Vincent Wheatley
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Vincent Wheatley has a total of 104 co-authors. Here are the top co-authors by number of shared publications:
D. I. Pullin
Graduate Aerospace Laboratories, California Institute of Technology, Pasadena, California 91125, USA
15 shared publicationsR. Samtaney
King Abdullah University of Science and Technology
14 shared publicationsMichael K. Smart
University of Queensland, Brisbane, Queensland 4072, Australia
11 shared publicationsAnanthanarayanan Veeraragavan
The University of Queensland, Brisbane, Queensland 4072, Australia
7 shared publicationsMichael Smart
7 shared publications- Adrian Pudsey
School of Mechanical and Mining Engineering, University of Queensland, Queensland, Brisbane 4072, Australia
5 shared publications
Latest Publications
- Open Access
- 13 March 2026
- Published by Elsevier in Computers & Fluids
- Vol. 311
Direct numerical simulations of a supersonic reacting ethylene-air shear layer interacting with an oblique shock
- 13 March 2026
- Published by Elsevier in Computers & Fluids
- Vol. 311
Open AccessDirect numerical simulations of a supersonic reacting ethylene-air shear layer interacting with an oblique shock
- 17 March 2025
- Published by Springer Nature in CEAS Space Journal
- Vol. 17 (4) , 645-659
Interaction of mainstream injection with supersonic boundary-layer combustion for hydrogen fuel
- 17 March 2025
- Published by Springer Nature in CEAS Space Journal
- Vol. 17 (4) , 645-659
Interaction of mainstream injection with supersonic boundary-layer combustion for hydrogen fuel
- 1 July 2024
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Spacecraft and Rockets
- Vol. 61 (4) , 1006-1018
Noise Generated in a Scramjet Combustor
This paper presents the noise levels generated inside a two-dimensional scramjet combustor at Mach 7.3 freestream using the focused laser differential interferometric (FLDI) technique. FLDI measurements were taken at the front, middle, and rear of the combustor’s center plane under unfueled, combustion-suppressed, and combustion-on conditions. Spectral analysis of the FLDI signal shows density fluctuations inside the scramjet combustor are almost two times higher than the freestream and confirms the capability of this technique for measuring the disturbances in a complex hypersonic flowfield. Though combustion-induced pressure rise is low, a trend in the increase in the normalized density fluctuations/noise levels due to supersonic combustion is observed across the measurement locations for the combustion-on condition. However, the overall increment in the noise level is modest between the three conditions and across the three probing locations. This infers that, for the current scramjet geometry, fueling rates, fuel–air mixing, and supersonic combustion are not the dominant noise sources in the scramjet combustor. Instead, the base hypersonic flowfield inside the scramjet combustor is the main contributor to the noise field. Noting that there is relatively large uncertainty in the measured noise levels and that the combustion-induced pressure rise is modest in the present study, further investigation is needed to check the applicability of these results to the scramjet engines with flow paths having more complex flowfields, fueling schemes, and fueling rates.
- 1 July 2024
- Published by American Institute of Aeronautics and Astronautics (AIAA) in Journal of Spacecraft and Rockets
- Vol. 61 (4) , 1006-1018
Noise Generated in a Scramjet Combustor
This paper presents the noise levels generated inside a two-dimensional scramjet combustor at Mach 7.3 freestream using the focused laser differential interferometric (FLDI) technique. FLDI measurements were taken at the front, middle, and rear of the combustor’s center plane under unfueled, combustion-suppressed, and combustion-on conditions. Spectral analysis of the FLDI signal shows density fluctuations inside the scramjet combustor are almost two times higher than the freestream and confirms the capability of this technique for measuring the disturbances in a complex hypersonic flowfield. Though combustion-induced pressure rise is low, a trend in the increase in the normalized density fluctuations/noise levels due to supersonic combustion is observed across the measurement locations for the combustion-on condition. However, the overall increment in the noise level is modest between the three conditions and across the three probing locations. This infers that, for the current scramjet geometry, fueling rates, fuel–air mixing, and supersonic combustion are not the dominant noise sources in the scramjet combustor. Instead, the base hypersonic flowfield inside the scramjet combustor is the main contributor to the noise field. Noting that there is relatively large uncertainty in the measured noise levels and that the combustion-induced pressure rise is modest in the present study, further investigation is needed to check the applicability of these results to the scramjet engines with flow paths having more complex flowfields, fueling schemes, and fueling rates.
