Juan Alemany
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Juan Alemany has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
F. Magnago
5 shared publicationsFernando Magnago
Nexant Inc., AZ, USA;Power Systems Analysis Group, Río Cuarto National University, Argentina
4 shared publicationsD. Moitre
GASEP, Departamento de Electricidad y Electrónica, Facultad de Ingeniería, Universidad Nacional de Río Cuarto, Argentina
3 shared publicationsJeremy Lin
PJM Interconnect, Audubon, PA USA
2 shared publications- Leszek Kasprzyk
Faculty of Control, Robotics and Electrical Engineering, Poznan University of Technology, 60-965 Poznań, Poland
2 shared publications Przemyslaw Komarnicki
IFF Fraunhofer, Magdeburg, Germany
2 shared publications
Latest Publications
- Open Access
- 1 January 2021
- Published by Politehnica University Timisoara in Journal of Electrical Engineering
- Vol. 21 (3) , 62-67
Induction motor: a new static model
Voltage stability in power system is largely determined by the characteristics of the load. In order to obtain reliable results in voltage stability, the load model must be represented as realistically as possible. The issue is even more challenging with static voltage stability techniques, because dynamic loads must be represented by static models. The commonly used static models are constant impedance, constant current, and constant power. A significant part of the load is made up of induction motors that are usually modeled as static constant power loads. Under variations of terminal voltage of the motor, this static model can approximately represent the active power, but it can commit major mistakes when representing the behavior of reactive power. Therefore, a new motor static model will be developed in this work.
- 1 January 2021
- Published by Politehnica University Timisoara in Journal of Electrical Engineering
- Vol. 21 (3) , 62-67
Open AccessInduction motor: a new static model
Voltage stability in power system is largely determined by the characteristics of the load. In order to obtain reliable results in voltage stability, the load model must be represented as realistically as possible. The issue is even more challenging with static voltage stability techniques, because dynamic loads must be represented by static models. The commonly used static models are constant impedance, constant current, and constant power. A significant part of the load is made up of induction motors that are usually modeled as static constant power loads. Under variations of terminal voltage of the motor, this static model can approximately represent the active power, but it can commit major mistakes when representing the behavior of reactive power. Therefore, a new motor static model will be developed in this work.
- Open Access
Optimization of a PV-Wind Hybrid Power Supply Structure with Electrochemical Storage Intended for Supplying a Load with Known Characteristics
An important aspect of the off-grid utilization of hybrid generation systems is the integration of energy storage facilities into their structures, which allows for improved power supply reliability. However, this results in a significant increase in the cost of such systems. Therefore, it is justified to use optimization resulting in the minimization of the selected economic indicator taking into account the most important technical constraints. For this reason, this work proposes an algorithm to optimize the structure of a hybrid off-grid power distribution system (with electrochemical energy storage), designed to supply a load with known daily energy demand. The authors recommend genetic algorithm utilization as well as a modified criterion for evaluating the quality of solutions based on the Levelized Cost of Energy (LCOE) index. Several technical and economic analyses were presented, including unit costs, power distribution of the wind and solar sections, nominal battery capacity, SSSI index (System Self-Sufficiency Index), etc. The model of the system includes durability of the elements which have a significant impact on the periodic battery replacement. The tests were carried out for two types of loads and two types of electrochemical batteries (NMC—Lithium Nickel Manganese Cobalt Oxide; and PbO2—Lead-Acid Battery), taking into account the forecast of an increased lifetime of NMC type batteries and decreasing their price within five years. The proposed synthesis method of photovoltaic-wind (PV-wind) hybrid off-line systems leads to limiting the energy capacity of electrochemical storages. Based on the analyses, the authors proposed recommended methods to improve (reduce) the value of the criterion index (LCOE) for PV-wind off-grid systems while maintaining the assumed level of power supply reliability.
Open AccessOptimization of a PV-Wind Hybrid Power Supply Structure with Electrochemical Storage Intended for Supplying a Load with Known Characteristics
An important aspect of the off-grid utilization of hybrid generation systems is the integration of energy storage facilities into their structures, which allows for improved power supply reliability. However, this results in a significant increase in the cost of such systems. Therefore, it is justified to use optimization resulting in the minimization of the selected economic indicator taking into account the most important technical constraints. For this reason, this work proposes an algorithm to optimize the structure of a hybrid off-grid power distribution system (with electrochemical energy storage), designed to supply a load with known daily energy demand. The authors recommend genetic algorithm utilization as well as a modified criterion for evaluating the quality of solutions based on the Levelized Cost of Energy (LCOE) index. Several technical and economic analyses were presented, including unit costs, power distribution of the wind and solar sections, nominal battery capacity, SSSI index (System Self-Sufficiency Index), etc. The model of the system includes durability of the elements which have a significant impact on the periodic battery replacement. The tests were carried out for two types of loads and two types of electrochemical batteries (NMC—Lithium Nickel Manganese Cobalt Oxide; and PbO2—Lead-Acid Battery), taking into account the forecast of an increased lifetime of NMC type batteries and decreasing their price within five years. The proposed synthesis method of photovoltaic-wind (PV-wind) hybrid off-line systems leads to limiting the energy capacity of electrochemical storages. Based on the analyses, the authors proposed recommended methods to improve (reduce) the value of the criterion index (LCOE) for PV-wind off-grid systems while maintaining the assumed level of power supply reliability.
