of 20 mS/mm. The FinFET architecture enables strong gate modulation achieving a high IOn/IOff ratio between 108-10⁹. A low contact resistance of 0.42 Ω.mm was achieved to the Si delta doped channel using MOCVD contact regrowth. Small-signal RF characterization revealed a current gain cut-off frequency (fT`) of 3.8 GHz and maximum oscillation frequency (fMAX) of 2.1 GHz for 0.9 micrometer gate length. These results demonstrate the efficacy of combining precision delta-doping and 3D FinFET geometry for high-frequency β-Ga₂O₃ electronics, establishing a platform for future RF and high-power applications.


  • Open Access

    P-i-N and Schottky P-i-N diamond diodes for high power limiters

    by Harshad Surdi, Mason Bressler, Mohammad Faizan Ahmad, Franz Koeck, Bryce Winters, Stephen Goodnick, Trevor Thornton, Robert J. Nemanich, Josephine Chang

    P-i-N and Schottky P-i-N diamond diodes are a promising technology for high-power limiters. Receivers, solid-state amplifiers, and detectors commonly use P-i-N and/or Schottky diodes for protection from high power incident signals. Here, we report on the RF power handling and power dissipation capability of diamond P-i-N and Schottky P-i-N diodes. We fabricate P-i-N diodes as vertical structures, with both majority and minority carriers involved in charge transport. Similarly, we fabricate vertical Schottky P-i-N diodes, with the doping in the n-layer reduced compared to P-i-N diodes such that the n-layer becomes fully depleted during operation, resulting in a majority-carrier device with a fast recovery time. Both P-i-N and Schottky P-i-N diodes were packaged in shunt-configuration and matched for 3 GHz operation, with a small signal insertion loss of ∼1.25 dB. P-i-N diodes operated up to 40 dBm before failing nondestructively at 45 dBm, demonstrating power dissipation handling that exceeds that of commercially available Si P-i-N diodes by more than a factor of five. Schottky P-i-N diodes operated up to 49 dBm before non-recoverable failure at 50 dBm.


  • Open Access

    Space charge limited corrections to the power figure of merit for diamond

    by Harshad Surdi, Trevor Thornton, Robert J. Nemanich, Stephen M. Goodnick

    An interpretation of the unipolar figure of merit is formulated for wide bandgap (WBG) semiconductors based on the on-state specific resistance (RON,sp) derived from the space charge limited current–voltage relationship (Mott–Gurney square law). The limitations of the traditional Ohmic RON,sp for WBG semiconductors are discussed, particularly at low doping, while the accuracy of the Mott–Gurney based RON,sp is confirmed by Silvaco ATLAS drift–diffusion simulations of diamond Schottky pin diodes. The effects of incomplete ionization are considered as well.


  • Demonstration and Analysis of Ultrahigh Forward Current Density Diamond Diodes

    by Harshad Surdi, Franz A. M. Koeck, Mohammad Faizan Ahmad, Trevor J. Thornton, Robert J. Nemanich, Stephen M. Goodnick

    A diamond Schottky p-i-n diode (SPIND) with the highest reported current density to date of ~116 kA/cm 2 is demonstrated, carrying a total current of ~1.32 A through a $50-\mu \text {m}$ wide pseudo-vertical diode structure. The diamond SPIND also provides a maximum power handling capacity of ${1.85}~ \text {MW/c}\text {m}^{{2}}$ and a low specific ON-resistance ${R}_{ \mathrm{ON}}S$ of ${0.05}~ \text {m}\Omega \cdot \text {cm}^{{{2}}}$ at a forward bias of ~16 V. The diamond Schottky p-i-n (SPIN) diode also shows excellent rectification characteristics with a current ON– OFF-ratio of $\sim {6} \times {10}^{{12}}$ . An analytical model including thermionic emission and space charge limited (SCL) current is presented together with Silvaco ATLAS Technology Computer Aided Design (TCAD) simulations to accurately reproduce the experimental ${J}$ – ${V}$ characteristics using multiple single-trap levels and other physical models emulating a real device. Theoretical calculations from the analytical model show that further improvement in the device turn on voltage and ${R}_{ \mathrm{ON}}{S}$ can be achieved by reducing the defect density and contact resistance in order to approach the ultimate performance in the Mott–Gurney SCL current regime.


  • Measurements and Simulation of Self-Heating in 40 nm SOI MOSFETs

    by Xiong Zhang, Payam Mehr, Dragica Vasileska, Trevor Thornton

    To understand self-heating in SOI CMOS, conventional and trap-rich substrates are used to fabricate 40nm gate length NFET pairs that share the same active region. One NFET serves as a heater, while the other is used as a calibrated thermometer. Measurements of the local heating confirm the simulated temperature distribution. Heat flow out of the metal contacts reduces the self-heating in NFETs on trap-rich substrates which have reduced thermal conductivity compared to conventional SOI wafers.