- Open Access
- 12 October 2023
- Published by Springer Nature in CEAS Space Journal
- Vol. 15 (6) , 777-779
High-speed vehicle systems and technologies
- 12 October 2023
- Published by Springer Nature in CEAS Space Journal
- Vol. 15 (6) , 777-779
Open AccessHigh-speed vehicle systems and technologies
- Open Access
- 1 February 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (2) , 022707
The effect of collisions on the multi-fluid plasma Richtmyer–Meshkov instability
The Richtmyer–Meshkov instability (RMI) results from the impulsive acceleration of a density interface where the RMI itself or the acceleration is perturbed. The RMI is ubiquitous in shock environments and may arise due to an interface of fluid species, isotopes, temperature, or more. The plasma RMI can be significantly influenced by electromagnetic effects and can be modeled more accurately by a multi-fluid plasma (MFP) model rather than conventional magnetohydrodynamics, though with increased computational expense. MFP modeling of the plasma RMI has revealed many phenomena but has only been completed within the ideal regime. Modeling the effects of elastic collisions is vital for understanding the behavior of the instability in a dense plasma. The Braginskii transport coefficients provide theoretically based relations modeling thermal equilibration, inter-species drag, viscous momentum- and energy-transfers, and thermal conductivity. Our numerical simulations of the MFP RMI with these relations show that the key changes from the ideal case are (1) reduction of relative motion between the ion and electron fluids (consequently affecting the self-generated electromagnetic fields), (2) introduction of anisotropy in momentum and energy via transport coefficients, and (3) damping of high frequency electromagnetic waves and plasma waves. Under the conditions studied, the net effect is a reduction in the MFP RMI amplitude width and the growth rate to levels approaching the neutral fluid instability, as well as a reduction in large scale perturbations along the ion fluid density interface, a positive for inertial confinement fusion efforts. There are, however, two important caveats: small-scale density interface perturbations remain, and the conditions simulated are a few relevant points in a large parameter space that requires further investigation.
- 1 February 2023
- Published by AIP Publishing in Physics of Plasmas
- Vol. 30 (2) , 022707
Open AccessThe effect of collisions on the multi-fluid plasma Richtmyer–Meshkov instability
The Richtmyer–Meshkov instability (RMI) results from the impulsive acceleration of a density interface where the RMI itself or the acceleration is perturbed. The RMI is ubiquitous in shock environments and may arise due to an interface of fluid species, isotopes, temperature, or more. The plasma RMI can be significantly influenced by electromagnetic effects and can be modeled more accurately by a multi-fluid plasma (MFP) model rather than conventional magnetohydrodynamics, though with increased computational expense. MFP modeling of the plasma RMI has revealed many phenomena but has only been completed within the ideal regime. Modeling the effects of elastic collisions is vital for understanding the behavior of the instability in a dense plasma. The Braginskii transport coefficients provide theoretically based relations modeling thermal equilibration, inter-species drag, viscous momentum- and energy-transfers, and thermal conductivity. Our numerical simulations of the MFP RMI with these relations show that the key changes from the ideal case are (1) reduction of relative motion between the ion and electron fluids (consequently affecting the self-generated electromagnetic fields), (2) introduction of anisotropy in momentum and energy via transport coefficients, and (3) damping of high frequency electromagnetic waves and plasma waves. Under the conditions studied, the net effect is a reduction in the MFP RMI amplitude width and the growth rate to levels approaching the neutral fluid instability, as well as a reduction in large scale perturbations along the ion fluid density interface, a positive for inertial confinement fusion efforts. There are, however, two important caveats: small-scale density interface perturbations remain, and the conditions simulated are a few relevant points in a large parameter space that requires further investigation.