- 1 July 2018
- Published by Elsevier in Electric Power Systems Research
- Vol. 160, 429-438
Effects of binary variables in mixed integer linear programming based unit commitment in large-scale electricity markets
- 1 July 2018
- Published by Elsevier in Electric Power Systems Research
- Vol. 160, 429-438
Effects of binary variables in mixed integer linear programming based unit commitment in large-scale electricity markets
- 15 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Sustainable Energy
- Vol. 10 (2) , 790-799
Constructing Hot Water Load Profile: An Agent-Based Modeling Approach
This paper proposes a flexible framework to analyze typical hot water demand consumption in households and to explore the impact of the consumers behavior due to economic stimulus. The proposed model studies typical home scenarios such as a family, couples, and single people. It allows desegregating the demand based on the utilization. The results presented in this paper can be used to optimize the control of water heaters, increasing their efficiency and reducing their electrical consumption.
- 15 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Sustainable Energy
- Vol. 10 (2) , 790-799
Constructing Hot Water Load Profile: An Agent-Based Modeling Approach
This paper proposes a flexible framework to analyze typical hot water demand consumption in households and to explore the impact of the consumers behavior due to economic stimulus. The proposed model studies typical home scenarios such as a family, couples, and single people. It allows desegregating the demand based on the utilization. The results presented in this paper can be used to optimize the control of water heaters, increasing their efficiency and reducing their electrical consumption.
- Open Access
- 1 January 2017
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2017 (1)
Multiobjective Optimization Model for Wind Power Allocation
There is an increasing need for the injection to the grid of renewable energy; therefore, to evaluate the optimal location of new renewable generation is an important task. The primary purpose of this work is to develop a multiobjective optimization model that permits finding multiple trade‐off solutions for the location of new wind power resources. It is based on the augmented ε‐constrained methodology. Two competitive objectives are considered: maximization of preexisting energy injection and maximization of new wind energy injection, both embedded, in the maximization of load supply. The results show that the location of new renewable generation units affects considerably the transmission network flows, the load supply, and the preexisting energy injection. Moreover, there are diverse opportunities to benefit the preexisting generation, contrarily to the expected effect where renewable generation displaces conventional power. The proposed methodology produces a diverse range of equivalent solutions, expanding and enriching the horizon of options and giving flexibility to the decision‐making process.
- 1 January 2017
- Published by Wiley in Mathematical Problems in Engineering
- Vol. 2017 (1)
Open AccessMultiobjective Optimization Model for Wind Power Allocation
There is an increasing need for the injection to the grid of renewable energy; therefore, to evaluate the optimal location of new renewable generation is an important task. The primary purpose of this work is to develop a multiobjective optimization model that permits finding multiple trade‐off solutions for the location of new wind power resources. It is based on the augmented ε‐constrained methodology. Two competitive objectives are considered: maximization of preexisting energy injection and maximization of new wind energy injection, both embedded, in the maximization of load supply. The results show that the location of new renewable generation units affects considerably the transmission network flows, the load supply, and the preexisting energy injection. Moreover, there are diverse opportunities to benefit the preexisting generation, contrarily to the expected effect where renewable generation displaces conventional power. The proposed methodology produces a diverse range of equivalent solutions, expanding and enriching the horizon of options and giving flexibility to the decision‐making process.
- 1 November 2016
- Published by Elsevier in Electric Power Systems Research
- Vol. 140, 363-377
Exploiting symmetry in unit commitment solutions for a large-scale electricity market
- 1 November 2016
- Published by Elsevier in Electric Power Systems Research
- Vol. 140, 363-377
Exploiting symmetry in unit commitment solutions for a large-scale electricity market
- 1 October 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 520-524
A low cost smart metering infrastructure with centralized demand response management
- 1 October 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 520-524
A low cost smart metering infrastructure with centralized demand response management
- 1 June 2015
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 68, 142-149
Impact of demand response resources on unit commitment and dispatch in a day-ahead electricity market
- 1 June 2015
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 68, 142-149
Impact of demand response resources on unit commitment and dispatch in a day-ahead electricity market
- 1 March 2015
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 66, 53-66
Benders decomposition applied to security constrained unit commitment: Initialization of the algorithm
- 1 March 2015
- Published by Elsevier in International Journal of Electrical Power & Energy Systems
- Vol. 66, 53-66
Benders decomposition applied to security constrained unit commitment: Initialization of the algorithm
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 257-262
Compensación en la generación eólica debido a la dispersión geográfica de las granjas
In general, the location of wind farms is defined by the expected annual energy production. The result is a concentration of wind farms in areas with high average wind speeds. While this goal is totally valid, in certain circumstances may produce an unfavorable effect on power systems due to the large fluctuations of the total wind energy production. However, the wind generation variability can be reduced by the compensation effect of wind farms installed in remote areas with very different wind patterns. In this paper, the compensation effect of wind farm locations is evaluated for the Argentinean electrical system. Specifically, the variability of wind production aggregation is minimized, optimizing the power location of eight wind farms in the state of Chubut.
- 1 June 2014
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 257-262
Compensación en la generación eólica debido a la dispersión geográfica de las granjas
In general, the location of wind farms is defined by the expected annual energy production. The result is a concentration of wind farms in areas with high average wind speeds. While this goal is totally valid, in certain circumstances may produce an unfavorable effect on power systems due to the large fluctuations of the total wind energy production. However, the wind generation variability can be reduced by the compensation effect of wind farms installed in remote areas with very different wind patterns. In this paper, the compensation effect of wind farm locations is evaluated for the Argentinean electrical system. Specifically, the variability of wind production aggregation is minimized, optimizing the power location of eight wind farms in the state of Chubut.