Patrick E. Mason
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Patrick E. Mason has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
Jenny M. Jones
6 shared publicationsA. Williams
5 shared publicationsAlan Williams
4 shared publicationsJ.M. Jones
3 shared publications- Jenny M. Jones
School of Chemical and Process Engineering, University of Leeds, Leeds LS2 9JT, UK
3 shared publications - Hannah Chalmers
School of Engineering, University of Edinburgh, Edinburgh, UK
2 shared publications
Latest Publications
- Open Access
- 1 August 2019
- Published by Elsevier in Biomass and Bioenergy
- Vol. 127
The impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash
- 1 August 2019
- Published by Elsevier in Biomass and Bioenergy
- Vol. 127
Open AccessThe impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash
High temperature volatile yield and nitrogen partitioning during pyrolysis of coal and biomass fuels
- Top Cited PapersOpen Access
- 1 June 2019
- Published by Elsevier in Journal of the Energy Institute
- Vol. 92 (3) , 523-534
A compilation of data on the radiant emissivity of some materials at high temperatures
- 1 June 2019
- Published by Elsevier in Journal of the Energy Institute
- Vol. 92 (3) , 523-534
Top Cited PapersOpen AccessA compilation of data on the radiant emissivity of some materials at high temperatures
- Open Access
- 27 December 2018
- Published by Springer Nature in Waste and Biomass Valorization
- Vol. 11 (5) , 1971-1981
An Assessment of Contaminants in UK Road-Verge Biomass and the Implications for Use as Anaerobic Digestion Feedstock
- 27 December 2018
- Published by Springer Nature in Waste and Biomass Valorization
- Vol. 11 (5) , 1971-1981
Open AccessAn Assessment of Contaminants in UK Road-Verge Biomass and the Implications for Use as Anaerobic Digestion Feedstock
- Open Access
- 27 November 2018
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 240, 03002
CFD analysis of a one-pass photovoltaic/thermal air system with and without offset strip fins
The focus on managing PV panel temperature has undergone a remarkable development in the last two decades. Specifically, in countries with moderate weather temperature and high insolation, the problem of keeping the PV cell temperature in an optimal range has been managed by use of PV/T collectors. In this work, a single pass PV/T collector using laminar air flow has been assessed. Two PV/T collector designs are utilised, one with and one without offset strip fins. COMSOL Multiphysics v5.3a has been used for the analysis of the thermal and electrical performances. Two assumptions were implemented in order to reduce the computational time from 95 hours to 7 hours, namely ignoring radiative effects between the fins and the wall channels, and representing thin layers as 2D boundaries, whilst ensuring a high level of conformity (4%),. Monocrystalline silicon PV cells were used with a power temperature coefficient of 0.41%. A validation against work in the literature was made, showing a good consistency. The objective of this work is to verify the performance of the air PV/T collector with offset strip fins compared to an unfinned air PV/T collector. The results reveal that the use of offset strip fins has a noticeable impact on both the electrical and thermal efficiencies of the system. In addition, the maximum combined efficiency (ηCo) for the finned PV/T system is 84.7% while the unfinned PV/T system is 51.2%.
- 27 November 2018
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 240, 03002
Open AccessCFD analysis of a one-pass photovoltaic/thermal air system with and without offset strip fins
The focus on managing PV panel temperature has undergone a remarkable development in the last two decades. Specifically, in countries with moderate weather temperature and high insolation, the problem of keeping the PV cell temperature in an optimal range has been managed by use of PV/T collectors. In this work, a single pass PV/T collector using laminar air flow has been assessed. Two PV/T collector designs are utilised, one with and one without offset strip fins. COMSOL Multiphysics v5.3a has been used for the analysis of the thermal and electrical performances. Two assumptions were implemented in order to reduce the computational time from 95 hours to 7 hours, namely ignoring radiative effects between the fins and the wall channels, and representing thin layers as 2D boundaries, whilst ensuring a high level of conformity (4%),. Monocrystalline silicon PV cells were used with a power temperature coefficient of 0.41%. A validation against work in the literature was made, showing a good consistency. The objective of this work is to verify the performance of the air PV/T collector with offset strip fins compared to an unfinned air PV/T collector. The results reveal that the use of offset strip fins has a noticeable impact on both the electrical and thermal efficiencies of the system. In addition, the maximum combined efficiency (ηCo) for the finned PV/T system is 84.7% while the unfinned PV/T system is 51.2%.
- Open Access
- 1 September 2018
- Published by Elsevier in Fuel Processing Technology
- Vol. 178, 13-23
Investigating the impact of an Al-Si additive on the resistivity of biomass ashes
- 1 September 2018
- Published by Elsevier in Fuel Processing Technology
- Vol. 178, 13-23
Open AccessInvestigating the impact of an Al-Si additive on the resistivity of biomass ashes
- Open Access
- 1 January 2017
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 36 (2) , 2207-2215
Gas phase potassium release from a single particle of biomass during high temperature combustion
- 1 January 2017
- Published by Elsevier in Proceedings of the Combustion Institute
- Vol. 36 (2) , 2207-2215
Open AccessGas phase potassium release from a single particle of biomass during high temperature combustion