Zhijie Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Zhijie Li has a total of 112 co-authors. Here are the top co-authors by number of shared publications:
Mengxuan Sun
School of Physics, University of Electronic Science and Technology of China, Chengdu 611731, PR China
25 shared publicationsXiaohe Ren
School of Physics University of Electronic Science and Technology of China Chengdu P. R. China
17 shared publications- Yongqi Fu
Northumbria University
16 shared publications Ziwei Gan
School of Physics University of Electronic Science and Technology of China Chengdu P. R. China
14 shared publicationsNengze Wang
Hubei Key Laboratory For High‐efficiency Utilization of Solar Energy and Operation Control of Energy Storage System Hubei University of Technology Wuhan P. R. China
13 shared publicationsYongxiu Sun
10 shared publications
Latest Publications
- 15 February 2026
- Published by Wiley in Advanced Energy Materials
- Vol. 16 (16)
Suppresses Vanadium Dissolution via Superlattice Strategy for Practical Zinc‐Vanadium Batteries with Ultralong Lifespan at Low Current Density
Aqueous zinc‐vanadium batteries face severe capacity decay and rapid failure, particularly at low current densities (< 1 A g −1 ), primarily due to the poor structural stability of the vanadium cathode and corrosion by highly active free water, which severely hinders their practical application. Here, we propose the superlattice vanadium oxide (Superlattice‐V 2 O 5 ) as a cathode material to improve the cycle stability at low current density. Its larger interlayer spacing of 21.5 Å reduces structural stress during hydrated Zn 2+ insertion/extraction, thus mitigating structural collapse, and effectively weakening the electrostatic interaction between Zn 2+ and the interlayer. Furthermore, the superlattice structure diminishes the release of highly active water molecules during the desolvation of hydrated Zn 2+ and increases the dissolution energy of the VO 2+ ion from 0.96 to 1.72 eV. These synergistic effects suppress vanadium dissolution and shuttling. Consequently, the Superlattice‐V 2 O 5 achieves a specific capacity of 445.1 mAh g −1 at a low current density of 0.2 A g −1 and enables vanadium shuttle‐free cycling for 750 cycles (lasting 106 days). Furthermore, the superlattice structure facilitates ion insertion into the deep regions of the high mass loading electrode, which effectively improves active material utilization, thereby achieving a stability of 2800 cycles at 0.5 A g −1 with a mass loading of 19.3 mg cm −2 .
- 15 February 2026
- Published by Wiley in Advanced Energy Materials
- Vol. 16 (16)
Suppresses Vanadium Dissolution via Superlattice Strategy for Practical Zinc‐Vanadium Batteries with Ultralong Lifespan at Low Current Density
Aqueous zinc‐vanadium batteries face severe capacity decay and rapid failure, particularly at low current densities (< 1 A g −1 ), primarily due to the poor structural stability of the vanadium cathode and corrosion by highly active free water, which severely hinders their practical application. Here, we propose the superlattice vanadium oxide (Superlattice‐V 2 O 5 ) as a cathode material to improve the cycle stability at low current density. Its larger interlayer spacing of 21.5 Å reduces structural stress during hydrated Zn 2+ insertion/extraction, thus mitigating structural collapse, and effectively weakening the electrostatic interaction between Zn 2+ and the interlayer. Furthermore, the superlattice structure diminishes the release of highly active water molecules during the desolvation of hydrated Zn 2+ and increases the dissolution energy of the VO 2+ ion from 0.96 to 1.72 eV. These synergistic effects suppress vanadium dissolution and shuttling. Consequently, the Superlattice‐V 2 O 5 achieves a specific capacity of 445.1 mAh g −1 at a low current density of 0.2 A g −1 and enables vanadium shuttle‐free cycling for 750 cycles (lasting 106 days). Furthermore, the superlattice structure facilitates ion insertion into the deep regions of the high mass loading electrode, which effectively improves active material utilization, thereby achieving a stability of 2800 cycles at 0.5 A g −1 with a mass loading of 19.3 mg cm −2 .
- 10 January 2026
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 708, 139880
PVA-assisted construction of cathode-electrolyte interface pre-desolvation strategy realizes high-performance flexible aqueous zinc ion batteries
- 10 January 2026
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 708, 139880
PVA-assisted construction of cathode-electrolyte interface pre-desolvation strategy realizes high-performance flexible aqueous zinc ion batteries
- 25 September 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 542
Multi-component deep eutectic solvents achieve high stability zinc deposition and dissolution for electrochromic devices
- 25 September 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 542
Multi-component deep eutectic solvents achieve high stability zinc deposition and dissolution for electrochromic devices
- 17 July 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (14) , 10289-10299
Construction of Stable Zn Anode by 3D Flamed Reduced Graphene Oxide with Long Cycling Life
- 17 July 2025
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 8 (14) , 10289-10299
Construction of Stable Zn Anode by 3D Flamed Reduced Graphene Oxide with Long Cycling Life
- 27 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 72 (1) , 445-452
Suppression of Multipactor Discharge on a Dielectric With a Beat Wave
An electromagnetic particle-in-cell (PIC) simulation technique is used to analyze multipactor discharge on a dielectric with a beat wave composed of multiple high-power microwaves (HPMs) with similar frequencies. Unlike the single-frequency HPM, the strength of $\textit{E}_{\text{n}}$ of the multipactor with a beat wave fluctuates greatly with time, resulting in the root-mean-square value of $\textit{E}_{\text{n}}$ (strongly related to the average deposition power) being significantly greater than the absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ (the traditional indicator of the multipactor strength), where $\textit{E}_{\text{n}}$ is the electric field due to the deposited charges induced by multipactor. In this article, the influence of double-frequency and triple-frequency beat waves on multipactor is studied from the perspective of the root-mean-square value and absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ . The results show that the strong multipactor with a beat wave is unaffected by the spectra of the beat wave and the beat wave cannot inhibit the strong multipactor strength in contrast to a single-frequency HPM with the same average microwave power while the inhibition effect of a beat wave on a moderated multipactor is obvious. Further analysis shows that the suppression effect of a beat wave on a moderated multipactor is greatest when both the frequencies and phases of the beat wave are arranged in an arithmetic progression and the moderated multipactor can also be suppressed substantially when the amplitudes of the beat wave deviate slightly from the condition of equal amplitude.
