Marina Pirulli
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Marina Pirulli has a total of 106 co-authors. Here are the top co-authors by number of shared publications:
Claudio Scavia
Department of Structural, Geotechnical and Building Engineering, Politecnico di Torino, Torino, Italy
11 shared publications- Cristina Occhiena
Politecnico di Torino
5 shared publications - Giulia La Porta
Research Fellow, Department of Structural, Geotechnical and Building Engineering, Politecnico di Torino, Torino, Italy
4 shared publications - Anne Mangeney
University Paris Cité, Institut de Physique du Globe de Paris, 1, rue Jussieu, 75238 Paris cedex 05, France
3 shared publications C Scavia
3 shared publicationsC. Scavia
3 shared publications
Latest Publications
- Open Access
- 10 September 2025
- Published by Springer Nature in Landslides
- p. 1-16
Post-wildfire debris flow in the Northwestern Italian Alps: description and numerical analysis of the June 2018 Bussoleno event
On June 7, 2018, a mud-debris flow occurred in the Comba delle Foglie basin, Susa Valley, Northwestern Italy. The event followed an unusually wet winter and spring with high cumulative rainfall, though no intense rainfall was recorded immediately prior to the flow. Approximately 20,000 $$\textrm{m}^3$$ of sediments and woody debris were transported to an urbanized alluvial fan, causing severe damage, including the destruction of two residential buildings and widespread flooding. Key predisposing factors include extensive wildfires in Autumn 2017, which are atypical for this region characterized by an alpine climate. Following the event, significant mitigation measures were implemented. This study presents an analysis of the event, integrating data on fire damage, rainfall distribution, flow runout, and deposit thickness from post-event surveys. A numerical back-analysis of the flow dynamics is conducted using two approaches to define the triggering area. The simplified triggering approach applies a method frequently used in the literature, simulating the runout of a concentrated mass to evaluate the flow’s rheology. Two rheological laws are tested by comparing simulated flow depths and path with field data. The susceptibility-based triggering approach incorporates a preliminary susceptibility analysis, integrating fire severity mapping and literature findings to account for wildfire-induced impacts on soil stability. A comparison of the simulations shows that the susceptibility-based analysis better reproduces the flow path, enhancing back-analysis accuracy. However, the simplified approach remains a reliable tool for the case study. Finally, the effectiveness of the implemented mitigation measures is assessed through numerical simulations, providing insights into the settlement’s potential response to future debris-flow events.- 10 September 2025
- Published by Springer Nature in Landslides
- p. 1-16
Open AccessPost-wildfire debris flow in the Northwestern Italian Alps: description and numerical analysis of the June 2018 Bussoleno event
On June 7, 2018, a mud-debris flow occurred in the Comba delle Foglie basin, Susa Valley, Northwestern Italy. The event followed an unusually wet winter and spring with high cumulative rainfall, though no intense rainfall was recorded immediately prior to the flow. Approximately 20,000 $$\textrm{m}^3$$ of sediments and woody debris were transported to an urbanized alluvial fan, causing severe damage, including the destruction of two residential buildings and widespread flooding. Key predisposing factors include extensive wildfires in Autumn 2017, which are atypical for this region characterized by an alpine climate. Following the event, significant mitigation measures were implemented. This study presents an analysis of the event, integrating data on fire damage, rainfall distribution, flow runout, and deposit thickness from post-event surveys. A numerical back-analysis of the flow dynamics is conducted using two approaches to define the triggering area. The simplified triggering approach applies a method frequently used in the literature, simulating the runout of a concentrated mass to evaluate the flow’s rheology. Two rheological laws are tested by comparing simulated flow depths and path with field data. The susceptibility-based triggering approach incorporates a preliminary susceptibility analysis, integrating fire severity mapping and literature findings to account for wildfire-induced impacts on soil stability. A comparison of the simulations shows that the susceptibility-based analysis better reproduces the flow path, enhancing back-analysis accuracy. However, the simplified approach remains a reliable tool for the case study. Finally, the effectiveness of the implemented mitigation measures is assessed through numerical simulations, providing insights into the settlement’s potential response to future debris-flow events. - 13 June 2025
- Published by Emerald Publishing in Environmental Geotechnics
- p. 1-14
Unconfined compressive strength prediction of lime-stabilised clayey soils under freeze-thaw conditions
In cold regions, and considering the increasing concerns regarding climate change, it is crucial to assess soil stabilisation techniques under adverse environmental conditions. The study addresses the challenge of forecasting geotechnical properties of lime-stabilised clayey soils subjected to freeze-thaw conditions. A model is proposed to accurately predict the unconfined compressive strength (UCS) of lime-stabilised clayey soils exposed to freeze-thaw cycles. As the prediction of UCS is essential in construction engineering, the use of the model is a viable early-phase alternative to time-consuming laboratory testing procedures. This research aims to propose a robust predictive model using readily accessible soil parameters. A comprehensive statistical model for predicting UCS was developed and validated using data sourced from the scientific literature. An extensive parametric analysis was conducted to assess the predictive performance of the developed model. The findings underscore the capability of statistical models to predict UCS of stabilised soils demonstrating their valuable contribution to this area of study.
