Luis Alejandro Galicia-Luna
Luis Alejandro Galicia-Luna
*This is an algorithmically generated author record based on publicly available information.
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Luis Alejandro Galicia-Luna has a total of 95 co-authors. Here are the top co-authors by number of shared publications:
- Octavio Elizalde-Solis
Instituto Politécnico Nacional
26 shared publications Abel Zúñiga-Moreno
16 shared publications- Dominique Richon
Discipline of Chemical Engineering, School of Engineering, University of KwaZulu-Natal, Howard College Campus, Durban, South Africa
9 shared publications Luis E. Camacho-Camacho
Laboratorio de Termodinámica, SEPI-ESIQIE, Instituto Politécnico Nacional, UPALM, Ed. Z, Secc. 6, 1 piso, Lindavista, C.P. 07738, México, D.F.
8 shared publications- Alfredo Pimentel-Rodas
Instituto Politécnico Nacional, UPALM Ed. 8, Lindavista
7 shared publications Alfredo Pimentel-Rodas
6 shared publications
Latest Publications
- 16 November 2023
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 68 (12) , 3265-3277
PρT Properties of Systems Containing Thiophene with Nonane or Decane at Temperatures between (313.15 and 363.15) K and Pressures up to 25 MPa
- 16 November 2023
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 68 (12) , 3265-3277
PρT Properties of Systems Containing Thiophene with Nonane or Decane at Temperatures between (313.15 and 363.15) K and Pressures up to 25 MPa
- 28 November 2022
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 67 (12) , 3589-3601
Simultaneous Viscosity and Density Measurements and Modeling on Liquid Undecane, Dodecane, Tridecane, and Tetradecane up to 50 MPa
- 28 November 2022
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 67 (12) , 3589-3601
Simultaneous Viscosity and Density Measurements and Modeling on Liquid Undecane, Dodecane, Tridecane, and Tetradecane up to 50 MPa
- Open Access
- 21 November 2019
- Published by Wiley in International Journal of Photoenergy
- Vol. 2019, 1-15
Photo-Fenton Degradation of RB5 Dye in Aqueous Solution Using Fe Supported on Mexican Natural Zeolite
A Mexican natural zeolite (MNZ) was impregnated with Fe at concentrations of 5 and 10 mg FeCl3/g MNZ (MNZ/Fe) in order to study the photo-Fenton degradation of Reactive Black 5 (RB5) dye. Two samples were prepared and calcined at 550 and 700°C for each concentration. These samples were also characterized by the following techniques: X-ray diffraction (XRD) to determine crystalline phases of mineral, X-ray photoelectron spectroscopy (XPS) to observe the elemental composition of the material where the main element was Fe as Fe2p, Mössbauer to establish the phases in the material which were magnetite (Fe3O4), fayalite, and chlorite, Raman to corroborate that magnetite clusters in natural material were presented, and transmission electron microscopy (TEM) by which magnetite nanoparticles were observe on zeolite surface. Afterwards, the catalytic degradation of RB5 dye was performed by photo-Fenton process using a 2.2 W lamp as a radiation source. Four initial concentrations of RB5 dye ((RB5)0) were evaluated which ranged from 40 to 100 mg/L. Then, the evaluation reaction was carried out by UV-Vis spectroscopy to know the change in RB5 concentration and chemical oxygen demand (COD) removal to determine the organic carbon. The best results on the photo-Fenton degradation was 91% discoloration and 68.5% chemical oxygen demand removal based on an initial concentrationmg/L and 10 mg MNZ/Fe (700°C of calcined temperature) atg/L catalyst dose in aqueous solution, g/L,, and 180 minutes of reaction time. Subsequently, variations on (RB5)0, pH, (H2O2), and (MNZ/Fe) were assessed in order to optimize the process by keeping 10 MNZ/Fe. The optimal RB5 dye degradation was achieved atmg/L in the presence ofg/L, g/L andwhere the highest discoloration and chemical oxygen demand removal were 93 and 70.5 at 180 min. Finally, the kinetic reaction was evaluated as a pseudo-first-order kinetics with an apparent rate constant (kapp) of 0.0225 min-1at latest conditions.- 21 November 2019