- 27 November 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 72 (1) , 445-452
Suppression of Multipactor Discharge on a Dielectric With a Beat Wave
An electromagnetic particle-in-cell (PIC) simulation technique is used to analyze multipactor discharge on a dielectric with a beat wave composed of multiple high-power microwaves (HPMs) with similar frequencies. Unlike the single-frequency HPM, the strength of $\textit{E}_{\text{n}}$ of the multipactor with a beat wave fluctuates greatly with time, resulting in the root-mean-square value of $\textit{E}_{\text{n}}$ (strongly related to the average deposition power) being significantly greater than the absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ (the traditional indicator of the multipactor strength), where $\textit{E}_{\text{n}}$ is the electric field due to the deposited charges induced by multipactor. In this article, the influence of double-frequency and triple-frequency beat waves on multipactor is studied from the perspective of the root-mean-square value and absolute value of the arithmetic mean of $\textit{E}_{\text{n}}$ . The results show that the strong multipactor with a beat wave is unaffected by the spectra of the beat wave and the beat wave cannot inhibit the strong multipactor strength in contrast to a single-frequency HPM with the same average microwave power while the inhibition effect of a beat wave on a moderated multipactor is obvious. Further analysis shows that the suppression effect of a beat wave on a moderated multipactor is greatest when both the frequencies and phases of the beat wave are arranged in an arithmetic progression and the moderated multipactor can also be suppressed substantially when the amplitudes of the beat wave deviate slightly from the condition of equal amplitude.
- 23 September 2024
- Published by Wiley in Advanced Functional Materials
- Vol. 35 (3)
Electric Field Regulator Constructed by Magnetron Sputtering for Dendrite‐Free and Stable Zinc Metal Anode
Rechargeable aqueous zinc‐ion batteries (AZIBs) are considered to be one of the most promising devices in the next generation of energy storage systems. However, the uncontrolled growth of Zn dendrites during electroplating leads to rapid battery failure, which hinders the wide application of AZIBs. In this work, an Fe metal interface (FMI) with electric field regulation is designed on the Zn metal anode using a magnetron sputtering technology. The FMI layer with nanosheet array not only uniforms the surface electric field, but also adjusts the surface Zn2+ ion distribution to inhibit 2D diffusion. The strong orientation relationships of the FMI layer enhance the reversibility of Zn plating/stripping, improving the structural stability of the interface layer. Consequently, FMI@Zn symmetric cell exhibits ultra‐stable lifespan for over 6000 h (Cumulative plated capacity, CPC = 15 Ah cm−2) with a low voltage hysteresis of 46.4 mV and high Coulombic efficiency of 99.8% at 5 mA cm−2. Even at the large current density of 40 mA cm−2, the CPC reaches 19.7 Ah cm−2. The proposed electric field regulation strategy reveals a promising prospect for designing highly stable Zn anode, which also applies to other metal anodes in energy storage systems.
- 23 September 2024
- Published by Wiley in Advanced Functional Materials
- Vol. 35 (3)
Electric Field Regulator Constructed by Magnetron Sputtering for Dendrite‐Free and Stable Zinc Metal Anode
Rechargeable aqueous zinc‐ion batteries (AZIBs) are considered to be one of the most promising devices in the next generation of energy storage systems. However, the uncontrolled growth of Zn dendrites during electroplating leads to rapid battery failure, which hinders the wide application of AZIBs. In this work, an Fe metal interface (FMI) with electric field regulation is designed on the Zn metal anode using a magnetron sputtering technology. The FMI layer with nanosheet array not only uniforms the surface electric field, but also adjusts the surface Zn2+ ion distribution to inhibit 2D diffusion. The strong orientation relationships of the FMI layer enhance the reversibility of Zn plating/stripping, improving the structural stability of the interface layer. Consequently, FMI@Zn symmetric cell exhibits ultra‐stable lifespan for over 6000 h (Cumulative plated capacity, CPC = 15 Ah cm−2) with a low voltage hysteresis of 46.4 mV and high Coulombic efficiency of 99.8% at 5 mA cm−2. Even at the large current density of 40 mA cm−2, the CPC reaches 19.7 Ah cm−2. The proposed electric field regulation strategy reveals a promising prospect for designing highly stable Zn anode, which also applies to other metal anodes in energy storage systems.
- 12 June 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 494
Triple engineering boosts high-performance accordion-like vanadium oxide for practical aqueous zinc-ion batteries
- 12 June 2024
- Published by Elsevier in Chemical Engineering Journal
- Vol. 494
Triple engineering boosts high-performance accordion-like vanadium oxide for practical aqueous zinc-ion batteries