- 13 June 2025
- Published by Emerald Publishing in Environmental Geotechnics
- p. 1-14
Unconfined compressive strength prediction of lime-stabilised clayey soils under freeze-thaw conditions
In cold regions, and considering the increasing concerns regarding climate change, it is crucial to assess soil stabilisation techniques under adverse environmental conditions. The study addresses the challenge of forecasting geotechnical properties of lime-stabilised clayey soils subjected to freeze-thaw conditions. A model is proposed to accurately predict the unconfined compressive strength (UCS) of lime-stabilised clayey soils exposed to freeze-thaw cycles. As the prediction of UCS is essential in construction engineering, the use of the model is a viable early-phase alternative to time-consuming laboratory testing procedures. This research aims to propose a robust predictive model using readily accessible soil parameters. A comprehensive statistical model for predicting UCS was developed and validated using data sourced from the scientific literature. An extensive parametric analysis was conducted to assess the predictive performance of the developed model. The findings underscore the capability of statistical models to predict UCS of stabilised soils demonstrating their valuable contribution to this area of study.
- 1 January 2025
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 62, 1-15
Influence of fine content on the behavior of sandy soils undergoing artificial freezing in triaxial conditions
Artificial ground freezing (AGF) is used to stabilize loose soils and fractured rocks during tunnel and shaft excavation, ensuring temporary ground stabilization and groundwater control. It is particularly relevant for intermediate soils, where the influence of granulometry on freezing is crucial for effective design. However, existing studies often focus on site-specific materials, limiting broader applicability. This research investigates how fine content influences the freezing behavior of intermediate soils. Sandy soils with varying kaolin content (0% to 15%) are tested under different confining pressures representative of AGF applications. A modified triaxial apparatus simulated field conditions, applying radial thermal loading to replicate freezing around a pipe. Results demonstrated a pronounced dependence on kaolin content. Samples with 15% kaolin exhibited significant swelling, whereas soils with lower kaolin content were classified as non-frost-susceptible. Swelling was mitigated by increasing confining pressure. Water drainage was observed during the freezing process, governed by two mechanisms: (1) the expulsion of liquid water from the freezing front as water turned into ice and (2) cryogenic suction, which drew water toward the freezing front. These findings contribute to a more generalized and quantitative understanding of soil behavior with varying fine content under freezing conditions, facilitating the optimization of AGF applications.
- 1 January 2025
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 62, 1-15
Influence of fine content on the behavior of sandy soils undergoing artificial freezing in triaxial conditions
Artificial ground freezing (AGF) is used to stabilize loose soils and fractured rocks during tunnel and shaft excavation, ensuring temporary ground stabilization and groundwater control. It is particularly relevant for intermediate soils, where the influence of granulometry on freezing is crucial for effective design. However, existing studies often focus on site-specific materials, limiting broader applicability. This research investigates how fine content influences the freezing behavior of intermediate soils. Sandy soils with varying kaolin content (0% to 15%) are tested under different confining pressures representative of AGF applications. A modified triaxial apparatus simulated field conditions, applying radial thermal loading to replicate freezing around a pipe. Results demonstrated a pronounced dependence on kaolin content. Samples with 15% kaolin exhibited significant swelling, whereas soils with lower kaolin content were classified as non-frost-susceptible. Swelling was mitigated by increasing confining pressure. Water drainage was observed during the freezing process, governed by two mechanisms: (1) the expulsion of liquid water from the freezing front as water turned into ice and (2) cryogenic suction, which drew water toward the freezing front. These findings contribute to a more generalized and quantitative understanding of soil behavior with varying fine content under freezing conditions, facilitating the optimization of AGF applications.