- Published by Wiley in International Journal of Photoenergy
- Vol. 2019, 1-15
Open AccessPhoto-Fenton Degradation of RB5 Dye in Aqueous Solution Using Fe Supported on Mexican Natural Zeolite
A Mexican natural zeolite (MNZ) was impregnated with Fe at concentrations of 5 and 10 mg FeCl3/g MNZ (MNZ/Fe) in order to study the photo-Fenton degradation of Reactive Black 5 (RB5) dye. Two samples were prepared and calcined at 550 and 700°C for each concentration. These samples were also characterized by the following techniques: X-ray diffraction (XRD) to determine crystalline phases of mineral, X-ray photoelectron spectroscopy (XPS) to observe the elemental composition of the material where the main element was Fe as Fe2p, Mössbauer to establish the phases in the material which were magnetite (Fe3O4), fayalite, and chlorite, Raman to corroborate that magnetite clusters in natural material were presented, and transmission electron microscopy (TEM) by which magnetite nanoparticles were observe on zeolite surface. Afterwards, the catalytic degradation of RB5 dye was performed by photo-Fenton process using a 2.2 W lamp as a radiation source. Four initial concentrations of RB5 dye ((RB5)0) were evaluated which ranged from 40 to 100 mg/L. Then, the evaluation reaction was carried out by UV-Vis spectroscopy to know the change in RB5 concentration and chemical oxygen demand (COD) removal to determine the organic carbon. The best results on the photo-Fenton degradation was 91% discoloration and 68.5% chemical oxygen demand removal based on an initial concentrationmg/L and 10 mg MNZ/Fe (700°C of calcined temperature) atg/L catalyst dose in aqueous solution, g/L,, and 180 minutes of reaction time. Subsequently, variations on (RB5)0, pH, (H2O2), and (MNZ/Fe) were assessed in order to optimize the process by keeping 10 MNZ/Fe. The optimal RB5 dye degradation was achieved atmg/L in the presence ofg/L, g/L andwhere the highest discoloration and chemical oxygen demand removal were 93 and 70.5 at 180 min. Finally, the kinetic reaction was evaluated as a pseudo-first-order kinetics with an apparent rate constant (kapp) of 0.0225 min-1at latest conditions. - 6 May 2019
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (11) , 4775-4780
Effect of 1-Propanol and TBAB on Gas Hydrates Dissociation Conditions for CO2 + Hexane + Water Systems
- 6 May 2019
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (11) , 4775-4780
Effect of 1-Propanol and TBAB on Gas Hydrates Dissociation Conditions for CO2 + Hexane + Water Systems
- 4 February 2019
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (5) , 2075-2083
Twenty Years of Experimental Determinations of Thermophysical Properties with High Accuracy: Thermodynamics Laboratory, ESIQIE-IPN, México
- 4 February 2019
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (5) , 2075-2083
Twenty Years of Experimental Determinations of Thermophysical Properties with High Accuracy: Thermodynamics Laboratory, ESIQIE-IPN, México
- 17 January 2019
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (2) , 763-770
Experimental Determination of Gas Hydrates Dissociation Conditions in CO2/N2 + Ethanol/1-Propanol/TBAB/TBAF + Water Systems
- 17 January 2019
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (2) , 763-770
Experimental Determination of Gas Hydrates Dissociation Conditions in CO2/N2 + Ethanol/1-Propanol/TBAB/TBAF + Water Systems
- 5 December 2018
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (1) , 324-336
Viscosity and Density of n-Alcohols at Temperatures between (298.15 and 323.15) K and Pressures up to 30 MPa
- 5 December 2018
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 64 (1) , 324-336
Viscosity and Density of n-Alcohols at Temperatures between (298.15 and 323.15) K and Pressures up to 30 MPa