RLRongLin Li

RongLin Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


RongLin Li has a total of 45 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Wideband Cavity-Slotted Waveguide Antenna for mm-Wave Automotive Radar Sensors

    by J. Sun, L. Wu, R. Li, X. Zhang, Y. Cui

    A wideband cavity-slotted waveguide antenna is proposed for millimeter-wave automotive radar applications. The antenna consists of a rectangular waveguide cavity with four rectangular slots. A TE 150 mode and a TE 160 mode are excited in the rectangular cavity. A combination of the TE 150 mode and the TE 160 mode leads to a wideband operation. A radiating layer is introduced above the slotted waveguide cavity to improve the impedance matching and the radiation patterns. The cavity-slotted waveguide antenna is fed by a rectangular waveguide at the bottom center of the cavity for avoiding main beam squinting. Simulation and measurement results show that the cavity-slotted waveguide antenna achieves a wide bandwidth of 69-91 GHz with an antenna gain of 14.5 dBi. A 6-TX/8-RX antenna module is developed to demonstrate the potential for commercial automotive radar sensors. Stable fan-beam radiation patterns and antenna gains are obtained.


  • An Aperture-Shared Dual-Band Antenna Array Based on Upstanding Dipoles

    by RongLin Li, Yuanjing Zhang, Bei Xiao, Yuehui Cui

    An aperture-shared dual-band dual-polarized antenna array is developed based on upstanding dipoles for 2G/3G/4G base-station applications. The dual-band antenna array consists of one element for low-band (LB) (0.69–0.96 GHz) and four (2×2) elements for high-band (HB) (1.7–2.7 GHz) operation. The LB element with two crossed upstanding dipoles features a minimum cross section and thus has the least shielding to the HB elements. Four horizontal chokes are introduced on each dipole of the LB element to block the current induced by the HB elements. Slots are etched on the ground of HB elements to suppress the common-mode current induced by the LB element. The aperture-shared dual-band antenna array achieves an antenna gain of 8 dBi for the LB element and 11 dBi for a 1×2 HB array with stable radiation patterns.


  • Aperture-Shared Dual-Band Antennas With Partially Reflecting Surfaces for Base-Station Applications

    by Yue Qin, Ronglin Li, Quan Xue, Xiuyin Zhang, Yuehui Cui

    A new approach is proposed to develop aperture-shared dual-band antennas using partially reflecting surfaces (PRSs). A fully aperture-shared dual-band antenna consisting of a low-band antenna (LBA) and a high-band antenna (HBA) right below the LBA is first investigated. The aperture sharing has little influence on the LBA but causes a severe shielding effect on the HBA. To alleviate the shielding effect, a low-pass PRS is inserted between the LBA and HBA, forming an air-filled quasi-Fabry–Perot cavity, which can make compensation for the radiation from the HBA but with little influence on the LBA. The second PRS is introduced above the LBA to enhance the bandwidth (BW) for HBA. It is shown that the fully aperture-shared dual-band antenna achieves an impedance BW ( $\vert \text{S}11\vert < -15$ dB) of ~43.7% (0.68–1.07 GHz) for the LBA and ~45% (1.7–2.7 GHz) for the HBA with an average gain of ~8 dBi and stable radiation patterns. Based on the PRSs, an aperture-shared dual-band antenna subarray is finally developed for base-station applications, which covers the frequency bands of 0.68–0.96 and 1.7–2.7 GHz for 2G/3G/4G mobile communications.


  • Open Access

    Embeddable Structure for Reducing Mutual Coupling in Massive MIMO Antennas

    by Yue Qin, Ronglin Li, Yuehui Cui

    An embeddable decoupling structure is proposed for massive multiple-input-multiple-output (M-MIMO) antennas in this paper. The embeddable decoupling structure is made up of an end-folded metal strip and a pair of C-shaped metal strips. By introducing the embeddable decoupling structure near two closely spaced dipole antennas, additional coupling can be generated to counterbalance the original mutual coupling between the dipole antennas. The decoupling structure is firstly designed for a $1\times 2$ MIMO antenna, which can provide a reduction of about 5 dB for the mutual coupling. Then, an evolutional decoupling structure is designed, which is composed of a pair of inverted U-shaped metal strips and two parallel reversed C-shaped metal strips. The evolutional decoupling structure is employed in a $3\times 3$ MIMO antenna operating in 5G bands to demonstrate its capability of decoupling. An average reduction of about 10 dB on mutual coupling is obtained over 3.3-4.5 GHz (30.8%). Moreover, it is found that the deteriorated radiation patterns due to the mutual coupling are improved. The decoupling structure can be totally embedded in a M-MIMO antenna, which has no increase in the antenna volume. The proposed decoupling structure exhibits advantages of radiation pattern distortion alleviation, wideband, embeddable, and dual-polarized capabilities for M-MIMO applications.