- Open Access
- 1 March 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (3) , 036104
Magnetohydrodynamic shock refraction at an inclined density interface
Shock wave refraction at a sharp density interface is a classical problem in hydrodynamics. Presently, we investigate the strongly planar refraction of a magnetohydrodynamic (MHD) shock wave at an inclined density interface. A magnetic field is applied that is initially oriented either perpendicular or parallel to the motion of incident shock. We explore flow structure by varying the magnitude of the magnetic field governed by the non-dimensional parameter and the inclination angle of density interface . The regular MHD shock refraction process results in a pair of outer fast shocks (reflected and transmitted) and a set of inner nonlinear magneto-sonic waves. By varying magnetic field (strength and direction) and inclination interface angle, the latter waves can be slow shocks, slow expansion fans, intermediate shocks, or slow-mode compound waves. For a chosen incident shock strength and density ratio, the MHD shock refraction transitions from regular (all nonlinear waves meeting at a single point) into irregular when the inclined density interface angle is less than a critical value. Irregular refraction patterns are not amenable to an analytical solution, and hence, we have obtained irregular refraction solutions by numerical simulations. Since the MHD shock refraction is self-similar, we further explore by converting the initial value problem into a boundary value problem (BVP) by a self-similar coordinate transformation. The self-similar solution to the BVP is numerically solved using an iterative method and implemented using the p4est adaptive mesh framework. The simulation shows that a Mach stem occurs in an irregular MHD shock refraction, and the flow structure can be an MHD equivalent to a single Mach reflection irregular refraction and convex-forwards irregular refraction that occur in hydrodynamic case. For Mach number M = 2, both analytical and numerical results show that perpendicular magnetics fields suppress the regular to irregular transition compared to the corresponding hydrodynamic case. As Mach number decreased, it is possible that strong perpendicular magnetics promote the regular to irregular transition, while moderate perpendicular magnetics suppress this transition compared to the corresponding hydrodynamic case.- 1 March 2022
- Published by AIP Publishing in Physics of Fluids
- Vol. 34 (3) , 036104
Open AccessMagnetohydrodynamic shock refraction at an inclined density interface
Shock wave refraction at a sharp density interface is a classical problem in hydrodynamics. Presently, we investigate the strongly planar refraction of a magnetohydrodynamic (MHD) shock wave at an inclined density interface. A magnetic field is applied that is initially oriented either perpendicular or parallel to the motion of incident shock. We explore flow structure by varying the magnitude of the magnetic field governed by the non-dimensional parameter and the inclination angle of density interface . The regular MHD shock refraction process results in a pair of outer fast shocks (reflected and transmitted) and a set of inner nonlinear magneto-sonic waves. By varying magnetic field (strength and direction) and inclination interface angle, the latter waves can be slow shocks, slow expansion fans, intermediate shocks, or slow-mode compound waves. For a chosen incident shock strength and density ratio, the MHD shock refraction transitions from regular (all nonlinear waves meeting at a single point) into irregular when the inclined density interface angle is less than a critical value. Irregular refraction patterns are not amenable to an analytical solution, and hence, we have obtained irregular refraction solutions by numerical simulations. Since the MHD shock refraction is self-similar, we further explore by converting the initial value problem into a boundary value problem (BVP) by a self-similar coordinate transformation. The self-similar solution to the BVP is numerically solved using an iterative method and implemented using the p4est adaptive mesh framework. The simulation shows that a Mach stem occurs in an irregular MHD shock refraction, and the flow structure can be an MHD equivalent to a single Mach reflection irregular refraction and convex-forwards irregular refraction that occur in hydrodynamic case. For Mach number M = 2, both analytical and numerical results show that perpendicular magnetics fields suppress the regular to irregular transition compared to the corresponding hydrodynamic case. As Mach number decreased, it is possible that strong perpendicular magnetics promote the regular to irregular transition, while moderate perpendicular magnetics suppress this transition compared to the corresponding hydrodynamic case. - 1 December 2021
- Published by Elsevier in Aerospace Science and Technology
- Vol. 119
Comparison of ethylene combustion mechanisms for the simulation of a supersonic combustion experiment
- 1 December 2021
- Published by Elsevier in Aerospace Science and Technology
- Vol. 119
Comparison of ethylene combustion mechanisms for the simulation of a supersonic combustion experiment
- 1 May 2020
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 58 (5) , 2180-2196
Characterization of Supersonic Turbulent Combustion in a Mach-10 Scramjet Combustor
Turbulent combustion remains an unsolved problem, and the simulation models that have been developed, although accurate for subsonic turbulent combustion, have limited accuracy when applied to supe...
- 1 May 2020
- Published by American Institute of Aeronautics and Astronautics (AIAA) in AIAA Journal
- Vol. 58 (5) , 2180-2196
Characterization of Supersonic Turbulent Combustion in a Mach-10 Scramjet Combustor
Turbulent combustion remains an unsolved problem, and the simulation models that have been developed, although accurate for subsonic turbulent combustion, have limited accuracy when applied to supe...
- 1 January 2020
- Published by University of Queensland Library
The Effect of Wall and Fuel Temperature in a Mach 6 Scramjet Engine
- 1 January 2020
- Published by University of Queensland Library
The Effect of Wall and Fuel Temperature in a Mach 6 Scramjet Engine