Amos Madhlopa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Amos Madhlopa has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
C. Johnstone
2 shared publicationsDebbie Sparks
2 shared publications- Edmund Chijioke Okoroigwe
Sustainable, Clean and Emerging Energy Technologies Group, Department of Mechanical Engineering, University of Nigeria, Nsukka, Nigeria
2 shared publications Mascha Moorlach
2 shared publicationsPieter Krog
2 shared publicationsSamantha Keen
2 shared publications
Latest Publications
- 19 August 2022
- Published by Elsevier
- p. 371-395
Testing of solar receivers
- 19 August 2022
- Published by Elsevier
- p. 113-149
Characteristics of heat transfer media
- Open Access
- 17 March 2022
- Published by Academy of Science of South Africa in Journal of Energy in Southern Africa
- Vol. 33 (1) , 68-84
Integration of waste heat in thermal desalination technologies: A review
Desalination is increasingly becoming a crucial method for providing fresh water globally. However, most of the desalination technologies are energy-intensive and driven by fossil fuels that are contributing to climate change and other environmental problems. In this vein, renewable energy and energy efficiency are promising pillars of sustainable energy production and consumption, and the recovery of waste heat helps to augment the energy efficiency of a system. Based on the temperature (T) of the heat source, waste heat can be classified into three categories: low temperature (T<100°C), medium temperature (100°C£T<300°C) and high temp-erature (T³300°C). There is scarcity of review work on the integration of waste heat in desalination technologies. In this study, the progress in the utilisation of waste heat to drive thermal desalination processes has been investigated. It is found that 63% of waste heat streams are of low grade, which is still satisfactory for thermal desalination technologies that run on low-temperature heat sources. As of 2018, there was only one known thermal desalination plant driven by waste heat. Lack of data on waste heat, especially in developing countries, has been identified as a major challenge to the advancement of desalination technologies driven by this source of thermal energy. Other constraints are presented and discussed in this paper.
- 17 March 2022
- Published by Academy of Science of South Africa in Journal of Energy in Southern Africa
- Vol. 33 (1) , 68-84
Open AccessIntegration of waste heat in thermal desalination technologies: A review
Desalination is increasingly becoming a crucial method for providing fresh water globally. However, most of the desalination technologies are energy-intensive and driven by fossil fuels that are contributing to climate change and other environmental problems. In this vein, renewable energy and energy efficiency are promising pillars of sustainable energy production and consumption, and the recovery of waste heat helps to augment the energy efficiency of a system. Based on the temperature (T) of the heat source, waste heat can be classified into three categories: low temperature (T<100°C), medium temperature (100°C£T<300°C) and high temp-erature (T³300°C). There is scarcity of review work on the integration of waste heat in desalination technologies. In this study, the progress in the utilisation of waste heat to drive thermal desalination processes has been investigated. It is found that 63% of waste heat streams are of low grade, which is still satisfactory for thermal desalination technologies that run on low-temperature heat sources. As of 2018, there was only one known thermal desalination plant driven by waste heat. Lack of data on waste heat, especially in developing countries, has been identified as a major challenge to the advancement of desalination technologies driven by this source of thermal energy. Other constraints are presented and discussed in this paper.
- Open Access
Urban Wind Resource Assessment: A Case Study on Cape Town
As the demand for renewable energy sources energy grows worldwide, small-scale urban wind energy (UWE) has drawn attention as having the potential to significantly contribute to urban electricity demand with environmental and socio-economic benefits. However, there is currently a lack of academic research surrounding realizable UWE potential, especially in the South African context. This study used high-resolution annual wind speed measurements from six locations spanning Cape Town to quantify and analyze the city’s UWE potential. Two-parameter Weibull distributions were constructed for each location, and the annual energy production (AEP) was calculated considering the power curves of four commonly used small-scale wind turbines (SWTs). The two Horizontal Axis Wind Turbines (HAWTs) showed higher AEP and capacity factors than Vertical Axis Wind Turbine (VAWT) ones. A diurnal analysis showed that, during summer, an SWT generates the majority of its electricity during the day, which resembles the typical South African electricity demand profile. However, during winter, the electricity is mainly generated in the early hours of the morning, which does not coincide with the typical load demand profile. Finally, the calculation of Levelized Cost of Electricity (LCOE) showed that SWT generation is more expensive, given current electricity market conditions and SWT technology. The study provides a detailed, large-scale and complete assessment of UWE resources of Cape Town, South Africa, the first of its kind at the time of this work.