- Open Access
- 26 April 2021
- Published by Springer Nature in Granular Matter
- Vol. 23 (2) , 1-8
Coriolis-induced instabilities in centrifuge modeling of granular flow
Granular flows are typically studied in laboratory flumes based on common similarity scaling, which create stress fields that only roughly approximate field conditions. The geotechnical centrifuge produces stress conditions that are closer to those observed in the field, but steady conditions can be hardly achieved. Moreover, secondary effects induced by the apparent Coriolis acceleration, which can either dilate or compress the flow, often obscure scaling. This work aims at studying a set of numerical experiments where the effects of the Coriolis acceleration are measured and analyzed. Three flow states are observed: dense, dilute, and unstable. It is found that flows generated under the influence of dilative Coriolis accelerations are likely to become unstable. Nevertheless, a steady dense flow can still be obtained if a large centrifuge is used. A parametric group is proposed to predict the insurgence of instabilities; this parameter can guide experimental designs and could help to avoid damage to the experimental apparatus and model instrumentation.Graphic
- 26 April 2021
- Published by Springer Nature in Granular Matter
- Vol. 23 (2) , 1-8
Open AccessCoriolis-induced instabilities in centrifuge modeling of granular flow
Granular flows are typically studied in laboratory flumes based on common similarity scaling, which create stress fields that only roughly approximate field conditions. The geotechnical centrifuge produces stress conditions that are closer to those observed in the field, but steady conditions can be hardly achieved. Moreover, secondary effects induced by the apparent Coriolis acceleration, which can either dilate or compress the flow, often obscure scaling. This work aims at studying a set of numerical experiments where the effects of the Coriolis acceleration are measured and analyzed. Three flow states are observed: dense, dilute, and unstable. It is found that flows generated under the influence of dilative Coriolis accelerations are likely to become unstable. Nevertheless, a steady dense flow can still be obtained if a large centrifuge is used. A parametric group is proposed to predict the insurgence of instabilities; this parameter can guide experimental designs and could help to avoid damage to the experimental apparatus and model instrumentation.Graphic
- Open Access
A new method for evaluating stony debris flow rainfall thresholds: the Backward Dynamical Approach
- 17 April 2018
- Published by Taylor & Francis
- p. 1353-1360
TRENT2D, a quasi-two-phase numerical code to simulate debris flow dynamics
Debris flows are multiphase, gravity-driven flows consisting of randomly dispersed interacting phases. Their rheology and flow behaviour can vary along the runout path and depend on the sediment composition and percentage of solid and fluid phases. In an attempt to better comprehend the mechanisms and dynamics of these complex phenomena, existing one-phase numerical models are being complemented or replaced by new two-phase models. In the present paper, capabilities and limits of a quasi-two-phase code (TRENT2D) to simulate debris flows are discussed with reference to the Pellaud catchment basin (Norwestern Italy). Since TRENT2D is based on Takahashi’s theory (1978), it restricts the angles of failing slopes to less than φ/2, that is most commonly exceeded at site. As a consequence, the flow dynamics in the Pellaud upper slope was simulated with a one-phase code (RASH3D) and its outputs were used as input in the TRENT2D code, as soon as the Takahashi’s conditions are respected.
- 17 April 2018
- Published by Taylor & Francis
- p. 1353-1360
TRENT2D, a quasi-two-phase numerical code to simulate debris flow dynamics
Debris flows are multiphase, gravity-driven flows consisting of randomly dispersed interacting phases. Their rheology and flow behaviour can vary along the runout path and depend on the sediment composition and percentage of solid and fluid phases. In an attempt to better comprehend the mechanisms and dynamics of these complex phenomena, existing one-phase numerical models are being complemented or replaced by new two-phase models. In the present paper, capabilities and limits of a quasi-two-phase code (TRENT2D) to simulate debris flows are discussed with reference to the Pellaud catchment basin (Norwestern Italy). Since TRENT2D is based on Takahashi’s theory (1978), it restricts the angles of failing slopes to less than φ/2, that is most commonly exceeded at site. As a consequence, the flow dynamics in the Pellaud upper slope was simulated with a one-phase code (RASH3D) and its outputs were used as input in the TRENT2D code, as soon as the Takahashi’s conditions are respected.
- 20 May 2017
- Published by Springer Nature
- p. 89-100
Numerical Analysis of a Potential Debris Flow Event on the Irazú Volcano, Costa Rica
- 20 May 2017
- Published by Springer Nature
- p. 89-100
Numerical Analysis of a Potential Debris Flow Event on the Irazú Volcano, Costa Rica
- Open Access
- 19 January 2017
- Published by Springer Nature in Geoenvironmental Disasters
- Vol. 4 (1) , 1-15
The failure of the Stava Valley tailings dams (Northern Italy): numerical analysis of the flow dynamics and rheological properties
- 19 January 2017
- Published by Springer Nature in Geoenvironmental Disasters
- Vol. 4 (1) , 1-15
Open AccessThe failure of the Stava Valley tailings dams (Northern Italy): numerical analysis of the flow dynamics and rheological properties
- 6 June 2016
- Published by Taylor & Francis
- p. 1951-1956
Experimental study for the design of flexible barriers under debris flow impact
- 6 June 2016
- Published by Taylor & Francis
- p. 1951-1956
Experimental study for the design of flexible barriers under debris flow impact