  • RF Characterization of Diamond Schottky p-i-n Diodes for Receiver Protector Applications

    by Harshad Surdi, Mohammad Faizan Ahmad, Franz Koeck, Robert J. Nemanich, Stephen Goodnick, Trevor J. Thornton

    Diamond Schottky p-i-n diodes have been grown by plasma-enhanced chemical vapor deposition (PECVD) and incorporated as a shunt element within coplanar striplines for RF characterization. The p-i-n diodes have a thin, lightly doped n-type layer that is fully depleted by the top metal contact, and they operate as high-speed Schottky rectifiers. Measurements from dc to 25 GHz confirm that the diodes can be modeled by a voltage-dependent resistor in parallel with a fixed-value capacitor. In the OFF state with a dc bias of 0 V, the diode insertion loss is less than 0.3 dB at 1 GHz and increases to 14 dB when forward biased to 7.6 V. With a contact resistance, RC, of 0.25 mΩ ·cm² and an OFF capacitance, COFF, of 17.5 nF/cm², the diodes have an RF figure of merit Foc = (2π RC COFF)⁻¹ of 36.5 GHz. The RF model suggests that reducing RC to less than 5 x 10⁻⁵ Ω · cm² will enable input power rejection exceeding 30 dB. Compared to conventional silicon or compound semiconductor based power limiters, the superior thermal conductivity of the diamond Schottky p-i-n diodes makes them ideally suitable for RF receiver protectors (RPs) that require high power handing capability.


  • Self-Heating in 40 nm SOI MOSFETs on High Resistivity, Trap-Rich Substrates

    by Xiong Zhang, Payam Mehr, Trevor J. Thornton

    Closely spaced n-channel MOSFETs have been used to compare the self-heating in nominally identical devices fabricated on conventional and high resistivity, trap-rich silicon-on-insulator (SOI) substrates. One of the MOSFETs operates above threshold and in saturation to heat the active silicon, while the other is biased into the sub-threshold regime and operates as a local thermometer. The trap-rich layer in the high resistivity substrates consists of a highly defected, poly-Si layer just below the buried oxide. Grain boundaries in the poly-Si lead to increased phonon scattering compared to single crystal silicon, with a corresponding decrease in thermal conductivity. Despite the reduced thermal conductivity there appears to be no difference in the self-heating between the MOSFETs on the high resistivity, trap-rich substrates compared to those on the conventional low resistivity substrates.


  • Adaptive Power Control Using Current Adjustment for Watt-Level Power Amplifiers in CMOS SOI

    by Soroush Moallemi, Payam Mehr, Kevin Grout, Trevor J. Thornton, Jennifer Kitchen

    This paper demonstrates the effectiveness of utilizing a 4-bit current steering DAC as an adaptive power controller to adjust the DC quiescent current of a linear power amplifier as a function of the input signal power. A custom made metal-semiconductor field-effect transistor (MESFET), which is used as the amplifying transistor, and a current steering DAC have been integrated on the same substrate to minimize the power amplifier’s form factor and mismatches between the power tracker and the MESFET. This design has been implemented in a 45 nm CMOS SOI Global Foundries (GF) process with a nominal supply voltage of 0.9 V and provides 31.8 dBm of output power, 45% peak efficiency and 24 dB maximum power gain. Measurement results at 70 MHz reveal about 10% efficiency improvement at 6 dB power back-off with continuous wave and 5% for standard 16-PSK EDGE modulated signals. The amplifier shows EVM of 5% and ACPR of -56.9 dBc at 400 kHz offset from the carrier frequency without digital pre-distortion, while transmitting 27 dBm of modulated output power.


  • CMOS-Compatible MESFETs for High Power RF Integrated Circuits

    by Payam Mehr, Soroush Moallemi, Xiong Zhang, William Lepkowski, Jennifer Kitchen, Trevor J. Thornton

    Metal semiconductor field effect transistors (MESFETs) have been fabricated using a 45 nm SOI CMOS technology available from Global Foundries. MESFETs with gate lengths of 200 nm show good manufacturability with well-controlled run-to-run variations. The DC and RF performance of devices with different drain access lengths are compared to illustrate the design trades between high breakdown voltage and high frequency operation. Two applications of the MESFETs for RF integrated circuit (RFIC) design are presented. The first demonstrates integrated n-channel MOSFET-MESFET cascode amplifiers that combine the enhanced voltage operation of the MESFET with the high frequency capability of the scaled MOSFET. The resulting small-signal amplifiers demonstrate cut-off frequencies of 50 GHz when operated with supply voltages of 6 V, significantly higher than the nominal 1 V breakdown voltage of the CMOS transistors. The second application demonstrates a watt-level MESFET power amplifier integrated with a CMOS current steering digital-to-analog converter (DAC). The MESFET serves as the RF output device, while the 4-bit CMOS DAC enables average power tracking. Both examples demonstrate the design flexibility enabled by the CMOS-compatible MESFETs.


  • $K$ -Band CMOS-Based MESFET Cascode Amplifiers

    by Payam Mehr, William Lepkowski, Trevor J. Thornton

    Cascode amplifiers consisting of a common-source MOSFET integrated with a common-gate metal-semiconductor field-effect transistor (MESFET) have been manufactured using a commercial 45-nm silicon-on-insulator RF CMOS process. The enhanced breakdown voltage of the MESFETs combined with the high speed of the RF MOSFETs, results in a maximum cutoff frequency of up to 70 GHz, with a maximum available gain of 18 dB at K-band frequencies (18-27 GHz) using a 6-V supply. This high-frequency operation makes the proposed amplifier a prospective candidate for 5G and millimeter wave applications.