Open AccessUrban Wind Resource Assessment: A Case Study on Cape Town
As the demand for renewable energy sources energy grows worldwide, small-scale urban wind energy (UWE) has drawn attention as having the potential to significantly contribute to urban electricity demand with environmental and socio-economic benefits. However, there is currently a lack of academic research surrounding realizable UWE potential, especially in the South African context. This study used high-resolution annual wind speed measurements from six locations spanning Cape Town to quantify and analyze the city’s UWE potential. Two-parameter Weibull distributions were constructed for each location, and the annual energy production (AEP) was calculated considering the power curves of four commonly used small-scale wind turbines (SWTs). The two Horizontal Axis Wind Turbines (HAWTs) showed higher AEP and capacity factors than Vertical Axis Wind Turbine (VAWT) ones. A diurnal analysis showed that, during summer, an SWT generates the majority of its electricity during the day, which resembles the typical South African electricity demand profile. However, during winter, the electricity is mainly generated in the early hours of the morning, which does not coincide with the typical load demand profile. Finally, the calculation of Levelized Cost of Electricity (LCOE) showed that SWT generation is more expensive, given current electricity market conditions and SWT technology. The study provides a detailed, large-scale and complete assessment of UWE resources of Cape Town, South Africa, the first of its kind at the time of this work.
- 16 December 2018
- Published by Wiley in Energy Technology
- Vol. 7 (5)
Advances in Biofueling of Micro Gas Turbines for Power Generation
The micro gas turbine (MGT) technology is gaining momentum in distributed energy solutions. Nevertheless, this technology is predominantly fueled by fossil energy resources at present. The use of biofuels to propel micro gas turbines (MGTs) for power generation is one of the most promising ways to reduce greenhouse gas emission resulting from fossil fuel consumption in power plants and to enhance energy security. Herein, various approaches to integrate biofuels into the MGT system for power generation are reviewed. It is found that biogas‐driven MGTs are in the most advanced stage of technological maturity. From an economic perspective, previous works show that combustion of biogas is most viable in a combined heat and power system compared to only power or heat generation. Nevertheless, the deployment of MGTs for commercial generation of power is scarce, which indicates that this sector is encountering some challenges. One of the major concerns about the exploitation of biofuels in gas turbines relates to fuel properties and combustion characteristics. Other challenges are also presented and discussed, and further research on the commercial production and combustion of biofuels in MGT engines is recommended.
- 16 December 2018
- Published by Wiley in Energy Technology
- Vol. 7 (5)
Advances in Biofueling of Micro Gas Turbines for Power Generation
The micro gas turbine (MGT) technology is gaining momentum in distributed energy solutions. Nevertheless, this technology is predominantly fueled by fossil energy resources at present. The use of biofuels to propel micro gas turbines (MGTs) for power generation is one of the most promising ways to reduce greenhouse gas emission resulting from fossil fuel consumption in power plants and to enhance energy security. Herein, various approaches to integrate biofuels into the MGT system for power generation are reviewed. It is found that biogas‐driven MGTs are in the most advanced stage of technological maturity. From an economic perspective, previous works show that combustion of biogas is most viable in a combined heat and power system compared to only power or heat generation. Nevertheless, the deployment of MGTs for commercial generation of power is scarce, which indicates that this sector is encountering some challenges. One of the major concerns about the exploitation of biofuels in gas turbines relates to fuel properties and combustion characteristics. Other challenges are also presented and discussed, and further research on the commercial production and combustion of biofuels in MGT engines is recommended.