MHMiao Hu

Miao Hu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Miao Hu has a total of 20 co-authors. Here are the top co-authors by number of shared publications:

  • Gregory B. McKenna

    Department of Chemical Engineering Texas Tech University Lubbock Texas USA

    4 shared publications
  • Christopher J. Dimitriou

    Nike Inc. , 13630 SW Terman Rd., Beaverton, Oregon 97005

    2 shared publications
  • David C. Venerus

    Illinois Institute of Technology Department of Chemical and Biological Engineering and Center of Excellence in Polymer Science and Engineering Chicago, Illinois 60616

    2 shared publications
  • Lynden A. Archer

    School of Chemical and Biomolecular Engineering and Department of Physics Ithaca, New York 14853

    2 shared publications
  • Rebecca M. Mick

    Illinois Institute of Technology Department of Chemical and Biological Engineering and Center of Excellence in Polymer Science and Engineering Chicago, Illinois 60616

    2 shared publications
  • Robert H. Grubbs

    Division of Chemistry and Chemical Engineering California Institute of Technology Pasadena California 91125

    2 shared publications

Latest Publications

  • The linear rheological responses of wedge‐type polymers

    by Miao Hu, Yan Xia, Christopher S. Daeffler, Jinhua Wang, Gregory B. McKenna, Julia A. Kornfield, Robert H. Grubbs

    The linear rheological responses of a series of specially designed wedge‐type polymers synthesized by the polymerization of large molecular weight monomers have been measured. These wedge polymers contained large side groups which contained three flexible branch chains per polymer chain unit. The master curves for these polymers were obtained by time temperature superposition of dynamic data at different temperatures from the terminal flow regime to well below the glass transition temperature, Tg. While these polymers maintained a behavior similar to that of linear polymers, the influence of the large side group structure lead to low entanglement densities and extremely low rubbery plateau modulus values, being near to 13 kPa. The viscosity molecular weight dependence was also somewhat higher than that normally observed for linear polymers, tending toward a power law near to 4.2 rather than the typical 3.4 found in entangled linear chains. The glassy modulus of these branched polymers is also found to be extremely low, being less than 100 MPa at Tg −60 °C. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015, 53, 899–906


  • Response to: Sufficiently entangled polymers do show shear strain localization at high enough Weissenberg numbers”

    by Yanfei Li, Miao Hu, Gregory B. McKenna, Christopher J. Dimitriou, Gareth H. McKinley, Rebecca M. Mick, David C. Venerus, Lynden A. Archer

    In response to the Letter Wang et al. (2014) challenging the results of Li et al. (2013), the present letter addresses the specific concerns in the order that they are raised. (1) Whether the material properties (molecular weight, concentration, and polydispersity index) of the samples used in [Li et al. (2013)] agree with Table I in the same paper? (2) What is the true shear banding phase diagram, if any? (3) Are the shear cessation tests carried out by Li et al. (2013) in the regime where nonquiescent relaxation is expected? (4) How to minimize edge effects? (5) How would other factors, such as location of particle tracking velocimetry observation, plastic film on meniscus, misalignment, and surface treatment, affect the velocity profiles?


  • Open Access

    Flow field visualization of entangled polybutadiene solutions under nonlinear viscoelastic flow conditions

    by Yanfei Li, Miao Hu, Gregory B. McKenna, Christopher J. Dimitriou, Gareth H. McKinley, Rebecca M. Mick, David C. Venerus, Lynden A. Archer

    Using self-designed particle visualization instrumentation, startup shear and step-strain tests were conducted under a series of systematically varied rheological and geometrical conditions, and the velocity profiles in three different well-entangled polybutadiene/oligomer solutions were obtained. For startup shear tests, in the regime of entanglement densities up to 89 and nominal reptation Weissenberg numbers up to 18.6, we generally observe either wall slip and a linear velocity/strain profile or simply the linear profile with no wall slip unless a massive edge fracture or instability has occurred in the sample. Meanwhile, step-strain tests conducted at similar and higher step Weissenberg numbers revealed little particle motion upon cessation. These results lead us to a conclusion that there is no compelling evidence of shear banding or nonquiescent relaxation in the range of entanglement density and Wi investigated; we interpret the results to imply that any observed banding probably correlates with edge effects.Using self-designed particle visualization instrumentation, startup shear and step-strain tests were conducted under a series of systematically varied rheological and geometrical conditions, and the velocity profiles in three different well-entangled polybutadiene/oligomer solutions were obtained. For startup shear tests, in the regime of entanglement densities up to 89 and nominal reptation Weissenberg numbers up to 18.6, we generally observe either wall slip and a linear velocity/strain profile or simply the linear profile with no wall slip unless a massive edge fracture or instability has occurred in the sample. Meanwhile, step-strain tests conducted at similar and higher step Weissenberg numbers revealed little particle motion upon cessation. These results lead us to a conclusion that there is no compelling evidence of shear banding or nonquiescent relaxation in the range of entanglement density and Wi investigated; we interpret the results to imply that any observed banding probably correlates with e...


  • Linear Rheological Response of a Series of Densely Branched Brush Polymers

    by Miao Hu, Yan Xia, Gregory B. McKenna, Julia A. Kornfield, Robert H. Grubbs


  • Influence of Coagents on the Silane Grafting and Cross-linking of Polypropylene

    by Shun Zhou, Miao Hu, Yuan Hu, Zhengzhou Wang

    The grafting of vinyltrimethoxysilane (VTMS) onto polypropylene (PP) was carried out in a melt process, and the cross-linking in the hot water. The influence of coagents, i.e., styrene (St), divinylbenzene (DVB), triallyl isocyanurate (TAIC) and trimethylolpropane triacrylate (TMPTA) on the grafting degree, gel percentage, melt flow index (MFI) of the VTMS modified PP were investigated. It was found that the incorporation of the coagents influenced the grafting and cross-linking of VTMS. The crystallization behavior and crystal structure of the coagent assisted VTMS-cross-linked PP were studied by differential scanning calorimetry (DSC) and wide-angle X-ray diffraction (WXAD), respectively. The thermogravimetric analysis (TG) studies indicate that the thermal stability of VTMS-cross-linked PP was improved by the incorporation of coagents.