  • A Triband SIW Cavity-Backed Differentially Fed Dual-Polarized Slot Antenna for WiFi/5G Applications

    by Yuehui Cui, Xuanbo Wang, Guoyan Shen, RongLin Li

    A tri-band differentially fed dual-polarized slot (DFDPS) antenna is developed for indoor WiFi/5G wireless communications. The tri-band antenna is made up of two crossed slots with four pairs of L-shaped slots. The lower and higher bands are generated by the crossed slots and the middle band is attributed to the L-shaped slots. Eight shorting pins are introduced for improving the impedance matching for all the three bands. A SIW (Substrate Integrated Waveguide) cavity is employed to back the antenna for unidirectional radiation. Two orthogonal feedlines are applied to differentially feed the antenna for dual polarization. The antenna has a low-profile of about 0.054λ2.4, where λ2.4 is the wavelength at the lowest frequency 2.4 GHz in free space. It is shown that the tri-band antenna can operate in three bands of 2.4-2.51 GHz, 3.29-3.6 GHz, and 4.8-5.05 GHz with good unidirectional patterns.


  • A High-Gain Quad-Polarization Reconfigurable Antenna

    by Guoying Lin, Yuehui Cui, RongLin Li

    A quad-polarization reconfigurable antenna with high gain is proposed in this paper. The high-gain antenna is a short backfire antenna (SBA) which is excited by two reconfigurable crossed slots. Eight PIN diodes are mounted across the slots. By changing the on/off states of the PIN diodes, the antenna can switch its polarization modes among horizontal polarization (HP), vertical polarization (VP), left-handed circular polarization (LHCP), and right-handed circular polarization (RHCP). Two probes are utilized to feed the crossed slots. An antenna prototype is fabricated. Experimental results show that the reconfigurable antenna exhibits an overlapped impedance bandwidth of 22.5% for return loss ˃10 dB and a high gain of about 10.5 dBi for all polarization states.


  • Open Access

    Experimental Observation of Linear and Rotational Doppler Shifts from Several Designer Surfaces

    by Baiyang Liu, Hongchen Chu, Henry Giddens, Ronglin Li, Yang Hao

    An orbital angular momentum (OAM) carrying beam has the ability to detect a spinning surface from its rotational Doppler effect. However, a mixture of linear and rotational Doppler effects can occur when an OAM beam is illuminated to a target, with not only spins but also vibrations. In this paper, we experimentally observe using OAM carrying beams, both linear and rotational Doppler effects from several designer surfaces. Specifically, a spinning polarization-independent metasurface, helicoidal reflector and propeller are applied respectively in this study. We demonstrate by the use of two microwave beams with opposite OAM to separate rotational Doppler shift from micro-Doppler shift. The proposed method can also be applied to measure the spinning speed of rotational objects, which have wider applications in intelligent sensing, radar and quantum optics.


  • A Low-Profile Broadband Quad-Polarization Reconfigurable Omnidirectional Antenna

    by Yuehui Cui, Changlong Qi, Rong Lin Li

    A low-profile broadband quad-polarization reconfigurable omnidirectional antenna is presented. The quad-polarization antenna consists of a circular loop for horizontal polarization (HP) and a top-loaded monopole for vertical polarization (VP). The circular loop is composed of four arc dipoles excited by a broadband feeding network. The left-handed circular polarization (LHCP) is obtained by feeding the circular loop and the top-loaded monopole simultaneously with different phases. Two λ g/2 phase shifters are introduced for the right-handed circular polarization (RHCP). Twelve PIN diodes are employed in the feeding network to realize the quad-polarization reconfiguration. It is shown that the bandwidth of the quad-polarization reconfigurable omnidirectional antenna overlapped for HP, VP, LHCP, and RHCP is about 28.6% (1.65–2.2 GHz) with good omnidirectional patterns. The total height of the antenna is about 0.09λ


  • Open Access

    Development of polarisation reconfigurable omnidirectional antennas using crossed dipoles

    by Yi Fan, RongLin Li, Yuehui Cui

    A new method for the development of polarisation reconfigurable omnidirectional antennas is presented. Four crossed‐dipole elements around a cylinder are used to construct an omnidirectional antenna. By switching on/off four PIN diodes for each crossed‐dipole element, three types of polarisation reconfigurable omnidirectional antennas are realised, including vertical or horizontal polarisation (VP/HP), ±45° slant polarisation (SP), and left‐handed circular polarisation or right‐handed circular polarisation (LHCP/RHCP). The VP/HP, ±45° SP, and LHCP/RHCP reconfigurable omnidirectional antennas are simulated, fabricated, and measured, respectively. Simulated and measured results show that all the three reconfigurable omnidirectional antennas feature good omnidirectional patterns with gain variations of <2 dB in the horizontal plane.